CMClaudio Madonna

Claudio Madonna

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Claudio Madonna has a total of 77 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Frictional Controls on Shallow Megathrust Slip: Field and Experimental Constraints from the Chugach-Kodiak Accretionary Wedge, Alaska

    by M. Rast, W. M. Behr, M. Claudio, G. Simon

    Subduction megathrusts accommodate a range of slip behaviors, from earthquakes to slow slip events and stable creep, but the controls governing their distribution remain poorly constrained. We investigate hydromechanical and lithologic controls on frictional behavior in the Mesozoic McHugh Complex (Alaska), an exhumed accretionary complex representative of the shallow plate interface (prehnite-pumpellyite facies). We integrate field observations with compositional and microstructural analyses and laboratory friction experiments on representative fault gouges and host rocks. Structural observations reveal that the accretionary complex incorporated inherited heterogeneity from the incoming plate. Experiments conducted under air-dry and water-saturated conditions at room temperature and normal stresses of 10–40 MPa show that frictional behavior is strongly controlled by composition. Water saturation preferentiallyweakens phyllosilicate-rich materials, promoting velocity-strengthening behavior. Organicrich argillitic gouges exhibit the lowest friction coefficients ( µ f ≈ 0.33) and accommodated stable creep, consistent with field evidence for strain concentration in these rocks. Cherts and veined pillow basalts are stronger ( µ f ≈ 0.53) and exhibit velocity-weakening tendencies. Basalt-hosted fault zones with chlorite-enrichment show transitional, near velocity-neutral behavior. Our results indicate that stable, unstable, and conditionally stable slip coexisted along the shallow megathrust, reflecting a mechanically heterogeneous interface generated by inherited lithologic architecture, alteration, fluid interactions, and fault-fabric evolution.

  • Open Access

    Blueschist Dislocation Creep and Glide in Subduction Systems: Constraints From Glaucophane Experiments

    by Lonnie J. Hufford, Leif Tokle, Whitney M. Behr, Luiz F. G. Morales, Claudio Madonna

    Blueschists are a defining component of subducting oceanic crust and influence slab and interface rheology across thermal regimes. Glaucophane, the dominant sodic amphibole in blueschist, is a key rheology‐controlling phase, yet its dislocation‐based strength is poorly constrained. We conducted load‐stepping experiments in a Griggs apparatus at 600–700C and 1.0 GPa over shear strain rates from ∼ to 1.2, using a starting grain size of n = 3, Q = 450 15 kJ/mol, A = 2.32 × and dislocation glide A = , = 22 GPa, H = 800 kJ/mol, p = 1, and q = 2. Extrapolation to geologic conditions suggests that dislocation glide will not operate under steady‐state subduction‐interface conditions, and is likely only relevant during transient high stress perturbations. Dislocation creep dominates at temperatures above 450°C at grain sizes of ∼1 mm or larger. Comparison with published quartz/metasediment and eclogite flow laws indicates that blueschist strengths are intermediate between these endmembers, implying a meaningful contribution to long‐term interface strength in mafic‐dominated (sediment‐poor) margins. Together, these results refine glaucophane‐controlled blueschist rheology and its implications for subduction zone mechanics.


  • Open Access

    Blueschist dislocation creep and glide in subduction systems: constraints from glaucophane experiments

    by Lonnie Justin Hufford, Leif Tokle, Whitney M. Behr, Luiz F Grafulha Morales, Claudio Madonna

    Blueschists are a defining component of subducting oceanic crust and influence slab and interface rheology across thermal regimes. Glaucophane, the dominant sodic amphibole in blueschist, is a key rheology-controlling phase, yet its dislocation-based strength is poorly constrained. We conducted load-stepping experiments in a Griggs apparatus at 600-700°C and 1.0 GPa over shear-strain rates from ~1.2 x 10-8 s-1 to ~1.2 x 10-3 s-1, using a starting grain size of < 63 μm. Mechanical data show a stress-exponent transition from 2.8–3.0 at relatively low stresses (dislocation creep) to 13-19 at high stresses (dislocation glide). Undulose extinction, subgrain development, and recrystallized grains corroborate dislocation activity. We derive flow laws for dislocation creep n = 3, Q = 450 ± 15 kJ/mol, A =2.32x1010 MPa-n s-1 and dislocation glide A = 1038.02, σp = 22 GPa, H = 800 kJ/mol, p = 1, and q = 2. Extrapolation to geologic conditions suggests that dislocation glide will not operate under steady-state subduction-interface conditions, and is likely only relevant during transient high stress perturbations. Dislocation creep dominates at temperatures above 450°C at grain sizes of ~1 mm or larger. Comparison with published quartz/metasediment and eclogite flow laws indicates that blueschist strengths are intermediate between these endmembers, implying a meaningful contribution to long-term interface strength in mafic-dominated (sediment-poor) margins. Together, these results refine glaucophane-controlled blueschist rheology and its implications for subduction zone mechanics.

  • Open Access

    Laboratory‐Constrained Seismic Properties of the COSC‐2 Borehole, Scandinavian Caledonides: Implications for Crustal Anisotropy and Reflectivity

    by Markus Rast, Claudio Madonna, Nora Schweizer, Bjarne S. G. Almqvist, Jonas B. Ruh

    Seismic surveys are essential for studying the Earth's subsurface. However, the interpretation of seismic surveys requires a link between field data and rock physical properties by linking laboratory‐derived data from drill core samples with borehole information and seismic images. Here, we study the seismic properties of the second “Collisional Orogeny in the Scandinavian Caledonides” borehole (COSC‐2), which intersects parautochthonous turbidites, highly deformed black shales (Alum Shale), autochthonous sediments, and the underlying Baltic basement. We selected six core samples of the major lithologies (graywacke, lithic arenite, Alum Shale, arkosic arenite, porphyry, and dolerite) to measure ultrasonic P‐ and S‐wave velocities ( and ) under dry conditions at confining pressures of 10–240 MPa. For anisotropic sedimentary samples, we measured and in three mutually perpendicular sub‐samples oriented relative to foliation and lineation. Combining our measurements with theoretical concepts of elasticity, we estimated key influences on seismic properties. Our results show: (a) Pressure solution seams in arenites have little effect on seismic anisotropy. (b) Strongly anisotropic graywacke and Alum Shale samples have orthorhombic or lower symmetry, challenging the common transverse isotropy assumption for clay‐rich rocks. Accounting for laboratory‐derived anisotropy may improve the reflectivity in seismic surveys. (c) Organic matter in Alum Shale reduces seismic velocities, enhances seismic anisotropy, and causes Alum Shale to be a prominent reflector. (d) Despite the low porosity, microcracks in the dolerite cause velocities to be significantly higher under saturated conditions than under dry conditions, which must be considered when interpreting the reflectivity of dolerites intruded into porphyries.


  • Open Access

    Investigating Criticality in Rock Failure Using Fiber‐Optic Strain Sensing

    by Hao Chen, Paul Antony Selvadurai, Tom de Geus, Antonio Felipe Salazar Vásquez, Patrick Bianchi, Sofia Michail, Markus Rast, Claudio Madonna, Stefan Wiemer

    Gradual localization of deformation preceding catastrophic failure can produce precursory signals associated with a phase transition that may be present prior to earthquakes. However, due to the unclear origin of these precursors and the complexity of the environmental conditions, detecting such preparatory signals remains challenging. Here we present the spatio‐temporal evolution of surface strain measured using fiber‐optic sensing during triaxial experiments in wet and dry conditions. We identify a power‐law distribution of strain increments where the largest magnitude diverges toward failure. This suggests a critical phase transition with the emergence of failure precursors. However, criticality is only observed in dry conditions and disappears with pressurized pore fluids, where the largest strain increment accelerates exponentially, consistent with a first‐order transition. Our results highlight that progressive damage features criticality for failure prediction, but elevated fluid pressures may shift this behavior to abrupt rupture.


  • Open Access

    Strain heterogeneities in laboratory faults driven by roughness and wear

    by Sofia Michail, Sofia Michail, Paul Antony Selvadurai, Paul Antony Selvadurai, Markus Rast, Markus Rast, Antonio Felipe Salazar Vásquez, Antonio Felipe Salazar Vásquez, Patrick Bianchi, Patrick Bianchi, et al.


  • Open Access

    The COSC-2 drill core and its well-preserved lower Palaeozoic sedimentary succession – an unexpected treasure beneath the Caledonian nappes

    by Oliver Lehnert, Bjarne Almqvist, Mark Anderson, Jenny Andersson, Simon Cuthbert, Mikael Calner, Isabel Carter, Riccardo Callegari, Christopher Juhlin, Henning Lorenz, et al.

    The Collisional Orogeny in the Scandinavian Caledonides (COSC) project focuses on processes related to the closure of the Iapetus Ocean, causing the Ordovician–Silurian continent–continent collision between Baltica and Laurentia. The rock succession in the second drill core (COSC-2) from the Jämtland County, central Sweden, provides the base for detailed sedimentological, stratigraphic, geophysical, geochemical, geothermal and structural studies. The basement, comprising 1.66–1.65 Ga Transscandinavian Igneous Belt porphyries intruded by 1.47 Ga and 1.27–1.26 Ga mafic dykes and sills, is heavily weathered towards the top. Here it grades into typical saprock and saprolite (including immature soil reflecting the sub-Cambrian peneplain). The overlying sedimentary sequence starts with basal conglomerates and heterogeneous sediments with shell fragments, indicating an early Cambrian rather than a Neoproterozoic age for the marine transgression in the area. The developing early Cambrian basin was rapidly filled, initially by mostly coarse-grained sediment gravity flows. These strata are covered by sandstone turbidites that show an upward transition into the Alum Shale Formation, representing a tectonically quieter period (mid-Cambrian/Maolingian to Early Ordovician/Tremadocian). The upper part of the Alum Shale Formation is overlain by a late Early Ordovician turbidite succession. Local sources of sediments below the Alum Shale Formation and the extended deposition period may indicate continuous sedimentation in a pull-apart basin preserved in a window beneath the Caledonian thrust sheets.


  • Open Access

    Importance of Water‐Clay Interactions for Fault Slip in Clay‐Rich Rocks

    by Markus Rast, Claudio Madonna, Paul A. Selvadurai, Quinn C. Wenning, Jonas B. Ruh

    Clay‐rich rocks are integral to subduction zone dynamics and of practical importance, for example, as barriers in nuclear waste and CO2 repositories. While the effects of swelling strain on the self‐sealing capabilities of these rocks are relatively well‐established, the implications of polar fluids interacting with charged clay particles on the frictional behavior, and the role of swelling stress in initiating slip in critically stressed faults, remain ambiguous. To address these uncertainties, we conducted triaxial friction experiments using saw‐cut samples, with the upper half composed of Opalinus claystone (OPA) and the lower half of Berea sandstone (BER). The frictional strength of the non‐wetted OPA‐BER interface was estimated based on experiments at confining pressures of 4–25 MPa and constant axial loading rate (0.1 mm/min). Fluid injection friction experiments were performed using decane (non‐polar fluid) or deionized water (polar fluid) at 10 and 25 MPa confining pressures and constant piston displacement control. Macroscopic mechanical data were complemented by distributed strain sensing on the sample surface. Compared to decane, the frictional strength of the OPA‐BER interface tended to decrease when injecting water, which is attributed to phyllosilicate lubrication and the transition of the OPA from a solid rock to an incohesive mud near the saw‐cut surface. When injecting water, slip was initiated during initial hydration of the OPA‐BER interface, although the apparent stress state was below the yield stress. To explain this behavior, we propose that the swelling stress is a crucial factor that should be integrated into the effective stress model.


  • Open Access

    Diffusion Creep of Sodic Amphibole‐Bearing Blueschist Limited by Microboudinage

    by Leif Tokle, Lonnie J. Hufford, Whitney M. Behr, Luiz F. G. Morales, Claudio Madonna

    To investigate the mechanical and microstructural properties of mafic blueschists, we conducted deformation experiments on powdered natural blueschist aggregates using the general shear geometry in the Griggs apparatus. Experiments were performed at ∼1.0 GPa and temperatures ranging from 650 to 700°C. The blueschist starting material consists primarily of sodic amphibole and epidote, with minor amounts of quartz, titanite, albite, and white mica. Strain rate stepping experiments provided mechanical data with stress exponents ranging from 1.8 to 2.2. Microstructural analysis of the deformed samples show that the blueschist aggregates were deforming by microboudinage of the sodic amphibole, with a chemically new sodic‐calcic amphibole diffused into the boudin neck. Based on these results, we interpret the samples to have deformed by diffusion creep of the sodic‐calcic amphibole, which was rate‐limited by diffusion into the boudin neck. We developed a microboudinage diffusion creep flow law using a least square regression, with parameters of A = 2.43e11 MPa−n μm s−1, n = 2.0 ± 0.3, m = 1.0, and Q = 384 ± 15 kJ/mol. Extrapolation of the flow law to the blueschist stability field suggests viscosities that are higher than metasedimentary rocks (quartz dislocation creep flow law) and lower than eclogitic rocks (omphacite dislocation creep flow law) consistent with field observations. We also show that this type of deformation mechanism matches observations of natural rocks in paleosubduction zone environments, supporting the application of this flow law to estimate amphibole rheology in modern subduction zones.