SOSwe Zin Oo

Swe Zin Oo

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Swe Zin Oo has a total of 53 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Low-temperature polycrystalline silicon waveguides for low loss transmission in the near-to-mid-infrared region

    by Amar Nath Ghosh, Stuart J. Macfarquhar, Ozan Aktas, Than Singh Saini, Swe Z. Oo, Harold M. H. Chong, Anna C. Peacock

    Low-temperature deposited polycrystalline silicon waveguides are emerging as a flexible platform that allows for dense optoelectronic integration. Here, the optical transmission properties of poly-silicon waveguides have been characterized from the near-to-mid-infrared wavelength regime, extending the optical transmission well beyond previous reports in the telecom band. The poly-Si waveguides with a dimension of 3 µm × ∼0.6 µm have been produced from pre-patterned amorphous silicon waveguides that are post-processed through laser melting, reflowing, and crystallization using a highly localized laser induced heat treatment at a wavelength of 532 nm. Low optical transmission losses (−1) have been observed at 1.55 µm as well as across the wavelength range of 2−2.25 µm, aided by the relatively large waveguide heights that are enabled by the deposition process. The results demonstrate the suitability of low-temperature poly-silicon waveguides to find wide ranging applications within integrated mid-infrared systems.


  • Open Access

    Nanometallic antenna-assisted amorphous silicon waveguide integrated bolometer for mid-infrared

    by Yangbo Wu, Zhibo Qu, Ahmed Osman, Chen Wei, Wei Cao, Antulio Tarazona, Swe Zin Oo, Harold M. H. Chong, Otto L. Muskens, Goran Z. Mashanovich, et al.

    Bolometers are thermal detectors widely applied in the mid-infrared (MIR) wavelength range. In an integrated sensing system on chip, a broadband scalable bolometer absorbing the light over the whole MIR wavelength range could play an important role. In this work, we have developed a waveguide-based bolometer operating in the wavelength range of 3.72–3.88 µm on the amorphous silicon (a-Si) platform. Significant improvements in the bolometer design result in a 20 × improved responsivity compared to earlier work on silicon-on-insulator (SOI). The bolometer offers 24.62% change in resistance per milliwatt of input power at 3.8 µm wavelength. The thermal conductance of the bolometer is 3.86 × 1 0 − 5 W / K , and an improvement as large as 3 orders magnitude may be possible in the future through redesign of the device geometry.


  • Open Access

    Nonlinear properties of laser-processed polycrystalline silicon waveguides for integrated photonics

    by Ozan Aktas, Stuart J. MacFarquhar, Swe Z. Oo, Antulio Tarazona, Harold M. H. Chong, Anna C. Peacock

    We report nonlinear optical characterization of cm-long polycrystalline silicon (poly-Si) waveguides at telecom wavelengths. Laser post-processing of lithographically-patterned amorphous silicon deposited on silica-on-silicon substrates provides low-loss poly-Si waveguides with surface-tension-shaped boundaries. Achieving optical losses as low as 4 dB cm-1 enabled us to demonstrate effects of self-phase modulation (SPM) and two-photon absorption (TPA). Analysis of the spectral broadening and nonlinear losses with numerical modeling reveals the best fit values of the Kerr coefficient n2=4.5×10−18 m W-1 and TPA coefficient βTPA=9.0×10−12 m2 W-1, which are within the range reported for crystalline silicon. On-chip low-loss poly-Si paves the way for flexible integration of nonlinear components in multi-layered photonic systems.


  • Open Access

    Ion Implantation of Germanium Into Silicon for Critical Coupling Control of Racetrack Resonators

    by Milan M. Milosevic, Xia Chen, Xingshi Yu, Nicholas J. Dinsdale, Ozan Aktas, Swe Zin Oo, Ali Z. Khokhar, David J. Thomson, Otto L. Muskens, Harold M. H. Chong, et al.

    Critical coupling control is an important concept used in integrated photonics to obtain functionalities such as single and coupled resonator optical filters and wavelength multiplexers. Realization of critical coupling depends strongly on device fabrication, and reproducibility is therefore an ongoing challenge. Post-fabrication trimming offers a solution for achieving optimal performance for individual devices. Ion implantation into silicon causes crystalline lattice damage which results in an increase of the material's refractive index and therefore creates a platform for realization of various optical devices. In recent years, we have presented results on the development of erasable gratings, optical filters and Mach-Zehnder interferometers using ion implantation of germanium into silicon. Here, we report the design, fabrication and testing of silicon-on-insulator racetrack resonators, trimmed by localised annealing of germanium ion implanted silicon using continuous and pulsed wave laser sources. The results demonstrate the ability to permanently tune the critical coupling condition of racetrack resonators. Compared to the pulsed lasers used for annealing, continuous wave lasers revealed much higher extinction ratio due to improved material quality after silicon recrystallization.


  • Open Access

    HWCVD a-Si:H interlayer slope waveguide coupler for multilayer silicon photonics platform

    by Rafidah Petra, Swe Zin Oo, Antulio Tarazona, Robert Cernansky, Scott A. Reynolds, Ali Z. Khokhar, Vinita Mittal, David J. Thomson, Alberto Politi, Goran Z. Mashanovich, et al.

    We present interlayer slope waveguides, designed to guide light from one level to another in a multi-layer silicon photonics platform. The waveguide is fabricated from hydrogenated amorphous silicon (a-Si:H) film, deposited using hot-wire chemical vapor deposition (HWCVD) at a temperature of 230°C. The interlayer slope waveguide is comprises of a lower level input waveguide and an upper level output waveguide, connected by a waveguide on a slope, with vertical separation to isolate other crossing waveguides. Measured loss of 0.17 dB/slope was obtained for waveguide dimensions of 600 nm waveguide width (w) and 400 nm core thickness (h) at a wavelength of 1550 nm and for transverse electric (TE) mode polarization.


  • Open Access

    Photonic micro-structures produced by selective etching of laser-crystallized amorphous silicon

    by G. Martinez-Jimenez, Y. Franz, A. F. J. Runge, M. Ceschia, N. Healy, S. Z. Oo, A. Tarazona, H. M. H. Chong, A. C. Peacock, S. Mailis

    We present a method for the production of polycrystalline Si (poly-Si) photonic micro-structures based on laser writing. The method consists of local laser-induced crystallization of amorphous silicon (a-Si) followed by selective etching in chemical agents that act preferentially on the a-Si material, consequently revealing the poly-Si content of the film. We have studied the characteristics of these structures as a function of the laser processing parameters and we demonstrate their potential photonic functionality by fabricating polycrystalline silicon ridge optical waveguides. Preliminary waveguide transmission performance results indicated an optical transmission loss of 9 dB/cm in these unrefined devices.


  • Open Access

    Laser crystallized low-loss polycrystalline silicon waveguides

    by Yohann Franz, Antoine F. J. Runge, Swe Z. Oo, Gregorio Jimenez-Martinez, Noel Healy, Ali Khokhar, Antulio Tarazona, Harold M. H. Chong, Sakellaris Mailis, Anna C. Peacock

    We report the fabrication of low-loss, low temperature deposited polysilicon waveguides via laser crystallization. The process involves pre-patterning amorphous silicon films to confine the thermal energy during the crystallization phase, which helps to control the grain growth and reduce the heat transfer to the surrounding media, making it compatible with CMOS integration. Micro-Raman spectroscopy, Secco etching and X-ray diffraction measurements reveal the high crystalline quality of the processed waveguides with the formation of millimeter long crystal grains. Optical losses as low as 5.3 dB/cm have been measured, indicating their suitability for the development of high-density integrated circuits.


  • Open Access

    Hot-wire chemical vapor deposition low-loss hydrogenated amorphous silicon waveguides for silicon photonic devices

    by Swe Z. Oo, Antulio Tarazona, Ali Z. Khokhar, Rafidah Petra, Yohann Franz, Goran Z. Mashanovich, Graham T. Reed, Anna C. Peacock, Harold M. H. Chong

    We demonstrate low-loss hydrogenated amorphous silicon (a-Si:H) waveguides by hot-wire chemical vapor deposition (HWCVD). The effect of hydrogenation in a-Si at different deposition temperatures has been investigated and analyzed by Raman spectroscopy. We obtained an optical quality a-Si:H waveguide deposited at 230°C that has a strong Raman peak shift at 480  cm−1, peak width (full width at half-maximum) of 68.9  cm−1, and bond angle deviation of 8.98°. Optical transmission measurement shows a low propagation loss of 0.8 dB/cm at the 1550 nm wavelength, which is the first, to our knowledge, report for a HWCVD a-Si:H waveguide.


  • Vertically coupled a-Si:H multimode interference waveguides for multi-layer silicon photonics platform

    by S. Z. Oo, A. Tarazona, R. Petra, A. Z. Khokhar, G. T. Reed, A. C. Peacock, H. M. H. Chong

    We successfully demonstrated low temperature fabrication process of vertical MMI a:Si-H waveguides for multi-layer photonic integrated circuit. Measured MMI loss of 1.97dB/MMI and vertical light coupling of TE polarization at 1550nm wavelength have been achieved.

  • Hot-wire CVD a-Si:H for low loss silicon photonic waveguides

    by S. Z. Oo, A. Tarazona, R. Petra, A. Z. Khokhar, G. T. Reed, A. C. Peacock, H. M. H. Chong

    We demonstrate low temperature hot-wire chemical vapor deposition of low loss a-Si:H wire waveguides. We achieved propagation loss of 0.65 dB/cm at TE polarized 1.55 μm wavelength for waveguides deposited at 230 °C.