AOAkihiko Ohi

Akihiko Ohi

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Akihiko Ohi has a total of 48 co-authors. Here are the top co-authors by number of shared publications:

  • Toshihide Nabatame

    National Institute for Materials Science

    7 shared publications
  • Mari Inoue

    National Institute for Materials Science (NIMS) 1 , 1-1 Namiki, Tsukuba, Ibaraki 305-0044, Japan

    4 shared publications
  • Naoki Ikeda

    Research Network and Facility Service Division, National Institute for Materials Science, Tsukuba, Ibaraki 305-0047, Japan

    4 shared publications
  • Erika Maeda

    National Institute for Materials Science (NIMS) 1 , 1-1 Namiki, Tsukuba, Ibaraki 305-0044, Japan

    3 shared publications
  • Masafumi Hirose

    National Institute for Materials Science (NIMS) 1 , 1-1 Namiki, Tsukuba, Ibaraki 305-0044, Japan

    3 shared publications
  • Akira Obuchi

    National Institute of Advanced Industrial Science and Technology (AIST), Research Center for New Fuels and Vehicle Technology, 16-1 Onogawa,Tsukuba 305-8569,Japan

    2 shared publications

Latest Publications

  • Open Access

    Structural effects on the performance of microfabricated in-plane π -type thermoelectric devices composed of p-type Mg2Sn0.8Ge0.2 and n-type Bi layers

    by Isao Ohkubo, Masayuki Murata, Akihiko Ohi, Mariana S. L. Lima, Takeaki Sakurai, Takashi Aizawa, Takao Mori

    Miniaturized in-plane π-type thermoelectric devices composed of p-type Mg2Sn0.8Ge0.2 and n-type Bi layers were prepared by microfabrication techniques. Structural effects on thermoelectric device performance need to be evaluated and optimized to improve device performance and operation. In this study, a rational analysis of the correction of the open-circuit output voltages, output powers, and output power densities by using effective temperature differences was performed, and the effects of device geometries (e.g., the number of π junctions and the cross-sectional area ratio between p- and n-type layers) were determined by comparing different types of in-plane π-type thermoelectric devices. The results revealed that it is crucial to consider the heat transfer loss caused by thermal contact effects in the device and to optimize the structural geometries of the device. Proper structural trends and the effects of the number of p–n pairs on the device performance were observed, which indicated the reasonable device operation of microfabricated in-plane π-type thermoelectric devices.


  • Influence of HfO2 and SiO2 interfacial layers on the characteristics of n-GaN/HfSiOx capacitors using plasma-enhanced atomic layer deposition

    by Toshihide Nabatame, Erika Maeda, Mari Inoue, Masafumi Hirose, Yoshihiro Irokawa, Akihiko Ohi, Naoki Ikeda, Takashi Onaya, Koji Shiozaki, Ryota Ochi, et al.

    We investigated the growth per cycle (GPC) for SiO2 and HfO2 on n-GaN/native oxide and p-Si/SiO2 substrates by plasma-enhanced atomic layer deposition using tris(dimethylamino)silane and tetrakis(dimethylamino)hafnium precursors, respectively, and O2 plasma gases. On the basis of the estimated GPC, we also examined the characteristics of n-GaN/Hf0.57Si0.43Ox/Pt capacitors with an inserted interfacial layer (IL) such as subnanometer-thick HfO2 and SiO2. We found that the GPC for SiO2 on n-GaN/native oxide was slightly smaller than that on p-Si/SiO2, whereas the GPC for HfO2 was the same on both substrates. The GPC for ALD-SiO2 could be reasonably plotted on the basis of the relationship between the GPC and the difference in electronegativity between the metal and oxygen in the metal-O underlayers including native oxide (Ga2O3) on GaN. On the basis of the GPC on n-GaN, Hf0.57Si0.43Ox (23 nm) capacitors were fabricated without and with a HfO2-IL (0.3 and 0.5 nm) or SiO2-IL (0.3 and 0.6 nm). These capacitors exhibited similar leakage current properties and a high breakdown electric field greater than 8.3 MV cm−1. No frequency dispersion and a flatband voltage (Vfb) hysteresis smaller than 50 mV were observed for all of the capacitors. Compared with the SiO2-IL [Si-rich HfSiOx (Si: > 0.43)] capacitors, the HfO2-IL [Hf-rich HfSiOx (Hf: > 0.57)] capacitors showed a smaller interface state density [(1.2–1.7) × 1011 cm−2 eV−1 at −0.4 eV from the conduction band] and a smaller negative Vfb shift. Therefore, the Hf-rich HfSiOx (Hf: > 0.57) grown using a HfO2-IL at the n-GaN/HfSiOx interface plays a substantial role in improving the electrical properties of n-GaN/HfSiOx capacitors.


  • Correlation between SiO2 growth rate and difference in electronegativity of metal–oxide underlayers for plasma enhanced atomic layer deposition using tris(dimethylamino)silane precursor

    by Erika Maeda, Toshihide Nabatame, Masafumi Hirose, Mari Inoue, Akihiko Ohi, Naoki Ikeda, Hajime Kiyono

    The growth rate of an SiO2 film on various metal–oxide (M–O) underlayers by plasma-enhanced atomic layer deposition (ALD) using tris(dimethylamino)silane precursor and O2 plasma gas is systematically investigated, and the effect of the difference in the electronegativity of the M–O underlayer on the ALD-SiO2 growth mechanism is also discussed. All data for the ALD-SiO2 film thickness on HfO2, TiO2, Al2O3, and SiO2 underlayers satisfied a linear relationship as a function of the ALD cycle. The growth per cycle (GPC) value of the ALD-SiO2 film increased in the following order: SiO2 (0.043 nm/cycle) < Al2O3 (0.14) < TiO2 (0.17) < HfO2 (0.22). On the other hand, the negative charge concentration of oxygen atoms in the M–O underlayer becomes higher in the following order: Si–O (1.76 eV) < Al–O (2.03) < Ti–O (2.18) < Hf–O (2.27) due to the electronegativity difference between the Si, Al, Ti, Hf, and O elements of the M–O underlayer. A correlation between the GPC of the ALD-SiO2 film and the difference in the electronegativity of the M–O underlayer was also determined.


  • Open Access

    An On‐Chip Quad‐Wavelength Pyroelectric Sensor for Spectroscopic Infrared Sensing

    by Thang Duy Dao, Satoshi Ishii, Anh Tung Doan, Yoshiki Wada, Akihiko Ohi, Toshihide Nabatame, Tadaaki Nagao

    Merging photonic structures and optoelectronic sensors into a single chip may yield a sensor‐on‐chip spectroscopic device that can measure the spectrum of matter. In this work, an on‐chip concurrent multiwavelength infrared (IR) sensor, which consists of a set of narrowband wavelength‐selective plasmonic perfect absorbers combined with pyroelectric sensors, where the response of each pyroelectric sensor is boosted only at the resonance of the nanostructured absorber, is proposed and realized. The proposed absorber, which is based on Wood's anomaly absorption from a 2D plasmonic square lattice, shows a narrowband polarization‐independent resonance (quality factor – Q of 73) with a nearly perfect absorptivity as high as 0.99 at normal incidence. The fabricated quad‐wavelength IR sensors exhibit four different narrowband spectral responses at normal incidence following the predesigned resonances in the mid‐wavelength infrared region that corresponds to the atmospheric window. The device can be applied for practical spectroscopic applications such as nondispersive IR sensors, IR chemical imaging devices, pyrometers, and spectroscopic thermography imaging.


  • Hafnium silicate gate dielectrics in GaN metal oxide semiconductor capacitors

    by Toshihide Nabatame, Erika Maeda, Mari Inoue, Kazuya Yuge, Masafumi Hirose, Koji Shiozaki, Naoki Ikeda, Tomoji Ohishi, Akihiko Ohi


  • Open Access

    Organic π-type thermoelectric module supported by photolithographic mold: a working hypothesis of sticky thermoelectric materials

    by Norifusa Satoh, Masaji Otsuka, Tomoko Ohki, Akihiko Ohi, Yasuaki Sakurai, Yukihiko Yamashita, Takao Mori

    To examine the potential of organic thermoelectrics (TEs) for energy harvesting, we fabricated an organic TE module to achieve 250 mV in the open-circuit voltage which is sufficient to drive a commercially available booster circuit designed for energy harvesting usage. We chose the π-type module structure to maintain the temperature differences in organic TE legs, and then optimized the p- and n-type TE materials’ properties. After injecting the p- and n-type TE materials into photolithographic mold, we eventually achieved 250 mV in the open-circuit voltage by a method to form the upper electrodes. However, we faced a difficulty to reduce the contact resistance in this material system. We conclude that TE materials must be inversely designed from the viewpoints of the expected module structures and mass-production processes, especially for the purpose of energy harvesting. GRAPHICAL ABSTRACT


  • Open Access

    Influence of Oxidant Gas of Atomic Layer Deposition on Electrical Characteristics of Al2O3 films

    by Toshihide Nabatame, Masayuki Kimura, Kazuya Yuge, Mari Inoue, Naoki Ikeda, Tomoji Ohishi, Akihiko Ohi

    総合学術電子ジャーナルサイト「J-STAGE」-国内で発行された学術論文全文を読むことのできる、日本最大級の総合電子ジャーナルプラットフォームです。


  • Electrical hysteresis in p-GaN metal–oxide–semiconductor capacitor with atomic-layer-deposited Al2O3 as gate dielectric

    by Kexiong Zhang, Meiyong Liao, Masataka Imura, Toshihide Nabatame, Akihiko Ohi, Masatomo Sumiya, Yasuo Koide, Liwen Sang

    The electrical hysteresis in current–voltage (I–V) and capacitance–voltage characteristics was observed in an atomic-layer-deposited Al2O3/p-GaN metal–oxide–semiconductor capacitor (PMOSCAP). The absolute minimum leakage currents of the PMOSCAP for forward and backward I–V scans occurred not at 0 V but at −4.4 and +4.4 V, respectively. A negative flat-band voltage shift of 5.5 V was acquired with a capacitance step from +4.4 to +6.1 V during the forward scan. Mg surface accumulation on p-GaN was demonstrated to induce an Mg–Ga–Al–O oxidized layer with a trap density on the order of 1013 cm−2. The electrical hysteresis is attributed to the hole trapping and detrapping process in the traps of the Mg–Ga–Al–O layer via the Poole–Frenkel mechanism.


  • Role of the (Ta/Nb)Ox/Al2O3 interface on the flatband voltage shift for Al2O3/(Ta/Nb)Ox/Al2O3 multilayer charge trap capacitors

    by Toshihide Nabatame, Akihiko Ohi, Kazuhiro Ito, Makoto Takahashi, Toyohiro Chikyo

    The authors studied the characteristics of Si/Al2O3/(Ta/Nb)Ox/Al2O3/SiO2/Pt charge trap capacitors fabricated by atomic layer deposition and postmetallization annealing at 400 °C. Al2O3 and (Ta/Nb)Ox films are amorphous and have negligible fixed charges. In program mode, a flatband voltage (Vfb) drastically shifts toward the positive direction at a short program time of 10−4 s. A large Vfb shift of approximately 4 V arises after programming at 1 mC/cm2 because there is a large difference in the conduction band offset between the (Ta/Nb)Ox-charge trapping layer (TNO-CTL) and the Al2O3-blocking layer (AlO-BL) (1.8 eV). In the retention mode, most of the trapped electrons in the TNO-CTL transfers across the Al2O3-tunneling layer (AlO-TL) rather than the AlO-BL. The thickness of the AlO-TL affects the Vfb shift degradation behavior in the retention mode. The injected electrons are dominantly located at the TNO-CTL/ALO-BL interface, determined from the thickness dependence of the TNO-CTL on the Vfb shift.


  • Formation of active sites on Ir/WO3–SiO2 for selective catalytic reduction of NO by CO

    by Tetsuya Nanba, Satoru Shinohara, Shouichi Masukawa, Junko Uchisawa, Akihiko Ohi, Akira Obuchi