SEStephen J. Elliott

Stephen J. Elliott

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Stephen J. Elliott has a total of 103 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A multi-factor knuckle and nail bed verification tool for forensic imagery analysis

    by Marco Santopietro, Richard Guest, Kathryn C. Seigfried-Spellar, Stephen J. Elliott


  • Roi: Return On Investment As A Factor In Designing Graduate Research Projects For Mutual Benefit

    by Michael Dyrenfurth, Kathryne Newton, Mark Schuver, Stephen Elliott

    Attachment A: Recommended Directed Project Outline Cover Page Methodology ≠ Introduction Abstract ≠ Research Design Table of Contents ≠ Research Design ≠ Population & Sample Purpose & Problem -Description of Population ≠ Introduction -Sampling method ≠ The Problem -Parameters -Sample ≠ The Purpose -Sampling ≠ Significance ≠ Variables ≠ Hypotheses -Independent or -Dependent ≠ Research Questions ≠ Treatment and/or ≠ Instrumentation ≠ Deliverables -Development ≠ Assumptions -Validation ≠ Delimitations -Utilization ≠ Limitations -Administration ≠ Definitions -Reliability ≠ Summary ≠ Data Collection -Respondents Review of Literature -Non-respondents ≠ Methodology of the Review -Follow-up procedures ≠ Findings pertaining to the ≠ Time Action Plan Problem ≠ Summary ≠ Findings pertaining to the Purpose Data Analysis ≠ Findings pertaining to the ≠ Data recording Methodology of Cited Studies & ≠ Data conditioning Proposed Methodology ≠ Analytical procedures ≠ Summary -Power -Effect size ≠ Findings ≠ Summary Conclusions, Discussions & Recommendations ≠ Introduction ≠ Conclusions ≠ Discussion ≠ Recommendations References Appendices

  • Open Access

    Extending the dynamic range of an energy harvester with a variable load resistance

    by Mehdi Hendijanizadeh, Stephen J Elliott, Maryam Ghandchi-Tehrani

    In some energy harvesters, the maximum throw of the seismic mass is limited due to the physical constraints of the device. The shunt load resistance of such a harvester is generally selected based on the allowable throw of the mass when the device is subjected to the maximum level of excitation. However, the energy harvester with this value of shunt resistance does not perform well at lower levels of excitation. In this article, a variable load resistance, scheduled on the excitation level, is introduced to extend the dynamic range of an energy harvester in applications where excitation level varies. This method is applied to the design of an energy harvester, which comprises a sprung mass coupled to an electric motor through a lead screw. The dynamic equation and parameters of the system are introduced and the device is experimentally characterized, by conducting random vibration tests. The harvested power and the relative displacement are then obtained for different sinusoidal base excitation amplitudes when the system is excited at a frequency close to its natural frequency. It is demonstrated that the use of a variable load resistance mechanism can significantly improve the dynamic range and output power of the energy harvester.


  • Expanding the human-biometric sensor interaction model to identity claim scenarios

    by Stephen J. Elliott, Kevin O'Connor, Eric Bartlow, Joshua J. Robertson, Richard M. Guest

    Biometric technologies represent a significant component of comprehensive digital identity solutions, and play an important role in crucial security tasks. These technologies support identification and authentication of individuals based on their physiological and behavioral characteristics. This has led many governmental agencies to choose biometrics as a supplement to existing identification schemes, most prominently ID cards and passports. Studies have shown that the success of biometric systems relies, in part, on how humans interact and accept such systems. In this paper, the authors build on previous work related to the Human-Biometric Sensor Interaction (HBSI) model and examine it with respect to the introduction of a token (e.g. an electronic passport or identity card) into the biometric system. The role of the imposter within an Identity Claim scenario has been integrated to expand the HBSI model into a full version, which is able to categorise potential False Claims and Attack Presentations.


  • Open Access

    Efficient energy transmission and amplification in the cochlea relies on frequency-dependent material properties of the tectorial membrane

    by Gareth P. Jones, Victoria A. Lukashkina, Ian J. Russell, Stephen J. Elliott, Andrei N. Lukashkin

    The remarkable sensitivity, frequency selectivity, and dynamic range of the mammalian cochlea relies on longitudinal transmission of minuscule amounts of energy as passive, pressure-driven, basilar membrane (BM) traveling waves which are actively amplified at frequency-specific locations. Transmission of passive waves through viscous tissue situated in a viscous media is not an easy task. Here we describe mechanical properties of the tectorial membrane (TM) which facilitate this transmission. From mechanical measurements of isolated segments of the TM, we discovered that the stiffness of the TM is reduced when it is mechanically stimulated at physiologically relevant magnitudes and at frequencies below their frequency place in the cochlea. The reduction in stiffness functionally uncouples the TM from the organ of Corti, thereby minimizing energy losses during passive traveling wave propagation. Stiffening and decreased viscosity of the TM at high stimulus frequencies can potentially facilitate active amplification, especially in the high-frequency, basal turn, where energy loss due to internal friction within the TM is less than in the apex. This prediction is confirmed by neural recordings from several frequency regions of the cochlea.

  • An investigation into biometric signature capture device performance and user acceptance

    by Michael Brockly, Stephen Elliott, Jarron Burdine, Michael Frost, Matthew Riedle, Richard Guest

    The human signature provides a natural and publically-accepted legally-admissible method for providing authentication to a process. Automatic biometric signature systems assess both the drawn image and the temporal aspects of signature construction, providing enhanced verification rates over and above conventional outcome assessment. To enable the capture of these constructional data requires the use of specialist `tablet' devices. In this paper we explore the enrolment performance using a range of common signature capture devices and investigate the reasons behind user preference. The results show that writing feedback and familiarity with conventional `paper and pen' donation configurations are the primary motivation for user preference. These results inform the choice of signature device from both technical performance and user acceptance viewpoints.


  • Assessing the level of difficulty of fingerprint datasets based on relative quality measures

    by Shengzhe Li, Hakil Kim, Changlong Jin, Stephen Elliott, Mingjie Ma


  • Interoperable biometric API for mobile devices

    by Raul Sanchez-Reillo, Ruben Romero-Garcia, Daniel Herrero-Berengue, Stephen Elliott

    The development of biometric applications in mobile devices will require the use of a standard API in order to reach a high level of interoperability. For those mobile devices where their applications are developed in Java (e.g. Android based systems), the use of BioAPI Java is a solution. This paper shows how BioAPI Java can be applied to mobile devices, as well as the needs for further improvement to provide a larger adoption of this future standard.


  • Assessing the Difficulty Level of Fingerprint Datasets Based on Relative Quality Measures

    by Shengzhe Li, Changlong Jin, Hakil Kim, Stephen Elliott

    Understanding the difficulty of a dataset is of primary importance when it comes to testing and evaluating fingerprint recognition systems or algorithms because the evaluation result is dependent on the dataset. Proposed in this paper is a general framework of assessing the level of difficulty of fingerprint datasets based on quantitative measurements of not only the sample quality of individual fingerprints but also relative differences between genuine pairs, such as common area and deformation. The experimental results over multi-year FVC datasets demonstrate that the proposed method can predict the relative difficulty levels of the fingerprint datasets which coincide with the equal error rates produced by two matching algorithms. The proposed framework is independent of matching algorithms and can be performed automatically.


  • The Impact of Force on Fingerprint Image Quality, Minutiae Count and Performance

    by Michael Petrelli, Stephen Elliott, Carl Dunkelberger

    The impact of force on acquiring a high quality fingerprint image has been systematically studied by researchers using single print optical scanners. A previous study examined force levels that ranged from 3N to 21N using a single print optical sensor. A second experiment used force levels ranging from 3N to 11N using a capacitive and optical single print sensor. Additional work has been conducted that looked at smaller increments of force also using an optical sensor. This paper contributes to the body of knowledge by using an alternative fingerprint sensor, an alternative force level and compares it to the auto-capture method.