Dazheng Jing
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Dazheng Jing has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Anders Lyngfelt
Chalmers University of Technology, 412 96 Göteborg, Sweden
3 shared publications Peter Hallberg
Department of Energy and Environment, Division of Energy Technology, Chalmers University of Technology, SE-41296 Gothenburg, Sweden
2 shared publicationsTobias Mattisson
Department of Energy and Environment, Division of Energy Technology, Chalmers University of Technology, SE-41296 Gothenburg, Sweden
2 shared publicationsFrans Snijkers
VITO-Flemish Institute for Technological Research, B-2400 Mol, Belgium
1 shared publicationHenrik Leion
Department of Chemistry and Chemical Engineering, Division of Energy and Materials, Chalmers University of Technology, SE-41296 Gothenburg, Sweden
1 shared publication- Henrik Leion
Chemistry and Chemical Engineering, Chalmers University of Technology, 412 93 Göteborg, Sweden
1 shared publication
Latest Publications
- 23 March 2016
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 30 (4) , 3257-3268
Effect of Production Parameters on the Spray-Dried Calcium Manganite Oxygen Carriers for Chemical-Looping Combustion
- 23 March 2016
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 30 (4) , 3257-3268
Effect of Production Parameters on the Spray-Dried Calcium Manganite Oxygen Carriers for Chemical-Looping Combustion
- 1 January 2016
- Published by Elsevier in Materials & Design
- Vol. 89, 527-542
Development of CaMn0.775Mg0.1Ti0.125O3-δ oxygen carriers produced from different Mn and Ti sources
- 1 January 2016
- Published by Elsevier in Materials & Design
- Vol. 89, 527-542
Development of CaMn0.775Mg0.1Ti0.125O3-δ oxygen carriers produced from different Mn and Ti sources
- Open Access
- 30 September 2013
- Published by Wiley in International Journal of Chemical Engineering
- Vol. 2013, 1-16
Examination of Perovskite Structure CaMnO3-δwith MgO Addition as Oxygen Carrier for Chemical Looping with Oxygen Uncoupling Using Methane and Syngas
Perovskite structure oxygen carriers with the general formula CaMnxMg1-xO3-δwere spray-dried and examined in a batch fluidized bed reactor. The CLOU behavior, reactivity towards methane, and syngas were investigated at temperature 900°C to 1050°C. All particles showed CLOU behavior at these temperatures. For experiments with methane, a bed mass corresponding to 57 kg/MW was used in the reactor, and the average CH4to CO2conversion was above 97% for most materials. Full syngas conversion was achieved for all materials utilizing a bed mass corresponding to 178 kg/MW. SEM/EDX and XRD confirmed the presence of MgO in the fresh and used samples, indicating that the Mg cation is not incorporated into the perovskite structure and the active compound is likely pure CaMnO3-δ. The very high reactivity with fuel gases, comparable to that of baseline oxygen carriers of NiO, makes these perovskite particles highly interesting for commercial CLC application. Contrary to NiO, oxygen carriers based on CaMnO3-δhave no thermodynamic limitations for methane oxidation to CO2and H2O, not to mention that the materials are environmentally friendly and can utilize much cheaper raw materials for production. The physical properties, crystalline phases, and morphology information were also determined in this work.
- 30 September 2013
- Published by Wiley in International Journal of Chemical Engineering
- Vol. 2013, 1-16
Open AccessExamination of Perovskite Structure CaMnO3-δwith MgO Addition as Oxygen Carrier for Chemical Looping with Oxygen Uncoupling Using Methane and Syngas
Perovskite structure oxygen carriers with the general formula CaMnxMg1-xO3-δwere spray-dried and examined in a batch fluidized bed reactor. The CLOU behavior, reactivity towards methane, and syngas were investigated at temperature 900°C to 1050°C. All particles showed CLOU behavior at these temperatures. For experiments with methane, a bed mass corresponding to 57 kg/MW was used in the reactor, and the average CH4to CO2conversion was above 97% for most materials. Full syngas conversion was achieved for all materials utilizing a bed mass corresponding to 178 kg/MW. SEM/EDX and XRD confirmed the presence of MgO in the fresh and used samples, indicating that the Mg cation is not incorporated into the perovskite structure and the active compound is likely pure CaMnO3-δ. The very high reactivity with fuel gases, comparable to that of baseline oxygen carriers of NiO, makes these perovskite particles highly interesting for commercial CLC application. Contrary to NiO, oxygen carriers based on CaMnO3-δhave no thermodynamic limitations for methane oxidation to CO2and H2O, not to mention that the materials are environmentally friendly and can utilize much cheaper raw materials for production. The physical properties, crystalline phases, and morphology information were also determined in this work.