Shinya Mizokami
Shinya Mizokami has a total of 49 co-authors. Here are the top co-authors by number of shared publications:
Masato Mizokami
Tokyo Electric Power Company Holdings, Inc
3 shared publicationsTakeshi Honda
Fukushima Daiichi Decontamination and Decommissioning Engineering Company, Tokyo Electric Power Company Holdings, Inc, Tokyo, Japan
3 shared publicationsDaisuke Yamauchi
Fuel Debris Retrieval Program Department, Fukushima Daiichi Decontamination and Decommissioning Engineering Company, Tokyo Electric Power Company Holdings, Inc
2 shared publications- Ayumi Itoh
Tokyo Institute of Technology
1 shared publication - Christopher L. Morris
Los Alamos National Laboratory (LANL), Los Alamos, NM (United States)
1 shared publication Daichi Yamada
Nuclear Asset Management Department, Tokyo Electric Power Company 1-1-3 Uchisaiwai-cho Chiyoda-ku, Tokyo, Japan
1 shared publication
Latest Publications
- Open Access
- 15 November 2026
- Published by Springer Nature in Scientific Reports
Application of Raman spectroscopy to the first actual fuel debris retrieved from the Fukushima Daiichi Nuclear Power Station Unit 2
Following the successful first trial retrieval of fuel debris from Unit 2 of the Fukushima Daiichi Nuclear Power Station (FDNPS), a Raman spectroscopic assessment was conducted to investigate the chemical states of the debris. The powdered fuel debris sample, prepared via a vibratory mill, was analyzed using micro-Raman spectroscopy and was compared with simulated debris synthesized under controlled conditions. The average Raman spectrum revealed characteristic bands corresponding to tetragonal ZrO₂, spinel-type oxides originating from stainless-steel structural components, and a cubic (U, Zr)O₂ solid solution. The Raman spectrum of the retrieved fuel debris differed significantly from that of uranium-containing particles (UP1) previously sampled from stagnant water at torus room of Unit 2 of the FDNPS, indicating that further sampling and analysis are required to fully understand the overall chemical complexity of the fuel debris. Raman spectroscopy proved effective for identifying oxidative products in the fuel debris, requiring only minimal sample amounts and no vacuum or coating pretreatments. This study highlights the method’s potential as a valuable tool in nuclear decommissioning efforts, especially for the characterization of uranium bearing compounds in fuel debris.
- 15 November 2026
- Published by Springer Nature in Scientific Reports
Open AccessApplication of Raman spectroscopy to the first actual fuel debris retrieved from the Fukushima Daiichi Nuclear Power Station Unit 2
Following the successful first trial retrieval of fuel debris from Unit 2 of the Fukushima Daiichi Nuclear Power Station (FDNPS), a Raman spectroscopic assessment was conducted to investigate the chemical states of the debris. The powdered fuel debris sample, prepared via a vibratory mill, was analyzed using micro-Raman spectroscopy and was compared with simulated debris synthesized under controlled conditions. The average Raman spectrum revealed characteristic bands corresponding to tetragonal ZrO₂, spinel-type oxides originating from stainless-steel structural components, and a cubic (U, Zr)O₂ solid solution. The Raman spectrum of the retrieved fuel debris differed significantly from that of uranium-containing particles (UP1) previously sampled from stagnant water at torus room of Unit 2 of the FDNPS, indicating that further sampling and analysis are required to fully understand the overall chemical complexity of the fuel debris. Raman spectroscopy proved effective for identifying oxidative products in the fuel debris, requiring only minimal sample amounts and no vacuum or coating pretreatments. This study highlights the method’s potential as a valuable tool in nuclear decommissioning efforts, especially for the characterization of uranium bearing compounds in fuel debris.
- Open Access
- 7 June 2024
- Published by Taylor & Francis in Nuclear Technology
- Vol. 211 (3) , 513-530
Evaluation of Fukushima Daiichi Unit 1 Ex-Vessel Phenomenon Leveraging on Primary Containment Vessel Robotic Inspections
- 7 June 2024
- Published by Taylor & Francis in Nuclear Technology
- Vol. 211 (3) , 513-530
Open AccessEvaluation of Fukushima Daiichi Unit 1 Ex-Vessel Phenomenon Leveraging on Primary Containment Vessel Robotic Inspections
- Open Access
- 13 May 2024
- Published by Taylor & Francis in Journal of Nuclear Science and Technology
- Vol. 61 (11) , 1453-1469
Early-phase core degradation interpretation by interaction between fuel cladding and fuel components in Fukushima Daiichi nuclear power plant Unit 2
- 13 May 2024
- Published by Taylor & Francis in Journal of Nuclear Science and Technology
- Vol. 61 (11) , 1453-1469
Open AccessEarly-phase core degradation interpretation by interaction between fuel cladding and fuel components in Fukushima Daiichi nuclear power plant Unit 2
- 15 December 2020
- Published by Taylor & Francis in Journal of Nuclear Science and Technology
- Vol. 58 (4) , 426-433
Inference of containment depressurization scenario of Fukushima Daiichi Nuclear Power Plant Unit-2 during the Morning of March 15th, 2011
The D/W pressure at Fukushima Daiichi Nuclear Power Plant Unit-2 dropped from 0.73 MPa [abs] to 0.155 MPa [abs] between 7:20 and 11:20 on the March15th, 2011. We assumed gas leakage from the PCV and steam condensation in the PCV as factors of this depressurization, and examined the feasibility of the accident progression scenario based on the observation facts obtained from the site. In case assuming that the PCV was depressurized only by the gas leak, it is necessary to think that there was alarge-scale leak including those other than the top head flange. However, it is difficult to explain the consistency with the observation facts obtained after the accident, such as relatively high airtightness of the PCV of Unit-2, and relatively low dose rate in the reactor building other than the operation floor. On the other hand, in case assuming that the PCV was depressurized by the condensation in addition to relatively small scale gas leak, it becomes easy to explain the consistency with the observation facts.
- 15 December 2020
- Published by Taylor & Francis in Journal of Nuclear Science and Technology
- Vol. 58 (4) , 426-433
Inference of containment depressurization scenario of Fukushima Daiichi Nuclear Power Plant Unit-2 during the Morning of March 15th, 2011
The D/W pressure at Fukushima Daiichi Nuclear Power Plant Unit-2 dropped from 0.73 MPa [abs] to 0.155 MPa [abs] between 7:20 and 11:20 on the March15th, 2011. We assumed gas leakage from the PCV and steam condensation in the PCV as factors of this depressurization, and examined the feasibility of the accident progression scenario based on the observation facts obtained from the site. In case assuming that the PCV was depressurized only by the gas leak, it is necessary to think that there was alarge-scale leak including those other than the top head flange. However, it is difficult to explain the consistency with the observation facts obtained after the accident, such as relatively high airtightness of the PCV of Unit-2, and relatively low dose rate in the reactor building other than the operation floor. On the other hand, in case assuming that the PCV was depressurized by the condensation in addition to relatively small scale gas leak, it becomes easy to explain the consistency with the observation facts.
- 1 December 2019
- Published by Elsevier in Nuclear Engineering and Design
- Vol. 354, 110217
Confirmation of severe accident code modeling in light of the findings at Fukushima Daiichi NPPs
- 1 December 2019
- Published by Elsevier in Nuclear Engineering and Design
- Vol. 354, 110217
Confirmation of severe accident code modeling in light of the findings at Fukushima Daiichi NPPs
- 8 January 2016
- Published by Taylor & Francis in Journal of Nuclear Science and Technology
- Vol. 53 (5) , 630-638
Unsolved issues related to thermal-hydraulics in the suppression chamber during Fukushima Daiichi accident progressions
On 11 March 2011, the Great East Japan Earthquake and Tsunami hit the Fukushima Daiichi Nuclear Power Station. The Fukushima Daiichi Units 1–3 lost all DC and AC power supplies, which set in motion a chain of events that led to releases of radioactivity to the environment. Since then, TEPCO has made many efforts to investigate the accident progressions and the status of the reactors and containment vessels. However, there still exist several tens of unsolved issues to be investigated for the fully understanding of the accident. In this paper, we introduce the unsolved issues related to thermal-hydraulics in the suppression chamber during the Fukushima Daiichi accident progressions. Especially, in Units 2 and 3, there are possibilities that thermal stratification inside their suppression chambers played an important role. It is important that these phenomena are addressed following both theoretical and experimental approaches as support to severe accident simulations.
- 8 January 2016
- Published by Taylor & Francis in Journal of Nuclear Science and Technology
- Vol. 53 (5) , 630-638
Unsolved issues related to thermal-hydraulics in the suppression chamber during Fukushima Daiichi accident progressions
On 11 March 2011, the Great East Japan Earthquake and Tsunami hit the Fukushima Daiichi Nuclear Power Station. The Fukushima Daiichi Units 1–3 lost all DC and AC power supplies, which set in motion a chain of events that led to releases of radioactivity to the environment. Since then, TEPCO has made many efforts to investigate the accident progressions and the status of the reactors and containment vessels. However, there still exist several tens of unsolved issues to be investigated for the fully understanding of the accident. In this paper, we introduce the unsolved issues related to thermal-hydraulics in the suppression chamber during the Fukushima Daiichi accident progressions. Especially, in Units 2 and 3, there are possibilities that thermal stratification inside their suppression chambers played an important role. It is important that these phenomena are addressed following both theoretical and experimental approaches as support to severe accident simulations.
- Open Access
- 2 December 2014
- Published by Springer Nature
- p. 21-50
Event Sequence of the Fukushima Daiichi Accident
- 2 December 2014
- Published by Springer Nature
- p. 21-50
Open AccessEvent Sequence of the Fukushima Daiichi Accident
- Open Access
- 13 January 2014
- Published by AIP Publishing in Applied Physics Letters
- Vol. 104 (2) , 024110
Analysis of muon radiography of the Toshiba nuclear critical assembly reactor
A 1.2 × 1.2 m2 muon tracker was moved from Los Alamos to the Toshiba facility at Kawasaki, Japan, where it was used to take ∼4 weeks of data radiographing the Toshiba Critical Assembly Reactor with cosmic ray muons. In this paper, we describe the analysis procedure, show results of this experiment, and compare the results to Monte Carlo predictions. The results validate the concept of using cosmic rays to image the damaged cores of the Fukushima Daiichi reactors.
- 13 January 2014
- Published by AIP Publishing in Applied Physics Letters
- Vol. 104 (2) , 024110
Open AccessAnalysis of muon radiography of the Toshiba nuclear critical assembly reactor
A 1.2 × 1.2 m2 muon tracker was moved from Los Alamos to the Toshiba facility at Kawasaki, Japan, where it was used to take ∼4 weeks of data radiographing the Toshiba Critical Assembly Reactor with cosmic ray muons. In this paper, we describe the analysis procedure, show results of this experiment, and compare the results to Monte Carlo predictions. The results validate the concept of using cosmic rays to image the damaged cores of the Fukushima Daiichi reactors.
- Open Access
- 13 December 2007
- Published by Wiley in Science and Technology of Nuclear Installations
- Vol. 2008, 1-11
BWR Stability Issues in Japan
The present paper reviews activates relevant to the boiling water reactor (BWR) stability phenomenon, which has a coupled neutronic and thermal-hydraulic nature, from the viewpoint of model and code developments and their applications to the BWR stability solution methodology in Japan.
- 13 December 2007
- Published by Wiley in Science and Technology of Nuclear Installations
- Vol. 2008, 1-11
Open AccessBWR Stability Issues in Japan
The present paper reviews activates relevant to the boiling water reactor (BWR) stability phenomenon, which has a coupled neutronic and thermal-hydraulic nature, from the viewpoint of model and code developments and their applications to the BWR stability solution methodology in Japan.