An He
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
An He has a total of 43 co-authors. Here are the top co-authors by number of shared publications:
Naoki Shikazono
8 shared publicationsJiaming Gong
3 shared publicationsKaihua Su
Institute of Fuel Cell, Shanghai Jiao Tong University, Shanghai 200240, China
3 shared publicationsTakaaki Shimura
3 shared publications- Cun Xue
Northwestern Polytechnical University
2 shared publications Junya Onishi
2 shared publications
Latest Publications
- Open Access
Monolithic Integration of Embedded III-V Lasers on SOI
Silicon photonic integration has gained great success in many application fields owing to the excellent optical device properties and complementary metal-oxide semiconductor (CMOS) compatibility. Realizing monolithic integration of III-V lasers and silicon photonic components on single silicon wafer is recognized as a long-standing obstacle for ultra-dense photonic integration, which can provide considerable economical, energy efficient and foundry-scalable on-chip light sources, that has not been reported yet. Here, we demonstrate embedded InAs/GaAs quantum dot (QD) lasers directly grown on trenched silicon-on-insulator (SOI) substrate, enabling monolithic integration with butt-coupled silicon waveguides. By utilizing the patterned grating structures inside pre-defined SOI trenches and unique epitaxial method via molecular beam epitaxy (MBE), high-performance embedded InAs QD lasers with out-coupled silicon waveguide are achieved on such template. By resolving the epitaxy and fabrication challenges in such monolithic integrated architecture, embedded III-V lasers on SOI with continuous-wave lasing up to 85 oC are obtained. The maximum output power of 6.8 mW can be measured from the end tip of the butt-coupled silicon waveguides, with estimated coupling efficiency of approximately -7.35 dB. The results presented here provide a scalable and low-cost epitaxial method for realization of on-chip light sources directly coupling to the silicon photonic components for future high-density photonic integration.
Open AccessMonolithic Integration of Embedded III-V Lasers on SOI
Silicon photonic integration has gained great success in many application fields owing to the excellent optical device properties and complementary metal-oxide semiconductor (CMOS) compatibility. Realizing monolithic integration of III-V lasers and silicon photonic components on single silicon wafer is recognized as a long-standing obstacle for ultra-dense photonic integration, which can provide considerable economical, energy efficient and foundry-scalable on-chip light sources, that has not been reported yet. Here, we demonstrate embedded InAs/GaAs quantum dot (QD) lasers directly grown on trenched silicon-on-insulator (SOI) substrate, enabling monolithic integration with butt-coupled silicon waveguides. By utilizing the patterned grating structures inside pre-defined SOI trenches and unique epitaxial method via molecular beam epitaxy (MBE), high-performance embedded InAs QD lasers with out-coupled silicon waveguide are achieved on such template. By resolving the epitaxy and fabrication challenges in such monolithic integrated architecture, embedded III-V lasers on SOI with continuous-wave lasing up to 85 oC are obtained. The maximum output power of 6.8 mW can be measured from the end tip of the butt-coupled silicon waveguides, with estimated coupling efficiency of approximately -7.35 dB. The results presented here provide a scalable and low-cost epitaxial method for realization of on-chip light sources directly coupling to the silicon photonic components for future high-density photonic integration.
- 1 December 2020
- Published by Elsevier in Journal of Power Sources
- Vol. 478
Microstructure optimization of porous mixed ionic and electronic conducting cathode for solid oxide fuel cells
- 1 December 2020
- Published by Elsevier in Journal of Power Sources
- Vol. 478
Microstructure optimization of porous mixed ionic and electronic conducting cathode for solid oxide fuel cells
- 1 February 2020
- Published by Elsevier in Journal of Power Sources
- Vol. 449
Optimization of electrode-electrolyte interface structure for solid oxide fuel cell cathode
- 1 February 2020
- Published by Elsevier in Journal of Power Sources
- Vol. 449
Optimization of electrode-electrolyte interface structure for solid oxide fuel cell cathode
- 1 March 2019
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 44 (13) , 6871-6885
Numerical simulation of La0.6Sr0.4Co0.2Fe0.8O3- Gd0.1Ce0.9O1.95 composite cathodes with micro pillars
- 1 March 2019
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 44 (13) , 6871-6885
Numerical simulation of La0.6Sr0.4Co0.2Fe0.8O3- Gd0.1Ce0.9O1.95 composite cathodes with micro pillars
- 1 July 2018
- Published by Elsevier in Mechanics Research Communications
- Vol. 91, 19-26
The position dependence of fracture behavior in a superconductor/ferromagnetic bilayer strip
- 1 July 2018
- Published by Elsevier in Mechanics Research Communications
- Vol. 91, 19-26
The position dependence of fracture behavior in a superconductor/ferromagnetic bilayer strip
- 1 May 2018
- Published by Elsevier in Journal of Power Sources
- Vol. 385, 91-99
Three dimensional electrochemical simulation of solid oxide fuel cell cathode based on microstructure reconstructed by marching cubes method
- 1 May 2018
- Published by Elsevier in Journal of Power Sources
- Vol. 385, 91-99
Three dimensional electrochemical simulation of solid oxide fuel cell cathode based on microstructure reconstructed by marching cubes method
- Open Access
- 9 April 2018
- Published by American Physical Society (APS) in Physical Review B
- Vol. 97 (13) , 134506
Tunable artificial vortex ice in nanostructured superconductors with a frustrated kagome lattice of paired antidots
Theoretical proposals for spin-ice analogs based on nanostructured superconductors have suggested larger flexibility for probing the effects of fluctuations and disorder than in the magnetic systems. In this paper, we unveil the particularities of a vortex ice system by direct observation of the vortex distribution in a kagome lattice of paired antidots using scanning Hall probe microscopy. The theoretically suggested vortex ice distribution, lacking long-range order, is observed at half matching field (). Moreover, the vortex ice state formed by the pinned vortices is still preserved at . This unexpected result is attributed to the introduction of interstitial vortices at these magnetic-field values. Although the interstitial vortices increase the number of possible vortex configurations, it is clearly shown that the vortex ice state observed at is less prone to defects than at . In addition, the nonmonotonic variations of the vortex ice quality on the lattice spacing indicates that a highly ordered vortex ice state cannot be attained by simply reducing the lattice spacing. The optimal design to observe defect-free vortex ice is discussed based on the experimental statistics. The direct observations of a tunable vortex ice state provides new opportunities to explore the order-disorder transition in artificial ice systems.- 9 April 2018
- Published by American Physical Society (APS) in Physical Review B
- Vol. 97 (13) , 134506
Open AccessTunable artificial vortex ice in nanostructured superconductors with a frustrated kagome lattice of paired antidots
Theoretical proposals for spin-ice analogs based on nanostructured superconductors have suggested larger flexibility for probing the effects of fluctuations and disorder than in the magnetic systems. In this paper, we unveil the particularities of a vortex ice system by direct observation of the vortex distribution in a kagome lattice of paired antidots using scanning Hall probe microscopy. The theoretically suggested vortex ice distribution, lacking long-range order, is observed at half matching field (). Moreover, the vortex ice state formed by the pinned vortices is still preserved at . This unexpected result is attributed to the introduction of interstitial vortices at these magnetic-field values. Although the interstitial vortices increase the number of possible vortex configurations, it is clearly shown that the vortex ice state observed at is less prone to defects than at . In addition, the nonmonotonic variations of the vortex ice quality on the lattice spacing indicates that a highly ordered vortex ice state cannot be attained by simply reducing the lattice spacing. The optimal design to observe defect-free vortex ice is discussed based on the experimental statistics. The direct observations of a tunable vortex ice state provides new opportunities to explore the order-disorder transition in artificial ice systems. - 1 August 2017
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 42 (34) , 21886-21900
Three-dimensional numerical simulation of solid oxide fuel cell cathode based on lattice Boltzmann method with sub-grid scale models
- 1 August 2017
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 42 (34) , 21886-21900
Three-dimensional numerical simulation of solid oxide fuel cell cathode based on lattice Boltzmann method with sub-grid scale models
- 30 May 2017
- Published by The Electrochemical Society in ECS Transactions
- Vol. 78 (1) , 2751-2763
Numerical Simulation of LSCF-GDC Composite Cathodes with Various Microstructures
In the present study, electrochemical performances of different LSCF-GDC microstructures are numerically simulated in order to investigate the effects of GDC particle sizes and GDC pillars on LSCF cathode performance. Lattice Boltzmann method (LBM) is applied for solving the governing equations. It is found from the numerical results of pure GDC and LSCF-GDC composite cathodes with various particle sizes that the performance improvement by GDC addition is more pronounced for cathodes with smaller particle sizes. In addition, it is shown that LSCF cathode with GDC pillars can enhance the performance of the cathode especially when the reactive region of the cathode becomes thin by using small size powders.
- 30 May 2017
- Published by The Electrochemical Society in ECS Transactions
- Vol. 78 (1) , 2751-2763
Numerical Simulation of LSCF-GDC Composite Cathodes with Various Microstructures
In the present study, electrochemical performances of different LSCF-GDC microstructures are numerically simulated in order to investigate the effects of GDC particle sizes and GDC pillars on LSCF cathode performance. Lattice Boltzmann method (LBM) is applied for solving the governing equations. It is found from the numerical results of pure GDC and LSCF-GDC composite cathodes with various particle sizes that the performance improvement by GDC addition is more pronounced for cathodes with smaller particle sizes. In addition, it is shown that LSCF cathode with GDC pillars can enhance the performance of the cathode especially when the reactive region of the cathode becomes thin by using small size powders.