Jose Eduardo Garcia
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jose Eduardo Garcia has a total of 197 co-authors. Here are the top co-authors by number of shared publications:
- Diego Alejandro Ochoa
Universitat Politecnica de Catalunya
40 shared publications - Fernando Rubio-Marcos
Instituto de Cerámica y Vidrio (ICV-CSIC), C/Kelsen 5, 28049 Madrid, Spain
19 shared publications - Jose Francisco Fernandez
Instituto de Cerámica y Vidrio (ICV), Consejo Superior de Investigaciones Científicas (CSIC), Calle Kelsen 5, 28049 Madrid, Spain
15 shared publications Diego A. Ochoa
Department of Physics, Universitat Politècnica de Catalunya (UPC), 08034 Barcelona, Spain
11 shared publications- Lourdes Mestres
Departament de Química Inorgánica, Universitat de Barcelona, Barcelona, Spain
10 shared publications A. Albareda
9 shared publications
Latest Publications
- Open Access
- 28 October 2026
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 26 (44) , 15490-15496
Light-Induced Reversible Broadening of Ferroelectric Domain Walls
Ferroelectric domain walls are active nanoscale interfaces whose functionality is governed by their internal structure rather than solely by their position. While optical stimuli are known to induce domain-wall motion, their impact on the spatial configuration of the domain-wall region remains unexplored. Here, we demonstrate that visible light induces a reversible and intensity-dependent broadening of ferroelectric domain walls in BaTiO3 crystals. Using confocal Raman microscopy, we resolve the evolution of the Raman-defined interfacial region and show that illumination transforms its spectroscopic signature from a relatively sharp boundary into an extended, graded interface. This broadening is associated with a continuous modification of the Raman response across the interfacial region and is fully reversible, with no evidence of irreversible structural changes. Our results reveal that domain walls can be dynamically reshaped by light, establishing optical excitation as a noncontact route to control the internal structure of ferroic interfaces and their associated functionalities.
- 28 October 2026
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 26 (44) , 15490-15496
Open AccessLight-Induced Reversible Broadening of Ferroelectric Domain Walls
Ferroelectric domain walls are active nanoscale interfaces whose functionality is governed by their internal structure rather than solely by their position. While optical stimuli are known to induce domain-wall motion, their impact on the spatial configuration of the domain-wall region remains unexplored. Here, we demonstrate that visible light induces a reversible and intensity-dependent broadening of ferroelectric domain walls in BaTiO3 crystals. Using confocal Raman microscopy, we resolve the evolution of the Raman-defined interfacial region and show that illumination transforms its spectroscopic signature from a relatively sharp boundary into an extended, graded interface. This broadening is associated with a continuous modification of the Raman response across the interfacial region and is fully reversible, with no evidence of irreversible structural changes. Our results reveal that domain walls can be dynamically reshaped by light, establishing optical excitation as a noncontact route to control the internal structure of ferroic interfaces and their associated functionalities.
- Open Access
- 8 September 2026
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 370
Sn-driven ferroelectric–antiferroelectric crossover in Ba-modified PLZT ceramics: structural evolution and functional response
- 8 September 2026
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 370
Open AccessSn-driven ferroelectric–antiferroelectric crossover in Ba-modified PLZT ceramics: structural evolution and functional response
- 6 March 2026
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 59 (11)
Textural and crystallographic phase dependence of functional properties in BST-BCT lead-free ferroelectric ceramics featuring polymorphic phase boundary
Here, we report the dependence of the functional properties on textural and crystallographic phases of Aand B-site co-doped BaTiO 3 ceramic, (0.82)BaTi 0.88 Sn 0.12 O 3 -(0.18)Ba 0.7 Ca 0.3 TiO 3 [BST-18BCT], featuring polymorphic phase boundaries (PPB), by varying the sintering temperature (1350 • C to 1550 • C) . Increasing sintering temperatures non-monotonically increased grain size, as confirmed by scanning electron microscopy, while conversely, reduced sintering temperatures enhanced tetragonality, as revealed by Rietveld refinement and corroborated by HRTEM and SAED analyses. Notably, increasing sintering temperature led to a significant enhancement in remanent polarization (P r ), saturation polarization (P s ), and permittivity (ε ′ ), whereas reduction in coercive field (E c ). Specifically, the sample sintered at the lowest temperature (1350 • C) exhibited a nearly three-times increase in E c and the lowest dielectric loss (tanδ). The study highlights that sintering temperature plays a pivotal role in tailoring the ferroelectric properties of PPB compositions by influencing grain size, grain boundaries, and crystallographic parameters.
- 6 March 2026
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 59 (11)
Textural and crystallographic phase dependence of functional properties in BST-BCT lead-free ferroelectric ceramics featuring polymorphic phase boundary
Here, we report the dependence of the functional properties on textural and crystallographic phases of Aand B-site co-doped BaTiO 3 ceramic, (0.82)BaTi 0.88 Sn 0.12 O 3 -(0.18)Ba 0.7 Ca 0.3 TiO 3 [BST-18BCT], featuring polymorphic phase boundaries (PPB), by varying the sintering temperature (1350 • C to 1550 • C) . Increasing sintering temperatures non-monotonically increased grain size, as confirmed by scanning electron microscopy, while conversely, reduced sintering temperatures enhanced tetragonality, as revealed by Rietveld refinement and corroborated by HRTEM and SAED analyses. Notably, increasing sintering temperature led to a significant enhancement in remanent polarization (P r ), saturation polarization (P s ), and permittivity (ε ′ ), whereas reduction in coercive field (E c ). Specifically, the sample sintered at the lowest temperature (1350 • C) exhibited a nearly three-times increase in E c and the lowest dielectric loss (tanδ). The study highlights that sintering temperature plays a pivotal role in tailoring the ferroelectric properties of PPB compositions by influencing grain size, grain boundaries, and crystallographic parameters.
- Open Access
- 24 February 2026
- Published by Elsevier in Materials Research Bulletin
- Vol. 200
Fine-grained barium stannate titanate ceramics obtained by current-controlled flash sintering for energy-storage applications
- 24 February 2026
- Published by Elsevier in Materials Research Bulletin
- Vol. 200
Open AccessFine-grained barium stannate titanate ceramics obtained by current-controlled flash sintering for energy-storage applications
- Open Access
- 11 December 2025
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 350
Electrocaloric and energy storage properties of barium stannate titanate system: A multifunctional approach
- 11 December 2025
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 350
Open AccessElectrocaloric and energy storage properties of barium stannate titanate system: A multifunctional approach
- Open Access
- 7 October 2025
- Published by Elsevier in Scripta Materialia
- Vol. 271
Self-catalytic flash sintering: A versatile approach for energy-efficient sintering and enhanced densification of ceramics
- 7 October 2025
- Published by Elsevier in Scripta Materialia
- Vol. 271
Open AccessSelf-catalytic flash sintering: A versatile approach for energy-efficient sintering and enhanced densification of ceramics
- 23 September 2025
- Published by Elsevier in Journal of the European Ceramic Society
- Vol. 46 (3)
Step-wise current reactive flash sintering of Ba0.85Ca0.15Ti0.90Zr0.10O3 (BCZT) ceramics: Structure and electrical properties
- 23 September 2025
- Published by Elsevier in Journal of the European Ceramic Society
- Vol. 46 (3)
Step-wise current reactive flash sintering of Ba0.85Ca0.15Ti0.90Zr0.10O3 (BCZT) ceramics: Structure and electrical properties
- 27 January 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 126 (4)
Stress release-induced piezoresponse in lead-free piezoceramics with high-symmetry morphotropic phase boundary
The (1 − x)(Bi0.5Na0.5)TiO3-xBaTiO3 (BNT-BT) system has attracted a great deal of interest because it presents a morphotropic phase boundary (MPB) between the rhombohedral and tetragonal phases for 0.05 < x < 0.08. Identifying the MPB in the BNT-BT system often results in materials exhibiting a high-symmetry (pseudo)cubic x-ray diffraction pattern. However, this singular composition exhibits ferroelectricity, which has been explained as a consequence of a field-induce phase transformation. Here, we demonstrate that the stress release after poling, from the virgin state of the sample, is a crucial phenomenon to obtain piezoelectric response in MPB BNT-BT. The mechanism behind the unusual poling–depoling process in piezoceramics exhibiting high-symmetry MPB is elucidated by combining x-ray diffraction measurements and advanced Raman spectroscopy. This underscores the importance of post-poling stress release from the virgin state as a critical factor in attaining piezoelectric response in lead-free piezoceramics with high-symmetry MPB configurations.
- 27 January 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 126 (4)
Stress release-induced piezoresponse in lead-free piezoceramics with high-symmetry morphotropic phase boundary
The (1 − x)(Bi0.5Na0.5)TiO3-xBaTiO3 (BNT-BT) system has attracted a great deal of interest because it presents a morphotropic phase boundary (MPB) between the rhombohedral and tetragonal phases for 0.05 < x < 0.08. Identifying the MPB in the BNT-BT system often results in materials exhibiting a high-symmetry (pseudo)cubic x-ray diffraction pattern. However, this singular composition exhibits ferroelectricity, which has been explained as a consequence of a field-induce phase transformation. Here, we demonstrate that the stress release after poling, from the virgin state of the sample, is a crucial phenomenon to obtain piezoelectric response in MPB BNT-BT. The mechanism behind the unusual poling–depoling process in piezoceramics exhibiting high-symmetry MPB is elucidated by combining x-ray diffraction measurements and advanced Raman spectroscopy. This underscores the importance of post-poling stress release from the virgin state as a critical factor in attaining piezoelectric response in lead-free piezoceramics with high-symmetry MPB configurations.
- Open Access
- 27 December 2024
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 13 (7) , 3578-3586
High performance BaTiO3–SrTiO3 ceramics with refined microstructure obtained by current-controlled reactive flash sintering of mixed powders
Current-controlled flash sintering has been demonstrated to be a powerful tool for microstructural engineering in dielectric materials, providing new pathways for developing energy-efficient storage systems through enhanced electrical homogeneity.
- 27 December 2024
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 13 (7) , 3578-3586
Open AccessHigh performance BaTiO3–SrTiO3 ceramics with refined microstructure obtained by current-controlled reactive flash sintering of mixed powders
Current-controlled flash sintering has been demonstrated to be a powerful tool for microstructural engineering in dielectric materials, providing new pathways for developing energy-efficient storage systems through enhanced electrical homogeneity.
- 22 May 2024
- Published by Elsevier in Applied Materials Today
- Vol. 38
Optical control of elasticity in ferroelectrics
- 22 May 2024
- Published by Elsevier in Applied Materials Today
- Vol. 38
Optical control of elasticity in ferroelectrics