E. Picatoste Olloqui
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
E. Picatoste Olloqui has a total of 1000 co-authors. Here are the top co-authors by number of shared publications:
- Eugeni Grauges
ICCUB, Universitat de Barcelona
228 shared publications - Celestina Satriano
INFN Sezione di Roma La Sapienza
227 shared publications - David Hutchcroft
University of Liverpool
227 shared publications - Lluis Garrido
ICCUB, Universitat de Barcelona
227 shared publications - Mariusz Witek
Henryk Niewodniczanski Institute of Nuclear Physics Polish Academy of Sciences
227 shared publications - Michele Veltri
INFN Sezione di Firenze
227 shared publications
Latest Publications
- 22 January 2026
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 1085
The AdvCam project: Designing the future cameras for the Large-Sized Telescopes of the Cherenkov Telescope Array Observatory
- 22 January 2026
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 1085
The AdvCam project: Designing the future cameras for the Large-Sized Telescopes of the Cherenkov Telescope Array Observatory
- Top Cited PapersOpen Access
- 1 May 2024
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 19 (05) , P05065
The LHCb Upgrade I
The LHCb upgrade represents a major change of the experiment. The detectors have been almost completely renewed to allow running at an instantaneous luminosity five times larger than that of the previous running periods. Readout of all detectors into an all-software trigger is central to the new design, facilitating the reconstruction of events at the maximum LHC interaction rate, and their selection in real time. The experiment's tracking system has been completely upgraded with a new pixel vertex detector, a silicon tracker upstream of the dipole magnet and three scintillating fibre tracking stations downstream of the magnet. The whole photon detection system of the RICH detectors has been renewed and the readout electronics of the calorimeter and muon systems have been fully overhauled. The first stage of the all-software trigger is implemented on a GPU farm. The output of the trigger provides a combination of totally reconstructed physics objects, such as tracks and vertices, ready for final analysis, and of entire events which need further offline reprocessing. This scheme required a complete revision of the computing model and rewriting of the experiment's software.
- 1 May 2024
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 19 (05) , P05065
Top Cited PapersOpen AccessThe LHCb Upgrade I
The LHCb upgrade represents a major change of the experiment. The detectors have been almost completely renewed to allow running at an instantaneous luminosity five times larger than that of the previous running periods. Readout of all detectors into an all-software trigger is central to the new design, facilitating the reconstruction of events at the maximum LHC interaction rate, and their selection in real time. The experiment's tracking system has been completely upgraded with a new pixel vertex detector, a silicon tracker upstream of the dipole magnet and three scintillating fibre tracking stations downstream of the magnet. The whole photon detection system of the RICH detectors has been renewed and the readout electronics of the calorimeter and muon systems have been fully overhauled. The first stage of the all-software trigger is implemented on a GPU farm. The output of the trigger provides a combination of totally reconstructed physics objects, such as tracks and vertices, ready for final analysis, and of entire events which need further offline reprocessing. This scheme required a complete revision of the computing model and rewriting of the experiment's software.
- Open Access
- 1 April 2024
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 19 (04) , C04016
Scintillating sampling ECAL technology for the LHCb ECAL Upgrade II
The aim of the LHCb Upgrade II is to be able to operate at a luminosity of 1.5×1034 cm-2 s-1 to collect a data set of 300 fb-1. The required substantial modifications of the current LHCb electromagnetic calorimeter due to high radiation doses in the central region and increased particle densities are referred to as LHCb ECAL Upgrade II. A consolidation of the ECAL already during the long shutdown 3 will reduce the occupancy and mitigate the effects of substantial ageing in the central region after Run 3. Several scintillating sampling ECAL technologies are being investigated in an ongoing R&D campaign: Spaghetti Calorimeter (SpaCal) with garnet scintillating crystals and tungsten absorber, SpaCal with scintillating plastic fibres and tungsten or lead absorber, and Shashlik with polystyrene tiles, lead absorber and fast WLS fibres. Timing capabilities with tens of picoseconds precision for neutral electromagnetic particles and increased granularity with a denser absorber in the central region are needed for pile-up mitigation. Time resolutions of better than 20 ps at high energy were observed in test beam measurements of prototype SpaCal and Shashlik modules. Energy resolutions with sampling contributions of about 10%/√E, in line with the requirements, were observed.
- 1 April 2024
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 19 (04) , C04016
Open AccessScintillating sampling ECAL technology for the LHCb ECAL Upgrade II
The aim of the LHCb Upgrade II is to be able to operate at a luminosity of 1.5×1034 cm-2 s-1 to collect a data set of 300 fb-1. The required substantial modifications of the current LHCb electromagnetic calorimeter due to high radiation doses in the central region and increased particle densities are referred to as LHCb ECAL Upgrade II. A consolidation of the ECAL already during the long shutdown 3 will reduce the occupancy and mitigate the effects of substantial ageing in the central region after Run 3. Several scintillating sampling ECAL technologies are being investigated in an ongoing R&D campaign: Spaghetti Calorimeter (SpaCal) with garnet scintillating crystals and tungsten absorber, SpaCal with scintillating plastic fibres and tungsten or lead absorber, and Shashlik with polystyrene tiles, lead absorber and fast WLS fibres. Timing capabilities with tens of picoseconds precision for neutral electromagnetic particles and increased granularity with a denser absorber in the central region are needed for pile-up mitigation. Time resolutions of better than 20 ps at high energy were observed in test beam measurements of prototype SpaCal and Shashlik modules. Energy resolutions with sampling contributions of about 10%/√E, in line with the requirements, were observed.
- Open Access
- 1 May 2018
- Published by Elsevier in Nuclear Physics B
- Vol. 930, 563-582
Search for decays to two charm mesons- 1 May 2018
- Published by Elsevier in Nuclear Physics B
- Vol. 930, 563-582
Open AccessSearch for decays to two charm mesons - Top Cited PapersOpen Access
- 25 April 2018
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 120 (17) , 171802
Measurement of the Ratio of the and Branching Fractions Using Three-Prong -Lepton DecaysThe ratio of branching fractions is measured using a data sample of proton-proton collisions collected with the LHCb detector at center-of-mass energies of 7 and 8 TeV, corresponding to an integrated luminosity of . For the first time, is determined using the -lepton decays with three charged pions in the final state. The yield is normalized to that of the mode, providing a measurement of , where the first uncertainty is statistical and the second systematic. The value of is obtained, where the third uncertainty is due to the limited knowledge of the branching fraction of the normalization mode. Using the well-measured branching fraction of the decay, a value of is established, where the third uncertainty is due to the limited knowledge of the branching fractions of the normalization and modes. This measurement is in agreement with the standard model prediction and with previous results.- 25 April 2018
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 120 (17) , 171802
Top Cited PapersOpen AccessMeasurement of the Ratio of the and Branching Fractions Using Three-Prong -Lepton DecaysThe ratio of branching fractions is measured using a data sample of proton-proton collisions collected with the LHCb detector at center-of-mass energies of 7 and 8 TeV, corresponding to an integrated luminosity of . For the first time, is determined using the -lepton decays with three charged pions in the final state. The yield is normalized to that of the mode, providing a measurement of , where the first uncertainty is statistical and the second systematic. The value of is obtained, where the third uncertainty is due to the limited knowledge of the branching fraction of the normalization mode. Using the well-measured branching fraction of the decay, a value of is established, where the third uncertainty is due to the limited knowledge of the branching fractions of the normalization and modes. This measurement is in agreement with the standard model prediction and with previous results. - Open Access
- 23 March 2018
- Published by Springer Nature in Journal of High Energy Physics
- Vol. 2018 (3) , 140
First measurement of the CP-violating phase $ {\phi}_s^{d\overline{d}} $ in B0 s → (K+π−)(K−π+) decays- 23 March 2018
- Published by Springer Nature in Journal of High Energy Physics
- Vol. 2018 (3) , 140
Open AccessFirst measurement of the CP-violating phase $ {\phi}_s^{d\overline{d}} $ in B0 s → (K+π−)(K−π+) decays - Top Cited PapersOpen Access
- 23 March 2018
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 120 (12) , 121801
Measurement of the Ratio of Branching FractionsA measurement is reported of the ratio of branching fractions , where the lepton is identified in the decay mode . This analysis uses a sample of proton-proton collision data corresponding to of integrated luminosity recorded with the LHCb experiment at center-of-mass energies of 7 and 8 TeV. A signal is found for the decay at a significance of 3 standard deviations corrected for systematic uncertainty, and the ratio of the branching fractions is measured to be . This result lies within 2 standard deviations above the range of central values currently predicted by the standard model.- 23 March 2018
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 120 (12) , 121801
Top Cited PapersOpen AccessMeasurement of the Ratio of Branching FractionsA measurement is reported of the ratio of branching fractions , where the lepton is identified in the decay mode . This analysis uses a sample of proton-proton collision data corresponding to of integrated luminosity recorded with the LHCb experiment at center-of-mass energies of 7 and 8 TeV. A signal is found for the decay at a significance of 3 standard deviations corrected for systematic uncertainty, and the ratio of the branching fractions is measured to be . This result lies within 2 standard deviations above the range of central values currently predicted by the standard model. - Open Access
- 13 March 2018
- Published by Springer Nature in Journal of High Energy Physics
- Vol. 2018 (3) , 78
Search for the lepton-flavour violating decays B0( s) → e±μ∓
A search for the lepton-flavour violating decays B s 0 → e ± μ ∓ and B 0 → e ± μ ∓ is performed based on a sample of proton-proton collision data corresponding to an integrated luminosity of 3 fb−1, collected with the LHCb experiment at centre-of-mass energies of 7 and 8 TeV. The observed yields are consistent with the background-only hypothesis. Upper limits on the branching fraction of the B s 0 → e ± μ ∓ decays are evaluated both in the hypotheses of an amplitude completely dominated by the heavy eigenstate and by the light eigenstate. The results are $$ \frac{@}{@}\mathrm{\mathcal{B}}\left({B}_s^0\to {e}^{\pm }{\mu}^{\mp}\right)<6.3(5.4)\times 1{0}^{-9} $$ and $$ \frac{@}{@}\mathrm{\mathcal{B}}\left({B}_s^0\to {e}^{\pm }{\mu}^{\mp}\right)<7.2(6.0)\times 1{0}^{-9} $$ at 95% (90%) confidence level, respectively. The upper limit on the branching fraction of the B 0 → e ± μ ∓ decay is also evaluated, obtaining $$ \frac{@}{@}\mathrm{\mathcal{B}}\left({B}^0\to {e}^{\pm }{\mu}^{\mp}\right)<1.3(1.0)\times 1{0}^{-9} $$ at 95% (90%) confidence level. These are the strongest limits on these decays to date.- 13 March 2018
- Published by Springer Nature in Journal of High Energy Physics
- Vol. 2018 (3) , 78
Open AccessSearch for the lepton-flavour violating decays B0( s) → e±μ∓
A search for the lepton-flavour violating decays B s 0 → e ± μ ∓ and B 0 → e ± μ ∓ is performed based on a sample of proton-proton collision data corresponding to an integrated luminosity of 3 fb−1, collected with the LHCb experiment at centre-of-mass energies of 7 and 8 TeV. The observed yields are consistent with the background-only hypothesis. Upper limits on the branching fraction of the B s 0 → e ± μ ∓ decays are evaluated both in the hypotheses of an amplitude completely dominated by the heavy eigenstate and by the light eigenstate. The results are $$ \frac{@}{@}\mathrm{\mathcal{B}}\left({B}_s^0\to {e}^{\pm }{\mu}^{\mp}\right)<6.3(5.4)\times 1{0}^{-9} $$ and $$ \frac{@}{@}\mathrm{\mathcal{B}}\left({B}_s^0\to {e}^{\pm }{\mu}^{\mp}\right)<7.2(6.0)\times 1{0}^{-9} $$ at 95% (90%) confidence level, respectively. The upper limit on the branching fraction of the B 0 → e ± μ ∓ decay is also evaluated, obtaining $$ \frac{@}{@}\mathrm{\mathcal{B}}\left({B}^0\to {e}^{\pm }{\mu}^{\mp}\right)<1.3(1.0)\times 1{0}^{-9} $$ at 95% (90%) confidence level. These are the strongest limits on these decays to date.