Rubén Álvarez-Asencio
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Rubén Álvarez-Asencio has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
- Mark William Rutland
KTH Royal Institute of Technology
6 shared publications - Esben Thormann
Department of Chemistry, Technical University of Denmark, 2800 Kongens Lyngby, Denmark
2 shared publications Jinshan Pan
2 shared publications- Ahmed Ghalgaoui
TU Dortmund University
1 shared publication - Akira Uedono
University of Tsukuba
1 shared publication Alejandra Camacho
L'Oréal Research and Innovation, Chicago, USA
1 shared publication
Latest Publications
- 22 November 2019
- Published by Springer Nature in Cellulose
- Vol. 27 (3) , 1357-1365
Preparation and characterization of cellulose acetate membranes with TEMPO-oxidized cellulose nanofibrils containing alkyl ammonium carboxylates
- 22 November 2019
- Published by Springer Nature in Cellulose
- Vol. 27 (3) , 1357-1365
Preparation and characterization of cellulose acetate membranes with TEMPO-oxidized cellulose nanofibrils containing alkyl ammonium carboxylates
- 1 February 2016
- Published by Elsevier in Journal of the Mechanical Behavior of Biomedical Materials
- Vol. 54, 185-193
Nanomechanical properties of human skin and introduction of a novel hair indenter
- 1 February 2016
- Published by Elsevier in Journal of the Mechanical Behavior of Biomedical Materials
- Vol. 54, 185-193
Nanomechanical properties of human skin and introduction of a novel hair indenter
- 21 January 2016
- Published by American Chemical Society (ACS) in Biomacromolecules
- Vol. 17 (2) , 669-678
Factors Affecting Peptide Interactions with Surface-Bound Microgels
Effects of electrostatics and peptide size on peptide interactions with surface-bound microgels were investigated with ellipsometry, confocal microscopy, and atomic force microscopy (AFM). Results show that binding of cationic poly-l-lysine (pLys) to anionic, covalently immobilized, poly(ethyl acrylate-co-methacrylic acid) microgels increased with increasing peptide net charge and microgel charge density. Furthermore, peptide release was facilitated by decreasing either microgel or peptide charge density. Analogously, increasing ionic strength facilitated peptide release for short peptides. As a result of peptide binding, the surface-bound microgels displayed pronounced deswelling and increased mechanical rigidity, the latter quantified by quantitative nanomechanical mapping. While short pLys was found to penetrate the entire microgel network and to result in almost complete charge neutralization, larger peptides were partially excluded from the microgel network, forming an outer peptide layer on the microgels. As a result of this difference, microgel flattening was more influenced by the lower Mw peptide than the higher. Peptide-induced deswelling was found to be lower for higher Mw pLys, the latter effect not observed for the corresponding microgels in the dispersed state. While the effects of electrostatics on peptide loading and release were similar to those observed for dispersed microgels, there were thus considerable effects of the underlying surface on peptide-induced microgel deswelling, which need to be considered in the design of surface-bound microgels as carriers of peptide loads, for example, in drug delivery or in functionalized biomaterials.
- 21 January 2016
- Published by American Chemical Society (ACS) in Biomacromolecules
- Vol. 17 (2) , 669-678
Factors Affecting Peptide Interactions with Surface-Bound Microgels
Effects of electrostatics and peptide size on peptide interactions with surface-bound microgels were investigated with ellipsometry, confocal microscopy, and atomic force microscopy (AFM). Results show that binding of cationic poly-l-lysine (pLys) to anionic, covalently immobilized, poly(ethyl acrylate-co-methacrylic acid) microgels increased with increasing peptide net charge and microgel charge density. Furthermore, peptide release was facilitated by decreasing either microgel or peptide charge density. Analogously, increasing ionic strength facilitated peptide release for short peptides. As a result of peptide binding, the surface-bound microgels displayed pronounced deswelling and increased mechanical rigidity, the latter quantified by quantitative nanomechanical mapping. While short pLys was found to penetrate the entire microgel network and to result in almost complete charge neutralization, larger peptides were partially excluded from the microgel network, forming an outer peptide layer on the microgels. As a result of this difference, microgel flattening was more influenced by the lower Mw peptide than the higher. Peptide-induced deswelling was found to be lower for higher Mw pLys, the latter effect not observed for the corresponding microgels in the dispersed state. While the effects of electrostatics on peptide loading and release were similar to those observed for dispersed microgels, there were thus considerable effects of the underlying surface on peptide-induced microgel deswelling, which need to be considered in the design of surface-bound microgels as carriers of peptide loads, for example, in drug delivery or in functionalized biomaterials.
- Open Access
- 1 December 2014
- Published by Elsevier in Corrosion Science
- Vol. 89, 236-241
Role of microstructure on corrosion initiation of an experimental tool alloy: A Quantitative Nanomechanical Property Mapping study
- 1 December 2014
- Published by Elsevier in Corrosion Science
- Vol. 89, 236-241
Open AccessRole of microstructure on corrosion initiation of an experimental tool alloy: A Quantitative Nanomechanical Property Mapping study
- 10 March 2014
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 30 (11) , 3075-3085
Monolayer Study by VSFS: In Situ Response to Compression and Shear in a Contact
Self-assembled octadecyltrichlorosilane ((OTS), CH3(CH2)17SiCl3) layers on hydroxyl-terminated silicon oxide (SiO2) were prepared. The monolayers were characterized with atomic force microscopy (AFM) and contact angle measurements; their conformation was studied before, during, and after contact with a polymer (either PDMS or PTFE) surface using the vibrational sum frequency spectroscopy (VSFS) technique. During contact, the effect of pressure was studied for both polymer surfaces, but in the case of PTFE, the effect of shear rate on the contact was simultaneously studied. The VSFS response of the monolayers with pressure was almost entirely due to changes in the real area of contact with the polymer and therefore the Fresnel factors, whereas sliding caused disorder in the previously all-trans monolayer, as evidenced by a significant increase in the population of gauche defects.
- 10 March 2014
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 30 (11) , 3075-3085
Monolayer Study by VSFS: In Situ Response to Compression and Shear in a Contact
Self-assembled octadecyltrichlorosilane ((OTS), CH3(CH2)17SiCl3) layers on hydroxyl-terminated silicon oxide (SiO2) were prepared. The monolayers were characterized with atomic force microscopy (AFM) and contact angle measurements; their conformation was studied before, during, and after contact with a polymer (either PDMS or PTFE) surface using the vibrational sum frequency spectroscopy (VSFS) technique. During contact, the effect of pressure was studied for both polymer surfaces, but in the case of PTFE, the effect of shear rate on the contact was simultaneously studied. The VSFS response of the monolayers with pressure was almost entirely due to changes in the real area of contact with the polymer and therefore the Fresnel factors, whereas sliding caused disorder in the previously all-trans monolayer, as evidenced by a significant increase in the population of gauche defects.
- 1 September 2013
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 84 (9) , 096102
Note: Determination of torsional spring constant of atomic force microscopy cantilevers: Combining normal spring constant and classical beam theory
A technique has been developed for the calculation of torsional spring constants for AFM cantilevers based on the combination of the normal spring constant and plate/beam theory. It is easy to apply and allow the determination of torsional constants for stiff cantilevers where the thermal power spectrum is difficult to obtain due to the high resonance frequency and low signal/noise ratio. The applicability is shown to be general and this simple approach can thus be used to obtain torsional constants for any beam shaped cantilever.
- 1 September 2013
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 84 (9) , 096102
Note: Determination of torsional spring constant of atomic force microscopy cantilevers: Combining normal spring constant and classical beam theory
A technique has been developed for the calculation of torsional spring constants for AFM cantilevers based on the combination of the normal spring constant and plate/beam theory. It is easy to apply and allow the determination of torsional constants for stiff cantilevers where the thermal power spectrum is difficult to obtain due to the high resonance frequency and low signal/noise ratio. The applicability is shown to be general and this simple approach can thus be used to obtain torsional constants for any beam shaped cantilever.
- 11 April 2013
- Published by Springer Nature in Tribology Letters
- Vol. 50 (3) , 387-395
Tribological Properties Mapping: Local Variation in Friction Coefficient and Adhesion
- 11 April 2013
- Published by Springer Nature in Tribology Letters
- Vol. 50 (3) , 387-395
Tribological Properties Mapping: Local Variation in Friction Coefficient and Adhesion
- 19 June 2012
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 28 (26) , 9967-9976
Ionic Liquid Nanotribology: Stiction Suppression and Surface Induced Shear Thinning
The friction and adhesion between pairs of materials (silica, alumina, and polytetrafluoroethylene) have been studied and interpreted in terms of the long-ranged interactions present. In ambient laboratory air, the interactions are dominated by van der Waals attraction and strong adhesion leading to significant frictional forces. In the presence of the ionic liquid (IL) ethylammonium nitrate (EAN) the van der Waals interaction is suppressed and the attractive/adhesive interactions which lead to “stiction” are removed, resulting in an at least a 10-fold reduction in the friction force at large applied loads. The friction coefficient for each system was determined; coefficients obtained in air were significantly larger than those obtained in the presence of EAN (which ranged between 0.1 and 0.25), and variation in the friction coefficients between systems was correlated with changes in surface roughness. As the viscosity of ILs can be relatively high, which has implications for the lubricating properties, the hydrodynamic forces between the surfaces have therefore also been studied. The linear increase in repulsive force with speed, expected from hydrodynamic interactions, is clearly observed, and these forces further inhibit the potential for stiction. Remarkably, the viscosity extracted from the data is dramatically reduced compared to the bulk value, indicative of a surface ordering effect which significantly reduces viscous losses.
- 19 June 2012
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 28 (26) , 9967-9976
Ionic Liquid Nanotribology: Stiction Suppression and Surface Induced Shear Thinning
The friction and adhesion between pairs of materials (silica, alumina, and polytetrafluoroethylene) have been studied and interpreted in terms of the long-ranged interactions present. In ambient laboratory air, the interactions are dominated by van der Waals attraction and strong adhesion leading to significant frictional forces. In the presence of the ionic liquid (IL) ethylammonium nitrate (EAN) the van der Waals interaction is suppressed and the attractive/adhesive interactions which lead to “stiction” are removed, resulting in an at least a 10-fold reduction in the friction force at large applied loads. The friction coefficient for each system was determined; coefficients obtained in air were significantly larger than those obtained in the presence of EAN (which ranged between 0.1 and 0.25), and variation in the friction coefficients between systems was correlated with changes in surface roughness. As the viscosity of ILs can be relatively high, which has implications for the lubricating properties, the hydrodynamic forces between the surfaces have therefore also been studied. The linear increase in repulsive force with speed, expected from hydrodynamic interactions, is clearly observed, and these forces further inhibit the potential for stiction. Remarkably, the viscosity extracted from the data is dramatically reduced compared to the bulk value, indicative of a surface ordering effect which significantly reduces viscous losses.
- Open Access
- 27 November 2007
- Published by Springer Nature in Proteome Science
- Vol. 5 (1) , 19
Age-related subproteomic analysis of mouse liver and kidney peroxisomes
Despite major recent advances in the understanding of peroxisomal functions and how peroxisomes arise, only scant information is available regarding this organelle in cellular aging. The aim of this study was to characterize the changes in the protein expression profile of aged versus young liver and kidney peroxisome-enriched fractions from mouse and to suggest possible mechanisms underlying peroxisomal aging. Peroxisome-enriched fractions from 10 weeks, 18 months and 24 months C57bl/6J mice were analyzed by quantitative proteomics.
- 27 November 2007
- Published by Springer Nature in Proteome Science
- Vol. 5 (1) , 19
Open AccessAge-related subproteomic analysis of mouse liver and kidney peroxisomes
Despite major recent advances in the understanding of peroxisomal functions and how peroxisomes arise, only scant information is available regarding this organelle in cellular aging. The aim of this study was to characterize the changes in the protein expression profile of aged versus young liver and kidney peroxisome-enriched fractions from mouse and to suggest possible mechanisms underlying peroxisomal aging. Peroxisome-enriched fractions from 10 weeks, 18 months and 24 months C57bl/6J mice were analyzed by quantitative proteomics.