RJRichard G. Jarrett

Richard G. Jarrett

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Richard G. Jarrett has a total of 59 co-authors. Here are the top co-authors by number of shared publications:

  • N. Anderson

    CSIRO, Division of Animal Health, Animal Health Research Laboratory, Private Bag No. 1, P.O., Parkville, Victoria 3052, Australia

    4 shared publications
  • Andreas Kiermeier

    Statistical Process Improvement Consulting and Training PTY Ltd., Gumeracha, SA 5233, Australia

    3 shared publications
  • Arūnas P. Verbyla

    School of Agriculture, Food and Wine The University of Adelaide Waite Campus, PMB 1 Glen Osmond South Australia 5064 Australia

    2 shared publications
  • B. J. T. Morgan

    Institute of Mathematics, University of Kent , Canterbury, Kent, CT2 7NF, England

    2 shared publications
  • B. L. Clark

    CSIRO Division of Animal Health, Animal Health Research Laboratory, Private Bag 1, Parkville, Victoria 3052

    2 shared publications
  • D. J. Stewart

    CSIRO Division of Animal Health, Animal Health Research Laboratory, Private Bag 1, Parkville, Victoria 3052

    2 shared publications

Latest Publications

  • Open Access

    Order Restricted Randomized Block Designs

    by Omer Ozturk, Richard Jarrett, Olena Kravchuk

    Field experiments are run under two competing objectives, high precision and minimal cost. The precision can be increased either by using sound experimentation techniques that account for the sources of variation with reasonable statistical models or by increasing the sample size. Large sample sizes usually increase the cost of the experiment and may not be feasible. This paper uses order restricted randomized designs (ORRD) to increase the precision while keeping the sample size and cost of the experiment minimal. The ORRD described here starts with a randomized block design but adds a second layer of blocking by ranking plots within each block. This creates a two-way lay-out, blocks and ranking groups, and uses a restricted randomization to improve the precision of estimation of the treatment parameters. Ranking groups create a correlation structure for within-block units. The restricted randomization uses this correlation structure to reduce the error variance of the experiment. The paper computes the expected mean square for each source of variation in the ORRD design under a suitable linear model. It also provides approximate F-tests for treatment and ranking group effects. The efficiency of the ORRD is investigated through empirical power studies. Finally, an example based on a uniformity field trial illustrates the use of the method in a split-plot experiment. Supplementary material to this paper is provided online.


  • Open Access

    Models for cluster randomized designs using ranked set sampling

    by Omer Ozturk, Olena Kravchuk, Richard Jarrett

    Cluster randomized designs (CRD) provide a rigorous development for randomization principles for studies where treatments are allocated to cluster units rather than the individual subjects within clusters. It is known that CRDs are less efficient than completely randomized designs since the randomization of treatment allocation is applied to the cluster units. To mitigate this problem, we embed a ranked set sampling design from survey sampling studies into CRD for the selection of both cluster and subsampling units. We show that ranking groups in ranked set sampling act like a covariate, reduce the expected mean squared cluster error, and increase the precision of the sampling design. We provide an optimality result to determine the sample sizes at cluster and sub‐sample level. We apply the proposed sampling design to a dental study on human tooth size, and to a longitudinal study from an education intervention program.


  • Estimating a Single Shelf‐Life for Multiple Batches

    by Andreas Kiermeier, Arūnas P. Verbyla, Richard G. Jarrett


  • Design and Analysis of Two‐Phase Experiments for Gene Expression Microarrays—Part I

    by Richard G. Jarrett, Katya Ruggiero

    SummaryGene expression microarray experiments are intrinsically two‐phase experiments. Messenger RNA (mRNA), required for the microarray experiment, must first be derived from plants or animals that are exposed to a set of treatments in a previous experiment (Phase 1). The mRNA is then used in the subsequent laboratory‐based microarray experiment (Phase 2) from which gene expression is measured and ultimately analyzed. We show that obtaining a valid test for the effects of treatments on gene expression depends on the design of both the Phase 1 and Phase 2 experiments. Examples show that the multiple dye‐swap design at Phase 2 is more robust than the alternating loop design in the absence of prior knowledge of the relative size of variation in the Phase 1 and Phase 2 experiments.


  • A-Optimal Block Designs with Additional Singly Replicated Treatments

    by Agnes M. Herzberg, Richard G. Jarrett

    Block designs to which have been added a number of singly-replicated treatments, known as secondary treatments, are particularly useful for experiments where only small amounts of material are available for some treatments, for example new plant varieties. The designs are of particular use in the microarray situation. Such designs are known as ‘augmented designs’. This paper obtains the properties of these designs and shows that, with an equal number of secondary treatments in each block, the A-optimal design is obtained by using the A-optimal design for the original block design. It develops formulae for the variance of treatment comparisons, for both the primary and the secondary treatments. A number of examples are used to illustrate the results.


  • A new approach to estimating shelf‐life

    by Andreas Kiermeier, Richard G. Jarrett, Arūnas P. Verbyla

    The current approach to the estimation of shelf‐life and the determination of the label shelf‐life as detailed in the International Conference on Harmonisation guidelines to industry is presented. The shortcomings of the status quo are explained and a possible solution is offered, which gives rise to a new definition of shelf‐life. Several methods for calculating a label shelf‐life are presented and investigated using a simulation study. Recommendations to adopt the new definition and to increase sample sizes are made. Copyright © 2004 John Wiley & Sons, Ltd.


  • Asset planning for water reticulation systems - the PARMS model

    by S. Burn, S. Tucker, M. Rahilly, P. Davis, R. Jarrett, M. Po

    Traditionally water reticulation systems have been operated so that pipeline repair/renewal occurs on a reactive basis, based upon the number of failures, the consequence of failure and the cost. Planning for future replacements and the costs associated with these has been based upon a best guess of pipe lifetimes, which have generally been very conservative, when compared to the actual pipe life obtained. Factors such as the required level of customer service, trade-offs between repair and renewal, or operating practices such as pressure reduction or shut-off block reduction have not been widely considered, except when they are required under the water authorities operating licence. To allow long-term strategies to be implemented for the repair/renewal of water pipelines, a Pipeline Asset and Risk Management System (PARMS) is being developed. This planning model has been designed to allow a range of “what if” scenarios to be analysed to determine their effects on water authorities’ long-term costs. This model is based upon whole of life costing and includes data on externality and customer impact costs. It analyses the failures of individual pipe assets, rather than the traditional practice of predicting failure of pipe cohorts, currently used by many authorities. This paper discusses the application of the PARMS planning model to allow selection of pipeline repair/renewal, and briefly analyses the influences that a range of customer service or operating decisions can have on a water authority’s capital and operational expenditure.


  • Occupational Stress in University Staff

    by Anthony H. Winefield, Richard Jarrett

    A survey was conducted of all staff members of an established Australian metropolitan university. The overall response rate for noncasual staff was 72% (77% for general staff and 65% for academic...