Muhammad Ashraf Sabri
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Muhammad Ashraf Sabri has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
- Mustafa Khamis
College of Arts and Sciences, American University of Sharjah, University City, Sharjah 26666, United Arab Emirates
9 shared publications - Taleb Hassan Ibrahim
Department of Chemical Engineering, American University of Sharjah, Sharjah P.O. Box 26666, United Arab Emirates
8 shared publications - Muhammad Faheem Hassan
Chemical and Biological Engineering Department, College of Engineering, American University of Sharjah, Sharjah, UAE
3 shared publications - Paul Nancarrow
Department of Chemical & Biological Engineering, American University of Sharjah, Sharjah P.O. Box 26666, United Arab Emirates
2 shared publications Sameer Al-Asheh
American University of Sharjah
2 shared publicationsAinee Hafeez
1 shared publication
Latest Publications
- Open Access
- 18 January 2021
- Published by MDPI AG in Sustainability
- Vol. 13 (2) , 923
Simultaneous Adsorption and Reduction of Cr(VI) to Cr(III) in Aqueous Solution Using Nitrogen-Rich Aminal Linked Porous Organic Polymers
Two novel nitrogen-rich aminal linked porous organic polymers, NRAPOP-O and NRAPOP-S, have been prepared using a single step-one pot Schiff-base condensation reaction of 9,10-bis-(4,6-diamino-S-triazin-2-yl)benzene and 2-furaldehyde or 2-thiophenecarboxaldehyde, respectively. The two polymers show excellent thermal and physiochemical stabilities and possess high porosity with Brunauer–Emmett–Teller (BET) surface areas of 692 and 803 m2 g−1 for NRAPOP-O and NRAPOP-S, respectively. Because of such porosity, attractive chemical and physical properties, and the availability of redox-active sites and physical environment, the NRAPOPs were able to effectively remove Cr(VI) from solution, reduce it to Cr(III), and simultaneously release it into the solution. The efficiency of the adsorption process was assessed under various influencing factors such as pH, contact time, polymer dosage, and initial concentration of Cr(VI). At the optimum conditions, 100% removal of Cr(VI) was achieved, with simultaneous reduction and release of Cr(III) by NRAPOP-O with 80% efficiency. Moreover, the polymers can be easily regenerated by the addition of reducing agents such as hydrazine without significant loss in the detoxication of Cr(VI).
- 18 January 2021
- Published by MDPI AG in Sustainability
- Vol. 13 (2) , 923
Open AccessSimultaneous Adsorption and Reduction of Cr(VI) to Cr(III) in Aqueous Solution Using Nitrogen-Rich Aminal Linked Porous Organic Polymers
Two novel nitrogen-rich aminal linked porous organic polymers, NRAPOP-O and NRAPOP-S, have been prepared using a single step-one pot Schiff-base condensation reaction of 9,10-bis-(4,6-diamino-S-triazin-2-yl)benzene and 2-furaldehyde or 2-thiophenecarboxaldehyde, respectively. The two polymers show excellent thermal and physiochemical stabilities and possess high porosity with Brunauer–Emmett–Teller (BET) surface areas of 692 and 803 m2 g−1 for NRAPOP-O and NRAPOP-S, respectively. Because of such porosity, attractive chemical and physical properties, and the availability of redox-active sites and physical environment, the NRAPOPs were able to effectively remove Cr(VI) from solution, reduce it to Cr(III), and simultaneously release it into the solution. The efficiency of the adsorption process was assessed under various influencing factors such as pH, contact time, polymer dosage, and initial concentration of Cr(VI). At the optimum conditions, 100% removal of Cr(VI) was achieved, with simultaneous reduction and release of Cr(III) by NRAPOP-O with 80% efficiency. Moreover, the polymers can be easily regenerated by the addition of reducing agents such as hydrazine without significant loss in the detoxication of Cr(VI).
- Open Access
Thermal Conductivities of Choline Chloride-Based Deep Eutectic Solvents and Their Mixtures with Water: Measurement and Estimation
The thermal conductivities of selected deep eutectic solvents (DESs) were determined using the modified transient plane source (MTPS) method over the temperature range from 295 K to 363 K at atmospheric pressure. The results were found to range from 0.198 W·m−1·K−1 to 0.250 W·m−1·K−1. Various empirical and thermodynamic correlations present in literature, including the group contribution method and mixing correlations, were used to model the thermal conductivities of these DES at different temperatures. The predictions of these correlations were compared and consolidated with the reported experimental values. In addition, the thermal conductivities of DES mixtures with water over a wide range of compositions at 298 K and atmospheric pressure were measured. The standard uncertainty in thermal conductivity was estimated to be less than ± 0.001 W·m−1·K−1 and ± 0.05 K in temperature. The results indicated that DES have significant potential for use as heat transfer fluids.
Open AccessThermal Conductivities of Choline Chloride-Based Deep Eutectic Solvents and Their Mixtures with Water: Measurement and Estimation
The thermal conductivities of selected deep eutectic solvents (DESs) were determined using the modified transient plane source (MTPS) method over the temperature range from 295 K to 363 K at atmospheric pressure. The results were found to range from 0.198 W·m−1·K−1 to 0.250 W·m−1·K−1. Various empirical and thermodynamic correlations present in literature, including the group contribution method and mixing correlations, were used to model the thermal conductivities of these DES at different temperatures. The predictions of these correlations were compared and consolidated with the reported experimental values. In addition, the thermal conductivities of DES mixtures with water over a wide range of compositions at 298 K and atmospheric pressure were measured. The standard uncertainty in thermal conductivity was estimated to be less than ± 0.001 W·m−1·K−1 and ± 0.05 K in temperature. The results indicated that DES have significant potential for use as heat transfer fluids.
- Top Cited Papers
- 1 January 2020
- Published by Elsevier in Journal of Analytical and Applied Pyrolysis
- Vol. 145
Recent trends in activated carbon fibers production from various precursors and applications—A comparative review
- 1 January 2020
- Published by Elsevier in Journal of Analytical and Applied Pyrolysis
- Vol. 145
Top Cited PapersRecent trends in activated carbon fibers production from various precursors and applications—A comparative review
- 1 September 2018
- Published by Elsevier in Journal of Industrial and Engineering Chemistry
- Vol. 65, 325-333
Spent caustic treatment using hydrophobic room temperatures ionic liquids
- 1 September 2018
- Published by Elsevier in Journal of Industrial and Engineering Chemistry
- Vol. 65, 325-333
Spent caustic treatment using hydrophobic room temperatures ionic liquids
- 16 June 2018
- Published by Springer Nature in International Journal of Environmental Research
- Vol. 12 (4) , 513-529
Use of Eucalyptus camaldulensis as Biosorbent for Lead Removal from Aqueous Solution
- 16 June 2018
- Published by Springer Nature in International Journal of Environmental Research
- Vol. 12 (4) , 513-529
Use of Eucalyptus camaldulensis as Biosorbent for Lead Removal from Aqueous Solution
- 10 May 2018
- Published by Taylor & Francis in Environmental Technology
- Vol. 40 (25) , 3337-3350
Application of multiwalled carbon nanotubes and its magnetite derivative for emulsified oil removal from produced water
Multiwalled carbon nanotubes and their magnetite derivatives were employed as adsorbents for emulsified oil removal from produced water. The experimental parameters for maximum emulsified oil removal efficiency and effective regeneration of these adsorbents were determined. The optimum parameters in terms of adsorbent dosage, contact time, salinity, pH and temperature were 3.0 g/L, 20.0 min, 0 ppm, 7.0 and 25°C for both adsorbents. Due to their low density, multiwalledcarbon nanotubes could not be successfully employed in packed bed columns. The magnetite derivative has a larger density and hence, for the removal of emulsified oil from produced water packed bed column studies were performed utilizing multiwalled carbon magnetite nanotubes. The packed bed column efficiency and behaviour were evaluated using Thomas, Clark, Yan et al. and Bohart and Adams models. The Yan model was found to best describe the column experimental data. The adsorbents were regenerated using n-hexane and reused several times for oil removal from produced water without any significant decrease in their initial adsorption capacities. GRAPHICAL ABSTRACT
- 10 May 2018
- Published by Taylor & Francis in Environmental Technology
- Vol. 40 (25) , 3337-3350
Application of multiwalled carbon nanotubes and its magnetite derivative for emulsified oil removal from produced water
Multiwalled carbon nanotubes and their magnetite derivatives were employed as adsorbents for emulsified oil removal from produced water. The experimental parameters for maximum emulsified oil removal efficiency and effective regeneration of these adsorbents were determined. The optimum parameters in terms of adsorbent dosage, contact time, salinity, pH and temperature were 3.0 g/L, 20.0 min, 0 ppm, 7.0 and 25°C for both adsorbents. Due to their low density, multiwalledcarbon nanotubes could not be successfully employed in packed bed columns. The magnetite derivative has a larger density and hence, for the removal of emulsified oil from produced water packed bed column studies were performed utilizing multiwalled carbon magnetite nanotubes. The packed bed column efficiency and behaviour were evaluated using Thomas, Clark, Yan et al. and Bohart and Adams models. The Yan model was found to best describe the column experimental data. The adsorbents were regenerated using n-hexane and reused several times for oil removal from produced water without any significant decrease in their initial adsorption capacities. GRAPHICAL ABSTRACT
- Open Access
- 1 April 2018
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 6 (2) , 3018-3033
Application of graphene nanoplatelets and graphene magnetite for the removal of emulsified oil from produced water
- 1 April 2018
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 6 (2) , 3018-3033
Open AccessApplication of graphene nanoplatelets and graphene magnetite for the removal of emulsified oil from produced water
- 24 April 2017
- Published by Taylor & Francis in Journal of Adhesion Science and Technology
- Vol. 31 (24) , 2697-2718
Mild steel green inhibition byFicus caricaleaves extract under practical field conditions
Various electrochemical techniques were employed to study the effectiveness of aqueous Ficus carica (Fig. tree) leaves extract as green corrosion inhibitor for mild steel under field conditions containing 3.5% sodium chloride solution saturated with carbon dioxide. Optimum inhibition efficiency of 90% was obtained using 50 mg/L of inhibitor in the temperature range of 25–40 °C. The mode of action of Ficus carica leave extract as revealed by Polarization studies was shown to act as a mixed inhibitor. The adsorption isotherm of the adsorption of Ficus carica leaves extract on the steel surface was found to follow Langmuir adsorption isotherm. In order to assess the individual contribution of the different constituents of the extract theoretically, the adsorption of the four major organic constituents of Ficus carica leave extract on mild steel were modelled using density functional theory and quench molecular dynamic simulations. Among the four major Ficus carica leaves extract constituent investigated, Caffeoylmalic acid was found to make the most contribution to the overall inhibition action of Ficus carica leaves extract.
- 24 April 2017
- Published by Taylor & Francis in Journal of Adhesion Science and Technology
- Vol. 31 (24) , 2697-2718
Mild steel green inhibition byFicus caricaleaves extract under practical field conditions
Various electrochemical techniques were employed to study the effectiveness of aqueous Ficus carica (Fig. tree) leaves extract as green corrosion inhibitor for mild steel under field conditions containing 3.5% sodium chloride solution saturated with carbon dioxide. Optimum inhibition efficiency of 90% was obtained using 50 mg/L of inhibitor in the temperature range of 25–40 °C. The mode of action of Ficus carica leave extract as revealed by Polarization studies was shown to act as a mixed inhibitor. The adsorption isotherm of the adsorption of Ficus carica leaves extract on the steel surface was found to follow Langmuir adsorption isotherm. In order to assess the individual contribution of the different constituents of the extract theoretically, the adsorption of the four major organic constituents of Ficus carica leave extract on mild steel were modelled using density functional theory and quench molecular dynamic simulations. Among the four major Ficus carica leaves extract constituent investigated, Caffeoylmalic acid was found to make the most contribution to the overall inhibition action of Ficus carica leaves extract.
- Open Access
- 1 January 2017
- Published by Elsevier in Desalination and Water Treatment
- Vol. 60, 129-136
Produced water treatment using olive leaves
- 1 January 2017
- Published by Elsevier in Desalination and Water Treatment
- Vol. 60, 129-136
Open AccessProduced water treatment using olive leaves