Jenny Lindvall
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jenny Lindvall has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
Gunilla Svensson
Department of Meteorology, Bolin Centre for Climate Research, Stockholm University, Stockholm, Sweden
4 shared publicationsA. C. M. Beljaars
1 shared publication- Albert A. M. Holtslag
Meteorology and Air Quality Section, Wageningen University, Wageningen, The Netherlands
1 shared publication B. Beare
1 shared publicationB. J. H. Van De Wiel
1 shared publication- Cecile Hannay
Climate and Global Dynamics Laboratory NCAR Boulder CO USA
1 shared publication
Latest Publications
- Open Access
- 4 July 2019
- Published by Wiley in Quarterly Journal of the Royal Meteorological Society
- Vol. 145 (724) , 3074-3088
Wind turning in the atmospheric boundary layer over land
- 4 July 2019
- Published by Wiley in Quarterly Journal of the Royal Meteorological Society
- Vol. 145 (724) , 3074-3088
Open AccessWind turning in the atmospheric boundary layer over land
- Open Access
- 18 August 2016
- Published by Springer Nature in Climate Dynamics
- Vol. 48 (11-12) , 3741-3758
The impact of changes in parameterizations of surface drag and vertical diffusion on the large-scale circulation in the Community Atmosphere Model (CAM5)
- 18 August 2016
- Published by Springer Nature in Climate Dynamics
- Vol. 48 (11-12) , 3741-3758
Open AccessThe impact of changes in parameterizations of surface drag and vertical diffusion on the large-scale circulation in the Community Atmosphere Model (CAM5)
- 1 July 2015
- Published by American Meteorological Society in Journal of Climate
- Vol. 28 (13) , 5233-5253
Evaluation of Near-Surface Variables and the Vertical Structure of the Boundary Layer in CMIP5 Models
The diurnal cycles of near-surface variables and turbulent heat fluxes are evaluated in 16 models from phase 5 of CMIP (CMIP5) and compared with observations from 26 flux tower sites. The diurnal cycle of 2-m temperature agrees well in general with what is observed. The amplitude of the diurnal cycle of wind speed shows a large intermodel spread and is often overestimated at midlatitude grassland sites and underestimated at midlatitude forest sites. There is a substantial systematic negative bias in the nighttime net surface radiative flux, which is partly compensated for by the turbulent heat fluxes. Four models (CESM1, BCC_CSM1.1, HadGEM2-A, and IPSL-CM5A) are evaluated in more detail, including the vertical structure of the atmospheric boundary layer, at the ARM Southern Great Plains site in Oklahoma. At that site, all models tend to frequently overestimate the boundary layer depth and the wind turning in the boundary layer reveals large intermodel differences. In summer, these models exhibit a substantial warm bias with particularly high daytime temperatures. These high temperatures are associated with very small latent heat fluxes, indicating that the soil is too dry, which is likely to impact climate change scenarios.
- 1 July 2015
- Published by American Meteorological Society in Journal of Climate
- Vol. 28 (13) , 5233-5253
Evaluation of Near-Surface Variables and the Vertical Structure of the Boundary Layer in CMIP5 Models
The diurnal cycles of near-surface variables and turbulent heat fluxes are evaluated in 16 models from phase 5 of CMIP (CMIP5) and compared with observations from 26 flux tower sites. The diurnal cycle of 2-m temperature agrees well in general with what is observed. The amplitude of the diurnal cycle of wind speed shows a large intermodel spread and is often overestimated at midlatitude grassland sites and underestimated at midlatitude forest sites. There is a substantial systematic negative bias in the nighttime net surface radiative flux, which is partly compensated for by the turbulent heat fluxes. Four models (CESM1, BCC_CSM1.1, HadGEM2-A, and IPSL-CM5A) are evaluated in more detail, including the vertical structure of the atmospheric boundary layer, at the ARM Southern Great Plains site in Oklahoma. At that site, all models tend to frequently overestimate the boundary layer depth and the wind turning in the boundary layer reveals large intermodel differences. In summer, these models exhibit a substantial warm bias with particularly high daytime temperatures. These high temperatures are associated with very small latent heat fluxes, indicating that the soil is too dry, which is likely to impact climate change scenarios.
- 26 April 2014
- Published by Springer Nature in Climate Dynamics
- Vol. 44 (1-2) , 405-421
The diurnal temperature range in the CMIP5 models
- 26 April 2014
- Published by Springer Nature in Climate Dynamics
- Vol. 44 (1-2) , 405-421
The diurnal temperature range in the CMIP5 models
- Top Cited Papers
- 1 November 2013
- Published by American Meteorological Society in Bulletin of the American Meteorological Society
- Vol. 94 (11) , 1691-1706
Stable Atmospheric Boundary Layers and Diurnal Cycles: Challenges for Weather and Climate Models
The representation of the atmospheric boundary layer is an important part of weather and climate models and impacts many applications such as air quality and wind energy. Over the years, the performance in modeling 2-m temperature and 10-m wind speed has improved but errors are still significant. This is in particular the case under clear skies and low wind speed conditions at night as well as during winter in stably stratified conditions over land and ice. In this paper, the authors review these issues and provide an overview of the current understanding and model performance. Results from weather forecast and climate models are used to illustrate the state of the art as well as findings and recommendations from three intercomparison studies held within the Global Energy and Water Exchanges (GEWEX) Atmospheric Boundary Layer Study (GABLS). Within GABLS, the focus has been on the examination of the representation of the stable boundary layer and the diurnal cycle over land in clear-sky conditions. For this purpose, single-column versions of weather and climate models have been compared with observations, research models, and large-eddy simulations. The intercomparison cases are based on observations taken in the Arctic, Kansas, and Cabauw in the Netherlands. From these studies, we find that even for the noncloudy boundary layer important parameterization challenges remain.
- 1 November 2013
- Published by American Meteorological Society in Bulletin of the American Meteorological Society
- Vol. 94 (11) , 1691-1706
Top Cited PapersStable Atmospheric Boundary Layers and Diurnal Cycles: Challenges for Weather and Climate Models
The representation of the atmospheric boundary layer is an important part of weather and climate models and impacts many applications such as air quality and wind energy. Over the years, the performance in modeling 2-m temperature and 10-m wind speed has improved but errors are still significant. This is in particular the case under clear skies and low wind speed conditions at night as well as during winter in stably stratified conditions over land and ice. In this paper, the authors review these issues and provide an overview of the current understanding and model performance. Results from weather forecast and climate models are used to illustrate the state of the art as well as findings and recommendations from three intercomparison studies held within the Global Energy and Water Exchanges (GEWEX) Atmospheric Boundary Layer Study (GABLS). Within GABLS, the focus has been on the examination of the representation of the stable boundary layer and the diurnal cycle over land in clear-sky conditions. For this purpose, single-column versions of weather and climate models have been compared with observations, research models, and large-eddy simulations. The intercomparison cases are based on observations taken in the Arctic, Kansas, and Cabauw in the Netherlands. From these studies, we find that even for the noncloudy boundary layer important parameterization challenges remain.
- Open Access
- 1 January 2013
- Published by American Meteorological Society in Journal of Climate
- Vol. 26 (1) , 26-44
Evaluation of Near-Surface Parameters in the Two Versions of the Atmospheric Model in CESM1 using Flux Station Observations
This paper describes the performance of the Community Atmosphere Model (CAM) versions 4 and 5 in simulating near-surface parameters. CAM is the atmospheric component of the Community Earth System Model (CESM). Most of the parameterizations in the two versions are substantially different, and that is also true for the boundary layer scheme: CAM4 employs a nonlocal K-profile scheme, whereas CAM5 uses a turbulent kinetic energy (TKE) scheme. The evaluation focuses on the diurnal cycle and global observational and reanalysis datasets are used together with multiyear observations from 35 flux tower sites, providing high-frequency measurements in a range of different climate zones. It is found that both model versions capture the timing of the diurnal cycle but considerably overestimate the diurnal amplitude of net radiation, temperature, wind, and turbulent heat fluxes. The seasonal temperature range at mid- and high latitudes is also overestimated with too warm summer temperatures and too cold winter temperatures. The diagnosed boundary layer is deeper in CAM5 over ocean in regions with low-level marine clouds as a result of the turbulence generated by cloud-top cooling. Elsewhere, the boundary layer is in general shallower in CAM5. The two model versions differ substantially in their representation of near-surface wind speeds over land. The low-level wind speed in CAM5 is about half as strong as in CAM4, and the difference is even larger in areas where the subgrid-scale terrain is significant. The reason is the turbulent mountain stress parameterization, only applied in CAM5, which acts to increase the surface stress and thereby reduce the wind speed.
- 1 January 2013
- Published by American Meteorological Society in Journal of Climate
- Vol. 26 (1) , 26-44
Open AccessEvaluation of Near-Surface Parameters in the Two Versions of the Atmospheric Model in CESM1 using Flux Station Observations
This paper describes the performance of the Community Atmosphere Model (CAM) versions 4 and 5 in simulating near-surface parameters. CAM is the atmospheric component of the Community Earth System Model (CESM). Most of the parameterizations in the two versions are substantially different, and that is also true for the boundary layer scheme: CAM4 employs a nonlocal K-profile scheme, whereas CAM5 uses a turbulent kinetic energy (TKE) scheme. The evaluation focuses on the diurnal cycle and global observational and reanalysis datasets are used together with multiyear observations from 35 flux tower sites, providing high-frequency measurements in a range of different climate zones. It is found that both model versions capture the timing of the diurnal cycle but considerably overestimate the diurnal amplitude of net radiation, temperature, wind, and turbulent heat fluxes. The seasonal temperature range at mid- and high latitudes is also overestimated with too warm summer temperatures and too cold winter temperatures. The diagnosed boundary layer is deeper in CAM5 over ocean in regions with low-level marine clouds as a result of the turbulence generated by cloud-top cooling. Elsewhere, the boundary layer is in general shallower in CAM5. The two model versions differ substantially in their representation of near-surface wind speeds over land. The low-level wind speed in CAM5 is about half as strong as in CAM4, and the difference is even larger in areas where the subgrid-scale terrain is significant. The reason is the turbulent mountain stress parameterization, only applied in CAM5, which acts to increase the surface stress and thereby reduce the wind speed.