Peng Cao

This figure reflects the process flow diagram of low-temperature SCR DeNO_x and the test efficiency of 3400 h.

This study investigated the symbiotic structure relationship between mixed algae and activated sludge while treating high-load printing and dyeing wastewater under natural light. The effects of hydraulic retention time (HRT) (12 h, 16 h and 20 h) and aeration rate (0.1–0.15, 0.4–0.5 and 0.7–0.8 L/min) on algal–bacterial symbiosis (ABS) and conventional activated sludge (CAS) systems. Experimental results showed that the ABS system exhibited the best removal performance for chemical oxygen demand (COD), ammonia nitrogen (NH₄⁺-N) and total phosphorus (TP), which was increased by 12.5%, 23.1% and 10.5%, respectively, and reduced colour 80 times compared with the printing and dyeing wastewater treatment plant. Algae growth could be promoted under lower dissolved oxygen (DO), and the addition of algae could provide more DO to the ABS system. The particle size distribution of sludge in the ABS system was stable, which guaranteed a stable treatment effect. In addition, the COD and colour could be further degraded under the conditions of no external carbon source and longer HRT. It is expected that the present study will provide a foundation for the practical application of the ABS system, and new insights for the treatment of printing and dyeing wastewater.

A two-dimensional MnAl-layered double oxide (LDO) was obtained by flash nanoprecipitation method (FNP) and used for the selective catalytic reduction of NO_x with NH₃. The MnAl-LDO (FNP) catalyst formed a particle size of 114.9 nm. Further characterization exhibited rich oxygen vacancies and strong redox property to promote the catalytic activity at low temperature. The MnAl-LDO (FNP) catalyst performed excellent NO conversion above 80% at the temperature range of 100–400 °C, and N₂ selectivity above 90% below 200 °C, with a gas hourly space velocity (GHSV) of 60,000 h⁻¹, and a NO concentration of 500 ppm. The maximum NO conversion is 100% at 200 °C; when the temperature in 150–250 °C, the NO conversion can also reach 95%. The remarkable low-temperature catalytic performance of the MnAl-LDO (FNP) catalyst presented potential applications for controlling NO emissions on the account of the presentation of oxygen vacancies.

The influent chemical oxygen demand (COD) of tomato paste wastewater changes with the quality of the raw material without any evident trend. The required aeration also changes irregularly during treatment. If the actual aeration rate is set at maximum and does not change, the treating cost increases. Thus, an adaptable aeration strategy based on simple data, such as the removal of COD and mixed liquor suspended solids (MLSS), must be established. The plug-flow activated sludge system of Shihezi Tianye Tomato Products Co., Ltd., was used to establish the relationship between the theoretical aeration rates and the removal of COD and MLSS in different regions. The calculation bases of the theoretical aeration rates at different COD loadings were determined. A flexible aeration strategy based on the removal of COD and MLSS was used to analogically calculate and compare the actual aeration patterns from 2010. The proposed method can decrease aeration rate by 8%.