KFKoichiro Fujimoto

Koichiro Fujimoto

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Koichiro Fujimoto has a total of 51 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Surface characterization of the water-treated olivine under different pH conditions at 25°C

    by Koichiro Fujimoto, Fumitaka Sakamoto

    Natural olivine crystals (Fo91) were subjected to water treatment at 25°C under different pH conditions covering 1 to 12. Hydrogen enriched surface layer with the thickness of about 20 nm was detected with X-ray photoelectron spectroscopy (XPS) and resonant nuclear reaction analysis (RNRA). H+ or H3O+ occupies the vacant octahedral sites in the Mg and Fe depleted surface layer at low pH. Molecular water penetrates along defects as deep as 200 nm. On the contrary, Si is selectively leached out and hydroxyl species are formed at high pH. This contrasting surface chemistry results from the difference in the surface species which are responsible for dissolution process under acidic and basic conditions.

  • Depth profiles of different water species for the hydration of silica glass under supercritical conditions by means of micro FT-IR

    by Norio Yanagisawa, Koichiro Fujimoto, Satoru Nakashima, Yoshiaki Kurata, Norio Sanada, J. H. Thomassin

    Hydrothermal hydration of silica glass was experimentally studied with pure water at temperatures of 400-500 °C and pressures of 40-96 MPa. Hydrated surface layers were characterized with optical microscopy, scanning electron microscopy, transmission electron microscopy, and microscopic Fourier transform infrared spectroscopy (micro FT-IR). Silica glass dissolved with nearly constant rate during the run, based on the weight loss. The thickness of the hydration layer increased gradually at the initial stage of the reaction and then reached the constant value at about 100 micro meters after several tens of hours. The concentration depth profiles of both OH group and H2O molecule in the hydration layer were obtained using micro FT-IR. The concentration of OH group was 0.4-1.3 wt% and that of H2O molecule was about one third of OH group near the surface. These concentrations decreased exponentially from the surface to the inner part of the silica glass. Dissolution-hydration reaction reached a steady state after several tens of hours and the overall reaction rate is interpreted to be determined by diffusion of water species in the hydration layer. The diffusion coefficient was estimated to be 10-15-10-14 m2/s. It shows positive correlation with pressure and temperature. The activation energy was about 60kJ/mol.

  • Open Access

    Source constraints for the 2015 phreatic eruption of Hakone volcano, Japan, based on geological analysis and resistivity structure

    by Kazutaka Mannen, Toshikazu Tanada, Akira Jomori, Takashi Akatsuka, George Kikugawa, Yui Fukazawa, Hiroyuki Yamashita, Koichiro Fujimoto

    On June 29, 2015, a small phreatic eruption occurred in the most intensively steaming area of Hakone volcano, Japan. A previous magnetotelluric survey for the whole volcano revealed that the eruption center area (ECA) was located near the apex of a bell-shaped conductive body (resistivity < 10 Ωm) beneath the volcano. We performed local, high-resolution magnetotelluric surveys focusing on the ECA before and after the eruption. The results from these, combined with our geological analysis of samples obtained from a steam well (500 m deep) in the ECA, revealed that the conductive body contained smectite. Beneath the ECA, however, the conductive body intercalated a very local resistive body located at a depth of approximately 150 m. This resistive body is considered a vapor pocket. For the 2 months prior to eruption, a highly localized uplift of the ECA had been observed via satellite InSAR. The calculated depth of the inflation source was coincident with that of the vapor pocket, implying that enhanced vapor flux during the precursory unrest increased the porosity and vapor content in the vapor pocket. In fact, our magnetotelluric survey indicated that the vapor pocket became inflated after the eruption. The layer overlaying the vapor pocket was characterized by the formation of various altered minerals, and mineral precipitation within the veins and cracks in the layer was considered to have formed a self-sealing zone. From the mineral assemblage, we conclude that the product of the 2015 eruption originated from the self-sealing zone. The 2015 eruption is thus considered a rupture of the vapor pocket only 150 m below the surface. Even though the eruption appeared to have been triggered by the formation of a considerably deeper crack, as implied by the ground deformation, no geothermal fluid or rocks from significantly deeper than 150 m were erupted.


  • Opal‐CT in chert beneath the toe of the Tohoku margin and its influence on the seismic aseismic transition in subduction zones

    by Jun Kameda, Atsushi Okamoto, Kiminori Sato, Koichiro Fujimoto, Asuka Yamaguchi, Gaku Kimura

    Thick accumulation of chert is a ubiquitous feature of old oceanic plates at convergent margins. In this study, we investigate chert fragments recovered by the Integrated Ocean Drilling Program expedition 343 at the Japan Trench where the 2011 Tohoku‐Oki earthquake (Mw 9.0) occurred. This sample provides a unique opportunity to investigate in situ chert diagenesis at an active subduction margin and its influence on the kinematics of megathrust faulting. Our mineralogical analyses revealed that the chert is characterized by hydrous opal‐CT and may therefore be highly deformable via pressure solution creep and readily accommodate shear strain between the converging plates at driving stresses of kilopascal order. As chert diagenesis advances, any further deformation requires stresses of >100 MPa, given the increasing transport distances for solutes as represented in cherts on land. The chert diagenesis is thus related to the mechanical transition from a weakly to strongly coupled plate interface at this margin.


  • Open Access

    Fault-Drilling Investigation of Earthquake Slip Behavior and Physicochemical Processes

    by Tetsuro Hirono, Kentaro Omura, Koichiro Fujimoto, Hisao Ito, James J. Mori, Hiroshi Sato


  • Open Access

    Characteristics of chlorites in seismogenic fault zones: the Taiwan Chelungpu Fault Drilling Project (TCDP) core sample

    by Y. Hashimoto, O. Tadai, M. Tanimizu, W. Tanikawa, T. Hirono, W. Lin, T. Mishima, M. Sakaguchi, W. Soh, S. R. Song, et al.

    The iron content and the asymmetry of iron and magnesium ions in chlorites are examined for the Chelungpu Fault in Taiwan, which is a seismogenic fault. The samples are collected from the cores drilled for the Taiwan Chelungpu Fault Drilling Project (TCDP, borehole B). Three fault zones are recognized as candidates for the source of seismogenic materials. The fault zones are composed of fractured-damaged rocks, breccia, gray gouge, black gouge, and black material. Chlorite from each type of rock was analyzed by using X-ray diffraction (XRD). The iron content and asymmetry of the iron and magnesium ions in the chlorites were estimated from the XRD peak ratios. The hydroxide and silicate layers of chlorite in the black gouge and black material have low iron contents. Many studies have suggested that a temperature rise occurred at the fault zones. In addition, the temperature rise can result in the production of iron oxides such as magnetite or maghemite, as reported by other studies. However, the temperature rise cannot explain the low value of iron content in the chlorites. Another reason for the low value of iron content is the variation in the pH of the fluid, which can be controlled by radical reactions. Therefore, on the basis of chlorite characteristics, the reactions at the seismogenic fault are due not only to the thermal decomposition resulting from the temperature rise and but also to rock-fluid interactions.