Birgit Claes
Research Subjects
Birgit Claes has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Dirk E. De Vos
KU Leuven
3 shared publications Anton Geers
Centre for Surface Chemistry and Catalysis
1 shared publicationBart Bueken
Department of Microbial and Molecular Systems, Centre for Surface Chemistry and Catalysis (COK), Leuven Chem&Tech, KU Leuven , Celestijnenlaan 200F, Postbox 2461, 3001 Leuven, Belgium
1 shared publicationBert Lagrain
Department of Microbial and Molecular Systems, Centre for Surface Chemistry and Catalysis (COK), Leuven Chem&Tech, KU Leuven , Celestijnenlaan 200F, Postbox 2461, 3001 Leuven, Belgium
1 shared publicationCédric Van Goethem
Centre for Surface Chemistry and Catalysis
1 shared publication- Dries Jonckheere
KU Leuven, Leuven Chem&Tech – Centre for Membrane Separations, Adsorption, Catalysis and Spectroscopy for Sustainable Solutions (cMACS), Celestijnenlaan 200F post box 2454, Leuven 3001, Belgium
1 shared publication
Latest Publications
- 25 August 2017
- Published by Royal Society of Chemistry (RSC) in Green Chemistry
- Vol. 19 (19) , 4642-4650
Stabilising Ni catalysts for the dehydration–decarboxylation–hydrogenation of citric acid to methylsuccinic acid
A new reaction sequence of dehydration–decarboxylation–hydrogenation to transform citric acid into methylsuccinic acid has recently been developed using Pd as a noble metal catalyst in water. In this work Ni catalysts were investigated as low cost, non-noble metal alternatives. Several home-made and commercial catalysts were screened for this reaction. Citric acid was very reactive and full conversions were readily obtained in all cases. However, the selectivity to methylsuccinic acid was initially low, since typical Ni catalysts were not stable and therefore not able to hydrogenate the formed CC double bonds. Due to the lower hydrogenation activity of Ni compared to Pd, new side products appeared. Particularly, hydration of the CC double bonds made the reaction network more complex in this case. Fortunately, the formation of all hydration products – even the rather stable lactone, β-carboxy-γ-butyrolactone – was eventually shown to be completely reversible. Three routes were then studied to stabilise Ni catalysts and to enable the Ni catalyzed conversion of citric acid to methylsuccinic acid; partial neutralisation of the acid reactant, adding Fe to Ni/ZrO2 or to the reaction mixture and coating Ni particles with carbon, all proved to stabilise Ni and all resulted in high to very high methylsuccinic acid yields. Furthermore, the role of Fe was unravelled by performing reference reactions with different Fe compounds and by in depth characterisation of the NiFe/ZrO2 catalyst. Finally, the reaction conditions were optimised using the carbon-coated Ni nanoparticles and kinetic profiles were recorded to confirm the extended reaction network.
- 25 August 2017
- Published by Royal Society of Chemistry (RSC) in Green Chemistry
- Vol. 19 (19) , 4642-4650
Stabilising Ni catalysts for the dehydration–decarboxylation–hydrogenation of citric acid to methylsuccinic acid
A new reaction sequence of dehydration–decarboxylation–hydrogenation to transform citric acid into methylsuccinic acid has recently been developed using Pd as a noble metal catalyst in water. In this work Ni catalysts were investigated as low cost, non-noble metal alternatives. Several home-made and commercial catalysts were screened for this reaction. Citric acid was very reactive and full conversions were readily obtained in all cases. However, the selectivity to methylsuccinic acid was initially low, since typical Ni catalysts were not stable and therefore not able to hydrogenate the formed CC double bonds. Due to the lower hydrogenation activity of Ni compared to Pd, new side products appeared. Particularly, hydration of the CC double bonds made the reaction network more complex in this case. Fortunately, the formation of all hydration products – even the rather stable lactone, β-carboxy-γ-butyrolactone – was eventually shown to be completely reversible. Three routes were then studied to stabilise Ni catalysts and to enable the Ni catalyzed conversion of citric acid to methylsuccinic acid; partial neutralisation of the acid reactant, adding Fe to Ni/ZrO2 or to the reaction mixture and coating Ni particles with carbon, all proved to stabilise Ni and all resulted in high to very high methylsuccinic acid yields. Furthermore, the role of Fe was unravelled by performing reference reactions with different Fe compounds and by in depth characterisation of the NiFe/ZrO2 catalyst. Finally, the reaction conditions were optimised using the carbon-coated Ni nanoparticles and kinetic profiles were recorded to confirm the extended reaction network.
- 22 August 2017
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 9 (35) , 30064-30073
Adsorption and Separation of Aromatic Amino Acids from Aqueous Solutions Using Metal–Organic Frameworks
Metal–organic frameworks (MOFs) are investigated for the adsorption of aromatic amino acids l-phenylalanine (l-Phe), l-tryptophan (l-Trp), and l-tyrosine (l-Tyr) from aqueous solutions. After screening a range of water-stable MOFs, the hydrophobic Zr-MOF MIL-140C emerged as the best performing material, exhibiting uptakes of 15 wt % for l-Trp and 20 wt % for l-Phe. These uptakes are 5–10 wt % higher than those of large-pore zeolites Beta and Y. Both single-compound and competitive adsorption isotherms for l-Phe and l-Trp were experimentally obtained at the natural pH of these amino acid mixtures (pH 6.5–7) without additional pH modification. We find that the hydrophobic nature of MIL-140C and the capacity of l-Trp to form hydrogen bonds favor the uptake of l-Trp with its larger indole moiety compared to the smaller phenyl side group of l-Phe. On the basis of literature and vibrational analysis, observations of hydrogen-bonded l-Trp within the MIL-140C framework are evidenced by red- and blue-shifted −NH vibrations (3400 cm–1) in Fourier transform infrared spectroscopy, which were attributed to types N–Hl-Trp···πMIL-140C and N–Hl-Trp···OMIL-140C, respectively. MIL-140C is shown to be recycled at least three times for both aromatic amino acids without any loss of adsorption capacity, separation performance, or crystallinity. Desorption of aromatic amino acids proceeds easily in aqueous ethanol. Substantial coadsorption of negatively charged amino acids l-glutamate and l-aspartate (l-Glu and l-Asp) was observed from a model solution for wheat straw protein hydrolysate at pH 4.3. On the basis of these results, we conclude that MIL-140C is an interesting material for the recovery of essential aromatic amino acids l-Tyr, l-Phe, and l-Trp and of l-Glu and l-Asp from waste protein hydrolysates.
- 22 August 2017
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 9 (35) , 30064-30073
Adsorption and Separation of Aromatic Amino Acids from Aqueous Solutions Using Metal–Organic Frameworks
Metal–organic frameworks (MOFs) are investigated for the adsorption of aromatic amino acids l-phenylalanine (l-Phe), l-tryptophan (l-Trp), and l-tyrosine (l-Tyr) from aqueous solutions. After screening a range of water-stable MOFs, the hydrophobic Zr-MOF MIL-140C emerged as the best performing material, exhibiting uptakes of 15 wt % for l-Trp and 20 wt % for l-Phe. These uptakes are 5–10 wt % higher than those of large-pore zeolites Beta and Y. Both single-compound and competitive adsorption isotherms for l-Phe and l-Trp were experimentally obtained at the natural pH of these amino acid mixtures (pH 6.5–7) without additional pH modification. We find that the hydrophobic nature of MIL-140C and the capacity of l-Trp to form hydrogen bonds favor the uptake of l-Trp with its larger indole moiety compared to the smaller phenyl side group of l-Phe. On the basis of literature and vibrational analysis, observations of hydrogen-bonded l-Trp within the MIL-140C framework are evidenced by red- and blue-shifted −NH vibrations (3400 cm–1) in Fourier transform infrared spectroscopy, which were attributed to types N–Hl-Trp···πMIL-140C and N–Hl-Trp···OMIL-140C, respectively. MIL-140C is shown to be recycled at least three times for both aromatic amino acids without any loss of adsorption capacity, separation performance, or crystallinity. Desorption of aromatic amino acids proceeds easily in aqueous ethanol. Substantial coadsorption of negatively charged amino acids l-glutamate and l-aspartate (l-Glu and l-Asp) was observed from a model solution for wheat straw protein hydrolysate at pH 4.3. On the basis of these results, we conclude that MIL-140C is an interesting material for the recovery of essential aromatic amino acids l-Tyr, l-Phe, and l-Trp and of l-Glu and l-Asp from waste protein hydrolysates.
- 24 January 2017
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 9 (5) , 4440-4449
Smart Metal–Organic Framework Coatings: Triggered Antibiofilm Compound Release
Metal–organic frameworks (MOFs) have a large potential for delivery of active molecules. Here, a MOF coating is investigated as a smart host matrix for triggered release of antibiofilm compounds. In addition to a coating consisting of the regular Fe-terephthalate MIL-88B(Fe), a new hydrophobic MIL-88B(Fe) coating is synthesized in hydrothermal conditions using palmitic acid as a lattice terminating group. These porous materials are used as a host matrix for the antibiofilm compound 5-(4-chlorophenyl)-N-(2-isobutyl)-2-aminoimidazole, which has a specific biofilm-inhibiting effect at concentrations at which no activity against planktonic cells is detected. The stability of MIL-88B(Fe) in distilled water and tryptic soy broth medium is investigated, together with the ability of iron(III) chelators to serve as a trigger for controlled decomposition of MIL-88B(Fe) by metal complexation. Organic iron chelators are used to mimic the iron chelating function of siderophores, which are specific molecules excreted by biofilm-forming bacteria. Trisodium citrate is able to chelate metal ions from the junctions of the framework. By sequestration of these metal ions, the host matrix is partially degraded, resulting in an antibiofilm compound release. Finally, the antibiofilm properties against Salmonella Typhimurium are validated by monitoring biofilm growth on MOF layers either loaded or not with aminoimidazole. A strong proof-of-concept is shown for efficient inhibition of biofilm growth through triggered antibiofilm compound release.
- 24 January 2017
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 9 (5) , 4440-4449
Smart Metal–Organic Framework Coatings: Triggered Antibiofilm Compound Release
Metal–organic frameworks (MOFs) have a large potential for delivery of active molecules. Here, a MOF coating is investigated as a smart host matrix for triggered release of antibiofilm compounds. In addition to a coating consisting of the regular Fe-terephthalate MIL-88B(Fe), a new hydrophobic MIL-88B(Fe) coating is synthesized in hydrothermal conditions using palmitic acid as a lattice terminating group. These porous materials are used as a host matrix for the antibiofilm compound 5-(4-chlorophenyl)-N-(2-isobutyl)-2-aminoimidazole, which has a specific biofilm-inhibiting effect at concentrations at which no activity against planktonic cells is detected. The stability of MIL-88B(Fe) in distilled water and tryptic soy broth medium is investigated, together with the ability of iron(III) chelators to serve as a trigger for controlled decomposition of MIL-88B(Fe) by metal complexation. Organic iron chelators are used to mimic the iron chelating function of siderophores, which are specific molecules excreted by biofilm-forming bacteria. Trisodium citrate is able to chelate metal ions from the junctions of the framework. By sequestration of these metal ions, the host matrix is partially degraded, resulting in an antibiofilm compound release. Finally, the antibiofilm properties against Salmonella Typhimurium are validated by monitoring biofilm growth on MOF layers either loaded or not with aminoimidazole. A strong proof-of-concept is shown for efficient inhibition of biofilm growth through triggered antibiofilm compound release.