JCJen-Inn Chyi

Jen-Inn Chyi

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Jen-Inn Chyi has a total of 176 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • InAs/InGaAs quantum dots with room temperature photoluminescence at 1380 nm by Sb surfactant-induced strain relaxation

    by Bhavya Kondapavuluri, Wei-Sheng Liu, Kai-Yang Hsu, Pin-Chih Liu, Jhih-Han Lin, Jen-Inn Chyi

    This study examined the effects of Sb exposure on the optical properties of InAs/InGaAs quantum dot-in-a-well (QDWELL) heterostructures. A two-step strain compensation scheme was employed, with InAs QDs embedded within an InGaAs matrix to reduce the compressive strain caused by lattice mismatch between InAs and GaAs. Subsequent post-growth Sb flux exposure further reduced strain and altered surface energetics, producing a pronounced redshift of the ground-state emission from 1310 to 1380 nm at room temperature with a narrow linewidth (<30 meV). Temperature-dependent photoluminescence measurements also showed an enhanced activation energy of approximately 288 meV, compared with 250 meV for the QDs without Sb exposure, indicating a deeper confinement potential arising from increased conduction and valence band offsets. These results suggest that this approach allows both strain and carrier confinement to be effectively tailored to enable wavelength tuning into the E-band, promising for QD-based long-wavelength optoelectronic devices.

  • Graphene/Semiconductor Photodetectors Prepared by Molecular Beam Epitaxy

    by Yu-Han Huang, Yi-Tien Chiang, Bhavya Kondapavuluri, Pin-Chih Liu, Jhih-Han Lin, Wei-Sheng Liu, Jen-Inn Chyi, Shih-Yen Lin

    Through the attachment of mono-layer graphene films to either GaAs substrates or epi-wafers prepared by the molecular beam epitaxy (MBE), high-responsivity graphene/semiconductor photodetectors can be fabricated. For the graphene/undoped GaAs device, responsivity values up to 102 kA/W are observed in the 750-850 nm wavelength range. To further extend the detection wavelengths, the other sample with 10 nm In0.15Ga0.85As grown on undoped GaAs substrates is prepared by using MBE. Besides high responsivity values, the detection wavelengths are extended from 900 to 1000 nm. By using the sample with 2.4 mono-layer (ML) InAs quantum dots (QDs) as the light absorption layer, the device has demonstrated an even longer detection wavelength 1200 nm. The observation of high responsivities for devices with graphene on either bulk semiconductors or epi-wafers prepared by MBE has demonstrated the potential of such devices in practical applications.


  • Impact of arsenic species on InAs/GaSb type II superlattice grown by molecular beam epitaxy

    by Wei-Sheng Liu, Po Hao Chang, Balaji Gururajan, Bhavya Kondapavuluri, Tsun-Jie Ko, Ming-En Hsu, Yung-Jyun Liao, Jen-Inn Chyi

    In this study, InAs/GaSb type-II superlattice (T2SL) structures were grown on GaSb substrates by molecular beam epitaxy to investigate the impact of arsenic species (As2 dimers vs As4 tetramers) and growth temperatures (385–425 °C) on the interface quality and device performance. Structural characterization revealed that InAs layers grown with As4 at 385 °C exhibit superior crystallinity, evidenced by sharper higher-order satellite peaks and minimal lattice strain in high-resolution x-ray diffraction patterns. High-resolution transmission electron microscopy further confirms the abruptness of the interface with suppressed intermixing. Photoluminescence measurements demonstrate enhanced emission intensity and narrower linewidths for samples grown with As4 at 385 °C compared to those grown with As2. The reduced reactivity and sticking coefficient of As4, relative to As2, likely suppress uncontrolled anion exchange, particularly at lower growth temperatures. In contrast, As2 facilitates direct substitutional incorporation, driven by lower activation energy barriers, which promotes aggressive As-Sb exchange at heterointerfaces. This leads to compromised crystal integrity through the formation of parasitic ternary/quaternary phases and an increase in nonradiative defect centers, which adversely affect optical performance. Fabricated p-i-n diodes utilizing the optimized As4-grown T2SL exhibit a low room-temperature dark current density of 2.2 × 10−5 A/cm2, attributed to the suppression of generation-recombination and tunneling currents via enhanced interface quality. These results demonstrate that As4-mediated growth effectively mitigates anion exchange, paving the way for high-operating-temperature T2SL devices in midwave infrared optoelectronics.

  • Engineering unidirectional photocurrent in isotype-Ga 2 O 3 /GaN-based light-activated diodes

    by Arnab Mondal, Indraneel Sanyal, Satinder Sharma, Jen-Inn Chyi, Ankush Bag

  • Fabrication of InAs 2D submonolayer nanostructure-based solar cells with InGaAs/GaAsSb double-well structure

    by Wei-Sheng Liu, Ting-Kai Yang, Ming-En Hsu, Kai-Yang Hsu, Bhavya Kondapavuluri, Jen-Inn Chyi


  • Open Access

    Scalable approach for growing hexagonal boron nitride on silicon and its role in III-nitride van der Waals epitaxy

    by Muzafar Ahmad Rather, Shao-Hsiang Hsu, Chih-Chieh Lin, Yen-Huang Tien, Chien-Ting Wu, Tung-Yuan Yu, Kun-Lin Lin, Kun-Yu Lai, Jen-Inn Chyi

    Hexagonal boron nitride (h-BN) stands out among 2D materials for its insulating properties, making it promising for the integration of 2D and 3D materials. However, achieving wafer-scale growth on silicon substrates remains a significant challenge. In this study, growth strategies for depositing h-BN on Si substrates are explored utilizing the wafer scalable metalorganic chemical vapor deposition. Our investigations reveal that employing a pulsed flow mode scheme is preferable over the conventional continuous flow mode scheme in growing h-BN thin films on 150 mm Si substrates. The as-grown h-BN film on Si exhibits uniform coverage with h-BN[0001]//Si[111]. With the successful wafer-scale growth of h-BN on Si, its role in aiding the van der Waals epitaxy of III-nitrides on Si substrates and subsequent epitaxial lift-off (ELO) of III-nitrides is further exemplified. An optimized h-BN thickness for the ELO process is also determined.


  • Pinch-off driven near-ideal output characteristics of n-Ga2O3/p-GaN light effect transistor for UV photonics

    by Arnab Mondal, Manoj K. Yadav, Arpit Nandi, Shiv Kumar, Indraneel Sanyal, Satinder K. Sharma, Jen-Inn Chyi, Ankush Bag

    Gallium oxide (Ga2O3) based phototransistor can be used as a switch and an amplifier in typical digital and analog UV photonic applications, respectively. The light detection capability in Ga2O3 is very high, but these phototransistors suffer from poor drain current saturation with bias. Furthermore, the transistor switching action generally necessitates a gate terminal voltage, where a faulty gate power supply can lead to a high current flow in the transistor and subsequently damage the control driver circuit. An alternative is a two-terminal device with pure optical coupling at gate terminal, termed as a light effect transistor (LET). The LET has the field effect transistor (FET)-like current–voltage output characteristics, where the controlling mode is light instead of voltage, and being a two-terminal device, the fabrication processes are straightforward and cost-effective in contrast to the traditional FET. The fabricated LET device comprised an n-Ga2O3/p-GaN heterojunction with a planar metal–semiconductor–metal structure. This unique device can operate in two modes, linear (photodetector) within 1–2.5 V and saturation [depletion width modulated light effect transistor (DM-LET)] within 2.5–5 V. Under the DM-LET mode, the structure exhibits transistor-like action, the drain current saturates with the variation in drain voltage and is only controlled by the change in optical intensity. The transistor-like action has been attributed to the pinch-off effect near the drain electrode due to modulation in the heterojunction depletion width and has been explained using detailed numerical simulation. Such devices have the potential to be used in UV photonic integrated circuits and UV-non-line-of-sight communication technologies.


  • Tuning the emission wavelength by varying the Sb composition in InGaAs/GaAsSb “W” quantum wells grown on GaAs (001) substrates

    by Zon, Tzu-Wei Lo, Zhen-Lun Li, Samatcha Vorathamrong, Chao-Chia Cheng, Chun-Nien Liu, Chun-Te Chiang, Li-Wei Hung, Ming-Sen Hsu, Wei-Sheng Liu, et al.

    InGaAs/GaAsSb “W” quantum wells with GaAsP barriers are grown on GaAs (001) substrates by molecular beam epitaxy. We investigate the effect of the Sb composition in GaAsSb on the photoluminescence (PL) wavelength. X-ray rocking curve (XRC) measurements and simulations are performed to investigate the material composition and layer thickness. Low-temperature PL spectra are consistent with the XRC results. At the lowest Sb composition of 6%, the PL intensity is the strongest, and room-temperature PL is realized at ∼1100 nm. By increasing the Sb composition in the GaAsSb layer, low-temperature (20 K) PL emits at longer wavelength up to ∼1400 nm at 21% Sb while the PL intensity is the weakest. The XRC is also degraded. The strained bandgap simulation reveals the type-I to type-II band alignment transition as the Sb composition is ≥9%.


  • Open Access

    The effects of strain compensation in type-II GaAsSb/InGaAs quantum wells grown on GaAs (001) substrates

    by Zon, Samatcha Voranthamrong, Chao-Chia Cheng, Tzu-Wei Lo, Zhen-Lun Li, Chun-Nien Liu, Chun-De Chiang, Li-Wei Hung, Ming-Sen Hsu, Wei-Sheng Liu, et al.

    The effect of the GaAsP strain-compensating layer on type-II GaAs1−xSbx/InyGa1−yAs was investigated. GaAsSb/InGaAs multiple quantum wells (MQWs) without and with GaAsP strain-compensating layers were grown by molecular beam epitaxy. Increasing Sb or In compositions can extend photoluminescence (PL) emission at longer wavelength along with the highly induced compressive strain in the QWs. The power-dependent PL measured at low temperature reveals the type-II band characteristics of the GaAs1−xSbx/InyGa1−yAs system. A detailed analysis of the experimental data reveals that the GaAsP layers compensate the compressive strain of GaAsSb/InGaAs. The type-II QWs with GaAsP layers, (8 nm) GaAs0.84Sb0.16/(2.5 nm) In0.3Ga0.7As/(10 nm) GaAs0.85P0.15, emits PL at ∼1.1 μm, up to 210 K, while the PL of those strained sample without GaAsP vanishes at lower temperature. In view of the described sample, x-ray diffraction (XRD) analysis along with the simulation shows the validity of the procedure, resulting in nearly matched parameters of QW thicknesses and material compositions—(8.9 nm) GaAs0.835Sb0.165/(2.3 nm) In0.3Ga0.7As/(10.3 nm) GaAs0.85P0.15, with those of the designed QW. The thicknesses of QW from the TEM image, (8.6 nm) GaAsSb/(3.1 nm) InGaAs/(10.1 nm) GaAsP, agree well with the XRD results.


  • Open Access

    Evidence of charged interface states limited scattering in GaN heterostructures

    by Indraneel Sanyal, Yu-Chih Chen, Chuan-Yue Yu, Jen-Inn Chyi

    This study provides experimental evidence of charged interface states limited scattering in III-nitride heterostructures. Temperature-dependent Hall measurements and temperature-dependent ID–VG measurements indicate a significant influence of the charged interface states on the electron mobility in different AlGaN/GaN heterostructures where the characteristic of the interface is controlled by modulating the growth conditions. Charged interface states at the AlGaN/GaN heterointerface lead to electron scattering as the distance between the centroid of the two-dimensional electron gas and the interface decreases with increasing electron density. It is observed that a component of experimental Hall mobility, which ranges between 9.2 × 103 and 3.4 × 104 cm2/V s among the three samples, obtained after adding all the scattering events using Matthiessen's rule cannot be explained completely by considering all the conventional scattering mechanisms such as phonon–phonon scattering, interface roughness scattering, and dislocation density scattering. An in-depth analysis reveals a significant scattering of channel electrons by the charged states at the GaN/AlN/AlGaN interface. Furthermore, the estimated interface states from the temperature-dependent subthreshold slopes conducted on the fabricated high electron mobility transistors are in good agreement with the charged interface states extracted from the temperature-dependent Hall measurements. A good understanding on this new scattering mechanism in the GaN heterostructure may help in designing high-performance III-nitride devices in the future.