FUFaruk Uysal

Faruk Uysal

*This is an algorithmically generated author record based on publicly available information.

Faruk Uysal has a total of 66 co-authors. Here are the top co-authors by number of shared publications:

  • Alexander Yarovoy

    Group of Microwave Sensing, Signals and Systems (MS3), Delft University of Technology, 2628CD Delft, The Netherlands

    3 shared publications
  • Ivan W. Selesnick

    Department of Electrical and Computer Engineering, Tandon School of Engineering, New York University, Brooklyn, NY, USA

    3 shared publications
  • Vinay Murthy

    C&P Technologies, Inc. (United States)

    3 shared publications
  • Alexandar Yarovoy

    Faculty of Electrical Engineering, Mathematics and Computer Science Delft University of Technology 2600 AA Delft Netherlands

    2 shared publications
  • Braham Himed

    AFRL/RYMD, Dayton, OH 45433 USA

    2 shared publications
  • Mark Yeary

    School of Electrical and Computer Engineering, University of Oklahoma, Norman, Oklahoma

    2 shared publications

Latest Publications

  • Open Access

    Few‐shot learning for satellite characterisation from synthetic inverse synthetic aperture radar images

    by Friso G. Heslinga, Faruk Uysal, Sabina B. van Rooij, Sven Berberich, Miguel Caro Cuenca

    Space situational awareness systems primarily focus on detecting and tracking space objects, providing crucial positional data. However, understanding the complex space domain requires characterising satellites, often involving estimation of bus and solar panel sizes. While inverse synthetic aperture radar allows satellite visualisation, developing deep learning models for substructure segmentation in inverse synthetic aperture radar images is challenging due to the high costs and hardware requirements. The authors present a framework addressing the scarcity of inverse synthetic aperture radar data through synthetic training data. The authors approach utilises a few‐shot domain adaptation technique, leveraging thousands of rapidly simulated low‐fidelity inverse synthetic aperture radar images and a small set of inverse synthetic aperture radar images from the target domain. The authors validate their framework by simulating a real‐case scenario, fine‐tuning a deep learning‐based segmentation model using four inverse synthetic aperture radar images generated through the backprojection algorithm from simulated raw radar data (simulated at the analogue‐to‐digital converter level) as the target domain. The authors results demonstrate the effectiveness of the proposed framework, significantly improving inverse synthetic aperture radar image segmentation across diverse domains. This enhancement enables accurate characterisation of satellite bus and solar panel sizes as well as their orientation, even when the images are sourced from different domains.


  • Open Access

    Long baseline bistatic radar imaging of tumbling space objects for enhancing space domain awareness

    by Alexander Serrano, Alexander Kobsa, Faruk Uysal, Delphine Cerutti‐Maori, Selenia Ghio, Andrew Kintz, Robert L. Morrison, Sarah Welch, Philip van Dorp, Gregory Hogan, et al.

    Long baseline bistatic radar systems herald enhanced sensitivity and metric accuracy for space objects in geosynchronous orbits and beyond. Radio telescopes are ideal participants in such a system; in particular, they often feature large apertures with low‐noise temperatures and have stable, synchronised clocks. Pairing radio telescopes with high‐power radars creates new methodologies for Space Domain Awareness. This paper describes long baseline bistatic measurements using the Millstone Hill Radar in the USA, the Tracking and Imaging Radar in Germany, multiple receivers of the enhanced multi‐element remotely linked interferometer network array in the United Kingdom, and the Westerbork Synthesis Radio Telescope in the Netherlands. The authors, a Research Task Group formed by the NATO Science and Technology Organisation Sensors and Electronic Technology Panel (SET‐293), performed novel bistatic and monostatic radar imaging experiments with real on‐orbit tumbling rocket bodies. These experiments on tumbling objects at near‐geosynchronous orbits highlight successful demonstrations of advanced bistatic Doppler characterisation across diverse imaging geometries. Specialised Doppler processing on tumbling targets, such as the Doppler superpulse algorithm, enables high‐fidelity rotation period estimation and determination of minimum target size.


  • Motion Estimation and Improved SAR Imaging for Agile Platforms Using Omnidirectional Radar and INS Sensor Fusion

    by Keith T. J. Klein, Faruk Uysal, Miguel Caro Cuenca, Matern P. G. Otten, Jacco J. M. de Wit

    Accurate motion estimation is a challenging problem for agile radar platforms, even when state of the art Inertial Navigation Sensors (INSs) are used. However, it is an important problem to solve as it can have a large impact on the performance of radar modes such as Synthetic Aperture Radar (SAR). This study addresses the motion estimation problem of agile radar platforms from the perspective of an omnidirectional radar array. In this study, we perform an analysis on the applicability of an omnidirectional radar array to explicitly estimate the motion of an agile SAR platform and improve imaging quality. Building on existing 1D SAR motion compensation techniques, we develop a method to estimate the 3D motion of the radar platform utilizing its height and velocity vector. Using a prototype radar developed at TNO, we experimentally verify that using the proposed velocity estimation method alone, we achieve comparable positioning performance to that of a state-of-the-art INS, making it possible to perform INS-free SAR imaging by using arbitrary flight paths. We also show that fusing the radar positioning estimates obtained from the proposed methods with the INS output yields an additional increase in SAR imaging performance, improving the resolvability and detectability of weak targets.


  • Unambiguous Recovery of Multistatic SAR Data for Nonzero Cross Track Baseline Case

    by Ozan Dogan, Faruk Uysal, Paco Lopez Dekker

    A wide-swath synthetic aperture radar (SAR) image is known to be achievable by merging multistatic aliased data that is collected with an appropriate along-track displacement. However, in terms of both flexibility requirements like potentiality of both along-track and cross-track (XT) interferometry and design requirements like orbital safety, etc., a XT baseline is not only demanded but also unavoidable. In this work, a method is proposed in order to merge SAR data to recover the Doppler spectrum unambiguously for the nonzero XT baseline case. The algorithm is compared and validated by simulating an azimuth invariant multistatic SAR satellite constellation. The results are promising in terms of dealing with XT baselines.


  • Top Cited Papers

    Phase-Coded FMCW Automotive Radar: System Design and Interference Mitigation

    by Faruk Uysal

    A frequency-modulated continuous-wave (FMCW) radar takes advantage of stretch processing (dechirping, deramping) to reduce the sampling requirements of radar systems such as automotive radars. When applying phase coding into FMCW radar systems for interference mitigation or joint communication, preservation of this benefit is not possible, due to the nature of this process. This paper proposes a new phase coded FMCW system as well as a processing strategy based on a group-delay filter to deal with unaligned phase-coded radar return signals. Moreover, this paper proposes an improved interference mitigation method based on a phase-coded linear- frequency-modulated (LFM) continuous waveform and points out the improvements in the signal-to-interference ratio (SIR). In the proposed mitigation technique, unlike the traditional approach where RF spectrum spreads, the beat frequency spectrum of the FMCW radar spreads, thus the bandwidth of RF hardware stays the same as a classical LFM continuous wave radar. The success of the proposed phase coded frequency-modulated continuous-wave (PC-FMCW) radar is illustrated in simulations and increased interference mitigation performance is validated by experiments.


  • Doppler Influence on Waveform Orthogonality in 79 GHz MIMO Phase-Coded Automotive Radar

    by Jeroen Overdevest, Feike Jansen, Faruk Uysal, Alexander Yarovoy

    Utilization of phase-coded waveforms in automotive MIMO radars for short to medium range applications is studied. Performances of three most-promising binary code families (Gold, APAS and ZCZ sequences) are compared. Design tradeoffs of practical implementation of phased-coded waveforms for MIMO radar are analyzed for the first time for a possible future System on Chip implementation. Orthogonality of the waveforms in case of moving targets is analyzed. The implications of the code properties for the Range-Doppler map, as well as the Range-Angular map, are pointed out. Doppler frequency shift impact on such performance indicators as the target peak power and range sidelobe levels in the range-Doppler plane, as well as the range and azimuth sidelobe behavior, and the angular error in the azimuthal plane have been comprehensively studied for the first time. It is shown that the time staggered transmit scheme with autocorrelation properties only (while introducing azimuthal errors) results in improved performance compared to code division multiplexing with auto- and cross-correlation properties.


  • Reconfigurable Range-Doppler Processing and Range Resolution Improvement for FMCW Radar

    by Sharef Neemat, Faruk Uysal, Oleg Krasnov, Alexander Yarovoy

    A reconfigurable range-Doppler processing method for FMCW radar is presented. By concatenating beat-frequency signals from more than one sweep, a continuous beat-frequency signal for the whole coherent processing interval (CPI) can be created. As a result, continuous targets’ observation time is extended beyond that of a single chirp duration, leading to range resolution improvement. The created continuous beat-frequency signal can be split in the digital domain to any two-dimensional slow-time fast-time matrices with the same number of elements as in the original signals, which offers a realization of a software defined pulse/sweep repetition rate in Range-Doppler processing. The signal concatenation is done in the Short-time Fourier Transform (STFT) domain, where beat-frequency slices are extrapolated to compensate for the observation time lost in the transient region between sweeps, then a phase correction is applied to each frequency-slice as appropriate, followed by an Inverse STFT (ISTFT). The proposed technique is verified with simulation and experiments with an FMCW radar for stable and moving target scenarios. We found that the method allows for range resolution improvement without the transmission of additional bandwidth, and allows for the ability to observe different resolution granularities in parallel from one CPI. It additionally allows the decoupling of the transmitted PRF from the Doppler processing PRF, permitting the facility to observe different unambiguous Doppler velocity intervals from one CPI, without compromising on the total CPI processing gain.


  • Wind Turbine Clutter Mitigation via Nonconvex Regularizers and Multidimensional Processing

    by Yinan Hu, Faruk Uysal, Ivan Selesnick

    This paper generalizes a previous formulation of signal separation problem for dynamic wind turbine clutter mitigation at weather radar systems. In this modified formulation, we use nonconvex regularizers together with multichannel overlapping group shrinkage (MOGS) to penalize weather signals and adopt multidimensional processing. We show the restored weather signals in plan position indicator (PPI) format and, to demonstrate the improvement, compare them with the ones produced by the previous method in reflectivity, spectral width, and Doppler velocity estimates of weather data. The improvement results from a better characterization of the sparsities of the weather radar returns. During the course of experiments, we observe that the proposed method successfully mitigates the wind turbine clutter and dramatically increases the signal-to-clutter ratio, even for different weather and wind turbine signatures. In addition, when the wind turbine clutter is weak in the mixture, our algorithm manages to attenuate the ground clutters and produces clutter-free weather signals favorable for further processing.


  • Accurate Target Localization for Automotive Radar

    by Faruk Uysal, Pascal J. Aubry, Alexander Yarovoy

    Automotive radars suffer from low angular estimation accuracy due to the limited number of antennas and insufficient onboard processing power. This paper addresses the single target tracking problem in automotive radar by using recently proposed MIMO-monopulse approach which blends the monopulse approach with the collocated MIMO radar. We demonstrate and compare the localization performance of the MIMO-monopulse at an automotive radar on a real-world scenario. Experiments show that MIMO-monopulse results in a better angular accuracy comparing to the conventional digital beamforming even though the low-level processing power.