PVPegah Mirzadeh Vaghefi

Pegah Mirzadeh Vaghefi

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Pegah Mirzadeh Vaghefi has a total of 37 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Preparation, Stability and Local Piezoelectrical Properties of P(VDF-TrFE)/Graphene Oxide Composite Fibers

    by Maxim Silibin, Dmitry Karpinsky, Vladimir Bystrov, Dzmitry Zhaludkevich, Marina Bazarova, P. Mirzadeh Vaghefi, P. A. A. P. Marques, Budhendra Singh, Igor Bdikin

    The unprecedented attributes such as biocompatibility and flexibility of macromolecular piezoelectric polymer has triggered an immense interested in scientific society for their potential exploitation in implantable electronic devices. In the present article, a theoretical and experimental investigation is done to explore the polarization behavior of composite fibers based on copolymer poly-trifluoroethylene P(VDF-TrFE) and graphene oxide (GO) with varying composition of the components is explored for its possible application in bioelectronic devices. Electromechanical properties of the PVDF/GO nanofibers were investigated using piezoresponse force microscopy (PFM) method. The switching behavior, charge states, and piezoelectric response of the fibers were found to depend on the concentration of GO up to 20%. Theoretical models of PVDF chains, interacting with Graphene/GO layers has been used to explore the evolution of piezoresponse in the composite fibers. In order to compute piezoelectric coefficients, the behavior of composite in electrical fields has been modeled using software HyperChem. The experimental results are qualitatively correlated with a computed theoretical model.


  • Open Access

    Giant Strain and Induced Ferroelectricity in Amorphous BaTiO3 Films under Poling

    by Pegah Mirzadeh Vaghefi, Ali Baghizadeh, Armando A.C.S. Lourenço, Vitor S. Amaral, Andre L. Kholkin

    We report an effect of giant surface modification of a 5.6 nm thick BaTiO3 film grown on Si (100) substrate under poling by conductive tip of a scanning probe microscope (SPM). The surface can be locally elevated by about 9 nm under −20 V applied during scanning, resulting in the maximum strain of 160%. The threshold voltage for the surface modification is about 12 V. The modified topography is stable enough with time and slowly decays after poling with the rate ~0.02 nm/min. Strong vertical piezoresponse after poling is observed, too. Combined measurements by SPM and piezoresponse force microscopy (PFM) prove that the poled material develops high ferroelectric polarization that cannot be switched back even under an oppositely oriented electric field. The topography modification is hypothesized to be due to a strong Joule heating and concomitant interface reaction between underlying Si and BaTiO3. The top layer is supposed to become ferroelectric as a result of local crystallization of amorphous BaTiO3. This work opens up new possibilities to form nanoscale ferroelectric structures useful for various applications.


  • Thickness dependence of microstructure in thin La 0.7 Sr 0.3 MnO 3 films grown on (1 0 0) SrTiO 3 substrate

    by P Mirzadeh Vaghefi, A Baghizadeh, M-G Willinger, M J Pereira, D A Mota, B G Almeida, J Agostinho Moreira, V S Amaral

    This study investigates the nanostructure of perovskite thin films, and its influence on magnetic properties. Epitaxial thin films of perovskite L a 0.7 S r 0.3 MnO 3 with thickness ranging from 13.5 nm to 320 nm were deposited on SrTiO 3 (1 0 0) substrates using pulsed laser deposition techniques. X-ray diffraction, along with high-resolution transmission electron microscopy (HRTEM) investigations were carried out, and showed the presence of a second, La-rich phase in thick film. Scanning electron microscopy analysis showed thinner films to have smooth surfaces, while thicker films presented large triangular shapes emerging out of the film surface. Also HRTEM images revealed epitaxial growth for thinner films. Thicker films grow with numerous misfit dislocations leading to columnar structure, where the thickest film presents branched structure with an intermediate La-rich layer. Lattice mismatch, diffusion of Mn ions into the substrate and substituting Ti ions are known as sources of strain in films near interfaces. Magnetic properties in the structure mentioned are described by double-exchange interaction, which is very sensitive to local structure. Hence, the nanostructure of films reported here has a remarkable effect on their magnetic properties.


  • Development of ferroelectric domains and topological defects in vacancy doped ceramics of h-LuMnO3

    by A. Baghizadeh, J. M. Vieira, P. Mirzadeh Vaghefi, M.-G. Willinger, V. S. Amaral

    Self-doping of the h-LuMnxO3±δ (0.92 ≤ x ≤ 1.12) phase and changes in the sintering time are applied to investigate the formation and annihilation of antiphase ferroelectric (FE) domains in bulk ceramics. The increase in the annealing time in sintering results in growth of FE domains, which depends on the type of vacancy, 6-fold vortices with dimensions of the order of 20 μm being observed. Interference of planar defects of the lattice with the growth of topological defects shows breaking of 6-fold symmetry in the self-doped ceramics. The role of grain boundaries in the development of topological defects has been studied. Dominance of the atypical FE domain network in very defective h-LuMnxO3±δ lattices saturated with Mn vacancies (x < 1) was also identified in the current study. After a long annealing time, scattered closed-loops of nano-dimensions are often observed isolated inside large FE domains with opposite polarization. Restoring of the polarization after alternative poling with opposite electrical fields is observed in FE domains. Stress/strain in the lattice driven by either planar defects or chemical inhomogeneity results in FE polarization switching on the nanoscale and further formation of nano-vortices, with detailed investigation being carried out by electron microscopy. Pinning of FE domains to planar defects is explored in the present microscopy analysis, and nano-scale observation of lattices is used to explain features of the ferroelectricity revealed in Piezo Force Microscopy images of the ceramics.


  • Interaction of multiferroic properties and interfaces in hexagonal LuMnO 3 ceramics

    by A Baghizadeh, J M Vieira, D G Stroppa, P Mirzadeh Vaghefi, M P Graça, J S Amaral, M-G Willinger, V S Amaral

    A study on the underlying interaction mechanisms between lattice constants, magnetic and dielectric properties with inhomogeneities or internal interfaces in hexagonal, off-stoichiometric LuMnO 3 oxide is presented. By increasing Mn content the a -axis constant and volume of the unit cell, the antiferromagnetic (AFM) Néel temperature, T N , and frustration factor of the frustrated Mn 3+ trimmers in basal plane show decreasing trends. It was found that increasing the annealing time improves the properties of the lattices and progressively eliminates secondary phases for compositions within the solid solution stability limits. A magnetic contribution below T N is observed for all samples. Two regimes of magnetization below and above 45 K were observed in the AFM state. The magnetic contribution below T N is assigned to either the secondary phase or internal interfaces like ferroelectric (FE) domain walls. Magneto-dielectric coupling at T N is preserved in off-stoichiometric ceramics. The presence of a low temperature anomaly of the dielectric constant is correlated to the composition of the solid solution in off-stoichiometric ceramics. Large FE domains are observed in piezoresponse force microscopy (PFM) images of doped and un-doped ceramics, whereas atomic structure analysis indicates the parallel formation of nano-sized FE domains. A combination of measured properties and microscopy images of micron- and nano-sized domains ascertain the role of lattice distortion and stability of solid solution on multiferroic properties.


  • Peculiar Magnetoelectric Coupling in BaTiO3:Fe113 ppm Nanoscopic Segregations

    by C. O. Amorim, F. Figueiras, J. S. Amaral, P. Mirzadeh Vaghefi, P. B. Tavares, M. R. Correia, A. Baghizadeh, E. Alves, J. Rocha, V. S. Amaral

    We report polycrystalline BaTiO3 with cooperative magnetization behavior associated with the scarce presence of about 113 atomic ppm of Fe ions, clearly displaying magnetoelectric coupling with significant changes in magnetization (up to ΔM/M ≈ 32%) at the ferroelectric transitions. We find that Fe ions are segregated mostly at the interfaces between grain boundaries and an Fe-rich phase, forming a self-composite with high magnetoelectric coupling above room temperature. We compare our results with ab initio calculations and other experimental results found in the literature, proposing mechanisms that could be behind the magnetoelectric coupling within the ferroelectric matrix. These findings open the way for further strategies to optimize interfacial magnetoelectric couplings.


  • Unravelling the effect of SrTiO3antiferrodistortive phase transition on the magnetic properties of La0.7Sr0.3MnO3thin films

    by D A Mota, Y Romaguera Barcelay, A M R Senos, C M Fernandes, P B Tavares, I T Gomes, P Sá, L Fernandes, B G Almeida, F Figueiras, et al.