RBRocio Bolanos-Jimenez

Rocio Bolanos-Jimenez

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Rocio Bolanos-Jimenez has a total of 33 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Three-dimensional experimental investigation of the interaction between a rising bubble and a vortex ring

    by Cecilia Estepa-Cantero, Manuel Lorite-Díez, Javier Ruiz-Rus, Sébastien Cazin, Rocío Bolaños-Jiménez, Patricia Ern, Carlos Martínez-Bazán

    The interaction between turbulent flows and bubbles is a complex phenomenon ubiquitous in natural and industrial settings. In this work, we experimentally investigate, from a fundamental perspective, the interaction between a rising bubble and a vortex ring in counterflow. Using time-resolved three-dimensional Lagrangian particle tracking (3D-LPT) coupled with shadowgraphy, we obtain simultaneous measurements of the bubble motion and the surrounding liquid flow. This approach enables detailed observation of bubble dynamics, deformation and eventual breakup, as well as the fluid motion. We examine several flow configurations by varying the vortex circulation and the Weber number while maintaining a comparable vortex-to-bubble size ratio. Based on these measurements, we classify the interaction events into three categories according to their impact on bubble dynamics and vortex stability over time. Through experiments, we address, for the first time, the three-dimensional effects of these interactions, which had not been considered in previous studies. The analysed experiments comprise the following: Case I, corresponding to a weak interaction in which neither the bubble nor the vortex is significantly affected; Case II, where the bubble is captured and advected by the vortex, leading to a strong distortion of the vortex due to the presence of the bubble within its core; and Case III, involving a stronger vortex capable of capturing the bubble and breaking it into two fragments without a severe loss of energy in the vortex core. The analysis of these results provides insight into the bubble breakup process and the mechanisms responsible for the destabilisation of the vortex ring.

  • Spreading viscous fluids on a horizontal surface: Project-based learning in fluid mechanics

    by R. Bolaños-Jiménez, P. L. Luque-Escamilla

    The spreading of a thin viscous fluid film on a horizontal surface is an interesting problem in fluid mechanics with many practical applications ranging from coating processes to biological systems and environmental flows. It can even be observed in everyday situations, such as syrup spreading on a pancake. We present a project-based learning approach to this problem, in which engineering or physics undergraduates apply classroom knowledge to understand and solve it, using dimensional analysis, experiments, and theoretical modeling. First, a dimensional analysis is conducted to guide the design of the experiment suitable for an undergraduate laboratory or even at home. The problem is then simplified to obtain a mathematical model that accounts for the experimental results. Through this process, students are able to obtain a solution compatible with those published in fluid mechanics journals with minimal supervision from the instructor. This project not only develops important skills but also motivates students by showing that they have the ability to solve complex problems.

  • Open Access

    Spreading viscous fluids on a horizontal surface: project-based learning in fluid mechanics

    by R. Bolaños-Jimenez, P. L. Luque-Escamilla

    The spreading of a thin viscous fluid film on a horizontal surface is an interesting problem in fluid mechanics with many practical applications ranging from coating processes to biological systems and environmental flows. It can even be observed in everyday situations, such as syrup spreading on a pancake. We present a project-based learning approach to this problem, in which engineering or physics undergraduates apply classroom knowledge to understand and solve it, using dimensional analysis, experiments, and theoretical modeling. First, a dimensional analysis is conducted to guide the design of the experiment suitable for an undergraduate laboratory or even at home. The problem is then simplified to obtain a mathematical model that accounts for the experimental results. Through this process, students are able to obtain a solution compatible with those published in fluid mechanics journals with minimal supervision from the instructor. This project not only develops important skills but also motivates students by showing that they have the ability to solve complex problems.

  • Open Access

    Effect of a downstream vertical wall on the rise regime of an isolated bubble: an experimental study

    by T. González-Rubio, A. Rubio, R. Bolaños-Jiménez, E. J. Vega

    This work experimentally investigates deformable nitrogen bubbles rising in ultrapure water and interacting with a vertical wall, focusing on how this downstream boundary alters their dynamics, an effect critical to many real-world processes. The experiments were conducted with a fixed Morton number, $Mo = 2.64 \times 10^{-11}$, with Bond, Galilei, and Reynolds numbers in the ranges $0.08 \lesssim Bo \lesssim 0.33$, $71 \lesssim Ga \lesssim 194$, and $132 \lesssim Re \lesssim 565$, respectively. The initial dimensionless horizontal distance between the wall and the bubble centroid was systematically varied, $0.3 \lesssim L \lesssim 5$, and the bubble trajectories from two orthogonal vertical planes were captured using high-speed imaging. While the bubble rising paths were stable without the wall presence for all the cases, the results reveal that wall proximity significantly affects the rising path, depending on $Bo$ (or $Ga$) and $L$. A map with four distinct interaction regimes and their transitions is obtained: (i) Rectilinear Path (RP) at low $Bo$ and large $L$, with negligible wall influence; (ii) Migration Away (MA) at higher $Bo$ and moderate-to-large $L$, with lateral deviation from the wall; (iii) Collision and Migration Away (C+MA) at high $Bo$ and small $L$, where bubbles first collide and then migrate away; and (iv) Periodic Collisions (PC) at low $Bo$, where repeated wall impacts occur due to competing forces. These findings bridge the gap between idealised simulations and practical systems, offering high-quality data to support and refine computational models of bubble-wall interactions in industrial and environmental applications.

  • Open Access

    Bubble rising near a vertical wall: Experimental characterization of paths and velocity

    by Cecilia Estepa-Cantero, Carlos Martínez-Bazán, Rocío Bolaños-Jiménez

    The trajectories of a single bubble rising in the vicinity of a vertical solid wall are experimentally investigated. Distinct initial wall-bubble distances are considered for three different bubble rising regimes, i.e. rectilinear, planar zigzag, and spiral. The problem is defined by three control parameters, namely the Galilei number, Ga, the Bond number, Bo, and the initial dimensionless distance between the bubble centroid and the wall, L. We focus on high-Bond numbers, varying L from 1 to 4, and compare the results with the corresponding unbounded case L → ∞ . In all cases, the bubble deviates from the expected unbounded trajectory and migrates away from the wall as it rises due to the overpressure generated in the gap between the bubble and the wall. This repulsion is more evident as the initial wall-bubble distance decreases. Moreover, in the planar zigzagging regime, the wall is found to impose a preferential zigzagging plane perpendicular to it when L is small enough. Only slight wall effects are observed in the velocity or the oscillation amplitude and frequency. The wall migration effect is more evident for the planar zigzagging case and less relevant for the rectilinear one. Finally, the influence of the vertical position of the wall is also investigated. When the wall is not present upon release, the bubbles have the expected behavior for the unbounded case and experience the migration only instants before reaching the wall edge. This repulsion is, in general, more substantial than in the initially-present-wall case.

  • Open Access

    Bubble rising near a vertical wall: experimental characterization of paths and velocity

    by Cecilia Estepa-Cantero, Carlos Martínez-Bazán, Rocío Bolaños-Jiménez

    The trajectories of a single bubble rising in the vicinity of a vertical solid wall are experimentally investigated. Distinct initial wall-bubble distances are considered for three different bubble rising regimes, i.e. rectilinear, planar zigzag, and spiral. The problem is defined by three control parameters, namely the Galilei number, $Ga$, the Bond number, $Bo$, and the initial dimensionless distance between the bubble centroid and the wall, $L$. We focus on high-Bond numbers, varying $L$ from 1 to 4, and compare the results with the corresponding unbounded case, $L \rightarrow \infty$. In all cases, the bubble deviates from the expected unbounded trajectory and migrates away from the wall as it rises due to the overpressure generated in the gap between the bubble and the wall. This repulsion is more evident as the initial wall-bubble distance decreases. Moreover, in the planar zigzagging regime, the wall is found to impose a preferential zigzagging plane perpendicular to it when $L$ is small enough. Only slight wall effects are observed in the velocity or the oscillation amplitude and frequency. The wall migration effect is more evident for the planar zigzagging case and less relevant for the rectilinear one. Finally, the influence of the vertical position of the wall is also investigated. When the wall is not present upon release, the bubbles have the expected behavior for the unbounded case and experience the migration only instants before reaching the wall edge. This repulsion is, in general, more substantial than in the initially-present-wall case.

  • Bubble rising near a vertical wall: Experimental characterization of paths and velocity

    by C. Estepa-Cantero, C. Martínez-Bazán, R. Bolaños-Jiménez

    Trajectories of a single bubble rising in the vicinity of a vertical solid wall are experimentally investigated. Distinct initial wall-bubble distances are considered for three different bubble rising regimes, i.e., rectilinear, planar zigzag, and spiral. The problem is defined by three control parameters, namely, the Galilei number, Ga, the Bond number, Bo, and the initial dimensionless distance between the bubble centroid and the wall, L. We focus on high-Bond numbers, varying L from 1 to 4, and compare the results with the corresponding unbounded case, L→∞. In all cases, the bubble deviates from the expected unbounded trajectory and migrates away from the wall as it rises due to the overpressure generated in the gap between the bubble and the wall. This repulsion is more evident as the initial wall-bubble distance decreases. Moreover, in the planar zigzagging regime, the wall is found to impose a preferential zigzagging plane perpendicular to it when L is small enough. Only slight wall effects are observed in the velocity or the oscillation amplitude and frequency. The wall migration effect is more evident for the planar zigzagging case and less relevant for the rectilinear one. Finally, the influence of the vertical position of the wall is also investigated. When the wall is not present upon release, the bubbles have the expected behavior for the unbounded case and experience the migration only instants before reaching the wall edge. This repulsion is, in general, more substantial than in the initially present wall case.