Chi-Chih Ho
Chi-Chih Ho has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Keng-Hui Lin
Institute of Physics, Academia Sinica
2 shared publications Po-Yuan Chen
Graduate Institute of Photonics and Optoelectronics, National Taiwan University, Taipei 10617, Taiwan
2 shared publicationsWei-Li Lee
Institute of Physics 3 , Academia Sinica, Taipei, Taiwan 115, Taiwan
2 shared publications- Wei-Li Lee
Institute of Physics, Academia Sinica, Taipei, Taiwan
2 shared publications Wen-Yi Lin
Department of Materials Science and Engineering, National Tsing Hua University, Hsinchu, Taiwan
2 shared publications- Yu-Tai Tao
Institute of Chemistry, Academia Sinica, Taipei 115, Taiwan
2 shared publications
Latest Publications
- 10 August 2016
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 6 (84) , 80463-80467
In situ monitoring of colloid packing at an air/water interface using visible laser diffraction
A diffractive method using a visible laser to directly monitor colloids trapped at an air/water interface under isothermal compression is discussed.
- 10 August 2016
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 6 (84) , 80463-80467
In situ monitoring of colloid packing at an air/water interface using visible laser diffraction
A diffractive method using a visible laser to directly monitor colloids trapped at an air/water interface under isothermal compression is discussed.
- Open Access
- 1 February 2016
- Published by AIP Publishing in AIP Advances
- Vol. 6 (2) , 025102
Large-scale production of ferromagnetic nanorings by a modified hole-mask colloidal lithography: Controlled creation of flux-closure vortex state
Large arrays of ferromagnetic nanorings are produced by a modified hole-mask colloidal lithography and ring dimension can be modulated to create flux-closed vortex, known as a dipole-free magnetic state with a low crosstalk arising from neighboring entities.
- 1 February 2016
- Published by AIP Publishing in AIP Advances
- Vol. 6 (2) , 025102
Open AccessLarge-scale production of ferromagnetic nanorings by a modified hole-mask colloidal lithography: Controlled creation of flux-closure vortex state
Large arrays of ferromagnetic nanorings are produced by a modified hole-mask colloidal lithography and ring dimension can be modulated to create flux-closed vortex, known as a dipole-free magnetic state with a low crosstalk arising from neighboring entities.
- 13 November 2014
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 51 (3) , 603-606
Crystallization of rubrene on a nanopillar-templated surface by the melt-recrystallization process and its application in field-effect transistors
Oriented rubrene nanocrystal growth from melt on a nanopillar-templated surface, adaptable for field-effect transistor application.
- 13 November 2014
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 51 (3) , 603-606
Crystallization of rubrene on a nanopillar-templated surface by the melt-recrystallization process and its application in field-effect transistors
Oriented rubrene nanocrystal growth from melt on a nanopillar-templated surface, adaptable for field-effect transistor application.
- 6 June 2014
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 6 (15) , 8606-8611
Quasi-3D gold nanoring cavity arrays with high-density hot-spots for SERS applications via nanosphere lithography
A simple and robust NSL fabrication for generating nanoring cavity arrays with high density hot spots.
- 6 June 2014
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 6 (15) , 8606-8611
Quasi-3D gold nanoring cavity arrays with high-density hot-spots for SERS applications via nanosphere lithography
A simple and robust NSL fabrication for generating nanoring cavity arrays with high density hot spots.
- Open Access
- 2 June 2014
- Published by Optica Publishing Group in Optics Express
- Vol. 22 (S4) , A1128-A1136
Periodic anti-ring back reflectors for hydrogenated amorphous silicon thin-film solar cells
Large and periodic anti-ring arrays are fabricated by using a monolayer of polymer/nanosphere hybrid technique and applied as back reflectors in substrate-type hydrogenated amorphous silicon (a-Si:H) thin-film solar cells. The structure of each anti-ring comprises a nanodome centered inside a nanohole. The excitation of Bloch wave surface plasmon polaritons is observed in the Ag-coated anti-ring arrays. The nanodomes of the anti-ring arrays turn out to enhance large-angle light scattering and increase the effective optical path in the solar cell. The resulting efficiency of an ultrathin a-Si:H (thickness: 150 nm) solar cell is enhanced by 39% compared to that with a flat back reflector and by 13% compared to that with a nanohole back reflector.
- 2 June 2014
- Published by Optica Publishing Group in Optics Express
- Vol. 22 (S4) , A1128-A1136
Open AccessPeriodic anti-ring back reflectors for hydrogenated amorphous silicon thin-film solar cells
Large and periodic anti-ring arrays are fabricated by using a monolayer of polymer/nanosphere hybrid technique and applied as back reflectors in substrate-type hydrogenated amorphous silicon (a-Si:H) thin-film solar cells. The structure of each anti-ring comprises a nanodome centered inside a nanohole. The excitation of Bloch wave surface plasmon polaritons is observed in the Ag-coated anti-ring arrays. The nanodomes of the anti-ring arrays turn out to enhance large-angle light scattering and increase the effective optical path in the solar cell. The resulting efficiency of an ultrathin a-Si:H (thickness: 150 nm) solar cell is enhanced by 39% compared to that with a flat back reflector and by 13% compared to that with a nanohole back reflector.
- 29 August 2011
- Published by AIP Publishing in Applied Physics Letters
- Vol. 99 (9) , 093306
High-performance space-charge-limited transistors with well-ordered nanoporous aluminum base electrode
A large-area and periodically patterned nanoporous aluminum grid with controlled pore size was fabricated by poly(ethylene oxide)-assisted self-assembly of polystyrene nanospheres. The grid layer was used as the shadow mask for the creation of nanochannels in a polymeric dielectric layer, as well as the base electrode in a space-charge limited transistor prepared thereafter. A high performance device with poly(3-hexylthiophene) as conducting semiconductor was achieved, yielding a high on-current output of ∼12 mA/cm2 and a high on-off ratio of ∼2 × 104 at a collector voltage of −2.0 V.
- 29 August 2011
- Published by AIP Publishing in Applied Physics Letters
- Vol. 99 (9) , 093306
High-performance space-charge-limited transistors with well-ordered nanoporous aluminum base electrode
A large-area and periodically patterned nanoporous aluminum grid with controlled pore size was fabricated by poly(ethylene oxide)-assisted self-assembly of polystyrene nanospheres. The grid layer was used as the shadow mask for the creation of nanochannels in a polymeric dielectric layer, as well as the base electrode in a space-charge limited transistor prepared thereafter. A high performance device with poly(3-hexylthiophene) as conducting semiconductor was achieved, yielding a high on-current output of ∼12 mA/cm2 and a high on-off ratio of ∼2 × 104 at a collector voltage of −2.0 V.
- 10 January 2011
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 3 (2) , 204-208
Fabrication of Monolayer of Polymer/Nanospheres Hybrid at a Water-Air Interface
A new type of polymer-assisted self-assembly of nanospheres at a water−air interface was uncovered. By adding merely 1−3 ppm of polyethylene oxide in the water, the polystyrene nanospheres, applicable to diameters ranging from 100 nm to 1 μm, were found to gradually move closer to each other and eventually form a close-packed structure confirmed from its diffraction pattern. As it turns out, polyethylene oxides are adsorbed onto the surface of polystyrene nanospheres, giving rise to the effective screening of coulomb repulsive force between nanospheres followed by the onset of polymer-bridging effect as demonstrated from the strong suppression of Brownian motion. The resulting monolayer of close-packed polymer/nanospheres hybrid at the water−air interface with area size more than 1 cm2 are robust and can be transferred to a substrate of any kind without serious breaking due to surface tension tearing. Our finding may provide a further extension to the scope of nanosphere lithography technique.
- 10 January 2011
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 3 (2) , 204-208
Fabrication of Monolayer of Polymer/Nanospheres Hybrid at a Water-Air Interface
A new type of polymer-assisted self-assembly of nanospheres at a water−air interface was uncovered. By adding merely 1−3 ppm of polyethylene oxide in the water, the polystyrene nanospheres, applicable to diameters ranging from 100 nm to 1 μm, were found to gradually move closer to each other and eventually form a close-packed structure confirmed from its diffraction pattern. As it turns out, polyethylene oxides are adsorbed onto the surface of polystyrene nanospheres, giving rise to the effective screening of coulomb repulsive force between nanospheres followed by the onset of polymer-bridging effect as demonstrated from the strong suppression of Brownian motion. The resulting monolayer of close-packed polymer/nanospheres hybrid at the water−air interface with area size more than 1 cm2 are robust and can be transferred to a substrate of any kind without serious breaking due to surface tension tearing. Our finding may provide a further extension to the scope of nanosphere lithography technique.
- 22 March 2010
- Published by AIP Publishing in Applied Physics Letters
- Vol. 96 (12) , 122504
Reduced saturation magnetization in cobalt antidot thin films prepared by polyethylene oxide-assisted self-assembly of polystyrene nanospheres
We have developed an approach to prepare large array nanostructured thin films using polyethylene oxide assisted self-assembly of polystyrene nanospheres as a template. By tuning the antidot diameter in the cobalt thin films, we found a crossover behavior in the magnetization reversal process. In addition, the effective moment per cobalt atom turns out to drop with growing antidot diameter which effectively increases the surface to bulk volume fraction. Our results suggest a tendency of reduced saturation magnetization in a ferromagnet/normal metal interface, where the mixing of itinerant electrons with ferromagnetic d electrons can give rise to observable effect.
- 22 March 2010
- Published by AIP Publishing in Applied Physics Letters
- Vol. 96 (12) , 122504
Reduced saturation magnetization in cobalt antidot thin films prepared by polyethylene oxide-assisted self-assembly of polystyrene nanospheres
We have developed an approach to prepare large array nanostructured thin films using polyethylene oxide assisted self-assembly of polystyrene nanospheres as a template. By tuning the antidot diameter in the cobalt thin films, we found a crossover behavior in the magnetization reversal process. In addition, the effective moment per cobalt atom turns out to drop with growing antidot diameter which effectively increases the surface to bulk volume fraction. Our results suggest a tendency of reduced saturation magnetization in a ferromagnet/normal metal interface, where the mixing of itinerant electrons with ferromagnetic d electrons can give rise to observable effect.
- 6 May 2008
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 24 (11) , 5663-5666
Novel Fabrication of Janus Particles from the Surfaces of Electrospun Polymer Fibers
A novel synthetic approach for the efficient fabrication of Janus silica particles was demonstrated by embedment of zero-dimensional colloids on one-dimensional polymer fiber surfaces, followed by the surface modification on the exposed silica hemispheres. Electrospinning of poly(methyl methacrylate) and poly(4-vinyl pyridine) blends produced polymer fibers with high specific surface area and desired surface hydrophilicities. Fiber compositions determined the colloid adsorption density and uniformity. The colloid embedding resulted from the polymer softening was manipulated by the isothermal heat treatment. Subsequent silianization completed the amino functionalities on hemispherical surfaces of embedded silica colloids. Janus particles with uniform asymmetric chemical features were further labeled with gold nanoparticles before their recovery from fiber substrates. Fabrication of Janus particles, including colloid adsorption, temperature-driven embedding, and hemispherical surface modification, were investigated and are discussed.
- 6 May 2008
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 24 (11) , 5663-5666
Novel Fabrication of Janus Particles from the Surfaces of Electrospun Polymer Fibers
A novel synthetic approach for the efficient fabrication of Janus silica particles was demonstrated by embedment of zero-dimensional colloids on one-dimensional polymer fiber surfaces, followed by the surface modification on the exposed silica hemispheres. Electrospinning of poly(methyl methacrylate) and poly(4-vinyl pyridine) blends produced polymer fibers with high specific surface area and desired surface hydrophilicities. Fiber compositions determined the colloid adsorption density and uniformity. The colloid embedding resulted from the polymer softening was manipulated by the isothermal heat treatment. Subsequent silianization completed the amino functionalities on hemispherical surfaces of embedded silica colloids. Janus particles with uniform asymmetric chemical features were further labeled with gold nanoparticles before their recovery from fiber substrates. Fabrication of Janus particles, including colloid adsorption, temperature-driven embedding, and hemispherical surface modification, were investigated and are discussed.