Ching-Ju Monica Chin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Ching-Ju Monica Chin has a total of 43 co-authors. Here are the top co-authors by number of shared publications:
- Costas Tsouris
Manufacturing Science Division, Oak Ridge National Laboratory, Oak Ridge, USA
7 shared publications Sotira Yiacoumi
Georgia Institute of Technology, 311 Ferst Drive, Atlanta, Georgia 30332-0512, USA
6 shared publicationsChihpin Huang
3 shared publicationsJill R. Pan
3 shared publicationsJr-Lin Lin
Institute of Environmental Engineering, National Chiao-Tung University, Hsinchu Taiwan
3 shared publications- Chiung-Fen Chang
Department of Environmental Science and Engineering, Tunghai University, Taichung, Taiwan
2 shared publications
Latest Publications
- 15 April 2019
- Published by IWA Publishing in Water Science & Technology
- Vol. 79 (8) , 1541-1549
Adsorption and desorption of crystal violet and basic red 9 by multi-walled carbon nanotubes
Batch adsorption and desorption of crystal violet (CV) and basic red 9 (BR9) on multi-walled carbon nanotubes (MWCNTs) were conducted. To investigate the possible mechanisms of adsorption/desorption hysteresis, oxidized MWCNTs (O-MWCNTs) with more oxygen-containing groups were obtained by oxidizing as-purchased MWCNTs (A-MWCNTs) using nitric acid. The adsorption kinetics could be described by the pseudo-second-order model, suggesting that chemical reactions are the rate-limiting steps. The adsorption isotherms were fitted well by the Langmuir model, which suggests that, in addition to π-π interactions, chemical reactions significantly affect the adsorption. The adsorption capacity decreased in the order of CV on A-MWCNTs, BR9 on A-MWCNTs, and BR9 on O-MWCNTs, possibly because the amidation between BR9 and the surface groups of MWCNTs results in steric hindrance, which limits the adsorption of BR9 to inner grooves between CNT bundles. Adsorption/desorption hysteresis was observed for BR9 but not for CV. It was found that the π − π interaction and molecular entrapment were not responsible for the adsorption/desorption hysteresis. The hysteresis might be caused by the irreversible amide bonds between BR9 and MWCNTs. The results indicate that the steric hindrance due to the three-dimensional structure of organic compounds plays an important role in both adsorption/desorption kinetics and equilibria.
- 15 April 2019
- Published by IWA Publishing in Water Science & Technology
- Vol. 79 (8) , 1541-1549
Adsorption and desorption of crystal violet and basic red 9 by multi-walled carbon nanotubes
Batch adsorption and desorption of crystal violet (CV) and basic red 9 (BR9) on multi-walled carbon nanotubes (MWCNTs) were conducted. To investigate the possible mechanisms of adsorption/desorption hysteresis, oxidized MWCNTs (O-MWCNTs) with more oxygen-containing groups were obtained by oxidizing as-purchased MWCNTs (A-MWCNTs) using nitric acid. The adsorption kinetics could be described by the pseudo-second-order model, suggesting that chemical reactions are the rate-limiting steps. The adsorption isotherms were fitted well by the Langmuir model, which suggests that, in addition to π-π interactions, chemical reactions significantly affect the adsorption. The adsorption capacity decreased in the order of CV on A-MWCNTs, BR9 on A-MWCNTs, and BR9 on O-MWCNTs, possibly because the amidation between BR9 and the surface groups of MWCNTs results in steric hindrance, which limits the adsorption of BR9 to inner grooves between CNT bundles. Adsorption/desorption hysteresis was observed for BR9 but not for CV. It was found that the π − π interaction and molecular entrapment were not responsible for the adsorption/desorption hysteresis. The hysteresis might be caused by the irreversible amide bonds between BR9 and MWCNTs. The results indicate that the steric hindrance due to the three-dimensional structure of organic compounds plays an important role in both adsorption/desorption kinetics and equilibria.
- 1 November 2017
- Published by Elsevier in Process Safety and Environmental Protection
- Vol. 112, 308-314
The role of oxygen-containing groups on the adsorption of bisphenol-A on multi-walled carbon nanotube modified by HNO 3 and KOH
- 1 November 2017
- Published by Elsevier in Process Safety and Environmental Protection
- Vol. 112, 308-314
The role of oxygen-containing groups on the adsorption of bisphenol-A on multi-walled carbon nanotube modified by HNO 3 and KOH
- 1 May 2017
- Published by Elsevier in Chemosphere
- Vol. 175, 76-84
Enhanced electrochemical degradation of ibuprofen in aqueous solution by PtRu alloy catalyst
- 1 May 2017
- Published by Elsevier in Chemosphere
- Vol. 175, 76-84
Enhanced electrochemical degradation of ibuprofen in aqueous solution by PtRu alloy catalyst
- 1 July 2014
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 277, 110-119
Effective anodic oxidation of naproxen by platinum nanoparticles coated FTO glass
- 1 July 2014
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 277, 110-119
Effective anodic oxidation of naproxen by platinum nanoparticles coated FTO glass
- 11 August 2010
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 123-125, 260-263
Synthesis of Magnetic TiO2 Nanoparticles as Bactericidal Photocatalyst
The magnetic photocatalysts can provide both a high specific surface area and an alternative for recovering used catalyst from treated water by the application of a magnetic field. In this study, the Fe3O4 nanoparticles were synthesized by co-precipitation. After chemical co-precipitation of ferric and ferrous solution under alkaline condition, the suspension of magnetite nanoparticles were then mixed with TEOT (Titanium (Ⅳ) ethoxide) for sol-gel coating. The separated MPCs (magnetic photocatalyst nanoparticle) were then dried and calcined in 400oC. Magnetic properties of MPCs were identified by superconducting quantum interference device magnetometer (SQUID). The bactericidal ability of synthesized MPCs was evaluated by counting the residual numbers of E. coli after irradiation under a light intensity of 1.0 mW/cm2 at 365 nm. The results show that the MPCs were both anatase and had good crystallinity with clear peaks and insignificant noises after calcination. The SQUID test also reveals that calcination only affects the magnetic susceptibility of the MPC nanoparticles slightly (< 8%). The bactericidal ability of the synthesized MPCs was compared with the commercial TiO2 nanoparticle DegussaTM P25; P25 provided a faster inactivation rate for E. coli in water than MPCs did at the same dosage. The calculated photocatalytic bactericidal rate by P25 is about 3.6 times faster than that by MPCs synthesized in this work. However, the bactericidal rate of magnetic TiO2 synthesized in this work was 5 times than that of other MPCs in the literature. The particles size and surface area of MPCs from this work were about 135 nm and 210 m2/g, respectively. The MPCs from this work have much smaller size and larger surface area; hence there are more active sites for bactericidal reaction.
- 11 August 2010
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 123-125, 260-263
Synthesis of Magnetic TiO2 Nanoparticles as Bactericidal Photocatalyst
The magnetic photocatalysts can provide both a high specific surface area and an alternative for recovering used catalyst from treated water by the application of a magnetic field. In this study, the Fe3O4 nanoparticles were synthesized by co-precipitation. After chemical co-precipitation of ferric and ferrous solution under alkaline condition, the suspension of magnetite nanoparticles were then mixed with TEOT (Titanium (Ⅳ) ethoxide) for sol-gel coating. The separated MPCs (magnetic photocatalyst nanoparticle) were then dried and calcined in 400oC. Magnetic properties of MPCs were identified by superconducting quantum interference device magnetometer (SQUID). The bactericidal ability of synthesized MPCs was evaluated by counting the residual numbers of E. coli after irradiation under a light intensity of 1.0 mW/cm2 at 365 nm. The results show that the MPCs were both anatase and had good crystallinity with clear peaks and insignificant noises after calcination. The SQUID test also reveals that calcination only affects the magnetic susceptibility of the MPC nanoparticles slightly (< 8%). The bactericidal ability of the synthesized MPCs was compared with the commercial TiO2 nanoparticle DegussaTM P25; P25 provided a faster inactivation rate for E. coli in water than MPCs did at the same dosage. The calculated photocatalytic bactericidal rate by P25 is about 3.6 times faster than that by MPCs synthesized in this work. However, the bactericidal rate of magnetic TiO2 synthesized in this work was 5 times than that of other MPCs in the literature. The particles size and surface area of MPCs from this work were about 135 nm and 210 m2/g, respectively. The MPCs from this work have much smaller size and larger surface area; hence there are more active sites for bactericidal reaction.
- 1 August 2010
- Published by Elsevier in Applied Surface Science
- Vol. 256 (20) , 6035-6039
Adsorption of nonpolar benzene derivatives on single-walled carbon nanotubes
- 1 August 2010
- Published by Elsevier in Applied Surface Science
- Vol. 256 (20) , 6035-6039
Adsorption of nonpolar benzene derivatives on single-walled carbon nanotubes
- 1 September 2009
- Published by Elsevier in Water Research
- Vol. 43 (17) , 4285-4295
The origin of Al(OH)3-rich and Al13-aggregate flocs composition in PACl coagulation
- 1 September 2009
- Published by Elsevier in Water Research
- Vol. 43 (17) , 4285-4295
The origin of Al(OH)3-rich and Al13-aggregate flocs composition in PACl coagulation
- 1 May 2009
- Published by Elsevier in Colloids and Surfaces A: Physicochemical and Engineering Aspects
- Vol. 339 (1-3) , 192-198
Improved coagulation performance using preformed polymeric iron chloride (PICl)
- 1 May 2009
- Published by Elsevier in Colloids and Surfaces A: Physicochemical and Engineering Aspects
- Vol. 339 (1-3) , 192-198
Improved coagulation performance using preformed polymeric iron chloride (PICl)
- 1 November 2008
- Published by Elsevier in Water Research
- Vol. 42 (17) , 4457-4466
Coagulation dynamics of fractal flocs induced by enmeshment and electrostatic patch mechanisms
- 1 November 2008
- Published by Elsevier in Water Research
- Vol. 42 (17) , 4457-4466
Coagulation dynamics of fractal flocs induced by enmeshment and electrostatic patch mechanisms