Victor P. Zhukov
Research Subjects
Research Interests
Victor P. Zhukov has a total of 104 co-authors. Here are the top co-authors by number of shared publications:
- Andrey Starikovskiy
NEQLab LLC, USA
13 shared publications Andrei Starikovskii
3 shared publications- Ilya N. Kosarev
Moscow Inst Phys & Technol, Dolgoprudnyi 141700, Moscow Region, Russia
3 shared publications V. A. Sechenov
Moscow Institute of Physics and Technology Dolgoprudny Russia
3 shared publicationsA. E. Rakitin
2 shared publicationsAleksandr Rakitin
2 shared publications
Latest Publications
- 18 January 2022
- Published by Elsevier in Combustion and Flame
- Vol. 238
Hydrogen-oxygen flame acceleration in narrow open ended channels
- 18 January 2022
- Published by Elsevier in Combustion and Flame
- Vol. 238
Hydrogen-oxygen flame acceleration in narrow open ended channels
- Open Access
Simulation of a GOx-GCH4 Rocket Combustor and the Effect of the GEKO Turbulence Model Coefficients
In this study, a single injector methane-oxygen rocket combustor is numerically studied. The simulations included in this study are based on the hardware and experimental data from the Technical University of Munich. The focus is on the recently developed generalized k–ω turbulence model (GEKO) and the effect of its adjustable coefficients on the pressure and on wall heat flux profiles, which are compared with the experimental data. It was found that the coefficients of ‘jet’, ‘near-wall’, and ‘mixing’ have a major impact, whereas the opposite can be deduced about the ‘separation’ parameter Csep, which highly influences the pressure and wall heat flux distributions due to the changes in the eddy-viscosity field. The simulation results are compared with the standard k–ε model, displaying a qualitatively and quantitatively similar behavior to the GEKO model at a Csep equal to unity. The default GEKO model shows a stable performance for three oxidizer-to-fuel ratios, enhancing the reliability of its use. The simulations are conducted using two chemical kinetic mechanisms: Zhukov and Kong and the more detailed RAMEC. The influence of the combustion model is of the same order as the influence of the turbulence model. In general, the numerical results present a good or satisfactory agreement with the experiment, and both GEKO at Csep = 1 or the standard k–ε model can be recommended for usage in the CFD simulations of rocket combustion chambers, as well as the Zhukov–Kong mechanism in conjunction with the flamelet approach.
Open AccessSimulation of a GOx-GCH4 Rocket Combustor and the Effect of the GEKO Turbulence Model Coefficients
In this study, a single injector methane-oxygen rocket combustor is numerically studied. The simulations included in this study are based on the hardware and experimental data from the Technical University of Munich. The focus is on the recently developed generalized k–ω turbulence model (GEKO) and the effect of its adjustable coefficients on the pressure and on wall heat flux profiles, which are compared with the experimental data. It was found that the coefficients of ‘jet’, ‘near-wall’, and ‘mixing’ have a major impact, whereas the opposite can be deduced about the ‘separation’ parameter Csep, which highly influences the pressure and wall heat flux distributions due to the changes in the eddy-viscosity field. The simulation results are compared with the standard k–ε model, displaying a qualitatively and quantitatively similar behavior to the GEKO model at a Csep equal to unity. The default GEKO model shows a stable performance for three oxidizer-to-fuel ratios, enhancing the reliability of its use. The simulations are conducted using two chemical kinetic mechanisms: Zhukov and Kong and the more detailed RAMEC. The influence of the combustion model is of the same order as the influence of the turbulence model. In general, the numerical results present a good or satisfactory agreement with the experiment, and both GEKO at Csep = 1 or the standard k–ε model can be recommended for usage in the CFD simulations of rocket combustion chambers, as well as the Zhukov–Kong mechanism in conjunction with the flamelet approach.
- Open Access
Future Fuels—Analyses of the Future Prospects of Renewable Synthetic Fuels
The Future Fuels project combines research in several institutes of the German Aerospace Center (DLR) on the production and use of synthetic fuels for space, energy, transportation, and aviation. This article gives an overview of the research questions considered and results achieved so far and also provides insight into the multidimensional and interdisciplinary project approach. Various methods and models were used which are embedded in the research context and based on established approaches. The prospects for large-scale fuel production using renewable electricity and solar radiation played a key role in the project. Empirical and model-based investigations of the technological and cost-related aspects were supplemented by modelling of the integration into a future electricity system. The composition, properties, and the related performance and emissions of synthetic fuels play an important role both for potential oxygenated drop-in fuels in road transport and for the design and certification of alternative aviation fuels. In addition, possible green synthetic fuels as an alternative to highly toxic hydrazine were investigated with different tools and experiments using combustion chambers. The results provide new answers to many research questions. The experiences with the interdisciplinary approach of Future Fuels are relevant for the further development of research topics and co-operations in this field.
Open AccessFuture Fuels—Analyses of the Future Prospects of Renewable Synthetic Fuels
The Future Fuels project combines research in several institutes of the German Aerospace Center (DLR) on the production and use of synthetic fuels for space, energy, transportation, and aviation. This article gives an overview of the research questions considered and results achieved so far and also provides insight into the multidimensional and interdisciplinary project approach. Various methods and models were used which are embedded in the research context and based on established approaches. The prospects for large-scale fuel production using renewable electricity and solar radiation played a key role in the project. Empirical and model-based investigations of the technological and cost-related aspects were supplemented by modelling of the integration into a future electricity system. The composition, properties, and the related performance and emissions of synthetic fuels play an important role both for potential oxygenated drop-in fuels in road transport and for the design and certification of alternative aviation fuels. In addition, possible green synthetic fuels as an alternative to highly toxic hydrazine were investigated with different tools and experiments using combustion chambers. The results provide new answers to many research questions. The experiences with the interdisciplinary approach of Future Fuels are relevant for the further development of research topics and co-operations in this field.
- Open Access
- 1 August 2019
- Published by Elsevier in Acta Astronautica
- Vol. 161, 524-530
The impact of methane oxidation kinetics on a rocket nozzle flow
- 1 August 2019
- Published by Elsevier in Acta Astronautica
- Vol. 161, 524-530
Open AccessThe impact of methane oxidation kinetics on a rocket nozzle flow
- Open Access
- 26 February 2019
- Published by Taylor & Francis in Combustion Science and Technology
- Vol. 192 (3) , 531-546
Extended Eddy-Dissipation Model for Modeling Hydrogen Rocket Combustors
In the work, an extension of the eddy-dissipation model (EDM) is developed to simulate turbulent combustion of hydrogen in undiluted oxygen in rocket combustion chambers. The modification of the eddy-dissipation model allows eliminating of main demerits of the original EDM model. This is achieved by introducing additional parameters into the model, which limit the reaction rate and depend on the local stoichiometry and temperature. The main such parameter is “Maximum flame temperature,” which depends on local stoichiometry and takes into account the dissociation of combustion products. The extension of the EDM model is based on the framework provided by ANSYS CFX. The new turbulent combustion model is validated against experimental data from three different subscale rocket combustors. The validation of the model is carried out against data on pressure and wall heat flux, which are the main targets of simulations of rocket combustion chambers.
- 26 February 2019
- Published by Taylor & Francis in Combustion Science and Technology
- Vol. 192 (3) , 531-546
Open AccessExtended Eddy-Dissipation Model for Modeling Hydrogen Rocket Combustors
In the work, an extension of the eddy-dissipation model (EDM) is developed to simulate turbulent combustion of hydrogen in undiluted oxygen in rocket combustion chambers. The modification of the eddy-dissipation model allows eliminating of main demerits of the original EDM model. This is achieved by introducing additional parameters into the model, which limit the reaction rate and depend on the local stoichiometry and temperature. The main such parameter is “Maximum flame temperature,” which depends on local stoichiometry and takes into account the dissociation of combustion products. The extension of the EDM model is based on the framework provided by ANSYS CFX. The new turbulent combustion model is validated against experimental data from three different subscale rocket combustors. The validation of the model is carried out against data on pressure and wall heat flux, which are the main targets of simulations of rocket combustion chambers.
- Open Access
- 8 August 2018
- Published by Elsevier in Acta Astronautica
- Vol. 158, 438-443
Evaluation of the grid convergence for a rocket combustion chamber with a porous injector
- 8 August 2018
- Published by Elsevier in Acta Astronautica
- Vol. 158, 438-443
Open AccessEvaluation of the grid convergence for a rocket combustion chamber with a porous injector
- Open Access
- 1 March 2018
- Published by SAGE Publications in Progress in Reaction Kinetics and Mechanism
- Vol. 43 (1) , 62-78
A Compact Reaction Mechanism of Methane Oxidation at High Pressures
A skeletal methane kinetic mechanism is developed for conditions relating to the combustion of undiluted methane–oxygen mixtures at high pressures. The new skeletal mechanism is based on the detailed mechanism of oxidation of alkanes by Zhukov (2009). The skeletal model has been created by eliminating unimportant species and reactions from the detailed mechanism. The reduction technique is based on the reaction path and sensitivity analyses. They allow one to determine the reactions and species that play important roles in combustion in rocket combustion chambers. The skeletal mechanism consists of 23 species and 51 reactions. The final and intermediate versions of the skeletal mechanism are compared with the parent detailed mechanism, with other reduced kinetic models and with experimental data on the ignition of methane at high pressures. This comparison shows that the developed skeletal mechanism has a better performance than other kinetic mechanisms in terms of accuracy and required computational power.
- 1 March 2018
- Published by SAGE Publications in Progress in Reaction Kinetics and Mechanism
- Vol. 43 (1) , 62-78
Open AccessA Compact Reaction Mechanism of Methane Oxidation at High Pressures
A skeletal methane kinetic mechanism is developed for conditions relating to the combustion of undiluted methane–oxygen mixtures at high pressures. The new skeletal mechanism is based on the detailed mechanism of oxidation of alkanes by Zhukov (2009). The skeletal model has been created by eliminating unimportant species and reactions from the detailed mechanism. The reduction technique is based on the reaction path and sensitivity analyses. They allow one to determine the reactions and species that play important roles in combustion in rocket combustion chambers. The skeletal mechanism consists of 23 species and 51 reactions. The final and intermediate versions of the skeletal mechanism are compared with the parent detailed mechanism, with other reduced kinetic models and with experimental data on the ignition of methane at high pressures. This comparison shows that the developed skeletal mechanism has a better performance than other kinetic mechanisms in terms of accuracy and required computational power.
- Open Access
- 27 June 2017
- Published by Wiley in International Journal of Aerospace Engineering
- Vol. 2017, 1-11
Numerical Simulations of the Flame of a Single Coaxial Injector
The processes of mixing and combustion in the jet of a shear-coaxial injector are investigated. Two test cases (nonreacting and reacting) are simulated using the commercial computational fluid dynamics code ANSYS CFX. The first test case is an experiment on the mixing in a nonreacting coaxial jet carried out with the use of planar laser induced fluorescence (PLIF). The second test case is an experiment on the visualization of hydrogen-oxygen flame using PLIF of OH in a single injector combustion chamber at pressure of 53 bar. In the first test case, the two-dimensional axisymmetric simulations are performed using the shear-stress turbulence (SST) model. Due to the dominant flow unsteadiness in the second test case, the turbulence is modeled using transient SAS (Scale-Adaptive Simulation) model. The combustion is modeled using the burning velocity model (BVM) while both two- and three-dimensional simulations are carried out. The numerical model agrees with the experimental data very well in the first test case and adequately in the second test case.
- 27 June 2017
- Published by Wiley in International Journal of Aerospace Engineering
- Vol. 2017, 1-11
Open AccessNumerical Simulations of the Flame of a Single Coaxial Injector
The processes of mixing and combustion in the jet of a shear-coaxial injector are investigated. Two test cases (nonreacting and reacting) are simulated using the commercial computational fluid dynamics code ANSYS CFX. The first test case is an experiment on the mixing in a nonreacting coaxial jet carried out with the use of planar laser induced fluorescence (PLIF). The second test case is an experiment on the visualization of hydrogen-oxygen flame using PLIF of OH in a single injector combustion chamber at pressure of 53 bar. In the first test case, the two-dimensional axisymmetric simulations are performed using the shear-stress turbulence (SST) model. Due to the dominant flow unsteadiness in the second test case, the turbulence is modeled using transient SAS (Scale-Adaptive Simulation) model. The combustion is modeled using the burning velocity model (BVM) while both two- and three-dimensional simulations are carried out. The numerical model agrees with the experimental data very well in the first test case and adequately in the second test case.
- 27 December 2016
- Published by Springer Nature in CEAS Space Journal
- Vol. 9 (2) , 211-225
Analysis of the laser ignition of methane/oxygen mixtures in a sub-scale rocket combustion chamber
- 27 December 2016
- Published by Springer Nature in CEAS Space Journal
- Vol. 9 (2) , 211-225
Analysis of the laser ignition of methane/oxygen mixtures in a sub-scale rocket combustion chamber