Jorge Ricardo Wagner
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jorge Ricardo Wagner has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
- Gonzalo Gastón Palazolo
Laboratorio de Investigación de Funcionalidad y Tecnología de Alimentos (LIFTA), Departamento de Ciencia y Tecnología, Universidad Nacional de Quilmes, Buenos Aires B1876BXD, Argentina
2 shared publications - Vanesa Ludemann
Laboratory of Food Mycology (LMA), Department of Science and Technology, National University of Quilmes, Bernal, Argentina
2 shared publications A. Brullo
Laboratorio de Investigation de Proteinas Vegetales (LIPROVE) Departamentos de Ciencias Biologicas y de Quimica Facultad de Ciencias Exactas Universidad Nacional de La Plata, Argentina
1 shared publication- Alfonsina Moavro
National University of Quilmes, Buenos Aires, Argentina
1 shared publication - Claudia Luisa Natalucci
Laboratorio de Investigación de Proteínas Vegetales (LIPROVE), Departamento de Ciencias Biológicas, Facultad de Ciencias Exactas, Universidad Nacional de La Plata, La Plata, Argentina
1 shared publication - Cristian Tapia
Departamento de Ciencia de Alimentos y Tecnología Química, Facultad de Ciencias Químicas y Farmacéuticas, Universidad de Chile, Santiago 8380494, Chile
1 shared publication
Latest Publications
- Open Access
Soluble Chenopodin–Alginate and Chenopodin–Chitosan Nanocomplexes as Building Blocks for Food Emulsion Gels
This study evaluates the network-forming and gelation capabilities of quinoa protein (QP) nanocomplexes formed with alginate (QP–Al) and chitosan (QP–C) for the development of structured food emulsion gels and their application in reduced-fat food dressings. Rheological and nanometric characterisation revealed that QP–C complexes exhibited strong shear-thinning behaviour and particle-size instability with increasing concentration, indicating the breakdown of an organised internal network at rest. Conversely, QP–Al showed Newtonian behaviour, smaller particle sizes (~100–250 nm) and high surface charge stability. Upon oil incorporation, the chitosan-based systems underwent an abrupt, concentration-dependent transition from a liquid-like state to a solid-like gel network between 1.2% and 1.6% w/v chitosan. The EQP–C8 gel network exhibited severe structural fragility, degrading into a purely viscous fluid over 28 days. Conversely, the alginate-based system (EQP–AL8) formed a weak physical hydrogel network characterised by a progressive build-up of structure that resisted creaming and maintained structural integrity across temperature changes. EQP–AL8 was successfully used to develop a plant-based, reduced-fat dressing with high organoleptic acceptance; 98% of participants were willing to purchase the product. These findings demonstrate that QP–AL8 provides a clean-label technological path to designing tunable, highly stable food emulsion gels.
Open AccessSoluble Chenopodin–Alginate and Chenopodin–Chitosan Nanocomplexes as Building Blocks for Food Emulsion Gels
This study evaluates the network-forming and gelation capabilities of quinoa protein (QP) nanocomplexes formed with alginate (QP–Al) and chitosan (QP–C) for the development of structured food emulsion gels and their application in reduced-fat food dressings. Rheological and nanometric characterisation revealed that QP–C complexes exhibited strong shear-thinning behaviour and particle-size instability with increasing concentration, indicating the breakdown of an organised internal network at rest. Conversely, QP–Al showed Newtonian behaviour, smaller particle sizes (~100–250 nm) and high surface charge stability. Upon oil incorporation, the chitosan-based systems underwent an abrupt, concentration-dependent transition from a liquid-like state to a solid-like gel network between 1.2% and 1.6% w/v chitosan. The EQP–C8 gel network exhibited severe structural fragility, degrading into a purely viscous fluid over 28 days. Conversely, the alginate-based system (EQP–AL8) formed a weak physical hydrogel network characterised by a progressive build-up of structure that resisted creaming and maintained structural integrity across temperature changes. EQP–AL8 was successfully used to develop a plant-based, reduced-fat dressing with high organoleptic acceptance; 98% of participants were willing to purchase the product. These findings demonstrate that QP–AL8 provides a clean-label technological path to designing tunable, highly stable food emulsion gels.
- Open Access
- 1 January 2023
- Published by FapUNIFESP (SciELO) in Scientia Agricola
- Vol. 80, e20220176
Drying of soybean seeds and effect on protein quality and oil extraction efficiency by extruding-expelling process
Soybean seeds (Glycine max) were dried under real scale conditions to different final moisture content (m.c.) (9.1, 9.7, 10.9 %, and control with 16.2 %) and processed through extruding-expelling. Results indicated that soybean seed m.c. affected the composition of the soybean expeller and, thus, the oil extraction efficiency (OEE), which increased as the seed m.c. decreased. A polynomic model was proposed for predicting OEE as a function of soybean m.c., indicating that drying soybean to 10 % resulted in an OEE of approximately 65 %. A thin layer drying experiment of soybean seeds indicated that the protein dispersibility index (PDI) was not affected as regards drying air temperatures up to approximately 69 °C, and a bi-linear model with a non-pre-established break point was fitted. The real scale drying treatment in a rack type dryer (mixed flow) did not show any effect (p > 0.05) on the PDI at 80 °C, while at 115 °C a reduction (p < 0.05) was observed (PDI reduction was 0.8 and 2.1 percentage points, respectively).
- 1 January 2023
- Published by FapUNIFESP (SciELO) in Scientia Agricola
- Vol. 80, e20220176
Open AccessDrying of soybean seeds and effect on protein quality and oil extraction efficiency by extruding-expelling process
Soybean seeds (Glycine max) were dried under real scale conditions to different final moisture content (m.c.) (9.1, 9.7, 10.9 %, and control with 16.2 %) and processed through extruding-expelling. Results indicated that soybean seed m.c. affected the composition of the soybean expeller and, thus, the oil extraction efficiency (OEE), which increased as the seed m.c. decreased. A polynomic model was proposed for predicting OEE as a function of soybean m.c., indicating that drying soybean to 10 % resulted in an OEE of approximately 65 %. A thin layer drying experiment of soybean seeds indicated that the protein dispersibility index (PDI) was not affected as regards drying air temperatures up to approximately 69 °C, and a bi-linear model with a non-pre-established break point was fitted. The real scale drying treatment in a rack type dryer (mixed flow) did not show any effect (p > 0.05) on the PDI at 80 °C, while at 115 °C a reduction (p < 0.05) was observed (PDI reduction was 0.8 and 2.1 percentage points, respectively).
- Open Access
- 29 March 2019
- Published by Faculty of Food Technology and Biotechnology - University of Zagreb in Food Technology and Biotechnology
- Vol. 57 (1) , 87-96
Microbiological and Sensory Characteristics of Mould-Ripened Salami under Different Packaging Conditions
The preservation of mould-ripened salami was investigated during 48 days at 19-20 °C under different packaging conditions: (i) high barrier film filled with air, 100 % N2 or under vacuum, (ii) biaxially oriented polypropylene film, (iii) microperforated polyethylene film and (iv) unpackaged. Sensory, texture profile, physicochemical and microbiological analyses were performed. Fungal quantification revealed two data groups. In group 1 (consisting of salami in microperforated polyethylene film, biaxially oriented polypropylene film and unpackaged) the conidium viability was relatively constant. In group 2 (salami preserved in high barrier film filled with air, 100 % N2 or under vacuum) the conidium viability decreased due to the absence of oxygen and the high carbon dioxide volume fraction. SEM micrographs showed micromorphological changes in fungal structure; microperforated polyethylene film, biaxially oriented polypropylene film and unpackaged conditions preserved the conidial morphology, while high barrier film filled with air, 100 % N2 or vacuum conditions collapsed the hyphae and most of the conidia. Salami packed in microperforated polyethylene film and biaxially oriented polypropylene film showed the most acceptable organoleptic characteristics and lower hardness and chewiness values after packaging.
- 29 March 2019
- Published by Faculty of Food Technology and Biotechnology - University of Zagreb in Food Technology and Biotechnology
- Vol. 57 (1) , 87-96
Open AccessMicrobiological and Sensory Characteristics of Mould-Ripened Salami under Different Packaging Conditions
The preservation of mould-ripened salami was investigated during 48 days at 19-20 °C under different packaging conditions: (i) high barrier film filled with air, 100 % N2 or under vacuum, (ii) biaxially oriented polypropylene film, (iii) microperforated polyethylene film and (iv) unpackaged. Sensory, texture profile, physicochemical and microbiological analyses were performed. Fungal quantification revealed two data groups. In group 1 (consisting of salami in microperforated polyethylene film, biaxially oriented polypropylene film and unpackaged) the conidium viability was relatively constant. In group 2 (salami preserved in high barrier film filled with air, 100 % N2 or under vacuum) the conidium viability decreased due to the absence of oxygen and the high carbon dioxide volume fraction. SEM micrographs showed micromorphological changes in fungal structure; microperforated polyethylene film, biaxially oriented polypropylene film and unpackaged conditions preserved the conidial morphology, while high barrier film filled with air, 100 % N2 or vacuum conditions collapsed the hyphae and most of the conidia. Salami packed in microperforated polyethylene film and biaxially oriented polypropylene film showed the most acceptable organoleptic characteristics and lower hardness and chewiness values after packaging.
- Open Access
Effect of Xanthan Gum on the Rheological Behavior and Microstructure of Sodium Caseinate Acid Gels
The aim of this work was to study the effect of xanthan gum (XG) on the gelation process of bovine sodium caseinate (NaCAS) induced by acidification with glucono-δ-lactone (GDL) and on the mixed acid gel microstructure. Before GDL addition, segregative phase separation was observed in all the NaCAS-XG mixtures evaluated. The gelation process was analyzed by using a fractional factorial experimental design. The images of the microstructure of the mixed acid gels were obtained by conventional optical microscopy and the mean diameter of the interstices was determined. Both the elastic character and the microstructure of the gels depended on the concentrations of XG added. As XG concentration increased, the kinetics of the gelation process was modified and the degree of compactness and elasticity component of the gel network increased. The microstructure of gels depends on the balance among thermodynamic incompatibility, protein gelation and NaCAS-XG interactions.
Open AccessEffect of Xanthan Gum on the Rheological Behavior and Microstructure of Sodium Caseinate Acid Gels
The aim of this work was to study the effect of xanthan gum (XG) on the gelation process of bovine sodium caseinate (NaCAS) induced by acidification with glucono-δ-lactone (GDL) and on the mixed acid gel microstructure. Before GDL addition, segregative phase separation was observed in all the NaCAS-XG mixtures evaluated. The gelation process was analyzed by using a fractional factorial experimental design. The images of the microstructure of the mixed acid gels were obtained by conventional optical microscopy and the mean diameter of the interstices was determined. Both the elastic character and the microstructure of the gels depended on the concentrations of XG added. As XG concentration increased, the kinetics of the gelation process was modified and the degree of compactness and elasticity component of the gel network increased. The microstructure of gels depends on the balance among thermodynamic incompatibility, protein gelation and NaCAS-XG interactions.
- 1 June 1998
- Published by Hindawi Limited in Journal of Food Biochemistry
- Vol. 22 (2) , 125-141
THERMAL BEHAVIOR, SOLUBILITY AND STRUCTURAL PROPERTIES OF SOY CONCENTRATE HYDROLYZED BY NEW PLANT PROTEASES
- 1 June 1998
- Published by Hindawi Limited in Journal of Food Biochemistry
- Vol. 22 (2) , 125-141
THERMAL BEHAVIOR, SOLUBILITY AND STRUCTURAL PROPERTIES OF SOY CONCENTRATE HYDROLYZED BY NEW PLANT PROTEASES