Natalia Bobrysheva
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Natalia Bobrysheva has a total of 80 co-authors. Here are the top co-authors by number of shared publications:
- Artem Aleksandrovich Selutin
Saint Petersburg State University, Universitetsky pr.26, Saint Petersburg 198504, Russia
18 shared publications - Mikhail Osmolowsky
Saint Petersburg State University, 7/9 Universitetskaya Embankment, Saint Petersburg, 199034, Russian Federation
10 shared publications - Olga M. Osmolovskaya
Saint Petersburg State University, Saint Petersburg
10 shared publications M. G. Osmolovskii
St. Petersburg State University
6 shared publications- Valentin Georgievich Semenov
Saint Petersburg University
6 shared publications - Mikhail Voznesenskiy
Department of Physical Chemistry, institute of Chemistry, St-Petersburg State University, Saint-Petersburg, Russia
5 shared publications
Latest Publications
- Open Access
- 25 June 2026
- Published by Ural Federal University in Chimica Techno Acta
- Vol. 13 (4) , 10502
Structural, electrochemical, and photocatalytic properties of Fe- and V-embedded MgAl layered double hydroxides
Mg-Al layered double hydroxides (LDHs) with Fe and V ions additively embedded in the layers were synthesized by co-precipitation and characterized by XRD, TEM, BET, XPS, ICP-AES, UV-Vis, and cyclic voltammetry. XRD confirmed a single hydrotalcite-like phase, while TEM revealed nanosheet morphology with thicknesses of ~ 3 nm. Cation addition caused a slight lattice contraction and significant changes in texture. V-embedded LDH exhibited the highest specific surface area (189 m2·g-1) and the widest pores (40 nm), whereas Fe-embedded LDH showed denser aggregation (127 m2·g-1) and the narrowest pores (9 nm). The fundamental optical band gap decreased from ~5.2 eV for pristine MgAl LDH to ~2.4 eV for Fe- and Fe, V-embedded samples and ~3.6 eV for V-embedded LDH, with additional sub-bandgap optical transitions enabling visible-light absorption. All modified samples showed similar decolorization efficiency (75–76%) under visible light, but TOC removal correlated with the optical properties: Fe- and Fe,V-embedded samples provided 48% total mineralization, compared to 35% for V-embedded LDH. These results highlight a correlation between the modified optical properties and the mineralization efficiency of the LDH-based photocatalysts, highlighting the importance of of rational selection of ions additively embedded in the layer for efficient visible-light photocatalysts.
- 25 June 2026
- Published by Ural Federal University in Chimica Techno Acta
- Vol. 13 (4) , 10502
Open AccessStructural, electrochemical, and photocatalytic properties of Fe- and V-embedded MgAl layered double hydroxides
Mg-Al layered double hydroxides (LDHs) with Fe and V ions additively embedded in the layers were synthesized by co-precipitation and characterized by XRD, TEM, BET, XPS, ICP-AES, UV-Vis, and cyclic voltammetry. XRD confirmed a single hydrotalcite-like phase, while TEM revealed nanosheet morphology with thicknesses of ~ 3 nm. Cation addition caused a slight lattice contraction and significant changes in texture. V-embedded LDH exhibited the highest specific surface area (189 m2·g-1) and the widest pores (40 nm), whereas Fe-embedded LDH showed denser aggregation (127 m2·g-1) and the narrowest pores (9 nm). The fundamental optical band gap decreased from ~5.2 eV for pristine MgAl LDH to ~2.4 eV for Fe- and Fe, V-embedded samples and ~3.6 eV for V-embedded LDH, with additional sub-bandgap optical transitions enabling visible-light absorption. All modified samples showed similar decolorization efficiency (75–76%) under visible light, but TOC removal correlated with the optical properties: Fe- and Fe,V-embedded samples provided 48% total mineralization, compared to 35% for V-embedded LDH. These results highlight a correlation between the modified optical properties and the mineralization efficiency of the LDH-based photocatalysts, highlighting the importance of of rational selection of ions additively embedded in the layer for efficient visible-light photocatalysts.
- 20 April 2026
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 18 (19) , 10383-10396
Multifunctional green pigment with UV protection based on capping agent-engineered Cr-doped hydroxyapatite nanoparticles
BB creams are multifunctional cosmetic formulations that combine tone correction, skin refinement, and sun protection. Common limitations of conventional UV filters and pigments include low photostability, environmental toxicity and skin penetration. To address these limitations, we developed chromium-doped hydroxyapatite (Cr-HAp) nanoparticles (with an effective dopant concentration ∼10 at%) modified with succinic, tartaric, and etidronic acids. Nanoparticles were synthesised via co-precipitation and hydrothermal treatment, with structural and surface modifications confirmed by XRD, FTIR spectroscopy, TEM, and XPS. The use of organic acids enabled a controlled oriented attachment (OA) process, allowing for precise morphology control with nanoparticle lengths ranging from short rods (∼15 nm) to elongated needles (up to 150 nm). Cr3+ incorporation into the hydroxyapatite lattice produced stable green pigments with adjustable CIELab colour coordinates (a* from ∼–12 to –8 and b* from ∼0 to 2.5) and lightness (70 to 85). Optical characterisation demonstrated effective UV protection through absorption across the UVB spectrum (280–320 nm), which was modulated by the specific capping agent and synthesis conditions. A prototype BB cream incorporating 1.23% w/w of modified Cr-HAp nanoparticles demonstrated their suitability as multifunctional cosmetic ingredients, successfully combining UV shielding, colour correction, and environmentally conscious formulation design.
- 20 April 2026
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 18 (19) , 10383-10396
Multifunctional green pigment with UV protection based on capping agent-engineered Cr-doped hydroxyapatite nanoparticles
BB creams are multifunctional cosmetic formulations that combine tone correction, skin refinement, and sun protection. Common limitations of conventional UV filters and pigments include low photostability, environmental toxicity and skin penetration. To address these limitations, we developed chromium-doped hydroxyapatite (Cr-HAp) nanoparticles (with an effective dopant concentration ∼10 at%) modified with succinic, tartaric, and etidronic acids. Nanoparticles were synthesised via co-precipitation and hydrothermal treatment, with structural and surface modifications confirmed by XRD, FTIR spectroscopy, TEM, and XPS. The use of organic acids enabled a controlled oriented attachment (OA) process, allowing for precise morphology control with nanoparticle lengths ranging from short rods (∼15 nm) to elongated needles (up to 150 nm). Cr3+ incorporation into the hydroxyapatite lattice produced stable green pigments with adjustable CIELab colour coordinates (a* from ∼–12 to –8 and b* from ∼0 to 2.5) and lightness (70 to 85). Optical characterisation demonstrated effective UV protection through absorption across the UVB spectrum (280–320 nm), which was modulated by the specific capping agent and synthesis conditions. A prototype BB cream incorporating 1.23% w/w of modified Cr-HAp nanoparticles demonstrated their suitability as multifunctional cosmetic ingredients, successfully combining UV shielding, colour correction, and environmentally conscious formulation design.
- 12 February 2025
- Published by Elsevier in Surfaces and Interfaces
- Vol. 60
Zinc oxide nanoobjects for dye removal: Effective photocatalyst design via oriented attachment process
- 12 February 2025
- Published by Elsevier in Surfaces and Interfaces
- Vol. 60
Zinc oxide nanoobjects for dye removal: Effective photocatalyst design via oriented attachment process
- 31 July 2024
- Published by Elsevier in Applied Surface Science
- Vol. 672
Fe3O4@ZnO Core-Shell Nanoparticles—a novel facile fabricated magnetically separable photocatalyst
- 31 July 2024
- Published by Elsevier in Applied Surface Science
- Vol. 672
Fe3O4@ZnO Core-Shell Nanoparticles—a novel facile fabricated magnetically separable photocatalyst
- 1 January 2024
- Published by Pleiades Publishing Ltd in Russian Journal of General Chemistry
- Vol. 94 (S1) , S1-S12
Formation via Oriented Attachment Process and Photocatalytic Activity of Small and Crystalline Spherical SnO2 Nanoparticles
Photocatalysis is an innovative method for environmentally friendly wastewater treatment. A development of modern photocatalyst, which is suitable for industrial water purification from hazardous organic compounds, is a global challenging problem. Novelty of this work is in the development of synthetic approach based on hydrothermal treatment in a combination with computational experiment. Oriented attachment mechanism was engaged via hydrothermal treatment to produce SnO2 nanoparticles out of preliminary obtained initial blocks – smaller SnO2 nanoparticles, obtained via precipitation method. The initial blocks and obtained nanoparticles were studied with a large set of methods, such as XRD, FTIR, SSA, HRTEM, XPS, and Raman spectroscopy. The oriented attachment mechanism was studied using a computational method, based on the earlier developed approach, revealing the role of ions, existing in the reaction media, and the path of nanoparticle formation. Initial blocks and obtained nanoparticles were tested as photocatalysts on test solutions of organic dyes (methylene blue, rhodamine 6G and congo red). The more complex the dye structure, the more difficult is photocatalytic decomposition of its molecule. However, optimization of the extraction procedure allowed to achieve up to 90% extraction efficiency.
- 1 January 2024
- Published by Pleiades Publishing Ltd in Russian Journal of General Chemistry
- Vol. 94 (S1) , S1-S12
Formation via Oriented Attachment Process and Photocatalytic Activity of Small and Crystalline Spherical SnO2 Nanoparticles
Photocatalysis is an innovative method for environmentally friendly wastewater treatment. A development of modern photocatalyst, which is suitable for industrial water purification from hazardous organic compounds, is a global challenging problem. Novelty of this work is in the development of synthetic approach based on hydrothermal treatment in a combination with computational experiment. Oriented attachment mechanism was engaged via hydrothermal treatment to produce SnO2 nanoparticles out of preliminary obtained initial blocks – smaller SnO2 nanoparticles, obtained via precipitation method. The initial blocks and obtained nanoparticles were studied with a large set of methods, such as XRD, FTIR, SSA, HRTEM, XPS, and Raman spectroscopy. The oriented attachment mechanism was studied using a computational method, based on the earlier developed approach, revealing the role of ions, existing in the reaction media, and the path of nanoparticle formation. Initial blocks and obtained nanoparticles were tested as photocatalysts on test solutions of organic dyes (methylene blue, rhodamine 6G and congo red). The more complex the dye structure, the more difficult is photocatalytic decomposition of its molecule. However, optimization of the extraction procedure allowed to achieve up to 90% extraction efficiency.
- 1 October 2021
- Published by Pleiades Publishing Ltd in Russian Journal of General Chemistry
- Vol. 91 (10) , 2118-2120
Synthesis and Optical Properties of Boehmite Nanoparticles Doped with 3d-Metal Ions
Nanorods and nanoplates of boehmite doped with copper, cobalt, and chromium ions were obtained by hydrothermal method. The resulting samples were characterized by X-ray powder diffraction, FTIR spectroscopy, and transmission electron microscopy. Their absorption spectra were measured and the band gap values were calculated. As expected, the doping results in the band gap reduction to a value, which is defined by the dopant nature and particle shape.
- 1 October 2021
- Published by Pleiades Publishing Ltd in Russian Journal of General Chemistry
- Vol. 91 (10) , 2118-2120
Synthesis and Optical Properties of Boehmite Nanoparticles Doped with 3d-Metal Ions
Nanorods and nanoplates of boehmite doped with copper, cobalt, and chromium ions were obtained by hydrothermal method. The resulting samples were characterized by X-ray powder diffraction, FTIR spectroscopy, and transmission electron microscopy. Their absorption spectra were measured and the band gap values were calculated. As expected, the doping results in the band gap reduction to a value, which is defined by the dopant nature and particle shape.
- 1 November 2016
- Published by Pleiades Publishing Ltd in Russian Journal of General Chemistry
- Vol. 86 (11) , 2570-2571
Low-temperature synthesis of biocompatible ceramics based on hydroxyapatite and barium ferrite
- 1 November 2016
- Published by Pleiades Publishing Ltd in Russian Journal of General Chemistry
- Vol. 86 (11) , 2570-2571
Low-temperature synthesis of biocompatible ceramics based on hydroxyapatite and barium ferrite
- 1 January 2016
- Published by Pleiades Publishing Ltd in Russian Journal of General Chemistry
- Vol. 86 (1) , 26-29
Thermogravimetric study of the solid-phase reaction of La2–x Sr x CoO4 cobaltates synthesis
The course of the solid-phase synthesis of perovskite-like oxides La2– xSr xCoO4was studied by the thermal analysis method. It was found that the formation of the oxides begins above 970°С after...
- 1 January 2016
- Published by Pleiades Publishing Ltd in Russian Journal of General Chemistry
- Vol. 86 (1) , 26-29
Thermogravimetric study of the solid-phase reaction of La2–x Sr x CoO4 cobaltates synthesis
The course of the solid-phase synthesis of perovskite-like oxides La2– xSr xCoO4was studied by the thermal analysis method. It was found that the formation of the oxides begins above 970°С after...
- 1 May 2015
- Published by Pleiades Publishing Ltd in Russian Journal of General Chemistry
- Vol. 85 (5) , 1189-1190
Magnetic ordering in nanofilms containing 3d elements
- 1 May 2015
- Published by Pleiades Publishing Ltd in Russian Journal of General Chemistry
- Vol. 85 (5) , 1189-1190
Magnetic ordering in nanofilms containing 3d elements