AKAchim von Keudell

Achim von Keudell

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Achim von Keudell has a total of 290 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Dynamics of iron oxide particle injection in a microwave plasma torch

    by J Thiel, L Kulik, M Böke, A von Keudell

    The hydrogen-based reduction of iron oxides in atmospheric plasmas is a promising approach to replace conventional methods that produce greenhouse gases. The in-flight reduction of hematite powder ( Fe 2 O 3 ) in an argon-hydrogen microwave plasma torch (MPT) confined in a quartz tube is studied. The MPT system utilizes an integrated particle feeder and provides extended optical access to the microwave resonator and plasma effluent. The particle trajectories in the MPT can be controlled by adjusting the gas-flow scenario, balancing an axial versus a swirl flow, which is used to shield the quartz tube from the hot central plasma, reaching more than 4200 K. Two CMOS (Complementary Metal-Oxide-Semiconductor) cameras were employed to track particle motion in three dimensions or to measure particle surface temperatures through two-color pyrometry. This is complemented by a fluid simulation in Ansys Fluent to model particle trajectories, gas velocities, temperature profiles of the plasma effluent, and heat transfer to particles. Space-resolved measurements of particle dynamics across various gas-flow scenarios revealed a strong dependence on the ratio between axial particle injection velocities and the swirl flow. Particles with higher axial injection velocities reached higher temperatures and velocities, experienced shorter cooling times, making them observable at greater distances from the resonator. In scenarios with increased swirl gas flow, the particles exhibited predominantly swirled trajectories. This resulted in lower axial velocities, with motion primarily within the outer perimeter of the confining quartz tube. X-ray diffraction measurements of the collected plasma-treated particles showed a more efficient reduction for particles from swirl trajectories compared to axial trajectories: on axial trajectories, the acquired particle surface temperatures are very high, reaching over 2500 K, leading also to evaporation rather than to reduction only; on swirl trajectories, the acquired temperatures of the particles stay moderate and their residence time is longer, which leads to a more optimal reduction.


  • CORRIGENDUM: Nanosecond and microsecond-pulsed plasma-in-liquid treated copper oxide surfaces (2025 J. Phys. D: Appl. Phys. 58 305201)

    by P Pottkämper, N Unteregge, S Weller, A von Keudell

    CORRIGENDUM: Nanosecond and microsecond-pulsed plasma-in-liquid treated copper oxide surfaces (2025 J. Phys. D: Appl. Phys. 58 305201), Pottkämper, P, Unteregge, N, Weller, S, von Keudell, A CORRIGENDUM: Nanosecond and microsecond-pulsed plasma-in-liquid treated copper oxide surfaces (2025 J. Phys. D: Appl. Phys. 58 305201), Pottkämper, P, Unteregge, N, Weller, S, von Keudell, A

  • Open Access

    Impact of catalytic surfaces on atmospheric RF plasma dynamics

    by S Yu, A von Keudell

    The combination of plasma and catalysis allows flexible solutions for species conversion. Any plasma catalysis synergism can constitute either of plasma conversion enhanced by a surface process or a surface process enhanced by plasma-excited species as reaction partners. The first case of the impact of a catalytic surface on plasma dynamics is investigated using phase-resolved optical emission spectroscopy (PROES) in RF helium and argon discharges with nitrogen, hydrogen, and oxygen admixtures. Different surfaces are being employed, and the electron energetics are monitored by measuring the temporal and spatial development of the helium emission line. Surfaces with high secondary electron emission coefficients (SEEC or γ e ) lead to increased electron densities in front of the surface, thereby enhancing plasma conversion. Higher SEEC promotes the transition of the discharge from α -mode to γ -mode, but the emission strength is also governed by electron energy distribution, surface charge dynamics, and surface roughness. The γ e values for a specific material from the former literature cannot necessary directly used, because the SEEC depends also on the microstructure of the surface, which may vary. Consequently, the PROES measurements presented here provide realistic γ e values, which better reflects the performance of the catalytic coating under actual discharge conditions, and show the impact on discharge dynamics.

  • Plasma in liquids for materials

    by Albert Engstfeld, Thierry Belmonte, Achim von Keudell, Mohan Sankaran

    Plasma in liquids for materials, Engstfeld, Albert, Belmonte, Thierry, von Keudell, Achim, Sankaran, Mohan

  • Open Access

    Ion energy distributions from the impact of an atmospheric dielectric barrier discharge plasma jet on surfaces

    by Daniel Henze, Laura Chauvet, Achim von Keudell

    The ion energy distribution functions (IEDFs) have been measured for a helium atmospheric pressure dielectric barrier discharge jet expanding into the air and impacting a metal or ceramic surface. The plasma jet produces ionization waves as guided positive streamers that reach the surface. Molecular beam mass spectrometry (MBMS) with an energy filter has been used to monitor the IEDFs at a distance of 1.5 cm from the dielectric barrier discharge plasma jet exit. The species are sampled from the supersonic expanding helium beam passing into the MBMS through a 40 µm (metal) or a 50 µm (ceramic) diameter orifice. N 2 + , O 2 + , NO+, O 3 + and water cluster ions (H2O) n H+ (n = 1...4) are abundantly produced in the discharge. The analysis of the time-resolved IEDFs reveals that all ions are predominantly sampled at a reference energy E beam when using the metallic orifice. This energy E beam is determined by the seeding of the ions into the supersonic expanding helium beam into the MBMS. After the impact of the streamer, an afterglow of 10 µs is observed when ions are continuously sampled at an energy higher than E beam by a few 0.1 eVs. This is resolved by postulating a positive space-charge region in front of a positively charged surface. The temporal sequence of the ion impact is consistent with reaction schemes in air plasmas, where O 2 + and N 2 + are created before the formation of NO and O3, as well as larger water cluster ions.


  • Open Access

    Nitrogen Oxidation on A Plasma-Exposed Surface

    by Steijn Vervloedt, Achim von Keudell

    The elementary processes during the fixation of nitrogen by plasma catalysis are studied in a low-pressure plasma experiment with N $$_2$$ 2 and O $$_2$$ 2 as source gases. The formation of surface groups on an iron oxide foil is monitored with infrared reflection absorption spectroscopy. Surface nitrates (NO $$_3^-$$ 3 - ) are formed when the substrate is exposed to a 1:1 N $$_2$$ 2 :O $$_2$$ 2 plasma, as well as N $$_2$$ 2 O(g), NO(g), NO $$_2$$ 2 (g), and O $$_3$$ 3 (g) in the gas phase. It is postulated that NO $$_{1,2}$$ 1 , 2 (g) species created by the plasma, adsorb at the surface and create these nitrates. This constitutes an intermediate step for nitrogen oxidation by plasma catalysis.


  • Open Access

    Nanosecond and microsecond-pulsed plasma-in-liquid treated copper oxide surfaces

    by P Pottkämper, N Unteregge, S Weller, A von Keudell

    Nanosecond and microsecond plasma-in liquid systems are explored to oxidize or regenerate a copper oxide surface in situ to serve as a catalyst for electrochemical CO2 conversion. The plasma excitation generates H2O2 in the liquid, which induces the dissolution of Cu into Cu(OH)2 and the recrystallization into Cu2O nanocubes at the interface. The plasma performance of the two excitation schemes is analyzed, showing that the H2O2 production of nanosecond plasma is more efficient than of microsecond plasmas. The nature of the Cu2O nanocubes is evaluated using electron microscopy and electrochemical characterization.


  • Open Access

    A SDBD Reactor for the Removal of Oxygen Traces in Hydrogen Operated above Atmospheric Pressure: Experiment and Simulation

    by Christian Oberste-Beulmann, Philipp Wirth, Soad Mohsenimehr, Timothy Oppotsch, Achim von Keudell, Peter Awakowicz, Martin Muhler

    Non-thermal plasma-based technologies have emerged as versatile tools for various industrial processes due to their ability to induce chemical reactions efficiently under ambient conditions. In particular, dielectric barrier discharges (DBDs) are of interest because of their robust and reliable design and scalability. This study investigates the role of pressure in tuning conversion, plasma parameters, and flow patterns in a plasma-assisted chemical reaction using a surface DBD (SDBD) reactor. The removal of O2 traces in H2 was used as a model reaction, where an unexpected increased conversion at elevated pressure was observed at high powers. This effect was studied using high-speed photography to analyze streamer dynamics and optical emission spectroscopy to determine plasma parameters. With increasing pressure, both the plasma area and the number of individual streamers decreased, and the electron density decreased as well. Fluid simulations were conducted to examine the impact of increased pressure on mass transport pointing to an enhanced contact time as the origin of the increased conversion at high dissipated powers. The findings highlight the importance of optimizing pressure and power conditions to maximize the efficiency of plasma-based chemical processes.


  • Impact of the surface on He(23S1) and He2(a 3 Σ u + ) metastables densities in atmospheric pressure RF plasma

    by S Yu, L Chauvet, A von Keudell

    The dynamic of helium metastable formation along an atmospheric pressure helium plasma channel with different bounding surfaces is analysed. The densities of He(23S1) and He2(a 3 Σ u + ) are measured using optical absorption spectroscopy. A simple model for helium metastable creation, quenching by water impurities and destruction upon surface impact, is developed. The model shows a very good agreement if one assumes that surfaces mainly control secondary electron emission, affecting the local heating at the plasma boundary sheath. This, in turn, changes the rate for He(23S1) and He2(a 3 Σ u + ) conversion. The helium metastable induced desorption of adsorbed water causes a decay of the metastable density along the plasma channel due to quenching.


  • Open Access

    Simulation of a Microwave Plasma Torch Used for Hydrogen Production via Methane Pyrolysis

    by Simon Kreuznacht, Marc Böke, Achim von Keudell

    Hydrogen is often envisioned as a green fuel and energy carrier. However, a greenhouse gas‐free production method is still needed for this purpose. A promising method is the pyrolysis of methane. In this study, we present the three‐dimensional simulation of methane pyrolysis in a microwave plasma torch operated in an argon–methane mixture. Due to the high gas temperatures, the chemistry is dominated by reactions between neutral particles. Therefore, the plasma is treated only as a heat source using space‐resolved gas temperature measurements as input. The end‐of‐pipe results of the simulation are compared to measured values, showing good agreement for methane conversion.