Jens Melder
Research Subjects
Jens Melder has a total of 67 co-authors. Here are the top co-authors by number of shared publications:
- Philipp Kurz
Institut Für Anorganische und Analytische Chemie Albert‐Ludwigs‐Universität Freiburg Freiburg Germany
6 shared publications - Alexandr Nikolaevich Simonov
Monash University
2 shared publications Axel Knop‐Gericke
Abteilung Anorganische Chemie, Fritz-Haber-Institut der Max-Planck-Gesellschaft, Faradayweg 4-6, 14195, Berlin, Germany
2 shared publications- Dmitriy Shevela
Umeå University
2 shared publications - Holger Dau
Department of Physics, Freie Universität Berlin, Arnimallee 14, 14195 Berlin, Germany
2 shared publications - Jie Xiao
Helmholtz-Zentrum Berlin für Materialien und Energie 12489 Berlin Germany
2 shared publications
Latest Publications
- 4 January 2026
- Published by Springer Nature
- p. 77-90
Defossilization Perspectives with Sustainable Alkylate Fuel for Outdoor Power Tools
- 4 January 2026
- Published by Springer Nature
- p. 77-90
Defossilization Perspectives with Sustainable Alkylate Fuel for Outdoor Power Tools
- 30 June 2024
- Published by Springer Nature
- p. 245-257
Sustainable Fuels for Outdoor Power-Tools and Equipment
- 30 June 2024
- Published by Springer Nature
- p. 245-257
Sustainable Fuels for Outdoor Power-Tools and Equipment
- Open Access
- 6 March 2023
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 37 (6) , 4580-4595
Comprehensive Two-Dimensional Gas Chromatography: A Universal Method for Composition-Based Prediction of Emission Characteristics of Complex Fuels
- 6 March 2023
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 37 (6) , 4580-4595
Open AccessComprehensive Two-Dimensional Gas Chromatography: A Universal Method for Composition-Based Prediction of Emission Characteristics of Complex Fuels
- 17 November 2022
- Published by Royal Society of Chemistry (RSC) in Sustainable Energy & Fuels
- Vol. 7 (1) , 92-105
Tuning electrocatalytic water oxidation by MnO x through the incorporation of abundant metal cations
Preparation and detailed characterization of metal cation doped layered manganese oxides (M y MnO x /CFP). Metal doping leads to tuning of the average manganese oxidation state and an OER performance boost under different pH conditions.
- 17 November 2022
- Published by Royal Society of Chemistry (RSC) in Sustainable Energy & Fuels
- Vol. 7 (1) , 92-105
Tuning electrocatalytic water oxidation by MnO x through the incorporation of abundant metal cations
Preparation and detailed characterization of metal cation doped layered manganese oxides (M y MnO x /CFP). Metal doping leads to tuning of the average manganese oxidation state and an OER performance boost under different pH conditions.
- 20 March 2022
- Published by Elsevier in Combustion and Flame
- Vol. 243
On the diversity of fossil and alternative gasoline combustion chemistry: A comparative flow reactor study
- 20 March 2022
- Published by Elsevier in Combustion and Flame
- Vol. 243
On the diversity of fossil and alternative gasoline combustion chemistry: A comparative flow reactor study
- 15 October 2019
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 7 (44) , 25333-25346
Carbon fibre paper coated by a layered manganese oxide: a nano-structured electrocatalyst for water-oxidation with high activity over a very wide pH range
Manganese oxide coated carbon fibre paper electrodes (MnOx/CFP), prepared via an easily scalable redox-deposition route, have been reported as promising materials for electrochemical water oxidation catalysis (WOC). In the study presented here, the catalyst mass-dependence of the activity of such nanostructured WOC electrodes and their activity and stability in phosphate buffer electrolytes over nearly the entire pH range (pH 1–14) was explored. For all pH values, current densities of >1 mA cm−2 at overpotentials η of 350–500 mV were observed, which are very good values for electrodes containing only earth-abundant elements (Mn, O and C in this case). The very decent performance observed for the mildly acidic pH regime (pH 2–6) was especially noteworthy. For the dependence of η on the pH, an ideal Nernstian behaviour was detected for the pH window pH 1–10. Above pH 10, a pronounced deviation from the expected trend was found, as most electro-kinetic parameters indicated even higher activities for the strongly alkaline regime. Concerning anode stabilities, current-densities of 2 mA cm−2 could be maintained at all studied pHs over at least 24 h of continuous operation. Pre- and post-operando spectroscopic analyses (e.g. vibrational and X-ray absorption spectroscopy, scanning electron microscopy) revealed only minor changes of the catalyst structure, composition, morphology or the average Mn oxidation state induced by the electrocatalytic operation, which confirms the good stabilities found in the electrochemical measurements. Thus, we report on an earth-abundant, easily-prepared type of WOC electrode, which exhibits promising activities and stabilities for applications in alkaline, neutral and even acidic electrolytes.
- 15 October 2019
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 7 (44) , 25333-25346
Carbon fibre paper coated by a layered manganese oxide: a nano-structured electrocatalyst for water-oxidation with high activity over a very wide pH range
Manganese oxide coated carbon fibre paper electrodes (MnOx/CFP), prepared via an easily scalable redox-deposition route, have been reported as promising materials for electrochemical water oxidation catalysis (WOC). In the study presented here, the catalyst mass-dependence of the activity of such nanostructured WOC electrodes and their activity and stability in phosphate buffer electrolytes over nearly the entire pH range (pH 1–14) was explored. For all pH values, current densities of >1 mA cm−2 at overpotentials η of 350–500 mV were observed, which are very good values for electrodes containing only earth-abundant elements (Mn, O and C in this case). The very decent performance observed for the mildly acidic pH regime (pH 2–6) was especially noteworthy. For the dependence of η on the pH, an ideal Nernstian behaviour was detected for the pH window pH 1–10. Above pH 10, a pronounced deviation from the expected trend was found, as most electro-kinetic parameters indicated even higher activities for the strongly alkaline regime. Concerning anode stabilities, current-densities of 2 mA cm−2 could be maintained at all studied pHs over at least 24 h of continuous operation. Pre- and post-operando spectroscopic analyses (e.g. vibrational and X-ray absorption spectroscopy, scanning electron microscopy) revealed only minor changes of the catalyst structure, composition, morphology or the average Mn oxidation state induced by the electrocatalytic operation, which confirms the good stabilities found in the electrochemical measurements. Thus, we report on an earth-abundant, easily-prepared type of WOC electrode, which exhibits promising activities and stabilities for applications in alkaline, neutral and even acidic electrolytes.
- 27 December 2018
- Published by Wiley in Angewandte Chemie International Edition
- Vol. 58 (11) , 3426-3432
Evolution of Oxygen–Metal Electron Transfer and Metal Electronic States During Manganese Oxide Catalyzed Water Oxidation Revealed with In Situ Soft X‐Ray Spectroscopy
Manganese oxide (MnOx) electrocatalysts are examined herein by in situ soft X‐ray absorption spectroscopy (XAS) and resonant inelastic X‐ray scattering (RIXS) during the oxidation of water buffered by borate (pH 9.2) at potentials from 0.75 to 2.25 V vs. the reversible hydrogen electrode. Correlation of L‐edge XAS data with previous mechanistic studies indicates MnIV is the highest oxidation state involved in the catalytic mechanism. MnOx is transformed into birnessite at 1.45 V and does not undergo further structural phase changes. At potentials beyond this transformation, RIXS spectra show progressive enhancement of charge transfer transitions from oxygen to manganese. Theoretical analysis of these data indicates increased hybridization of the Mn−O orbitals and withdrawal of electron density from the O ligand shell. In situ XAS experiments at the O K‐edge provide complementary evidence for such a transition. This step is crucial for the formation of O2 from water.
- 27 December 2018
- Published by Wiley in Angewandte Chemie International Edition
- Vol. 58 (11) , 3426-3432
Evolution of Oxygen–Metal Electron Transfer and Metal Electronic States During Manganese Oxide Catalyzed Water Oxidation Revealed with In Situ Soft X‐Ray Spectroscopy
Manganese oxide (MnOx) electrocatalysts are examined herein by in situ soft X‐ray absorption spectroscopy (XAS) and resonant inelastic X‐ray scattering (RIXS) during the oxidation of water buffered by borate (pH 9.2) at potentials from 0.75 to 2.25 V vs. the reversible hydrogen electrode. Correlation of L‐edge XAS data with previous mechanistic studies indicates MnIV is the highest oxidation state involved in the catalytic mechanism. MnOx is transformed into birnessite at 1.45 V and does not undergo further structural phase changes. At potentials beyond this transformation, RIXS spectra show progressive enhancement of charge transfer transitions from oxygen to manganese. Theoretical analysis of these data indicates increased hybridization of the Mn−O orbitals and withdrawal of electron density from the O ligand shell. In situ XAS experiments at the O K‐edge provide complementary evidence for such a transition. This step is crucial for the formation of O2 from water.
- 27 December 2018
- Published by Wiley in Angewandte Chemie
- Vol. 131 (11) , 3464-3470
Evolution of Oxygen–Metal Electron Transfer and Metal Electronic States During Manganese Oxide Catalyzed Water Oxidation Revealed with In Situ Soft X‐Ray Spectroscopy
Manganese oxide (MnOx) electrocatalysts are examined herein by in situ soft X‐ray absorption spectroscopy (XAS) and resonant inelastic X‐ray scattering (RIXS) during the oxidation of water buffered by borate (pH 9.2) at potentials from 0.75 to 2.25 V vs. the reversible hydrogen electrode. Correlation of L‐edge XAS data with previous mechanistic studies indicates MnIV is the highest oxidation state involved in the catalytic mechanism. MnOx is transformed into birnessite at 1.45 V and does not undergo further structural phase changes. At potentials beyond this transformation, RIXS spectra show progressive enhancement of charge transfer transitions from oxygen to manganese. Theoretical analysis of these data indicates increased hybridization of the Mn−O orbitals and withdrawal of electron density from the O ligand shell. In situ XAS experiments at the O K‐edge provide complementary evidence for such a transition. This step is crucial for the formation of O2 from water.
- 27 December 2018
- Published by Wiley in Angewandte Chemie
- Vol. 131 (11) , 3464-3470
Evolution of Oxygen–Metal Electron Transfer and Metal Electronic States During Manganese Oxide Catalyzed Water Oxidation Revealed with In Situ Soft X‐Ray Spectroscopy
Manganese oxide (MnOx) electrocatalysts are examined herein by in situ soft X‐ray absorption spectroscopy (XAS) and resonant inelastic X‐ray scattering (RIXS) during the oxidation of water buffered by borate (pH 9.2) at potentials from 0.75 to 2.25 V vs. the reversible hydrogen electrode. Correlation of L‐edge XAS data with previous mechanistic studies indicates MnIV is the highest oxidation state involved in the catalytic mechanism. MnOx is transformed into birnessite at 1.45 V and does not undergo further structural phase changes. At potentials beyond this transformation, RIXS spectra show progressive enhancement of charge transfer transitions from oxygen to manganese. Theoretical analysis of these data indicates increased hybridization of the Mn−O orbitals and withdrawal of electron density from the O ligand shell. In situ XAS experiments at the O K‐edge provide complementary evidence for such a transition. This step is crucial for the formation of O2 from water.