Cuncun Zuo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Cuncun Zuo has a total of 61 co-authors. Here are the top co-authors by number of shared publications:
Haofei Huang
24 shared publicationsTingting Ge
22 shared publicationsMing Wang
18 shared publicationsYanxia Zheng
Institute of Clean Chemical Technology, School of Chemistry and Chemical Engineering, Shandong University of Technology Zibo People's Republic of China
17 shared publications- Yuchao Li
Research Institute of Clean Chemical Technology, School of Chemistry and Chemical Engineering, Shandong University of Technology, Zibo 255049, P. R. China
12 shared publications Yuchao Li
10 shared publications
Latest Publications
- 8 April 2026
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 104 (9) , 4989-5000
Design and screening of bimetallic Ni‐based ZSM ‐5 catalysts for enhanced ethylene oligomerization
Nickel‐based heterogeneous catalysts (Ni‐ZSM‐5 and bimetallic Ni‐M‐ZSM‐5, M = Cr, Co, Fe) were prepared by ultrasonic‐assisted impregnation, and their catalytic performance and product regulation mechanism in ethylene oligomerization reaction were systematically investigated. The characterization analysis showed that the metal loading did not destroy the structure of ZSM‐5 zeolite skeleton, but significantly affected the carbon deposition behaviour: Ni‐ZSM‐5 mainly generated carbon nanotube structure carbon deposits, while bimetallic catalysts (such as Ni‐Cr‐ZSM‐5) mainly used ordinary carbon accumulation. In the fixed‐bed reactor (ethylene pressure 1 MPa, temperature 300°C, flow rate 10 mL/min(GHSV(120 mL/(mL·h)), reaction 48 h), Ni‐Fe‐ZSM‐5 showed the best ethylene conversion rate and the highest selectivity for C4 olefins, and its conversion rate to ethylene could still be maintained at about 96.3% after 48 h of reaction, while the selectivity for C4 could also reach 65.2%. Among the liquid phase products generated, Ni‐Cr‐ZSM‐5 had the highest selectivity for olefins (46.8%), Ni‐ZSM‐5 had the highest selectivity for aliphatic hydrocarbons (69.24%), while pure ZSM‐5 had a selectivity of 63.49% for aromatics due to the strong acidic site as the dominant reaction path, and the amount of liquid phase products generated when using pure ZSM‐5 was much higher than that of other metal‐loaded ZSM‐5 zeolites.
- 8 April 2026
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 104 (9) , 4989-5000
Design and screening of bimetallic Ni‐based ZSM ‐5 catalysts for enhanced ethylene oligomerization
Nickel‐based heterogeneous catalysts (Ni‐ZSM‐5 and bimetallic Ni‐M‐ZSM‐5, M = Cr, Co, Fe) were prepared by ultrasonic‐assisted impregnation, and their catalytic performance and product regulation mechanism in ethylene oligomerization reaction were systematically investigated. The characterization analysis showed that the metal loading did not destroy the structure of ZSM‐5 zeolite skeleton, but significantly affected the carbon deposition behaviour: Ni‐ZSM‐5 mainly generated carbon nanotube structure carbon deposits, while bimetallic catalysts (such as Ni‐Cr‐ZSM‐5) mainly used ordinary carbon accumulation. In the fixed‐bed reactor (ethylene pressure 1 MPa, temperature 300°C, flow rate 10 mL/min(GHSV(120 mL/(mL·h)), reaction 48 h), Ni‐Fe‐ZSM‐5 showed the best ethylene conversion rate and the highest selectivity for C4 olefins, and its conversion rate to ethylene could still be maintained at about 96.3% after 48 h of reaction, while the selectivity for C4 could also reach 65.2%. Among the liquid phase products generated, Ni‐Cr‐ZSM‐5 had the highest selectivity for olefins (46.8%), Ni‐ZSM‐5 had the highest selectivity for aliphatic hydrocarbons (69.24%), while pure ZSM‐5 had a selectivity of 63.49% for aromatics due to the strong acidic site as the dominant reaction path, and the amount of liquid phase products generated when using pure ZSM‐5 was much higher than that of other metal‐loaded ZSM‐5 zeolites.
- Open Access
- 2 February 2026
- Published by Elsevier in SSRN Electronic Journal
Zn-Promoted FeSx/γ-Al2O3 Catalyst for Stable Selective Reduction of High-concentration SO2 with Methane: Synergistic Mitigation of Carbon and Sulfur deposition
Selective reduction of high-concentration SO2 (57%) to elemental sulfur using methane (CH4) offers a flexible strategy for industrial sulfur recovery, yet catalyst deactivation due to carbon and sulfur deposition remains a major obstacle. A series of Fe-based catalysts supported on γ-Al2O3 were systematically designed, and various metal promoters were screened to enhance catalytic performance. Among them, Zn was identified as the optimal promoter, achieving a sulfur yield of 91.05% compared to 81.04% for the unpromoted catalyst. Response surface methodology (RSM) was employed to optimize key reaction parameters, including the CH4: SO2 molar ratio, temperature, and gas hourly space velocity (GHSV). Comprehensive characterizations, including XRD, XPS, and Raman, confirmed that Zn modification promotes the dispersion of Fe species and the formation of mixed-valence Fe7S8 active phases. The reaction mechanism involves the activation of SO2 on FeSx sites through electron transfer, while CH4 dissociates on Fe0 sites to form H radicals and reactive carbon species. XPS and H2-TPR results indicated that Zn donates electron density to FeSx ensembles and accelerates lattice-oxygen mobility, which facilitates surface carbon gasification. Furthermore, CO2-TPD data revealed that Zn disrupts strong basic sites responsible for SO₂ dissociative adsorption, thereby synergistically mitigating both carbon and sulfur accumulation. Under optimized conditions (CH4:SO2 = 1.96, 725 °C, and GHSV = 778 h⁻¹), the Zn-FeSx/γ-Al2O3 catalyst demonstrated exceptional stability during a 720-hour continuous operation test. This work provides a robust catalytic strategy for the industrial abatement of high-concentration SO2 from metallurgical flue gas and efficient recovery of elemental sulfur.
- 2 February 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessZn-Promoted FeSx/γ-Al2O3 Catalyst for Stable Selective Reduction of High-concentration SO2 with Methane: Synergistic Mitigation of Carbon and Sulfur deposition
Selective reduction of high-concentration SO2 (57%) to elemental sulfur using methane (CH4) offers a flexible strategy for industrial sulfur recovery, yet catalyst deactivation due to carbon and sulfur deposition remains a major obstacle. A series of Fe-based catalysts supported on γ-Al2O3 were systematically designed, and various metal promoters were screened to enhance catalytic performance. Among them, Zn was identified as the optimal promoter, achieving a sulfur yield of 91.05% compared to 81.04% for the unpromoted catalyst. Response surface methodology (RSM) was employed to optimize key reaction parameters, including the CH4: SO2 molar ratio, temperature, and gas hourly space velocity (GHSV). Comprehensive characterizations, including XRD, XPS, and Raman, confirmed that Zn modification promotes the dispersion of Fe species and the formation of mixed-valence Fe7S8 active phases. The reaction mechanism involves the activation of SO2 on FeSx sites through electron transfer, while CH4 dissociates on Fe0 sites to form H radicals and reactive carbon species. XPS and H2-TPR results indicated that Zn donates electron density to FeSx ensembles and accelerates lattice-oxygen mobility, which facilitates surface carbon gasification. Furthermore, CO2-TPD data revealed that Zn disrupts strong basic sites responsible for SO₂ dissociative adsorption, thereby synergistically mitigating both carbon and sulfur accumulation. Under optimized conditions (CH4:SO2 = 1.96, 725 °C, and GHSV = 778 h⁻¹), the Zn-FeSx/γ-Al2O3 catalyst demonstrated exceptional stability during a 720-hour continuous operation test. This work provides a robust catalytic strategy for the industrial abatement of high-concentration SO2 from metallurgical flue gas and efficient recovery of elemental sulfur.
- 1 January 2026
- Published by Royal Society of Chemistry (RSC) in Reaction Chemistry & Engineering
Synergistic H 2 activation and structural stabilization by Ag doping in CoO catalysts for enhanced dicyclopentadiene hydroformylation
The Ag/CoO catalyst promotes H 2 activation and increases active sites, enabling efficient and stable hydroformylation reactions.
- 1 January 2026
- Published by Royal Society of Chemistry (RSC) in Reaction Chemistry & Engineering
Synergistic H 2 activation and structural stabilization by Ag doping in CoO catalysts for enhanced dicyclopentadiene hydroformylation
The Ag/CoO catalyst promotes H 2 activation and increases active sites, enabling efficient and stable hydroformylation reactions.
- 23 December 2025
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 65 (1) , 165-174
Synergistic Effect of Gold and Hydrophobic Reagents Enhances Ester Formation from Aldehydes via One-Step Oxidative Esterification
- 23 December 2025
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 65 (1) , 165-174
Synergistic Effect of Gold and Hydrophobic Reagents Enhances Ester Formation from Aldehydes via One-Step Oxidative Esterification
- 20 November 2025
- Published by Elsevier in Applied Catalysis A: General
- Vol. 710
Controllable synthesis of SiO₂-supported cobalt nanocatalysts for selective hydrogenation of dinitriles to primary diamines
- 20 November 2025
- Published by Elsevier in Applied Catalysis A: General
- Vol. 710
Controllable synthesis of SiO₂-supported cobalt nanocatalysts for selective hydrogenation of dinitriles to primary diamines
- 17 November 2025
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 49 (45) , 19555-19569
Bimetallic Cr–Ni–PNP catalysts for enhanced high-selectivity ethylene oligomerization: design, optimization, and DFT insights
A series of metal-coordinated chromium–bis(diphenylphosphino)amine (Cr–PNP) catalysts were synthesized for highly selective ethylene oligomerization.
- 17 November 2025
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 49 (45) , 19555-19569
Bimetallic Cr–Ni–PNP catalysts for enhanced high-selectivity ethylene oligomerization: design, optimization, and DFT insights
A series of metal-coordinated chromium–bis(diphenylphosphino)amine (Cr–PNP) catalysts were synthesized for highly selective ethylene oligomerization.