Miguel Angel Muñoz-García

This study evaluates the integration of reused PV modules within an agrivoltaic system designed for sustainable horticultural production, focusing on energy performance and agricultural outcomes. The experimental setup included both new and partially repaired PV modules, installed over tomato crops under real operating conditions. The results demonstrate that reused PV modules exhibit a strong and consistent energy performance, achieving correlations between irradiance and energy output comparable to new panels. Despite slightly lower performance ratios, reused modules maintained stable efficiency and operational viability, emphasizing their potential for sustainable applications. On the agricultural side, shading provided by PV panels protects the crop yield. This study highlights the environmental and economic advantages of incorporating reused PV modules into agrivoltaic systems, including reductions in raw material extraction, electronic waste generation, and overall environmental impact. By leveraging the circular economy principles, agrivoltaics with reused PV modules provide a sustainable pathway to balance energy production and food security while optimizing land use efficiency. These findings establish the potential of agrivoltaics as a key technology in advancing the sustainable energy transition.

The European Union (EU) is witnessing an expansion in solar capacity, aligning with its commitment to achieving climate neutrality by 2050. However, deploying solar capacity introduces significant environmental complexities, such as managing photovoltaic waste when the modules reach their end of life. This study presents an assessment of PV waste mass generation, integrating the latest data from the revised targets of the National Energy and Climate Plans (NECPs) of EU Member States presented in December 2023. Annual and cumulative PV waste mass is presented, analyzing the results in terms of the PV capacity deployment in each country and their recycling needs to face the treatment of the generated PV waste. According to the reviewed targets, the analysis reveals significant variations in PV waste mass generation across EU countries. The revisions show a substantial increase in the amount of waste generated in Europe. Lithuania and Ireland are anticipated to face substantial challenges, particularly under the early-loss scenario, whereas Germany, Italy, France, and Spain continue to be the countries that will generate the most PV waste mass in Europe. These findings emphasize the necessity for formulating and implementing effective waste management strategies to address the increasing generation of PV waste and mitigate its environmental impact. Furthermore, the study underscores the need to reassess projections to accommodate evolving energy policies and targets, ensuring alignment with sustainability objectives in this dynamic field.

Photovoltaic (PV) installation rate is growing globally, therefore (PV) waste mass presents an environmental challenge.

Within this paper, a PLC system that takes advantage of the loop resonance of an entire DC-PV string configured as a circular signal path is developed and implemented. Low cost and extremely simple transceivers intended to be installed within each PV module of a string have been designed and successfully tested. In addition, an anti-saturation coil has been conceived to avoid saturation of the core when the entire DC current of the string flows through it. Bi-directional half-duplex communication was successfully executed with up to a 1 MHz carrier frequency (150 kbps bitrate), using a simple ASK modulation scheme. The transmission and reception performance are presented, along with the overall system cost in comparison to the previous literature.

The editorial introduces a Special Issue entitled “Photovoltaics and Electrification in Agriculture”

For decades, society has been changing towards an energy mix that enhances the use of renewable sources and a more distributed generation of energy. The agricultural sector is included in this trend, which is why several studies are currently being carried out focused on the use of solar energy in greenhouses. This article aims to demonstrate the viability of a greenhouse that integrates, as a novelty, semi-transparent amorphous silicon photovoltaic (PV) glass (a-Si), covering the entire roof surface and the main sides of the greenhouse. The designed prototype is formed by a simple rectangular structure 12 m long and 2.5 m wide, with a monopitch roof, oriented to the southwest, and with a 35° inclination. The greenhouse is divided into two contiguous equal sections, each with an area of 15 m², and physically separated by an interior partition transparent wall. The surface enclosure of one of the sections is made of conventional glass, and the one of the other, of PV glass. How the presence of semitransparent PV glass influences the growth of horticultural crops has been studied, finding that it slightly reduces the production of vegetal mass and accelerates the apical growth mechanism of heliophilic plants. However, from a statistical point of view, this influence is negligible, so it is concluded that the studied technology is viable for horticultural production. The energy balance carried out indicates that the energy produced by the PV system is greater than the energy consumed by the greenhouse, which shows that the greenhouse is completely viable and self-sufficient for sites with the adequate solar resource.