Peng Zheng
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Peng Zheng has a total of 61 co-authors. Here are the top co-authors by number of shared publications:
- Shouwu Guo
Shanghai Jiao Tong University
6 shared publications Ting Liu
6 shared publicationsJialin Guo
Shaanxi Key Laboratory of Comprehensive Utilization of Tailings Resources, College of Chemical Engineering and Modern Materials, Shang Luo University, Shang Luo, People’s Republic of China
5 shared publicationsShouwu Guo
5 shared publicationsLifeng Zhang
4 shared publicationsDazhong Ren
3 shared publications
Latest Publications
- 11 August 2026
- Published by Springer Nature in JOM
- p. 1-9
Anthracite-Derived Lamellar Carbon with Enhanced Graphitization for Lithium–Sulfur Batteries
- 11 August 2026
- Published by Springer Nature in JOM
- p. 1-9
Anthracite-Derived Lamellar Carbon with Enhanced Graphitization for Lithium–Sulfur Batteries
- Open Access
- 28 February 2025
- Published by (Xiamen: Dianhuaxue Bianjibu) Editorial Office of Journal of Electrochemistry, Xiamen University in Journal of Electrochemistry
- Vol. 31 (2) , 3
SnO2 Particles Embedded into Carbon Coated Mesoporous SiOx Rod as High Volumetric Capacity Anode for Lithium-ion Batteries
Due to the high capacity and moderate volume expansion of silicon protoxide SiOx (160%) compared with that of Si (300%), reducing silicon dioxide SiO2 into SiOx while maintaining its special nano-morphology makes it attractive as an anode of Li-ion batteries. Herein, through a one-pot facile high-temperature annealing route, using SBA15 as the silicon source, and embedding tin dioxide SnO2 particles into carbon coated SiOx, the mesoporous SiOx-SnO2@C rod composite was prepared and tested as the anode material. The results revealed that the SnO2 particles were distributed uniformly in the wall, which could further improve their volume energy densities. The coated carbon plays a role in maintaining structural integrality during lithiation, and the rich mesopores structure can release the expanded volume and enhance Li-ion transfer. At 0.1 A·g–1, the gravimetric and volumetric capacities of the composite were as high as 1271 mAh·g–1 and 1573 mAh·cm–3, respectively. After 200 cycles, the 95% capacity could be retained compared with that upon the 2nd cycle at 0.5 A·g–1. And the rod morphology was well kept, except that the diameter of the rod was 3 times larger than its original size after the cell was discharged into 0.01 V.
- 28 February 2025
- Published by (Xiamen: Dianhuaxue Bianjibu) Editorial Office of Journal of Electrochemistry, Xiamen University in Journal of Electrochemistry
- Vol. 31 (2) , 3
Open AccessSnO2 Particles Embedded into Carbon Coated Mesoporous SiOx Rod as High Volumetric Capacity Anode for Lithium-ion Batteries
Due to the high capacity and moderate volume expansion of silicon protoxide SiOx (160%) compared with that of Si (300%), reducing silicon dioxide SiO2 into SiOx while maintaining its special nano-morphology makes it attractive as an anode of Li-ion batteries. Herein, through a one-pot facile high-temperature annealing route, using SBA15 as the silicon source, and embedding tin dioxide SnO2 particles into carbon coated SiOx, the mesoporous SiOx-SnO2@C rod composite was prepared and tested as the anode material. The results revealed that the SnO2 particles were distributed uniformly in the wall, which could further improve their volume energy densities. The coated carbon plays a role in maintaining structural integrality during lithiation, and the rich mesopores structure can release the expanded volume and enhance Li-ion transfer. At 0.1 A·g–1, the gravimetric and volumetric capacities of the composite were as high as 1271 mAh·g–1 and 1573 mAh·cm–3, respectively. After 200 cycles, the 95% capacity could be retained compared with that upon the 2nd cycle at 0.5 A·g–1. And the rod morphology was well kept, except that the diameter of the rod was 3 times larger than its original size after the cell was discharged into 0.01 V.
- 2 August 2024
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 35 (22) , 1-10
Co-doped MnO2 nanorods with oxygen vacancies as anode for Li-ion battery
- 2 August 2024
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 35 (22) , 1-10
Co-doped MnO2 nanorods with oxygen vacancies as anode for Li-ion battery
- 11 August 2023
- Published by Springer Nature in Applied Physics A
- Vol. 129 (9) , 1-8
Carbon-coated high nickel cathode nanosheet with stable structure for lithium-ion batteries
- 11 August 2023
- Published by Springer Nature in Applied Physics A
- Vol. 129 (9) , 1-8
Carbon-coated high nickel cathode nanosheet with stable structure for lithium-ion batteries
- 23 December 2022
- Published by Springer Nature in Applied Physics A
- Vol. 129 (1) , 1-8
Carbon-wrapped amorphous Ni–Co binary oxide nanosheet for high-performance pseudocapacitors
- 23 December 2022
- Published by Springer Nature in Applied Physics A
- Vol. 129 (1) , 1-8
Carbon-wrapped amorphous Ni–Co binary oxide nanosheet for high-performance pseudocapacitors
- 9 January 2022
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 33 (8) , 4862-4868
Catalytic graphitization of anthracite-derived carbon as the anode for Li/K-ion batteries
- 9 January 2022
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 33 (8) , 4862-4868
Catalytic graphitization of anthracite-derived carbon as the anode for Li/K-ion batteries
- 9 April 2021
- Published by Springer Nature in Applied Physics A
- Vol. 127 (5) , 1-9
Pomelo peel-derived lamellar carbon with surface oxygen functional groups for high-performance supercapacitors
- 9 April 2021
- Published by Springer Nature in Applied Physics A
- Vol. 127 (5) , 1-9
Pomelo peel-derived lamellar carbon with surface oxygen functional groups for high-performance supercapacitors
- 12 August 2020
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 31 (18) , 16037-16043
Nitrogen-doped carbon/SiOx composites from rice husks as a high-performance anode for lithium-ion batteries
- 12 August 2020
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 31 (18) , 16037-16043
Nitrogen-doped carbon/SiOx composites from rice husks as a high-performance anode for lithium-ion batteries
- 1 June 2020
- Published by Elsevier in Ceramics International
- Vol. 46 (8) , 11570-11576
Rice husk-derived SiOx@carbon nanocomposites as a high-performance bifunctional electrode for rechargeable batteries
- 1 June 2020
- Published by Elsevier in Ceramics International
- Vol. 46 (8) , 11570-11576
Rice husk-derived SiOx@carbon nanocomposites as a high-performance bifunctional electrode for rechargeable batteries
- 13 May 2020
- Published by Wiley in Energy Technology
- Vol. 8 (7)
One‐Pot Template‐Free Cross‐Linking Synthesis of SiOx–SnO2@C Hollow Spheres as a High Volumetric Capacity Anode for Lithium‐Ion Batteries
Porous SiOx anodes for Li‐ion batteries with a high volumetric energy density are desired. Herein, carbon‐coated SiOx–SnO2 hollow spheres are prepared by facile one‐pot high‐temperature annealing without using any template. During the process, SiOx is obtained through Sn reduction with the assistance of C. In the composite, the SiOx hollow spheres have a thin wall, the small SnO2 particles are uniformly imbedded in the sphere wall, and the SiOx–SnO2 hollow spheres are coated by cross‐linked carbon. As an anode, the composite has a large volumetric capacity (1339 mAh cm−3 at 0.1 A g−1), a high gravimetric capacity (1030 mAh g−1 at 0.1 A g−1), and a good cyclic stability (after 100 cycles, 90% capacity is retained compared with that of the second cycle at 0.5 A g−1). The high capacity and good cycle stability result from the superior structure of the composite. Furthermore, the thin wall of the sphere can timely release a large expanded volume during lithiation, and the conformal carbon also provides a framework to maintain the structural integrity and facilitate the formation of a stable solid–electrolyte interface.
- 13 May 2020
- Published by Wiley in Energy Technology
- Vol. 8 (7)
One‐Pot Template‐Free Cross‐Linking Synthesis of SiOx–SnO2@C Hollow Spheres as a High Volumetric Capacity Anode for Lithium‐Ion Batteries
Porous SiOx anodes for Li‐ion batteries with a high volumetric energy density are desired. Herein, carbon‐coated SiOx–SnO2 hollow spheres are prepared by facile one‐pot high‐temperature annealing without using any template. During the process, SiOx is obtained through Sn reduction with the assistance of C. In the composite, the SiOx hollow spheres have a thin wall, the small SnO2 particles are uniformly imbedded in the sphere wall, and the SiOx–SnO2 hollow spheres are coated by cross‐linked carbon. As an anode, the composite has a large volumetric capacity (1339 mAh cm−3 at 0.1 A g−1), a high gravimetric capacity (1030 mAh g−1 at 0.1 A g−1), and a good cyclic stability (after 100 cycles, 90% capacity is retained compared with that of the second cycle at 0.5 A g−1). The high capacity and good cycle stability result from the superior structure of the composite. Furthermore, the thin wall of the sphere can timely release a large expanded volume during lithiation, and the conformal carbon also provides a framework to maintain the structural integrity and facilitate the formation of a stable solid–electrolyte interface.