Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


David Zuliani has a total of 119 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Implementing a dense accelerometer network in Veneto (NE Italy): a support for rapid earthquake impact assessment

    by Pier Luigi Bragato, Jacopo Boaga, Giorgio Capotosti, Paolo Comelli, Stefano Parolai, Giuliana Rossi, Helga Siracusa, Piero Ziani, David Zuliani

    In 2022, the Italian National Institute of Oceanography and Applied Geophysics - OGS set up a dense accelerometer network for strong-motion monitoring in Veneto (an Italian region in the north-east of the country), covering 312 sites in over 50% of the region’s municipalities. The network is primarily focused on measurements for rapid damage assessment and the prompt organization of rescue operations. Based on the latest generation of MEMS accelerometers, it is cost-effective and sensitive enough to provide useful recordings (i.e. with a good signal-to-noise ratio) of earthquakes with a magnitude down to 2.5. This feature helps to tune the recording and processing system in less critical situations than a severe earthquake. This paper describes the technical characteristics of the network, the practical solutions for its construction, the management tools currently used and some initial results. The technical and economic sustainability of the network in the long term is a key issue that was taken into account during planning and implementation and is also constantly monitored during normal operation. The aim is to extend the life of the network well beyond the five years envisaged for the original project so that similar solutions can be proposed for other regions of Italy.


  • EuroMASS Soil-Structure Interaction Experiment: A Semi-Dense Array for the Analysis of Wave Propagation from a Single-Degree-of-Freedom Structure to Its Surroundings

    by Anna Maria Skłodowska, Chiara Amendola, Shoaib Ayjaz Mohammed, Srihari Sangaraju, Carla Barnaba, Dimitris Pitilakis, Philippe Roux, Alessio Compagno, Bojana Petrovic, Valentin Schindelholz, et al.

    For years, soil-structure interaction (SSI) has been a subject of interdisciplinary studies, although full-scale SSI experiments and the use of real data are rare. To study SSI in a well-known and controlled environment, a full-scale experiment, EuroMASS, was conducted at the Piana di Toppo test site in Northeast Italy. For the needs of the experiment, a simple structure consisting of a lumped mass overtopping a steel column on a concrete base was designed and assembled at the test site. In April 2022, a three-component instrumentation network was installed to record the seismic noise, weak earthquake motions, and active source signals to study the structure, the foundation, and the soil seismic responses. The experiment was designed to collect data that can be used for accurate dynamic characterization of the structure and analysis of wave propagation in the soil-structure system.


  • Open Access

    Present-Day Surface Deformation in North-East Italy Using InSAR and GNSS Data

    by Giulia Areggi, Giuseppe Pezzo, John Peter Merryman Boncori, Letizia Anderlini, Giuliana Rossi, Enrico Serpelloni, David Zuliani, Lorenzo Bonini

    Geodetic data can detect and estimate deformation signals and rates due to natural and anthropogenic phenomena. In the present study, we focus on northeastern Italy, an area characterized by ~1.5–3 mm/yr of convergence rates due to the collision of Adria-Eurasia plates and active subsidence along the coasts. To define the rates and trends of tectonic and subsidence signals, we use a Multi-Temporal InSAR (MT-InSAR) approach called the Stanford Method for Persistent Scatterers (StaMPS), which is based on the detection of coherent and temporally stable pixels in a stack of single-master differential interferograms. We use Sentinel-1 SAR images along ascending and descending orbits spanning the 2015–2019 temporal interval as inputs for Persistent Scatterers InSAR (PSI) processing. We apply spatial-temporal filters and post-processing steps to reduce unrealistic results. Finally, we calibrate InSAR measurements using GNSS velocities derived from permanent stations available in the study area. Our results consist of mean ground velocity maps showing the displacement rates along the radar Line-Of-Sight for each satellite track, from which we estimate the east–west and vertical velocity components. Our results provide a detailed and original view of active vertical and horizontal displacement rates over the whole region, allowing the detection of spatial velocity gradients, which are particularly relevant to a better understanding of the seismogenic potential of the area. As regards the subsidence along the coasts, our measurements confirm the correlation between subsidence and the geological setting of the study area, with rates of ~2–4 mm/yr between the Venezia and Marano lagoons, and lower than 1 mm/yr near Grado.


  • Open Access

    LZER0: A Cost-Effective Multi-Purpose GNSS Platform

    by David Zuliani, Lavinia Tunini, Marco Severin, Michele Bertoni, Cristian Ponton, Stefano Parolai

    Recent advances in Global Navigation Satellite System (GNSS) technology have made low-cost sensors available to the mass market, opening up new opportunities for real-time ground deformation and structure monitoring. In this paper, we present a new product developed in this framework by the National Institute of Oceanography and Applied Geophysics–OGS in collaboration with a private company (SoluTOP SAS): a cost-effective, multi-purpose GNSS platform called LZER0, suitable not only for surveying measurements, but also for monitoring tasks. The LZER0 platform is a complete system that includes the GNSS equipment (M8T single-frequency model produced by u-blox) and the web portal where the results are displayed. The GNSS data are processed using the RTKLIB software package, and the processed results are made available to the end user. The relative positioning mode was adopted both with real-time and post-processing RTKLIB engines. We present three applications of LZER0—cadastral, monitoring, and automotive—which demonstrate that it is a flexible, multi-purpose platform that is easy to use in terms of both hardware and software, and can be easily deployed to perform various tasks in the research, educational, or professional sectors.


  • Open Access

    Cost-Effective, Single-Frequency GPS Network as a Tool for Landslide Monitoring

    by David Zuliani, Lavinia Tunini, Federico Di Traglia, Massimiliano Chersich, Davide Curone

    The constant monitoring of active landslides, particularly those located in the proximity of populated areas or touristic places, is crucial for early warning and risk-management purposes. The commonly used techniques deploy expensive instrumentation that can be hardly afforded, especially by small mountain communities in which landslide events often occur repeatedly. In recent years, the scientific community, as well as the private sector, have devoted growing effort to reducing the costs of monitoring systems. In this work, we present a monitoring network based on single-frequency Global Positioning System (GPS) sensors that have been activated to monitor an active landslide in the Carnic Alps, North-Eastern Italy. The system, which was composed of 12 single-frequency GPS stations, one seismometric station coupled with a single-frequency GPS instrument for real-time monitoring, and one permanent dual-frequency GPS station located in a stable area, provided daily reports of the landslide motion to the local authorities and administration. We show that this system is a valuable, flexible, and cost-effective tool for quick landslide characterization, and has high potential to be used as a landslide early warning system in case of emergency situations.


  • Open Access

    Applicability of Cost-Effective GNSS Sensors for Crustal Deformation Studies

    by Lavinia Tunini, David Zuliani, Andrea Magrin

    The geodetic monitoring of the continuous crustal deformation in a particular region has traditionally been the prerogative of the scientific communities capable of affording high-price geodetic-class instruments to track the tiny movements of tectonic plates without losing precision. However, GNSS technology has been continuously and rapidly growing, and in the last years, new cost-efficient instruments have entered the mass market, gaining the attention of the scientific community for potentially being high-performing alternative solutions. In this study, we match in parallel a dual-frequency low-cost receiver with two high-price geodetic instruments, all connected to the same geodetic antenna. We select North-East Italy as testing area, and we process the data together with the observations coming from a network of GNSS permanent stations operating in this region. We show that mm-order precision can be achieved by cost-effective GNSS receivers, while the results in terms of time series are largely comparable to those obtained using high-price geodetic receivers.


  • Open Access

    Seismic hazard for the Trans Adriatic Pipeline (TAP). Part 2: broadband scenarios at the Fier Compressor Station (Albania)

    by L. Moratto, A. Vuan, A. Saraò, D. Slejko, C. Papazachos, R. Caputo, D. Civile, V. Volpi, S. Ceramicola, A. Chatzipetros, et al.

    To ensure environmental and public safety, critical facilities require rigorous seismic hazard analysis to define seismic input for their design. We consider the case of the Trans Adriatic Pipeline (TAP), which is a pipeline that transports natural gas from the Caspian Sea to southern Italy, crossing active faults and areas characterized by high seismicity levels. For this pipeline, we develop a Probabilistic Seismic Hazard Assessment (PSHA) for the broader area, and, for the selected critical sites, we perform deterministic seismic hazard assessment (DSHA), by calculating shaking scenarios that account for the physics of the source, propagation, and site effects. This paper presents a DSHA for a compressor station located at Fier, along the Albanian coastal region. Considering the location of the most hazardous faults in the study site, revealed by the PSHA disaggregation, we model the ground motion for two different scenarios to simulate the worst-case scenario for this compressor station. We compute broadband waveforms for receivers on soft soils by applying specific transfer functions estimated from the available geotechnical data for the Fier area. The simulations reproduce the variability observed in the ground motion recorded in the near-earthquake source. The vertical ground motion is strong for receivers placed above the rupture areas and should not be ignored in seismic designs; furthermore, our vertical simulations reproduce the displacement and the static offset of the ground motion highlighted in recent studies. This observation confirms the importance of the DSHA analysis in defining the expected pipeline damage functions and permanent soil deformations.


  • Open Access

    Analysis of GNSS data along the Southern Gas Corridor and estimate of the expected slowly-cumulating tectonic displacements

    by Giuliana Rossi, Riccardo Caputo, David Zuliani, Paolo Fabris, Massimiliano Maggini, Panagiotis Karvelis

    Coseismic surface displacements, soil liquefaction effects, and induced landslides are among the most critical issues to be accounted for evaluating the exposure and vulnerability of pipelines. However, tectonic plates and crustal blocks are in an almost continuous relative movement, most pronounced in the narrow zones between tectonic plates, where we observe differential velocities from a few mm to some cm per year. Hence, even without the occurrence of strong earthquakes, a pipeline crossing active tectonic plate boundaries must cope during its lifetime, with remarkable differential motions along its length, due to the interseismic elastic strain-accumulation within the upper crust. Such movements, leading to permanent ground deformation, can distress the pipe and cause operation interruptions, while the anchor points can result in local stress concentrations.Here, we analyze the Southern Gas Corridor’s final part, a route highlighted in the European Energy Security and Energy Union Strategies. This route, which will be occupied by the TransAdriatic pipeline, crosses one of the world’s most seismically active zones. Our study aims to identify areas where critical differential motions could be expected along the route over the nominal 50-years pipeline-lifespan. We analyzed the available GNSS data and interpolated the sparsely available velocity vectors to have regular information along the pipeline path in two ways. In the first, we considered the region as a continuum; in the second, we applied an original blocky approach. We subdivided the path into segments, characterized by a relatively homogenous deformational behavior, or a specific tectonic setting, independently upon the neighboring ones. We compared the results of the two methods with the input observation. We calculated the maximum displacement that would cumulate in the next 50 years and the differential displacements that could cause possible critical bending to the pipeline structure. The approach followed in this research could be applied to other infrastructures to identify the segments prone to localized deformation because of interseismic tectonic loading.The work was done within the Trans Adriatic Pipeline Seismological Investigation RfP Seismic Hazard Assessment Evaluation for E.ON New Build & Technology GmbH. We thank Dario Slejko and the other project partners for valuable information, data, advice, and fruitful discussions. For our GIS-based strain velocity system, we used Quantum GIS (QGIS), a user-friendly Open Source Geographic Information System (GIS) licensed under the GNU General Public License (https://hub.qgis.org/). For the interpolation, we used the function TriScatteredInterp from MATLAB® library (MATLAB R2011a).

  • Open Access

    Analysis of global navigation satellite system data along the Southern Gas Corridor and estimate of the expected displacements

    by Giuliana Rossi, Riccardo Caputo, David Zuliani, Paolo Fabris, Massimiliano Maggini, Panagiotis Karvelis

    In the present paper, we analyze the final part of the Southern Gas Corridor, a route highlighted in the European energy security and energy union strategies. This route crosses one of the most seismically active zones of the Mediterranean with several recognized crustal-scale seismogenic sources. We focus on the possibility of identifying the areas where critical differential motions could be expected along the route, which will be occupied by the Trans Adriatic Pipeline, over the nominal pipeline life span of 50 yr. We analyze the available global navigation satellite system data and compare the results to the deformation patterns of the most significant faults affecting the area. We interpolated the sparsely available velocity vectors and calculated strain rate information, both considering the region as a continuum and by applying an original algorithm that allows the linear interpolation within individual blocks. The blocks are characterized by a relatively homogenous deformational behavior, or a specific tectonic setting, independently upon the neighboring ones. The results of the two methods are then compared by calculating the maximum displacement that would cumulate in the next 50 yr of the pipeline lifespan and the differential displacements that could cause possible bending phenomena to the pipeline structure. The methodological approach followed in this research could be applied to other infrastructures to identify the segments prone to localized deformation because of interseismic tectonic loading.