Feng Zhao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Feng Zhao has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
Ting Sun
School of Chemistry and Materials Science, Guizhou Education University, Wudang District, People’s Republic of China
3 shared publications- Lin Liu
Henan Province of Key Laboratory of New Optoelectronic Functional Materials, College of Chemistry and Chemical Engineering, Anyang Normal University, Anyang 455000, China
2 shared publications Aixia Han
Chemical Engineering College, Qinghai University, Xining 810016, China
1 shared publicationChang Dong
College of Chemistry and Chemical Engineering, Anyang Normal University, Anyang 455000, P. R. China
1 shared publicationChao Zhang
Chemical Engineering College, Qinghai University, Xining 810016, China
1 shared publicationDefang Xu
Key Lab of Comprehensive and Highly Efficient Utilization of Salt Lake Resources, Qinghai Institute of Salt Lakes, Chinese Academy of Sciences, Xining 810008, China
1 shared publication
Latest Publications
- 29 July 2020
- Published by Springer Nature in Microchimica Acta
- Vol. 187 (8) , 1-7
Self-assembled biotin-phenylalanine nanoparticles for the signal amplification of surface plasmon resonance biosensors
A strategy for amplifying the signal of surface plasmon resonance (SPR) biosensors is reported. Biotinylated phenylalanine (Biotin-Phe) monomers were rapidly self-assembled into nanoparticles in a mild environment. The self-assembled nanoparticles were then used as the carriers of streptavidin-antibody complexes by the streptavidin-biotin interaction. The signal was amplified because of the high molecular weight of the nanoparticle-streptavidin-antibody conjugate. With prostate-specific antigen as a model analyte, the target concentration as low as 1 pg mL−1 was readily measured. The results of the nanoparticle-enhanced SPR biosensor for analysis of serum samples are well consistent with those achieved by the enzyme-linked immunosorbent assays. This work is valuable for designing of various optical and electronic biosensors through the streptavidin-biotin interaction. Graphical abstract
- 29 July 2020
- Published by Springer Nature in Microchimica Acta
- Vol. 187 (8) , 1-7
Self-assembled biotin-phenylalanine nanoparticles for the signal amplification of surface plasmon resonance biosensors
A strategy for amplifying the signal of surface plasmon resonance (SPR) biosensors is reported. Biotinylated phenylalanine (Biotin-Phe) monomers were rapidly self-assembled into nanoparticles in a mild environment. The self-assembled nanoparticles were then used as the carriers of streptavidin-antibody complexes by the streptavidin-biotin interaction. The signal was amplified because of the high molecular weight of the nanoparticle-streptavidin-antibody conjugate. With prostate-specific antigen as a model analyte, the target concentration as low as 1 pg mL−1 was readily measured. The results of the nanoparticle-enhanced SPR biosensor for analysis of serum samples are well consistent with those achieved by the enzyme-linked immunosorbent assays. This work is valuable for designing of various optical and electronic biosensors through the streptavidin-biotin interaction. Graphical abstract
- Open Access
- 24 June 2019
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 9 (34) , 19641-19647
Efficient solid-state emission and reversible mechanofluorochromism of a tetraphenylethene-pyrene-based β-diketonate boron complex
A new twisted donor–acceptor (D–A) dye (BF2-TP) that was composed of tetraphenylethene and pyrene connected with a β-diketonate boron moiety has been synthesized and characterized. Such a dye showed unique intramolecular charge transfer (ICT) features, which were evidenced by spectral analysis and theoretical calculations. More importantly, BF2-TP solid samples exhibited an obvious mechanofluorochromic (MFC) behavior. Upon grinding with a spatula, the as-prepared powder sample illustrated a remarkable red shift of 62 nm, with considerable color contrast from yellow (562 nm) to orange red (624 nm). Its fluorescence color can be reversibly switched by repeating both the grinding–fuming and grinding–annealing processes. The mechanochromism is attributed to the phase transformation between amorphous and crystalline states. The results obtained would be helpful for designing novel MFC materials.
- 24 June 2019
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 9 (34) , 19641-19647
Open AccessEfficient solid-state emission and reversible mechanofluorochromism of a tetraphenylethene-pyrene-based β-diketonate boron complex
A new twisted donor–acceptor (D–A) dye (BF2-TP) that was composed of tetraphenylethene and pyrene connected with a β-diketonate boron moiety has been synthesized and characterized. Such a dye showed unique intramolecular charge transfer (ICT) features, which were evidenced by spectral analysis and theoretical calculations. More importantly, BF2-TP solid samples exhibited an obvious mechanofluorochromic (MFC) behavior. Upon grinding with a spatula, the as-prepared powder sample illustrated a remarkable red shift of 62 nm, with considerable color contrast from yellow (562 nm) to orange red (624 nm). Its fluorescence color can be reversibly switched by repeating both the grinding–fuming and grinding–annealing processes. The mechanochromism is attributed to the phase transformation between amorphous and crystalline states. The results obtained would be helpful for designing novel MFC materials.
- 19 July 2017
- Published by Wiley in Journal of Separation Science
- Vol. 40 (18) , 3725-3733
Dispersive solid‐phase extraction for the determination of trace organochlorine pesticides in apple juices using reduced graphene oxide coated with ZnO nanocomposites as sorbent
In this work, reduced graphene oxide coated with ZnO nanocomposites was used as an efficient sorbent of dispersive solid‐phase extraction and successfully applied for the extraction of organochlorine pesticides from apple juice followed by gas chromatography with mass spectrometry. Several experimental parameters affecting the extraction efficiencies, including the amount of adsorbent, extraction time, and the pH of the sample solution, as well as the type and volume of eluent solvent, were investigated and optimized. Under the optimal experimental conditions, good linearity existed in the range of 1.0–200.0 ng/mL for all the analytes with the correlation coefficients (R2) ranging from 0.9964 to 0.9994. The limits of detection of the method for the compounds were 0.011–0.053 ng/mL. Good reproducibilities were acquired with relative standard deviations below 8.7% for both intraday and interday precision. The recoveries of the method were in the range of 78.1–105.8% with relative standard deviations of 3.3–6.9%.
- 19 July 2017
- Published by Wiley in Journal of Separation Science
- Vol. 40 (18) , 3725-3733
Dispersive solid‐phase extraction for the determination of trace organochlorine pesticides in apple juices using reduced graphene oxide coated with ZnO nanocomposites as sorbent
In this work, reduced graphene oxide coated with ZnO nanocomposites was used as an efficient sorbent of dispersive solid‐phase extraction and successfully applied for the extraction of organochlorine pesticides from apple juice followed by gas chromatography with mass spectrometry. Several experimental parameters affecting the extraction efficiencies, including the amount of adsorbent, extraction time, and the pH of the sample solution, as well as the type and volume of eluent solvent, were investigated and optimized. Under the optimal experimental conditions, good linearity existed in the range of 1.0–200.0 ng/mL for all the analytes with the correlation coefficients (R2) ranging from 0.9964 to 0.9994. The limits of detection of the method for the compounds were 0.011–0.053 ng/mL. Good reproducibilities were acquired with relative standard deviations below 8.7% for both intraday and interday precision. The recoveries of the method were in the range of 78.1–105.8% with relative standard deviations of 3.3–6.9%.
- 21 July 2016
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 6 (73) , 69560-69568
Effects of cyano groups on the properties of thiazole-based β-ketoiminate boron complexes: aggregation-induced emission and mechanofluorochromism
A series of new thiazole-based β-ketoiminate boron complexes BF2-TT-CN, BPh2-TT-CN, BF2-TT and BPh2-TT, have been designed and successfully synthesized. These compounds show clear intramolecular charge transfer (ICT) from the electron donor (triphenylamine unit) to the electron acceptor (the β-iminoenolate boron moiety). It is particularly noteworthy that these compounds exhibit strong cyano-dependent aggregation-induced emission (AIE) and mechanofluorochromic (MFC) properties. In the cyano-substituted derivatives, BF2-TT-CN and BPh2-TT-CN, the high electron affinity of the cyano group confers stronger ICT properties relative to BF2-TT and BPh2-TT. In addition, the internal steric hindrance arising from the cyano group results in more twisted conformations, endowing BF2-TT-CN and BPh2-TT-CN with evident AIE characteristics and reversible mechanofluorochromism. The MFC behavior of BF2-TT-CN (from bright yellow to orange emission, λem from 542 to 599 nm) and BPh2-TT-CN (from bright yellow to orange emission, λem from 549 to 566 nm) is reversible by repeating the grinding-fuming process. However, BF2-TT and BPh2-TT, which lack cyano groups, exhibit no AIE and mechanofluorochromism, partly because of their relatively weak twisted configurations. Therefore, the introduction of the cyano group plays an important role in the strong ICT behavior and excellent mechanofluorochromic AIE properties of BF2-TT-CN and BPh2-TT-CN. These results will be of great help in understanding the AIE and MFC mechanisms and designing new MFC AIE materials.
- 21 July 2016
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 6 (73) , 69560-69568
Effects of cyano groups on the properties of thiazole-based β-ketoiminate boron complexes: aggregation-induced emission and mechanofluorochromism
A series of new thiazole-based β-ketoiminate boron complexes BF2-TT-CN, BPh2-TT-CN, BF2-TT and BPh2-TT, have been designed and successfully synthesized. These compounds show clear intramolecular charge transfer (ICT) from the electron donor (triphenylamine unit) to the electron acceptor (the β-iminoenolate boron moiety). It is particularly noteworthy that these compounds exhibit strong cyano-dependent aggregation-induced emission (AIE) and mechanofluorochromic (MFC) properties. In the cyano-substituted derivatives, BF2-TT-CN and BPh2-TT-CN, the high electron affinity of the cyano group confers stronger ICT properties relative to BF2-TT and BPh2-TT. In addition, the internal steric hindrance arising from the cyano group results in more twisted conformations, endowing BF2-TT-CN and BPh2-TT-CN with evident AIE characteristics and reversible mechanofluorochromism. The MFC behavior of BF2-TT-CN (from bright yellow to orange emission, λem from 542 to 599 nm) and BPh2-TT-CN (from bright yellow to orange emission, λem from 549 to 566 nm) is reversible by repeating the grinding-fuming process. However, BF2-TT and BPh2-TT, which lack cyano groups, exhibit no AIE and mechanofluorochromism, partly because of their relatively weak twisted configurations. Therefore, the introduction of the cyano group plays an important role in the strong ICT behavior and excellent mechanofluorochromic AIE properties of BF2-TT-CN and BPh2-TT-CN. These results will be of great help in understanding the AIE and MFC mechanisms and designing new MFC AIE materials.
- Open Access
- 18 January 2016
- Published by MDPI AG in Nanomaterials
- Vol. 6 (1) , 20
A Graphene Oxide-Based Fluorescent Platform for Probing of Phosphatase Activity
We presented a strategy for fabricating graphene oxide (GO)-based fluorescent biosensors to monitor the change of phosphorylation state and detect phosphatase activity. By regulating the interaction between the negatively charged phosphate group and the positively charged amino residue, we found that GO showed different quenching efficiency toward the phosphorylated and dephosphorylated dye-labeled peptides. To demonstrate the application of our method, alkaline phosphatase (ALP) was tested as a model enzyme with phosphorylated fluorescein isothiocyanate (FITC)-labeled short peptide FITC–Gly–Gly–Gly–Tyr(PO32−)–Arg as the probe. When the negatively charged phosphate group in the Tyr residue was removed from the peptide substrate by enzymatic hydrolysis, the resulting FITC–Gly–Gly–Gly–Tyr–Arg was readily adsorbed onto the GO surface through electrostatic interaction. As a result, fluorescence quenching was observed. Furthermore, the method was applied for the screening of phosphatase inhibitors.
- 18 January 2016
- Published by MDPI AG in Nanomaterials
- Vol. 6 (1) , 20
Open AccessA Graphene Oxide-Based Fluorescent Platform for Probing of Phosphatase Activity
We presented a strategy for fabricating graphene oxide (GO)-based fluorescent biosensors to monitor the change of phosphorylation state and detect phosphatase activity. By regulating the interaction between the negatively charged phosphate group and the positively charged amino residue, we found that GO showed different quenching efficiency toward the phosphorylated and dephosphorylated dye-labeled peptides. To demonstrate the application of our method, alkaline phosphatase (ALP) was tested as a model enzyme with phosphorylated fluorescein isothiocyanate (FITC)-labeled short peptide FITC–Gly–Gly–Gly–Tyr(PO32−)–Arg as the probe. When the negatively charged phosphate group in the Tyr residue was removed from the peptide substrate by enzymatic hydrolysis, the resulting FITC–Gly–Gly–Gly–Tyr–Arg was readily adsorbed onto the GO surface through electrostatic interaction. As a result, fluorescence quenching was observed. Furthermore, the method was applied for the screening of phosphatase inhibitors.