Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Dong Min Kim has a total of 39 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Computation offloading and information freshness in edge-assisted networked robotic systems

    by Junyeong Jeon, Daniel Poul Mtowe, Dong Min Kim

    Camera-based wireless networked control systems must move visual information across a shared wireless link before a command can be applied, so the placement of the perception computation fixes both the communication load and the freshness of the information that drives the actuator. We partition a road-following perception pipeline between a mobile robot and a remote controller at four cut points, spanning measured application payloads from a 61,570 B raw image (PUPPET) to a 4 B road-center feature (E3), and evaluate the system on a physical testbed under two controlled uplink conditions. Freshness is quantified as actuation-side Age of Information (AoI): the age of the camera observation underlying the command actually applied at the motors, reconstructed in continuous time from a single monotonic clock on the robot. Under the constrained channel, mean actuation AoI falls from 82.7 ms in PUPPET to 44.8 ms in E3, and the 95th-percentile AoI decreases from 208.7 ms to 68.7 ms. The payload–freshness relation saturates sharply. The first edge cut removes 95.6 % of the raw-image payload and captures 96.6 % – 99.6 % of the total freshness improvement, whereas a further 99.85 % reduction in payload yields only an additional 0.5 ms improvement, which remains statistically detectable after multiple-comparison correction but is between approximately 28- and 269-times smaller than the preceding PUPPET-to-E1 improvement, depending on the channel and freshness metric. A separate closed-loop campaign shows the same knee in image-plane tracking error, with the first cut capturing 96.4 % of the PUPPET-to-E3 RMSE reduction. Extending the measured payloads to a shared medium under a fixed-overhead airtime model shows that the same knee governs multi-robot scalability, but at a different cut: because a payload-independent per-frame cost dominates once an update fits in a single frame, the budget-based robot count rises 30-fold from PUPPET to E1 but only 1.8-fold from E1 to E3 against a 674-fold reduction in transmitted bytes. Actuation freshness, sustainable robot density, and raw byte volume are, therefore, exhausted in three different ways along the offloading axis, so computation placement in cooperative multi-robot deployments should be selected against the binding system constraint rather than by assuming smaller payloads are uniformly better.

  • Open Access

    Scalable Edge–Cloud Cooperative Digital Twin Control for Multi-Robot Systems

    by Daniel Poul Mtowe, Minhyeok Park, Dong Min Kim

    While edge-enabled Digital Twin networked control systems (E-DTNCSs) perform perception at the network edge and transmit compact semantic states instead of raw sensor streams, prior validations have been confined to small fleets. In this paper, we investigate whether these advantages persist as the fleet grows, investigating this issue in terms of perception complexity, communication load, and closed-loop responsiveness. We redesign the Smart Observer so that its per-frame cost is dominated by resolution-dependent operations, with only lightweight per-robot decoding growing with the number of robots. A dual-channel architecture separates fleet-state observation from robot-specific control: the observation path keeps a single periodic source whose payload grows by approximately 36 bytes per robot per update, and robots can join or leave a running Digital Twin (DT) session without reinitializing perception. Physical experiments with two to eight robots show that Smart Observer processing increases from 30.61 to 34.28 ms and DT synchronization latency increases from 34.00 to 37.65 ms, while the compression ratio relative to per-robot raw-image uplinks increases from 811:1 to 1298:1. The system remains collision-free through eight robots at a conservative safety radius, achieves higher task throughput than a raw-image DTNCS that becomes inoperable beyond five robots, and handles repeated join, leave, and rejoin events without interrupting observation. Calibrated component-wise scaling models give a nominal decision-availability latency of approximately 95 ms at N=100, an analytical stress point rather than a physically validated fleet size.

  • Open Access

    Low-Latency Edge-Enabled Digital Twin System for Multi-Robot Collision Avoidance and Remote Control

    by Daniel Poul Mtowe, Lika Long, Dong Min Kim

    This paper proposes a low-latency and scalable architecture for Edge-Enabled Digital Twin networked control systems (E-DTNCS) aimed at multi-robot collision avoidance and remote control in dynamic and latency-sensitive environments. Traditional approaches, which rely on centralized cloud processing or direct sensor-to-controller communication, are inherently limited by excessive network latency, bandwidth bottlenecks, and a lack of predictive decision-making, thus constraining their effectiveness in real-time multi-agent systems. To overcome these limitations, we propose a novel framework that seamlessly integrates edge computing with digital twin (DT) technology. By performing localized preprocessing at the edge, the system extracts semantically rich features from raw sensor data streams, reducing the transmission overhead of the original data. This shift from raw data to feature-based communication significantly alleviates network congestion and enhances system responsiveness. The DT layer leverages these extracted features to maintain high-fidelity synchronization with physical robots and to execute predictive models for proactive collision avoidance. To empirically validate the framework, a real-world testbed was developed, and extensive experiments were conducted with multiple mobile robots. The results revealed a substantial reduction in collision rates when DT was deployed, and further improvements were observed with E-DTNCS integration due to significantly reduced latency. These findings confirm the system’s enhanced responsiveness and its effectiveness in handling real-time control tasks. The proposed framework demonstrates the potential of combining edge intelligence with DT-driven control in advancing the reliability, scalability, and real-time performance of multi-robot systems for industrial automation and mission-critical cyber-physical applications.


  • Open Access

    A Sub-6 GHz Switching System for Simultaneous Use of 2-Port Network Analyzer by 4 Users

    by Youna Jang, Chang In Baek, Dong Min Kim, Dal Ahn, Seong-Ho Son

    A vector network analyzer (VNA) is an expensive and essential device for measuring the scattering coefficients of RF devices in the research and development of microwave systems. However, these VNAs are limited in that they can be only used by one user. To address this limitation, this paper presents a switching system that allows multiple users to measure each device under test using a single VNA at the same time. In particular, a four-user switching system is developed in this study. It is important to calibrate the differences between each channel that inevitably arise during implementation. For calibration, we propose and implement a technique for de-embedding the uneven characteristics between these channels. Its performance is validated by measuring insertion loss, reflection loss, and isolation for the developed switching system.


  • Open Access

    Edge-Computing-Enabled Low-Latency Communication for a Wireless Networked Control System

    by Daniel Poul Mtowe, Dong Min Kim

    This study proposes a novel strategy for enhancing low-latency control performance in Wireless Networked Control Systems (WNCSs) through the integration of edge computing. Traditional networked control systems require the receipt of raw data from remote sensors to enable the controller to generate an appropriate control command, a process that can result in substantial periodic communication traffic and consequent performance degradation in some applications. To counteract this, we suggest the use of edge computing to preprocess the raw data, extract the essential features, and subsequently transmit them. Additionally, we introduce an adaptive scheme designed to curtail frequent data traffic by adaptively modifying periodic data transmission based on necessity. This scheme is achieved by refraining from data transmission when a comparative analysis of the previously transmitted and newly generated data shows no significant change. The effectiveness of our proposed strategy is empirically validated through experiments conducted on a remote control system testbed using a mobile robot that navigates the road by utilizing camera information. Through leveraging edge computing, only 3.42% of the raw data was transmitted. Our adaptive scheme reduced the transmission frequency by 20%, while maintaining an acceptable control performance. Moreover, we conducted a comparative analysis between our proposed solution and the state-of-the-art communication framework, WebRTC technology. The results demonstrate that our method effectively reduces the latency by 58.16% compared to utilizing the WebRTC alone in a 5G environment. The experimental results confirm that our proposed strategy significantly improves the latency performance of a WNCS.


  • A Consideration for Port Area in Electromagnetic Simulation for CPW Transmission Lines

    by Joonwan An, Jongsik Lim, Seong-Ho Son, Dong Min Kim, Won-Sang Yoon, Sang-Min Han, Dal Ahn

    본 논문에서는 CPW(동평면 도파관, Coplanar Waveguide) 전송선로를 전자기적으로 시뮬레이션할 때 좀 더 정확한 S-파라미터를 얻기 위해 단자 영역을 설정하는 방법에 대하여 고찰한다. CPW 전송선로에서 접지도체면의 넓이가 넓어도 단자영역 폭을 유전체면의 폭보다 좁게 하면 시뮬레이션 결과가 나빠진다. 이에 비하여 접지도체면의 폭을 중심 신호선의 폭만큼 좁게 제한해도 단자 영역의 폭을 유전체면의 폭만큼 충분히 넓게 하면 채택할 만한 정도의 특성 곡선을 얻을 수 있다. 한 예로 신호선의 폭이 2.76㎜이고 접지도체면과의 거리가 0.12㎜인 CPW 선로에서 접지도체면의 폭을 3㎜로 크게 낮추어 전자기적으로 시뮬레이션하고 실제로 제작하여 8GHz까지 측정한 결과를 제시한다. 시뮬레이션 및 측정에서 얻은 S-파라미터가 서로 유사하므로 접지도체면의 선폭이 좁더라도 전 유전체면을 포함하도록 단자 영역을 설정하는 것이 타당하다는 결론을 보인다.


  • Design of a Microwave Branch Line Hybrid Coupler using Corrugated Cardboards

    by Sunghee Cho, Jongsik Lim, Seong-Ho Son, Dong Min Kim, Won-Sang Yoon, Sang-Min Han, Dal Ahn

    본 논문에서는 골판지 종이로 마이크로파 회로의 프로토타입을 신속하게 저가로 설계 및 제작하는 연구 결과를 기술한다. 골판지의 비유전율을 실험적으로 결정하기 위하여 어렵고 복잡한 전자기파 이론이 기대는 대신 의도적으로 시행착오를 겪기 위한 경험적 선행실험 과정을 거친다. 실험적으로 추출한 골판지의 비유전율(1.3)을 검증하기 위하여 마이크로파 전송선로를 설계하고, 대표적인 마이크로파 회로 가운데 하나인 브랜치라인 하이브리드 커플러 회로를 설계한다. 한 예로써, 중심주파수 1㎓에서 설계한 브랜치 라인 하이브리드 커플러 회로는 -3.39㏈, -3.81㏈의 전력분배, -25.37㏈의 단자 정합, -25.46㏈의 격리도 특성, 88.92도의 출력간 위상차 특성을 가진다.

  • Open Access

    CSNOMA: Carrier Sense Non-Orthogonal Multiple Access

    by Dong Min Kim, Seong-Lyun Kim

    In this paper, we investigate the possibility of the cross-layer design of a distributed random access scheme with considering physical (PHY) and multiple access control (MAC) layers, which utilizes the interference cancellation technique. In this regard, we propose a new multiple access protocol, named carrier sense non-orthogonal multiple access (CSNOMA). We consider the spatially randomly distributed interferers to realistically capture the effect of interference. The proposed protocol shows better area spectral efficiency than carrier sense multiple access (CSMA), as the node density increases. We also present a practical signaling design compatible with IEEE 802.11 DCF mode.


  • Open Access

    User-centric resource allocation with two-dimensional reverse pricing in mobile communication services

    by Jinho Choi, Sang Yeob Jung, Seong-Lyun Kim, Dong Min Kim, Petar Popovski

    Reverse pricing has been recognized as an effective tool to handle demand variability and uncertainty in the travel industry (e.g., airlines and hotels). To investigate its viability in mobile communication services, as a benchmark case, we first consider that a single mobile network operator (MNO) adopts (MNO-driven) forward pricing only, taking into account heterogeneous and stochastic user demands. To effectively deal with the drawbacks of forward pricing only, we propose (user-driven) two-dimensional reverse pricing on top of forward pricing and design a ξ-approximate polynomial-time algorithm that can maximize the revenue of the MNO. Through analytical and numerical results, we show that the proposed scheme can achieve "triple-win" solutions: Higher average network capacity utilization, the increase in the average revenue of the MNO, and the increment in the total average payoff of the users. To verify its feasibility in practice, we further implement its real prototype and perform experimental studies. We show that the proposed scheme still creates triple-win solutions in practice. Our findings provide a new outlook on resource allocation, and design guidelines for adopting two-dimensional reverse pricing on top of forward pricing.