SMSyed Mubeen

Syed Mubeen

*This is an algorithmically generated author record based on publicly available information.

Syed Mubeen has a total of 61 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • The Role of Oxygen Vacancies in Copper Amended Titanium Dioxide-Carbon Nanofiber Electrodes in Electrochemical Nitrate Reduction in Water

    by Kuan-Lin Lee, Chenxu Yan, Ashley Hesterberg Butzlaff, Eleanor Spielman-Sun, David M. Cwiertny, Syed Mubeen, Charles J. Werth


  • Open Access

    Evaluating Copper-Modified Carbon Composite Nanofiber Electrodes for Electrocatalytic Nitrate Reduction

    by Ashley Hesterberg Butzlaff, Abdulsattar H. Ghanim, Yun Young Choi, Chenxu Yan, Xiaonan Shan, Nosang Vincent Myung, Charles J. Werth, David M. Cwiertny, Syed Mubeen

    The increasing urgency to address nitrate (NO3 –) pollution in water sources has intensified research on electrochemical nitrate reduction, a process capable of transforming NO3 – into valuable ammonia (NH3) by using renewable electricity. Copper (Cu) catalysts can reduce NO3 –, but their activity and selectivity toward NH3 can vary based on their structure, reaction environment, and support material. This study examines the efficacy of Cu-modified carbon nanofiber (CNF) supports, tailored through electrospinning, in enhancing the electrocatalytic reduction of NO3 – to NH3. Three variants of CNF supports were synthesized: pristine CNFs, CNFs integrated with carbon nanotubes (CNF/CNTs), and CNFs embedded with titanium dioxide nanoparticles (CNF/TiO2). Each electrode’s physical and electrochemical properties were analyzed before and after Cu electrodeposition. Notably, the CNF/TiO2/Cu composites demonstrated a selectivity exceeding 40% for the conversion of NO3 – to NH3 at neutral pHsignificantly outperforming the CNF/CNT/Cu (2/Cu electrode also exhibited consistent and stable performance over the extended experimental duration (|Q| = 70 C), maintaining NH3 selectivity rates of over 50%. Tafel analysis and operando Raman spectroscopy suggest that TiO2 plays an active role in hydrogenating nitrogenous reduction products for enhanced selectivity. This research highlights the importance of electrode-catalyst selection in electrochemical NO3 – reduction and identifies TiO2-containing electrodes as promising solutions in this domain.


  • Optimizing Sputtered Iridium Electrocatalysts for Acidic Oxygen Evolution Using Design of Experiments

    by Joshua Adedeji Bolarin, Gyan Prakash Sharma, Chayanika Das, Syed Mubeen, Nirala Singh


  • Fine-tuning syngas composition using laser surface modified silver electrode for CO2 electroreduction

    by Austin McKee, Wuji Huang, Ninggang Shen, Syed Mubeen, Hongtao Ding

    Electrochemical reduction of CO2 and H2O to synthesize gas (H2 and CO mixture) is of significant interest due to established industrial pathways to tune the H2 to CO composition to generate an array of valuable products including methanol, synthetic fuel, synthetic natural gas, and hydrogen. However, controlled H2:CO ratios are challenging on CO-active electrocatalysts like silver. We demonstrate that applying laser engineering to adjust the surface wetting state of a silver electrocatalyst with water contact angles θw ranging from 47° and 135°, H2:CO ratios can be tuned from 1 to 4 at modest potentials (−0.7 V versus RHE, RHE—reversible hydrogen electrode) with almost total unity Faradaic efficiency. Both hydrophilic (θw = 47°) and more hydrophobic (θw = 135°) samples showed an increasing H2:CO trend with rising potentials (0.7–1.2 V versus RHE) due to mass transport. Conversely, silver electrocatalyst with θw = 110° exhibited a constant H2:CO ratio of 4. This indicates catalyst wettability potentially affects *H and *HOCO intermediates’ adsorption, impacting H2:CO ratios. Our results show the feasibility of syngas composition control on silver catalysts via surface wettability, providing a simpler alternative to complex multicomponent electrocatalytic systems.

  • Open Access

    Electrospun TiO2/carbon composite nanofibers as effective (photo)electrodes for removal and transformation of recalcitrant water contaminants

    by Ashley Hesterberg Butzlaff, Madeline Jensen, Chenxu Yan, Abdulsattar H Ghanim, Charles Werth, David Michael Cwiertny, Syed Mubeen

    Electrochemical (EC) and photoelectrochemical (PEC) water treatment systems are gaining popularity, necessitating new electrode materials that offer reliable performance across diverse application platforms. For applications specifically targeting dilute chemical pollutants (i.e., parts-per-million concentrations or less), beneficial electrode properties include high surface area to overcome kinetic overpotential losses, low electrode areal electrical resistance, and high water permeability with sufficient mechanical strength for use in electroactive membrane-based treatment systems. Here, we used electrospinning to fabricate (photo)electrodes from carbon nanofibers (CNFs) containing titanium dioxide (TiO2) nanoparticles. Optimal CNF/TiO2 composites were electrochemically and photoelectrochemically active with a surface area of ~50 m2 g-1 and electrode areal resistance of 2.66 Ω-cm2, values comparable to commercial carbon-based electrode materials (e.g., Kynol Activated Carbon Cloth). Transformation experiments with carbamazepine (CBZ), a recalcitrant organic contaminant, suggest CNF/TiO2 electrodes initially sorb CBZ prior to electrooxidation at positive applied potentials. Complete CBZ transformation was observed in both EC (dark) and PEC (UV light; 280 mW cm-2) systems over 90 minutes, with PEC systems exhibiting 1.5-fold higher transformation rates (kobs ~ 0.18 min-1) at +1.00 V (vs. Ag/AgCl). Composite electrodes also exhibited stability across repeated use, yielding consistent current densities over five experimental cycles (120 min each) of CBZ transformation (0.25 ± 0.03 mA cm-2). Because of their high surface area, electrical conductivity, photoactivity, and electrochemical stability, these electrospun CNF/TiO2 composites represent promising (photo)electrode alternatives for diverse EC and PEC applications.


  • Evaluation of novel cathodes with single and bi-metal catalysts for electrocatalytic reduction of nitrate with high activity, current efficiency, and selectivity for dinitrogen

    by Chenxu Yan, Jacob P Troutman, Kuan-Lin Lee, Carolyn Brady, Simon M Humphrey, Charles J Werth, Ashley Hesterberg, David M Cwiertny, Syed Mubeen

  • Reflection Optical Imaging to Study Oxygen Evolution Reactions

    by Xu Yang, Jonathan G. Koonce, Ying-Chau Liu, Guangxia Feng, Yaping Shi, Xiaoliang Li, Syed Mubeen, Xiaonan Shan

    Discovery of high-efficiency water-splitting catalysts is critical for clean hydrogen fuel generation. Quantitative and reliable chemical imaging methods can play a crucial role in providing critical catalyst efficiency information for materials development and screening. Here, we developed a reflection optical imaging method to map the performance of transition metal oxide catalysts for oxygen evolution reaction (OER). The generated high concentration of oxygen in the electrolyte will decrease the refractive index of the solutions near the electrode and change the reflectivity of optical images. We successfully imaged and measured the OER on cobalt oxide, and the localized current density and overpotential distribution maps have been extracted. The oxidation and reduction of cobalt oxide can be imaged with our reflection optical imaging method as well. These maps showed that the catalytic activities are quite different at different locations, and some regions showed much higher activities. This is due to the non-uniformity created by the catalyst synthesis process and demonstrates the importance of using the optical imaging method to map the localized catalytic efficiency. In addition, the NiFe alloy’s OER catalytic activities have been studied as well. The proposed reflection optical imaging method could find many applications in catalyst activity measurement and screening.


  • Effect of silver electrode wetting state on oxygen reduction electrochemistry

    by Austin McKee, Avik Samanta, Alan Rassoolkhani, Jonathan Koonce, Wuji Huang, Jacob Fields, Scott K. Shaw, Joseph Gomes, Hongtao Ding, Syed Mubeen

    Surface wettability plays an important role in heterogeneous electrocatalysis. Here we report a facile laser ablation strategy to directly modify the wettability of the silver catalyst surface and investigate its effect on oxygen reduction reaction (ORR). A broad range tuning of 2e−/4e− ORR pathways was achieved, with hydrophilic silver surfaces (contact angle (θw) 31.1° ± 0.6°) showing high activity and selectivity towards 4e− reduction of oxygen to water.


  • Open Access

    Electrochemical Approach to Measure Physiological Fluid Flow Rates

    by Srivats Sarathy, Marco A. Nino, Abdulsattar H. Ghanim, Srinivasan Rajagopal, Syed Mubeen, M. L. Raghavan

    In vivo measurement of the flow rate of physiological fluids such as the blood flow rate in the heart is vital in critically ill patients and for those undergoing surgical procedures. The reliability of these measurements is therefore quite crucial. However, current methods in practice for measuring flow rates of physiological fluids suffer from poor repeatability and reliability. Here, we assessed the feasibility of a flow rate measurement method that leverages time transient electrochemical behavior of a tracer that is injected directly into a medium (the electrochemical signal caused due to the tracer injectate will be diluted by the continued flow of the medium and the time response of the current—the electrodilution curve—will depend on the flow rate of the medium). In an experimental flow loop apparatus equipped with an electrochemical cell, we used the AC voltammetry technique and tested the feasibility of electrodilution-based measurement of the flow rate using two mediums—pure water and anticoagulated blood—with 0.9 wt% saline as the injectate. The electrodilution curve was quantified using three metrics—change in current amplitude, total time, and change in the total charge for a range of AC voltammetry settings (peak voltages and frequencies). All three metrics showed an inverse relationship with the flow rate of water and blood, with the strongest negative correlation obtained for change in current amplitude. The findings are a proof of concept for the electrodilution method of the flow rate measurement and offer the potential for physiological fluid flow rate measurement in vivo.


  • Open Access

    Scalable reactor design for electrocatalytic nitrite and nitrate reduction with minimal mass transport limitations

    by Syed Mubeen, Ashley Hesterberg, Chenxu Yan, Charles J Werth, Sruthi Kakuturu, David M Cwiertny