Ari Visa
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Ari Visa has a total of 172 co-authors. Here are the top co-authors by number of shared publications:
- Juha Jylha
Laboratory of Signal Processing, Tampere University of Technology, Tampere, Finland
29 shared publications - Juho Vihonen
Department of Signal Processing, Tampere University of Technology, Tampere, Finland
27 shared publications Iivari Kunttu
Tampere University of Technology, Institute of Signal Processing, P.O. Box 553, FI-33101 Tampere, Finland
13 shared publications- Minna Vaila
Laboratory of Signal Processing, Tampere University of Technology, Tampere, Finland
13 shared publications - Henna Perala
Department of Signal Processing, Tampere University of Technology, Finland
11 shared publications Leena Lepistö
Tampere University of Technology, Institute of Signal Processing, P.O. Box 553, FI-33101 Tampere, Finland
11 shared publications
Latest Publications
- Open Access
A Comparison of Various Algorithms for Classification of Food Scents Measured with an Ion Mobility Spectrometry
The present aim was to compare the accuracy of several algorithms in classifying data collected from food scent samples. Measurements using an electronic nose (eNose) can be used for classification of different scents. An eNose was used to measure scent samples from seven food scent sources, both from an open plate and a sealed jar. The k-Nearest Neighbour (k-NN) classifier provides reasonable accuracy under certain conditions and uses traditionally the Euclidean distance for measuring the similarity of samples. Therefore, it was used as a baseline distance metric for the k-NN in this paper. Its classification accuracy was compared with the accuracies of the k-NN with 66 alternative distance metrics. In addition, 18 other classifiers were tested with raw eNose data. For each classifier various parameter settings were tried and compared. Overall, 304 different classifier variations were tested, which differed from each other in at least one parameter value. The results showed that Quadratic Discriminant Analysis, MLPClassifier, C-Support Vector Classification (SVC), and several different single hidden layer Neural Networks yielded lower misclassification rates applied to the raw data than k-NN with Euclidean distance. Both MLP Classifiers and SVC yielded misclassification rates of less than when applied to raw data. Furthermore, when applied both to the raw data and the data preprocessed by principal component analysis that explained at least or of the total variance in the raw data, Quadratic Discriminant Analysis outperformed the other classifiers. The findings of this study can be used for further algorithm development. They can also be used, for example, to improve the estimation of storage times of fruit.Open AccessA Comparison of Various Algorithms for Classification of Food Scents Measured with an Ion Mobility Spectrometry
The present aim was to compare the accuracy of several algorithms in classifying data collected from food scent samples. Measurements using an electronic nose (eNose) can be used for classification of different scents. An eNose was used to measure scent samples from seven food scent sources, both from an open plate and a sealed jar. The k-Nearest Neighbour (k-NN) classifier provides reasonable accuracy under certain conditions and uses traditionally the Euclidean distance for measuring the similarity of samples. Therefore, it was used as a baseline distance metric for the k-NN in this paper. Its classification accuracy was compared with the accuracies of the k-NN with 66 alternative distance metrics. In addition, 18 other classifiers were tested with raw eNose data. For each classifier various parameter settings were tried and compared. Overall, 304 different classifier variations were tested, which differed from each other in at least one parameter value. The results showed that Quadratic Discriminant Analysis, MLPClassifier, C-Support Vector Classification (SVC), and several different single hidden layer Neural Networks yielded lower misclassification rates applied to the raw data than k-NN with Euclidean distance. Both MLP Classifiers and SVC yielded misclassification rates of less than when applied to raw data. Furthermore, when applied both to the raw data and the data preprocessed by principal component analysis that explained at least or of the total variance in the raw data, Quadratic Discriminant Analysis outperformed the other classifiers. The findings of this study can be used for further algorithm development. They can also be used, for example, to improve the estimation of storage times of fruit. - 1 March 2020
- Published by Elsevier in Parallel Computing
- Vol. 91
Programming languages for data-Intensive HPC applications: A systematic mapping study
- 1 March 2020
- Published by Elsevier in Parallel Computing
- Vol. 91
Programming languages for data-Intensive HPC applications: A systematic mapping study
- Open Access
- 19 July 2019
- Published by Association for Computing Machinery (ACM)
- p. 175-180
Real-time Online Drilling Vibration Analysis Using Data Mining
- 19 July 2019
- Published by Association for Computing Machinery (ACM)
- p. 175-180
Open AccessReal-time Online Drilling Vibration Analysis Using Data Mining
- 1 April 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Automatic Detection of Water Inside Concrete Slabs Using Ground Penetrating Radar
Ground Penetrating Radar (GPR) is generally used as a non-destructive method of inspection for structures and for finding defects in concrete slabs. In this paper, GPR is used in the detection of water inside the cavities of concrete hollow core slabs. We propose an algorithm that determines the water level inside the concrete slab by analyzing the time delays of the reflections originating from inside the cavity. The algorithm is based on utilizing prior knowledge about the geometry of the hollow core slab. The presence of water was successfully detected and an estimate for the height of the water surface was obtained with a GPR system operating with a central frequency of 2.7 GHz. Based on the experiments, the proposed method holds promise in providing a robust and accurate method for the detection of water inside the concrete slabs. Results, possible future research and analysis of the feasibility of GPR systems in water detection are presented and discussed.
- 1 April 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Automatic Detection of Water Inside Concrete Slabs Using Ground Penetrating Radar
Ground Penetrating Radar (GPR) is generally used as a non-destructive method of inspection for structures and for finding defects in concrete slabs. In this paper, GPR is used in the detection of water inside the cavities of concrete hollow core slabs. We propose an algorithm that determines the water level inside the concrete slab by analyzing the time delays of the reflections originating from inside the cavity. The algorithm is based on utilizing prior knowledge about the geometry of the hollow core slab. The presence of water was successfully detected and an estimate for the height of the water surface was obtained with a GPR system operating with a central frequency of 2.7 GHz. Based on the experiments, the proposed method holds promise in providing a robust and accurate method for the detection of water inside the concrete slabs. Results, possible future research and analysis of the feasibility of GPR systems in water detection are presented and discussed.
- Open Access
- 26 March 2019
- Published by Springer Nature
- p. 138-162
Big Data in 5G Distributed Applications
- 26 March 2019
- Published by Springer Nature
- p. 138-162
Open AccessBig Data in 5G Distributed Applications
- Open Access
- 1 February 2019
- Published by Elsevier in Biochimica et Biophysica Acta (BBA) - Gene Regulatory Mechanisms
- Vol. 1862 (2) , 119-128
Regulation of asymmetries in the kinetics and protein numbers of bacterial gene expression
- 1 February 2019
- Published by Elsevier in Biochimica et Biophysica Acta (BBA) - Gene Regulatory Mechanisms
- Vol. 1862 (2) , 119-128
Open AccessRegulation of asymmetries in the kinetics and protein numbers of bacterial gene expression
- 1 October 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 397-402
Indoor Localisation using Aroma Fingerprints: Comparing Nearest Neighbour Classification Accuracy using Different Distance Measures
Measurements from an ion mobility spectrometry electronic nose (eNose) can be used for distinguishing different rooms in indoor localisation. An earlier study showed that the Nearest Neighbour classifier with Euclidean distance for features provides reasonable accuracy under certain conditions. In this paper 66 alternative distance measures are compared to the Euclidean distance and principal component analysis (PCA) is applied to the data. PCA shows that the measurements on the various channels of the eNose are correlated and that using principal components 1, 2 and 4 increases the accuracy considerably. Furthermore, the experiments revealed three Pareto optimal distance measures that reduce the misclassification rate between 9-10% while using only 82-88% of the search time compared with Euclidean distance.
- 1 October 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 397-402
Indoor Localisation using Aroma Fingerprints: Comparing Nearest Neighbour Classification Accuracy using Different Distance Measures
Measurements from an ion mobility spectrometry electronic nose (eNose) can be used for distinguishing different rooms in indoor localisation. An earlier study showed that the Nearest Neighbour classifier with Euclidean distance for features provides reasonable accuracy under certain conditions. In this paper 66 alternative distance measures are compared to the Euclidean distance and principal component analysis (PCA) is applied to the data. PCA shows that the measurements on the various channels of the eNose are correlated and that using principal components 1, 2 and 4 increases the accuracy considerably. Furthermore, the experiments revealed three Pareto optimal distance measures that reduce the misclassification rate between 9-10% while using only 82-88% of the search time compared with Euclidean distance.
- 1 February 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Aerospace and Electronic Systems
- Vol. 54 (1) , 295-314
Data-Driven Motion Compensation Techniques for Noncooperative ISAR Imaging
We consider the data-driven motion compensation problem in inverse synthetic aperture radar (ISAR) imaging. We present optimization-based ISAR techniques and propose improvements to the range alignment, time-window selection, autofocus, time-frequency-based image reconstruction and crossrange scaling procedures. In experiments, the improvements reduced the computational burden and increased the image contrast by 50 percent at best and 28 percent on average in several test cases including changing translational and rotational motion.
- 1 February 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Aerospace and Electronic Systems
- Vol. 54 (1) , 295-314
Data-Driven Motion Compensation Techniques for Noncooperative ISAR Imaging
We consider the data-driven motion compensation problem in inverse synthetic aperture radar (ISAR) imaging. We present optimization-based ISAR techniques and propose improvements to the range alignment, time-window selection, autofocus, time-frequency-based image reconstruction and crossrange scaling procedures. In experiments, the improvements reduced the computational burden and increased the image contrast by 50 percent at best and 28 percent on average in several test cases including changing translational and rotational motion.
- 3 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 66 (12) , 3280-3288
Joint-Space Kinematic Model for Gravity-Referenced Joint Angle Estimation of Heavy-Duty Manipulators
A gravity-referenced joint angle estimation, which acts in joint space, is proposed for multiple-degree-of-freedom hydraulic manipulators. As a novelty, the estimation pairs up inertial units across a section of an open kinematic chain. In this way, the three-axis linear accelerometers and the three-axis rate gyros provide a drift-free solution for observing the motion state of a rotary joint connecting two links without relying on the full forward kinematics. For a low-noise, low-delay estimate, the linear accelerations acting on the paired inertial units are modeled and robustly combined with the principles of complementary and Kalman filtering. In pick-and-place experiments with a serial-link manipulator on a multiton, off-road forestry vehicle, joint angle sensing error of less than ±1° was achieved in spite of the dynamic interaction between the vehicle base and the terrain. Furthermore, the kinematic modeling's ability to compensate for the nonplanar, coupled 3-D linkage motion is studied for one- and two-axis rate measurements along with Cartesian path tracking. This gives new insights from the typical planar kinematic models and heavy-duty control viewpoints.
- 3 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 66 (12) , 3280-3288
Joint-Space Kinematic Model for Gravity-Referenced Joint Angle Estimation of Heavy-Duty Manipulators
A gravity-referenced joint angle estimation, which acts in joint space, is proposed for multiple-degree-of-freedom hydraulic manipulators. As a novelty, the estimation pairs up inertial units across a section of an open kinematic chain. In this way, the three-axis linear accelerometers and the three-axis rate gyros provide a drift-free solution for observing the motion state of a rotary joint connecting two links without relying on the full forward kinematics. For a low-noise, low-delay estimate, the linear accelerations acting on the paired inertial units are modeled and robustly combined with the principles of complementary and Kalman filtering. In pick-and-place experiments with a serial-link manipulator on a multiton, off-road forestry vehicle, joint angle sensing error of less than ±1° was achieved in spite of the dynamic interaction between the vehicle base and the terrain. Furthermore, the kinematic modeling's ability to compensate for the nonplanar, coupled 3-D linkage motion is studied for one- and two-axis rate measurements along with Cartesian path tracking. This gives new insights from the typical planar kinematic models and heavy-duty control viewpoints.
- 1 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-3
Circular deformation estimation for a flexible link
To address the tip positioning problem among flexible link robotic applications, we propose a new circular beam deformation model that is ideally suited for networked linear accelerometers and rate gyros. Importantly, the tip positioning problem of multiple-flexible-link system is reduced to the tip positioning problem of an individual flexible link subject to the circularly characterized deformation. The validity of the theoretical results is verified by experiments with a highly flexible single-link hydraulic manipulator.
- 1 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-3
Circular deformation estimation for a flexible link
To address the tip positioning problem among flexible link robotic applications, we propose a new circular beam deformation model that is ideally suited for networked linear accelerometers and rate gyros. Importantly, the tip positioning problem of multiple-flexible-link system is reduced to the tip positioning problem of an individual flexible link subject to the circularly characterized deformation. The validity of the theoretical results is verified by experiments with a highly flexible single-link hydraulic manipulator.