Chao Niu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Chao Niu has a total of 61 co-authors. Here are the top co-authors by number of shared publications:
- Jiming Bao
Department of Electrical and Computer Engineering University of Houston 77204 Houston Texas USA
6 shared publications - Jonathan Hu
Baylor University
6 shared publications Yanan Wang
Institute of Fundamental and Frontier Sciences, University of Electronic Science and Technology of China, Chengdu, Sichuan 610054, China
6 shared publicationsZhaoping Liu
Ningbo Institute of Materials Technology & Engineering, Chinese Academy of Sciences, Ningbo, Zhejiang 315201, China
6 shared publicationsFeng Lin
Institute of Fundamental and Frontier Sciences University of Electronic Science and Technology of China Chengdu 610054 Sichuan China
5 shared publicationsJonathan Hu
Department of Electrical and Computer Engineering Baylor University Waco TX 76798 USA
5 shared publications
Latest Publications
- Open Access
- 5 March 2020
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 12 (13) , 7109-7115
Photoacoustic identification of laser-induced microbubbles as light scattering centers for optical limiting in a liquid suspension of graphene nanosheets
Liquid suspensions of carbon nanotubes, graphene and transition metal dichalcogenides have exhibited excellent performance in optical limiting.
- 5 March 2020
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 12 (13) , 7109-7115
Open AccessPhotoacoustic identification of laser-induced microbubbles as light scattering centers for optical limiting in a liquid suspension of graphene nanosheets
Liquid suspensions of carbon nanotubes, graphene and transition metal dichalcogenides have exhibited excellent performance in optical limiting.
- Open Access
- 3 January 2020
- Published by American Physical Society (APS) in Physical Review Research
- Vol. 2 (1) , 013008
Large graphene-induced shift of surface-plasmon resonances of gold films: Effective-medium theory for atomically thin materials
Despite successful modeling of graphene as a 0.34-nm-thick optical film synthesized by exfoliation or chemical vapor deposition (CVD), graphene-induced shift of surface-plasmon resonance (SPR) of gold films has remained controversial. Here we report the resolution of this controversy by developing a clean CVD graphene transfer method and extending Maxwell-Garnett effective-medium theory (EMT) to two-dimensional (2D) materials. A SPR shift of 0.24° is obtained and it agrees well with 2D EMT in which wrinkled graphene is treated as a 3-nm graphene/air layered composite, in agreement with the average roughness measured by atomic force microscopy. Because the anisotropic built-in boundary condition of 2D EMT is compatible with graphene's optical anisotropy, graphene can be modeled as a film thicker than 0.34 nm without changing its optical property; however, its actual roughness, i.e., effective thickness, will significantly alter its response to strong out-of-plane fields, leading to a larger SPR shift.
- 3 January 2020
- Published by American Physical Society (APS) in Physical Review Research
- Vol. 2 (1) , 013008
Open AccessLarge graphene-induced shift of surface-plasmon resonances of gold films: Effective-medium theory for atomically thin materials
Despite successful modeling of graphene as a 0.34-nm-thick optical film synthesized by exfoliation or chemical vapor deposition (CVD), graphene-induced shift of surface-plasmon resonance (SPR) of gold films has remained controversial. Here we report the resolution of this controversy by developing a clean CVD graphene transfer method and extending Maxwell-Garnett effective-medium theory (EMT) to two-dimensional (2D) materials. A SPR shift of 0.24° is obtained and it agrees well with 2D EMT in which wrinkled graphene is treated as a 3-nm graphene/air layered composite, in agreement with the average roughness measured by atomic force microscopy. Because the anisotropic built-in boundary condition of 2D EMT is compatible with graphene's optical anisotropy, graphene can be modeled as a film thicker than 0.34 nm without changing its optical property; however, its actual roughness, i.e., effective thickness, will significantly alter its response to strong out-of-plane fields, leading to a larger SPR shift.
- Open Access
- 11 October 2019
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 5 (10) , eaau8763
Quantum plasmonic control of trions in a picocavity with monolayer WS 2
Tip-enhanced quantum plasmonics enables simultaneous nanoscale imaging and picoscale control of trions in monolayer WS 2 .
- 11 October 2019
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 5 (10) , eaau8763
Open AccessQuantum plasmonic control of trions in a picocavity with monolayer WS 2
Tip-enhanced quantum plasmonics enables simultaneous nanoscale imaging and picoscale control of trions in monolayer WS 2 .
- Open Access
- 12 November 2018
- Published by Wiley in Advanced Functional Materials
- Vol. 28 (46)
Graphene Sheets: Planar Alignment of Graphene Sheets by a Rotating Magnetic Field for Full Exploitation of Graphene as a 2D Material (Adv. Funct. Mater. 46/2018)
- 12 November 2018
- Published by Wiley in Advanced Functional Materials
- Vol. 28 (46)
Open AccessGraphene Sheets: Planar Alignment of Graphene Sheets by a Rotating Magnetic Field for Full Exploitation of Graphene as a 2D Material (Adv. Funct. Mater. 46/2018)
- 25 September 2018
- Published by Wiley in Advanced Functional Materials
- Vol. 28 (46)
Planar Alignment of Graphene Sheets by a Rotating Magnetic Field for Full Exploitation of Graphene as a 2D Material
Planar alignment of disc‐like nanomaterials is required to transfer their superior anisotropic properties from microscopic individual structures to macroscopic collective assemblies. However, such alignment by electrical or magnetic field is challenging due to their additional degrees of orientational freedom compared to that of rod‐like nanostructures. Here, the realization of planar alignment of suspended graphene sheets using a rotating magnetic field produced by a pair of small NdFeB magnets and subsequent demonstration of high optical anisotropy and potential novel device applications is reported. Compared to partially aligned sheets with a static magnetic field, planar aligned graphene suspensions exhibit a near‐perfect order parameter, much higher birefringence and anisotropic absorption/transmission. A unique feature of discotic nanomaterial assemblies is that the observed order parameter and optical property can vary from isotropic to partial and complete alignment depending on the experimental configuration. By immobilizing and patterning aligned graphene in a UV‐curable polymer resin, we further demonstrated an all‐graphene permanent display, which exhibits wide‐angle, high dark‐bright contrast in either transmission or reflection mode without any polarizing optics. The ability to control and pattern graphene orientation in all three dimensions opens up new exploration and broad device applications of graphene.
- 25 September 2018
- Published by Wiley in Advanced Functional Materials
- Vol. 28 (46)
Planar Alignment of Graphene Sheets by a Rotating Magnetic Field for Full Exploitation of Graphene as a 2D Material
Planar alignment of disc‐like nanomaterials is required to transfer their superior anisotropic properties from microscopic individual structures to macroscopic collective assemblies. However, such alignment by electrical or magnetic field is challenging due to their additional degrees of orientational freedom compared to that of rod‐like nanostructures. Here, the realization of planar alignment of suspended graphene sheets using a rotating magnetic field produced by a pair of small NdFeB magnets and subsequent demonstration of high optical anisotropy and potential novel device applications is reported. Compared to partially aligned sheets with a static magnetic field, planar aligned graphene suspensions exhibit a near‐perfect order parameter, much higher birefringence and anisotropic absorption/transmission. A unique feature of discotic nanomaterial assemblies is that the observed order parameter and optical property can vary from isotropic to partial and complete alignment depending on the experimental configuration. By immobilizing and patterning aligned graphene in a UV‐curable polymer resin, we further demonstrated an all‐graphene permanent display, which exhibits wide‐angle, high dark‐bright contrast in either transmission or reflection mode without any polarizing optics. The ability to control and pattern graphene orientation in all three dimensions opens up new exploration and broad device applications of graphene.
- 23 January 2018
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 123 (4) , 044302
Graphene levitation and orientation control using a magnetic field
This paper studies graphene levitation and orientation control using a magnetic field. The torques in all three spatial directions induced by diamagnetic forces are used to predict stable conditions for different shapes of millimeter-sized graphite plates. We find that graphite plates, in regular polygon shapes with an even number of sides, will be levitated in a stable manner above four interleaved permanent magnets. In addition, the orientation of micrometer-sized graphene flakes near a permanent magnet is studied in both air and liquid environments. Using these analyses, we are able to simulate optical transmission and reflection on a writing board and thereby reveal potential applications using this technology for display screens. Understanding the control of graphene flake orientation will lead to the discovery of future applications using graphene flakes.
- 23 January 2018
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 123 (4) , 044302
Graphene levitation and orientation control using a magnetic field
This paper studies graphene levitation and orientation control using a magnetic field. The torques in all three spatial directions induced by diamagnetic forces are used to predict stable conditions for different shapes of millimeter-sized graphite plates. We find that graphite plates, in regular polygon shapes with an even number of sides, will be levitated in a stable manner above four interleaved permanent magnets. In addition, the orientation of micrometer-sized graphene flakes near a permanent magnet is studied in both air and liquid environments. Using these analyses, we are able to simulate optical transmission and reflection on a writing board and thereby reveal potential applications using this technology for display screens. Understanding the control of graphene flake orientation will lead to the discovery of future applications using graphene flakes.
- Open Access
- 2 January 2017
- Published by Wiley in Advanced Materials
- Vol. 29 (1)
Graphene Flakes: Orientation Control of Graphene Flakes by Magnetic Field: Broad Device Applications of Macroscopically Aligned Graphene (Adv. Mater. 1/2017)
- 2 January 2017
- Published by Wiley in Advanced Materials
- Vol. 29 (1)
Open AccessGraphene Flakes: Orientation Control of Graphene Flakes by Magnetic Field: Broad Device Applications of Macroscopically Aligned Graphene (Adv. Mater. 1/2017)
- 1 January 2017
- Published by Optica Publishing Group
- p. SW4K.5
Graphene Flakes Controlled by Magnetic Fields for a Display Application
We study optical transmission and reflection of graphene flakes suspended in liquid with external magnetic fields in both experiment and simulation. We show that graphene flakes controlled by magnetic fields can be used for display.
- 1 January 2017
- Published by Optica Publishing Group
- p. SW4K.5
Graphene Flakes Controlled by Magnetic Fields for a Display Application
We study optical transmission and reflection of graphene flakes suspended in liquid with external magnetic fields in both experiment and simulation. We show that graphene flakes controlled by magnetic fields can be used for display.
- 10 November 2016
- Published by Wiley in Advanced Materials
- Vol. 29 (1)
Orientation Control of Graphene Flakes by Magnetic Field: Broad Device Applications of Macroscopically Aligned Graphene
Owing to a large diamagnetism, graphene flakes can respond and be aligned to magnetic field like a ferromagnetic material. Aligned graphene flakes exhibit emergent properties approaching single‐layer graphene. Anisotropic optical properties also give rise to a magnetic writing board using graphene suspension and a bar magnet as a pen. This simple alignment technique opens up enormous applications of graphene.
- 10 November 2016
- Published by Wiley in Advanced Materials
- Vol. 29 (1)
Orientation Control of Graphene Flakes by Magnetic Field: Broad Device Applications of Macroscopically Aligned Graphene
Owing to a large diamagnetism, graphene flakes can respond and be aligned to magnetic field like a ferromagnetic material. Aligned graphene flakes exhibit emergent properties approaching single‐layer graphene. Anisotropic optical properties also give rise to a magnetic writing board using graphene suspension and a bar magnet as a pen. This simple alignment technique opens up enormous applications of graphene.
- Open Access
- 27 April 2016
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 3 (5) , 869-874
Excitonic Resonant Emission–Absorption of Surface Plasmons in Transition Metal Dichalcogenides for Chip-Level Electronic–Photonic Integrated Circuits
The monolithic integration of electronics and photonics has attracted enormous attention due to its potential applications. A major challenge to this integration is the identification of suitable materials that can emit and absorb light at the same wavelength. In this paper we utilize unique excitonic transitions in WS2 monolayers and show that WS2 exhibits a perfect overlap between its absorption and photoluminescence spectra. By coupling WS2 to Ag nanowires, we then show that WS2 monolayers are able to excite and absorb surface plasmons of Ag nanowires at the same wavelength of exciton photoluminescence. This resonant absorption by WS2 is distinguished from that of the ohmic propagation loss of silver nanowires, resulting in a short propagation length of surface plasmons. Our demonstration of resonant optical generation and detection of surface plasmons enables nanoscale optical communication and paves the way for on-chip electronic–photonic integrated circuits.
- 27 April 2016
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 3 (5) , 869-874
Open AccessExcitonic Resonant Emission–Absorption of Surface Plasmons in Transition Metal Dichalcogenides for Chip-Level Electronic–Photonic Integrated Circuits
The monolithic integration of electronics and photonics has attracted enormous attention due to its potential applications. A major challenge to this integration is the identification of suitable materials that can emit and absorb light at the same wavelength. In this paper we utilize unique excitonic transitions in WS2 monolayers and show that WS2 exhibits a perfect overlap between its absorption and photoluminescence spectra. By coupling WS2 to Ag nanowires, we then show that WS2 monolayers are able to excite and absorb surface plasmons of Ag nanowires at the same wavelength of exciton photoluminescence. This resonant absorption by WS2 is distinguished from that of the ohmic propagation loss of silver nanowires, resulting in a short propagation length of surface plasmons. Our demonstration of resonant optical generation and detection of surface plasmons enables nanoscale optical communication and paves the way for on-chip electronic–photonic integrated circuits.