KCKwong-Kit Choi

Kwong-Kit Choi

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Kwong-Kit Choi has a total of 87 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Broadband omnidirectional antireflection (AR) coating based on inverse transfer design towards high efficiency photovoltaic cells

    by Patrick Oduor, Varun Menon, Zunaid Omair, Kwong-Kit Choi, Achyut K. Dutta

    The solar spectrum reaching Earth spans from ultraviolet to infrared wavelengths with a cutoff at around 2.5 μm. About 30% of the irradiance is absorbed by the atmosphere, and the rest is absorbed by the Earth's surface. The radiance available for generating renewable energy ranges from 400 nm to 2.0 μm. Silicon and III-V materials are used for photovoltaic (PV) cells. The PV cells reflect 30% of incoming radiation and to reduce this reflection, antireflection coating (ARC) is being used. Conventional techniques such as single or stacked multi-layer ARC or micro-nanostructures ARC are used. However, they lack in providing broadband and omnidirectional transmission, which limits its conversion efficiency in today’s PV cells. We present broadband ARC achieved with an inverse transfer design, a prospect towards significantly high conversion efficiency PV cells. The ARC exhibit significantly increased transmission more than 96% over the solar spectrum ranges up to 2.5 μm, even with wide angles of incidence from ~ 0° to >70°. This transmission over the same angles of incidence, is significantly higher than that of ARC based on quarter-wavelength optical thickness (QWOT), a state-of-art ARC. The results also rival the transmission performance of state-of-the-art nanostructure-based ARC even at large angles of incidence, but are significantly easier to fabricate using standard e-beam evaporation and/or sputtering. The results show over broadband spectrum ranges, radiation back due to reflection makes to zero, leading to significantly increased conversion efficiency of the PV cells.


  • Fast, computationally efficient inverse design of thin films for reflection and transmission

    by Zunaid Omair, Varun Menon, Kwong-Kit Choi, Patrick Oduor, Achyut K. Dutta

    Multilayer optical coatings are used to control the reflection, transmission, and absorption of light in a variety of applications. However, the design of these coatings is a challenging and computationally expensive task. In this article, we present an inverse-design method that provides an efficient and automated way to design one-dimensional optical coatings with superior optical properties. Our approach involves starting with a desired optical response and working backward to determine the optimal coating structure that can achieve that response. To accomplish this, we define a figure of merit (FOM) that maximizes the reflection or transmission within a desired spectral range and polarization. We identify the design variables, calculate the derivatives of the FOM, and iteratively update the thickness of each layer until the desired FOM is achieved. Our method applies to a broad variety of one-dimensional optical coatings, and we demonstrate its effectiveness by designing broadband mirrors and anti-reflection coatings. Our results show that the optimized structures outperform the initial fixed-thickness structures, highlighting the potential of inverse design to simplify the design and fabrication of complex multilayer optical coatings with greater precision and efficiency.

  • Silicon meta-APD integrated with InGaAsP meta-emitter for near-infrared (NIR) for active imaging and LIDAR

    by Kwong-Kit Choi, Patrick Oduor, Achyut K. Dutta

    The detection of Nd: YAG laser emission at 1.064 microns is important for a number of applications such as active infrared imaging and space LIDAR. We propose a silicon avalanche photodiode (APD) based on micro-scaled photonic metastructures. In one approach, the metastructure contains a hexagonal hole array filled with SiO2 to yield optical diffraction and trapping. With 3D electromagnetic modeling, we optimize the array dimensions and yield 26.0% theoretical absorption at 1.064 microns. It is 59 times larger than that of the planar structure with an additional 18% dark current reduction. In another approach, the metastructure contains a ring array fabricated on the top contact layer to excite localized surface plasmons. The theoretical QE is 52 times larger and the dark current is 8.6 times lower. In addition to active imaging and LIDAR, the present meta-APD designs are also useful for broadband passive imaging, in which Ip/Id can be improved by 3.9 and 8.7 times, respectively. The ring metastructure can also be integrated with an InGaAsP light emitting diode to produce coherent, directional emission at 1.064 micron to further improve SWaP in active applications.


  • Resonant Thermal Emitters and PV Cells for Thermophotovoltaic Power Generation

    by Kwong-Kit Choi, Zunaid Omair, Patrick Oduor, Achyut K. Dutta

    A thermophotovoltaic (TPV) power generation system based on resonator-pixel (RP) emitters and photovoltaic (PV) cells is proposed. The RP structure enables wavelength-selective emission and absorption, which increases the system power throughout and efficiency. An RP structure contains a thin semiconductor material etched into an array of micron-sized rings and covered with a metal layer. The emissivity of the RP emitter is determined by equating it to absorptivity and is modeled by three-dimensional electromagnetic modeling. The result shows that the emitter is able to increase the wavelength selectivity by eight times compared to a bulk emitter. Integrated with an RP PV cell having enhanced absorption at the band edge, the power conversion efficiency can be maintained constant in a wide range of temperatures, while the power throughput increases by 1.7 times. In addition, the RP emission is highly directional. Its far-field beamwidth is less than 10°, with which the emitter and PV cell can be placed at a larger distance to avoid convectional heating on the PV cell. In this work, we also confirm a near-field TPV effect that raises the electrical power by a factor of 2 when the emitter and cell are placed less than 2 μ m apart.

  • Resonant InGaAs Detectors and Emitters for Passive and Active Imaging Application

    by Kwong-Kit Choi, Patrick Oduor, Nibir K. Dhar, Achyut K. Dutta

    In this work, we design an InGaAs avalanche photodiode (APD) with a higher photocurrent to dark current ratio than a conventional APD. The improvement is based on optical confinement in an optical resonator, which increases the optical intensity in the detector volume and thus its quantum efficiency. With optical confinement, the absorbing layer can be 20 times thinner than the conventional APD, reducing the intrinsic generation-recombination dark current by the same amount and still be able to produce 90.9% of the photocurrent. The photocurrent to intrinsic dark current ratio can thus be increased theoretically by 18.2 times in concomitant with a lower operating voltage. Higher photocurrent can also be obtained using a thicker absorber. Besides APDs, the optical resonator structure can also be applied to p-i-n photodiodes for similar improvement. To further increase the detection sensitivity, we design an efficient InGaAsP light emitting diode (LED) having a similar resonator geometry. The resonator geometry enables more collimated emission and increases the optical power theoretically by more than 36 times compared to a conventional LED. Integrating the resonant APD and LED together will yield a powerful SWIR transceiver for various low light, LIDAR, and 3-dimensional imaging applications.


  • Remote temperature sensing by the compact thermal imager from the International Space Station

    by Kwong-Kit Choi, Murzy Jhabvala, Donald Jennings, Kyle Turck, Anh La, Dong Wu, Tilak Hewagama, Thomas Holmes, Thomas Flatley, Analia Cillis, et al.

    A systematic calibration approach is presented to correlate the digital output of an infrared camera and the scene temperature. Aided by the optoelectronic properties of the camera, as few as two experimental data points are needed to establish this correlation. This approach can readily include the effects of atmospheric transmission, scene emissivity, and different background subtractions. Hence, the temperature conversion in flight can be reliably obtained from laboratory calibration. The conversion function can also be used to identify the camera’s thermal sensitivity and temperature resolution, which are important information in different space missions. In applying this calibration procedure to a laboratory camera and the compact thermal imager onboard the International Space Station, its validity is confirmed.


  • Open Access

    Compact Thermal Imager (CTI) for Atmospheric Remote Sensing

    by Dong L. Wu, Donald E. Jennings, Kwong-Kit Choi, Murzy D. Jhabvala, James A. Limbacher, Thomas Flatley, Kyu-Myong Kim, Anh T. La, Ross J. Salawitch, Luke D. Oman, et al.

    The demonstration of a newly developed compact thermal imager (CTI) on the International Space Station (ISS) has provided not only a technology advancement but a rich high-resolution dataset on global clouds, atmospheric and land emissions. This study showed that the free-running CTI instrument could be calibrated to produce scientifically useful radiance imagery of the atmosphere, clouds, and surfaces with a vertical resolution of ~460 m at limb and a horizontal resolution of ~80 m at nadir. The new detector demonstrated an excellent sensitivity to detect the weak limb radiance perturbations modulated by small-scale atmospheric gravity waves. The CTI’s high-resolution imaging was used to infer vertical cloud temperature profiles from a side-viewing geometry. For nadir imaging, the combined high-resolution and high-sensitivity capabilities allowed the CTI to better separate cloud and surface emissions, including those in the planetary boundary layer (PBL) that had small contrast against the background surface. Finally, based on the ISS’s orbit, the stable detector performance and robust calibration algorithm produced valuable diurnal observations of cloud and surface emissions with respect to solar local time during May–October 2019, when the CTI had nearly continuous operation.


  • High Performance Infrared Photodetectors and Energy Harvesting Devices Based on Micro-Scaled Photonics Structures

    by Kwong-Kit Choi, Achyut K. Dutta, Nibir K. Dhar

    For mid-wave infrared detectors, we designed a meta-surface to enhance quantum efficiency (QE) across 2 to 6 microns. The relative enhancement depends on the intrinsic absorption coefficient α of the material. If α is large at 2×104/cm, a 0.1 micron-thick meta-detector can yield a peak QE of 90%, which is 2.6 times higher than the conventional detector. The improvement is larger with a smaller α. When it is 2000/cm, the improvement is about 10 times with a peak QE of 49%. For energy harvesting devices, we designed several nanostructures etched on top of silicon solar cells to enhance their absorption. Employing an array of nano-columns increases absorption from 55% to 97% at 0.7 microns and from 5.0% to 37% at 1.0 microns. An array of nano-cones further increases the average absorption to 95% between 0.4 to 0.8 microns. The overall integrated absorption is increased by 74% for nano-columns and 92% for nano-cones. For GaAs solar cells, a metasurface can improve photocurrent by 26% from a planar solar cell with a 100 nm-thick absorber.


  • Dielectric Resonator Antenna-Coupled Antimonide-Based Detectors (DRACAD) for the Infrared

    by Jordan Budhu, Nicole A. Pfiester, Kwong-Kit Choi, Steve Young, Christopher Ball, Sanjay Krishna, Anthony Grbic

    In an infrared photodetector, noise current (dark current) is generated throughout the volume of the detector. Reducing the volume will reduce dark current, but the corresponding smaller area will also reduce the received signal. By using a separate antenna to receive light, one can reduce the detector area without reducing the signal, thereby increasing its signal-to-noise ratio (SNR). Here, we present a dielectric resonator antenna (DRA)-coupled infrared photodetector. Its performance is compared to a conventional resonant cavity-enhanced slab detector. The noise equivalent power (NEP) is used as a figure of merit for the comparison. Formulas for the NEP are derived for both cases. A pBp photodiode detector is assumed in the comparison. The active region of the photodiode is an InAs/GaSb Type II Superlattice (T2SL). A Genetic Algorithm is used to optimize the dimensions of the detector and the DRA to achieve the smallest NEP. The result is a photodetector that converts over 85% of the incident light into carriers with a volume reduced by 95%. This optimal geometry leads to an NEP reduced by 6.02 dB over that of the conventional resonant cavity-enhanced slab detector.


  • Open Access

    Infrared Digital Focal Plane Arrays for Earth Remote Sensing Instruments

    by Sarath Gunapala, Sir Rafol, David Ting, Alexander Soibel, Arezou Khoshakhlagh, Sam Keo, Brian Pepper, Anita Fisher, Cory Hill, Edward Luong, et al.

    In this presentation, we will discuss the advantages of using an in-pixel digital read out integrated circuit and type-II strained layer superlattice detector array technology to elevate the operating temperature of the focal plane array for Earth remote sensing instruments.