AKAli-Reza Kiani

Ali-Reza Kiani

*This is an algorithmically generated author record based on publicly available information.

Ali-Reza Kiani has a total of 19 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Comparative effects of direct seeding and transplanting on rice yield and water productivity under different irrigation methods

    by Alireza Kiani, Mohammadreza Yazdani

    Water scarcity and soil degradation pose major challenges to traditional rice. This two-year field study (2019–2020) in northern Iran evaluated the potential of direct seeding as an alternative to transplanting to reduce water. The study examined four different irrigation methods (sprinkler, I 1 ; flooding, I 2 ; wet & dry, I 3 ; tape, I 4 ) and three cultivation techniques (direct seeding, C 1 ; direct seedling, C 2 ; traditional transplanting, C 3 ). The experiment followed a randomized complete block design with three replications. Throughout the season, applied water, yield, yield components and water productivity were measured and calculated. Overall, the results indicate that the direct cultivation method of rice (C 1 and C 2 ) consumed significantly less water than the traditional transplanting method (C 3 ). However, the direct method also resulted in a lower rice yield compared to the traditional method. The highest yield (8206 kg/ha) was recorded in I 2 C 3 . In C 3 , changing from I 2 to I 1 , I 3 , and I 4 , led to yield decreases of about 14 %, 9 %, and 11 %, respectively. The highest water use was recorded for I 2 C 1 (12 490 m 3 /ha). Transitioning from I 2 C 3 to I 4 C 2 led to a 24 % decrease in yield and a 45 % decrease in water consumption. In this scenario, physical and economic water productivity reached 0.9 kg/m 3 and 0.45 $/m 3 , respectively. The study suggests that direct seeding of rice, compared to the traditional method, can significantly reduce non-beneficial water usage. To address the reduction in yield and adopt water-saving methods, it is important to offer encouraging incentives.


  • Effect of magnetized water on infiltration capacity of different soil textures

    by M. Khoshravesh‐Miangoleh, A.‐R. Kiani

    The infiltration process is important in the planning and management of irrigation systems. This study was performed in M azandaran province, I ran, to compare the effect of magnetized and non‐magnetized irrigation water on cumulative infiltration and final infiltration rate of three soil textures. Magnetized water was obtained by passing the water through a strong permanent magnet installed on a feed pipeline. The results showed that the effects of soil texture and magnetized irrigation water on cumulative water infiltration and final infiltration rate was significant ( P < 0.01). Cumulative water infiltration and final infiltration rates with magnetized water were greater than that of non‐magnetized water. The cumulative water infiltration rate after 4 h for magnetized and non‐magnetized water was 26.4 and 12.7 cm in clay soil, 37.6 and 20 cm in silty loam soil and 40.8 and 29.3 cm in sandy loam soil, respectively. The final infiltration rates after 4 h for magnetized and non‐magnetized water were 0.05 and 0.023 cm/min in clay soil, 0.063 and 0.036 cm/min in silty loam soil and 0.076 and 0.046 cm/min in sandy loam soil, respectively. Therefore, magnetized irrigation water had most effect on the infiltration capacity of clay soil.


  • AquaCrop model simulation under different irrigation water and nitrogen strategies

    by Mojtaba Khoshravesh, Behrouz Mostafazadeh-Fard, Manouchehr Heidarpour, Ali-Reza Kiani

    On a global scale, irrigated agriculture consumes about 72% of available freshwater resources. Deficit irrigation can be applied in the field to save irrigation water and still lead to acceptable crop production. The AquaCrop model is a simulation model for management of irrigation and nitrogen fertilizer. This model is a new model that is accurate, robust and requires fewer data inputs compared with the other models. The purpose of this study was to simulate canopy cover, grain yield and water use efficiency (WUE) for soybean using the AquaCrop model. A field line source sprinkler irrigation system was conducted under full and deficit irrigation using different nitrogen fertilizer applications during two cropping seasons for soybean at Gorgan province in Iran. The simulation results showed a reasonably accurate prediction of yield, canopy cover and WUE in all cases (error less than 23%). The simulated pattern of canopy progression over time was close to measured values, with Willmott's index of agreement for all the cases being ≥0.95 for different parameters. The AquaCrop model has the ability to simulate the WUE of soybean under different irrigation water and nitrogen applications. This model is a useful tool for managing the crop water productivity.


  • Effects of Magnetized Water on Soil Chemical Components underneath Trickle Irrigation

    by B. Mostafazadeh-Fard, M. Khoshravesh, S. F. Mousavi, A. R. Kiani

    Magnetized water has been studied by many researchers. However, to date, there is no study about the effects of magnetized water on soil chemical characteristics such as cations and anions in trickle irrigation. This study was performed at Gorgan Agricultural and Natural Resources Research Center, Gorgan Province, Iran, to investigate soil chemical characteristics under trickle irrigation using magnetized water. Two main treatments of magnetic and nonmagnetized water, and three subtreatments of irrigation water salts, including well water as control and addition of 1 or 2  meq/L calcium carbonate (CaCO3) to irrigation water, were used. The experiment was laid out with a completely randomized block design with three replications. The results showed that mean soil cations (such as calcium, sodium, and magnesium) and anions (such as bicarbonate, chloride, and sulfate) at soil depths of 0–20, 20–40, and 40–60 cm below the emitter for magnetized irrigation water treatment were lower than those with nonmagnetized irrigation water treatment, and the differences were significant (p<0.05). With experiments that continued to the end of the season, the effect of magnetized water was increased. Therefore, soil moisture for each irrigation in magnetized irrigation water was higher than nonmagnetized irrigation water and caused high leaching of soil salt so that this effect was significant. The use of magnetized water is recommended for trickle irrigation to reclaim soils with high cations and anions content such as calcium, sodium, and bicarbonate.


  • Effects of magnetized water on the distribution pattern of soil water with respect to time in trickle irrigation

    by M. Khoshravesh, B. Mostafazadeh‐Fard, S. F. Mousavi, A. R. Kiani

    In arid and semi‐arid regions, farmers use low quality groundwater because of limited availability of high quality irrigation water; instead, magnetized water can be used for irrigation given its better quality. Magnetized water is obtained by passing water through permanent magnets or through electro‐magnets installed in or on a feeding pipeline. This study at the Gorgan Agricultural and Natural Resources Research Center, Gorgan province, Iran, investigated soil moisture distribution from trickle irrigation. Treatments were magnetic and non‐magnetic water and sub‐treatments involved the addition of 200 mg/L calcium carbonate and 400 mg/L calcium carbonate with well water providing the control. The experiment was laid out with a complete randomized block design with three replications. Soil moisture around the drippers was measured for 1, 2 and 3 days after irrigation during the 3‐month irrigation period. The results show that the differences in soil moisture for days 1, 2 and 3 after irrigation with magnetized irrigation water were lesser than those for the non‐magnetized irrigation water treatments. Irrigation with magnetized irrigation water caused higher soil moisture compared with the non‐magnetized irrigation water for different irrigation water salinities. The use of magnetized water for irrigation is recommended to improve irrigation efficiency.


  • Effects of Magnetized Water and Irrigation Water Salinity on Soil Moisture Distribution in Trickle Irrigation

    by Behrouz Mostafazadeh-Fard, Mojtaba Khoshravesh, Sayed-Farhad Mousavi, Ali-Reza Kiani

    Magnetized water is obtained by passing water through a strong permanent magnet installed in or on a feed pipeline. This study was performed at Gorgan Agricultural and Natural Resources Research Center, Gorgan province, Iran, to investigate soil moisture distribution under trickle irrigation. Two main treatments of magnetic and nonmagnetic water and three subtreatments of irrigation water salts, including well water as a control, 200-ppm calcium carbonate, and 400-ppm calcium carbonate were used. The experiment was laid out with a complete randomized block design with three replications. Soil moisture distribution around the emitters were measured 24 h after irrigation during the 3-month irrigation period. The results showed that the mean soil moisture contents at depths of 0–20, 20–40, and 40–60 cm below the emitter for the magnetized irrigation water treatment were more than the nonmagnetized irrigation water treatment, and the differences were significant at the 5% level. The irrigation with magnetic w...


  • Assessment of the water–salinity crop production function of wheat using experimental data of the Golestan province, Iran

    by A. R. Kiani, F. Abbasi

    Optimisation of agricultural water management in arid and semi‐arid regions requires the availability of water–salinity crop production functions. A two‐year experiment was conducted in the northern Golestan province of Iran to assess the water–salinity production function of wheat. The treatments in the experiment consisted of four levels of irrigation water, i.e. 50 (W1), 75 (W2), 100 (W3) and 125 (W4) % of crop water requirement, and four levels of water salinity, respectively 1.5 (S1), 8.5 (S2), 11.5 (S3) and 14.2 (S4) dS m−1. The plots were arranged in a randomised complete block design with three replications and water quantity as main plot treatment and water quality as subplot treatment. The data were analysed using linear, quadratic, Cobb–Douglas and transcendental functions, complemented with an economic analysis. The results indicate that for the given climate–soil conditions, transcendental functions best predict wheat yield under both water and salinity stress conditions. Yield reduction caused by a unit increase of matric potential is found to be larger than that caused by a unit increase of osmotic potential. The marginal rate of technical substitution indicates that each one of the two factors studied, namely soil salinity and water supply, can be substituted with the other in a wide range in order to achieve equal amount of yield. Copyright © 2008 John Wiley & Sons, Ltd.