Sattar Al-Kabi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Sattar Al-Kabi has a total of 86 co-authors. Here are the top co-authors by number of shared publications:
Shui-Qing Yu
21 shared publicationsAboozar Mosleh
Microelectronics-Photonics Program, University of Arkansas, Fayetteville, AR, 72701, USA
19 shared publicationsBaohua Li
Arktonics, LLC. 1339 South Pinnacle Drive, Fayetteville, Arkansas 72701, USA
19 shared publicationsMansour Mortazavi
Department of Chemistry and Physics, University of Arkansas at Pine Bluff, Pine Bluff, Arkansas 71601, USA
19 shared publicationsJoe Margetis
ASM, 3440 East University Drive, Phoenix, Arizona 85034, USA
18 shared publicationsJohn Tolle
ASM, 3440 East University Drive, Phoenix, Arizona 85034, USA
18 shared publications
Latest Publications
- Open Access
- 14 November 2019
- Published by Springer Nature in Scientific Reports
- Vol. 9 (1) , 1-8
High Temperature and Power Dependent Photoluminescence Analysis on Commercial Lighting and Display LED Materials for Future Power Electronic Modules
Commercial light emitting diode (LED) materials - blue (i.e., InGaN/GaN multiple quantum wells (MQWs) for display and lighting), green (i.e., InGaN/GaN MQWs for display), and red (i.e., Al0.05Ga0.45In0.5P/Al0.4Ga0.1In0.5P for display) are evaluated in range of temperature (77–800) K for future applications in high density power electronic modules. The spontaneous emission quantum efficiency (QE) of blue, green, and red LED materials with different wavelengths was calculated using photoluminescence (PL) spectroscopy. The spontaneous emission QE was obtained based on a known model so-called the ABC model. This model has been recently used extensively to calculate the internal quantum efficiency and its droop in the III-nitride LED. At 800 K, the spontaneous emission quantum efficiencies are around 40% for blue for lighting and blue for display LED materials, and it is about 44.5% for green for display LED materials. The spontaneous emission QE is approximately 30% for red for display LED material at 800 K. The advance reported in this paper evidences the possibility of improving high temperature optocouplers with an operating temperature of 500 K and above.
- 14 November 2019
- Published by Springer Nature in Scientific Reports
- Vol. 9 (1) , 1-8
Open AccessHigh Temperature and Power Dependent Photoluminescence Analysis on Commercial Lighting and Display LED Materials for Future Power Electronic Modules
Commercial light emitting diode (LED) materials - blue (i.e., InGaN/GaN multiple quantum wells (MQWs) for display and lighting), green (i.e., InGaN/GaN MQWs for display), and red (i.e., Al0.05Ga0.45In0.5P/Al0.4Ga0.1In0.5P for display) are evaluated in range of temperature (77–800) K for future applications in high density power electronic modules. The spontaneous emission quantum efficiency (QE) of blue, green, and red LED materials with different wavelengths was calculated using photoluminescence (PL) spectroscopy. The spontaneous emission QE was obtained based on a known model so-called the ABC model. This model has been recently used extensively to calculate the internal quantum efficiency and its droop in the III-nitride LED. At 800 K, the spontaneous emission quantum efficiencies are around 40% for blue for lighting and blue for display LED materials, and it is about 44.5% for green for display LED materials. The spontaneous emission QE is approximately 30% for red for display LED material at 800 K. The advance reported in this paper evidences the possibility of improving high temperature optocouplers with an operating temperature of 500 K and above.
- Open Access
- 1 January 2019
- Published by ASTES Journal in Advances in Science, Technology and Engineering Systems Journal
- Vol. 4 (2) , 17-22
High-Temperature Optical Characterization of Wide Band Gap Light Emitting Diodes and Photodiodes for Future Power Module Application
- 1 January 2019
- Published by ASTES Journal in Advances in Science, Technology and Engineering Systems Journal
- Vol. 4 (2) , 17-22
Open AccessHigh-Temperature Optical Characterization of Wide Band Gap Light Emitting Diodes and Photodiodes for Future Power Module Application
- 22 November 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Emerging and Selected Topics in Power Electronics
- Vol. 8 (1) , 845-853
Systematic Investigation of Spontaneous Emission Quantum Efficiency Drop up to 800 K for Future Power Electronics Applications
Future high-density power electronics applications may require high-temperature optoelectronic devices for gate drive. Thus, a systematic study of optoelectronic material from 10 to 800 K has been performed to understand the potential of the high-temperature operation of optoelectronic devices. The temperature dependence of the photoluminescence (PL) of indium gallium nitride/gallium nitride multiple quantum wells was studied. The integrated PL intensity dropped by an order of magnitude at 800 K compared to 10 K. The spontaneous emission quantum efficiency was calculated from the power-law relation linking the integrated PL signal and the excitation pump power. The validation of the traditional ABC model for solid-state lighting is extended to 800 K. This paper demonstrates the feasibility of developing high-temperature optoelectronic devices, which have operating temperatures over 500 K.
- 22 November 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Emerging and Selected Topics in Power Electronics
- Vol. 8 (1) , 845-853
Systematic Investigation of Spontaneous Emission Quantum Efficiency Drop up to 800 K for Future Power Electronics Applications
Future high-density power electronics applications may require high-temperature optoelectronic devices for gate drive. Thus, a systematic study of optoelectronic material from 10 to 800 K has been performed to understand the potential of the high-temperature operation of optoelectronic devices. The temperature dependence of the photoluminescence (PL) of indium gallium nitride/gallium nitride multiple quantum wells was studied. The integrated PL intensity dropped by an order of magnitude at 800 K compared to 10 K. The spontaneous emission quantum efficiency was calculated from the power-law relation linking the integrated PL signal and the excitation pump power. The validation of the traditional ABC model for solid-state lighting is extended to 800 K. This paper demonstrates the feasibility of developing high-temperature optoelectronic devices, which have operating temperatures over 500 K.
- 17 September 2018
- Published by Optica Publishing Group in Optics Letters
- Vol. 43 (19) , 4558-4561
Optically pumped lasing at 3 μm from compositionally graded GeSn with tin up to 22.3%
The recent demonstration of the GeSn laser opened a promising route towards the monolithic integration of light sources on the Si platform. A GeSn laser with higher Sn content is highly desirable to enhance the emission efficiency and to cover longer wavelength. This Letter reports optically pumped edge-emitting GeSn lasers operating at 3 μm, whose device structure featured Sn compositionally graded with a maximum Sn content of 22.3%. By using a 1950-nm laser pumping in comparison with a 1064-nm pumping, the local heating and quantum defect were effectively reduced, which improved laser performance in terms of higher maximum lasing temperature and lower threshold.
- 17 September 2018
- Published by Optica Publishing Group in Optics Letters
- Vol. 43 (19) , 4558-4561
Optically pumped lasing at 3 μm from compositionally graded GeSn with tin up to 22.3%
The recent demonstration of the GeSn laser opened a promising route towards the monolithic integration of light sources on the Si platform. A GeSn laser with higher Sn content is highly desirable to enhance the emission efficiency and to cover longer wavelength. This Letter reports optically pumped edge-emitting GeSn lasers operating at 3 μm, whose device structure featured Sn compositionally graded with a maximum Sn content of 22.3%. By using a 1950-nm laser pumping in comparison with a 1064-nm pumping, the local heating and quantum defect were effectively reduced, which improved laser performance in terms of higher maximum lasing temperature and lower threshold.
- 1 September 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
High Temperature Photoluminsence of InGaN-Based MQWs on Patterned Sapphire Substrates
Temperature and power dependent photoluminescence (PL) measurements from InGaN/GaN MQWs has been studied from 77 to 800 K to extract the PL efficiency. The laser powers at maximum quantum efficiency in a wide range of temperatures are calculated.
- 1 September 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
High Temperature Photoluminsence of InGaN-Based MQWs on Patterned Sapphire Substrates
Temperature and power dependent photoluminescence (PL) measurements from InGaN/GaN MQWs has been studied from 77 to 800 K to extract the PL efficiency. The laser powers at maximum quantum efficiency in a wide range of temperatures are calculated.
- 9 April 2018
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 47 (7) , 3733-3740
GePb Alloy Growth Using Layer Inversion Method
- 9 April 2018
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 47 (7) , 3733-3740
GePb Alloy Growth Using Layer Inversion Method
- Open Access
- 4 April 2018
- Published by Springer Nature in Scientific Reports
- Vol. 8 (1) , 1-11
Investigation of GeSn Strain Relaxation and Spontaneous Composition Gradient for Low-Defect and High-Sn Alloy Growth
Recent development of group-IV alloy GeSn indicates its bright future for the application of mid-infrared Si photonics. Relaxed GeSn with high material quality and high Sn composition is highly desirable to cover mid-infrared wavelength. However, its crystal growth remains a great challenge. In this work, a systematic study of GeSn strain relaxation mechanism and its effects on Sn incorporation during the material growth via chemical vapor deposition was conducted. It was discovered that Sn incorporation into Ge lattice sites is limited by high compressive strain rather than historically acknowledged chemical reaction dynamics, which was also confirmed by Gibbs free energy calculation. In-depth material characterizations revealed that: (i) the generation of dislocations at Ge/GeSn interface eases the compressive strain, which offers a favorably increased Sn incorporation; (ii) the formation of dislocation loop near Ge/GeSn interface effectively localizes defects, leading to the subsequent low-defect grown GeSn. Following the discovered growth mechanism, a world-record Sn content of 22.3% was achieved. The experiment result shows that even higher Sn content could be obtained if further continuous growth with the same recipe is conducted. This report offers an essential guidance for the growth of high quality high Sn composition GeSn for future GeSn based optoelectronics.
- 4 April 2018
- Published by Springer Nature in Scientific Reports
- Vol. 8 (1) , 1-11
Open AccessInvestigation of GeSn Strain Relaxation and Spontaneous Composition Gradient for Low-Defect and High-Sn Alloy Growth
Recent development of group-IV alloy GeSn indicates its bright future for the application of mid-infrared Si photonics. Relaxed GeSn with high material quality and high Sn composition is highly desirable to cover mid-infrared wavelength. However, its crystal growth remains a great challenge. In this work, a systematic study of GeSn strain relaxation mechanism and its effects on Sn incorporation during the material growth via chemical vapor deposition was conducted. It was discovered that Sn incorporation into Ge lattice sites is limited by high compressive strain rather than historically acknowledged chemical reaction dynamics, which was also confirmed by Gibbs free energy calculation. In-depth material characterizations revealed that: (i) the generation of dislocations at Ge/GeSn interface eases the compressive strain, which offers a favorably increased Sn incorporation; (ii) the formation of dislocation loop near Ge/GeSn interface effectively localizes defects, leading to the subsequent low-defect grown GeSn. Following the discovered growth mechanism, a world-record Sn content of 22.3% was achieved. The experiment result shows that even higher Sn content could be obtained if further continuous growth with the same recipe is conducted. This report offers an essential guidance for the growth of high quality high Sn composition GeSn for future GeSn based optoelectronics.
- 1 January 2018
- Published by Optica Publishing Group
- p. JTh2A.79
Investigation of High Temperature Photoluminescence Efficiency from InGaN/GaN MQWs
Temperature and power dependent photoluminescence (PL) measurements from InGaN/GaN MQWs, which was grown on a sapphire substrate were performed to extract the PL efficiency.
- 1 January 2018
- Published by Optica Publishing Group
- p. JTh2A.79
Investigation of High Temperature Photoluminescence Efficiency from InGaN/GaN MQWs
Temperature and power dependent photoluminescence (PL) measurements from InGaN/GaN MQWs, which was grown on a sapphire substrate were performed to extract the PL efficiency.
- Top Cited Papers
- 15 December 2017
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 5 (3) , 827-833
Si-Based GeSn Lasers with Wavelength Coverage of 2–3 μm and Operating Temperatures up to 180 K
- 15 December 2017
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 5 (3) , 827-833
Top Cited PapersSi-Based GeSn Lasers with Wavelength Coverage of 2–3 μm and Operating Temperatures up to 180 K
- 1 November 2017
- Published by Elsevier in Materials Science in Semiconductor Processing
- Vol. 70, 38-43
Fundamentals of Ge 1−x Sn x and Si y Ge 1−x-y Sn x RPCVD epitaxy
- 1 November 2017
- Published by Elsevier in Materials Science in Semiconductor Processing
- Vol. 70, 38-43
Fundamentals of Ge 1−x Sn x and Si y Ge 1−x-y Sn x RPCVD epitaxy