Guang-Hui Su
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Guang-Hui Su has a total of 49 co-authors. Here are the top co-authors by number of shared publications:
- Suizheng Qiu
Department of Nuclear Science and Technology, Xi’an Jiaotong University, Xi’an, China
9 shared publications Wenxi Tian
State Key Laboratory of Multiphase Flow in Power Engineering, School of Nuclear Science and Technology, Xi'an Jiaotong University, Xi'an, 710049, Shaanxi, PR China
6 shared publications- Yingwei Wu
School of Nuclear Science and Technology, Xi’an Jiaotong University, No. 28, Xianning West Road, Beilin County, Xi’an 710049, China
5 shared publications - Mingjun Wang
Xi’an Jiaotong University
3 shared publications - Dalin Zhang
State Key Laboratory of Multiphase Flow in Power Engineering, Shaanxi Key Laboratory of Advanced Nuclear Energy and Technology, School of Nuclear Science and Technology, Xi'an Jiaotong University 1 , Xi'an 710049, Shaanxi
2 shared publications Haoyu Liao
2 shared publications
Latest Publications
- 1 December 2023
- Published by Springer Nature in Nuclear Science and Techniques
- Vol. 34 (12) , 1-16
Transient fuel performance analysis of UO2–BeO fuel with composite SiC coated with Cr cladding based on multiphysics method
- 1 December 2023
- Published by Springer Nature in Nuclear Science and Techniques
- Vol. 34 (12) , 1-16
Transient fuel performance analysis of UO2–BeO fuel with composite SiC coated with Cr cladding based on multiphysics method
- 1 September 2021
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 160, 108377
Development of a transient module based on FROBA-ROD code and assessment for fuel rod performance under reactivity-initiated accident
- 1 September 2021
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 160, 108377
Development of a transient module based on FROBA-ROD code and assessment for fuel rod performance under reactivity-initiated accident
- Open Access
- 1 September 2020
- Published by Elsevier in Nuclear Engineering and Technology
- Vol. 52 (9) , 1945-1954
Large eddy simulation on the turbulent mixing phenomena in 3×3 bare tight lattice rod bundle using spectral element method
- 1 September 2020
- Published by Elsevier in Nuclear Engineering and Technology
- Vol. 52 (9) , 1945-1954
Open AccessLarge eddy simulation on the turbulent mixing phenomena in 3×3 bare tight lattice rod bundle using spectral element method
- 1 March 2020
- Published by Elsevier in Progress in Nuclear Energy
- Vol. 121, 103258
Boiling incipience of liquid sodium flow in an annular channel based on wavelet analysis
- 1 March 2020
- Published by Elsevier in Progress in Nuclear Energy
- Vol. 121, 103258
Boiling incipience of liquid sodium flow in an annular channel based on wavelet analysis
- 1 November 2019
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 133, 900-915
Modification and update of FROBA-ROD code and its applications in fuel rod behavior analysis for PWRs
- 1 November 2019
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 133, 900-915
Modification and update of FROBA-ROD code and its applications in fuel rod behavior analysis for PWRs
- Open Access
- 1 April 2019
- Published by Wiley in Science and Technology of Nuclear Installations
- Vol. 2019, 1-13
Numerical Study of Bubble Rising and Coalescence Characteristics under Flow Pulsation Based on Particle Method
Two-phase flow instability may occur in nuclear reactor systems, which is often accompanied by periodic fluctuation in fluid flow rate. In this study, bubble rising and coalescence characteristics under inlet flow pulsation condition are analyzed based on the MPS-MAFL method. To begin with, the single bubble rising behavior under flow pulsation condition was simulated. The simulation results show that the bubble shape and rising velocity fluctuate periodically as same as the inlet flow rate. Additionally, the bubble pairs’ coalescence behavior under flow pulsation condition was simulated and compared with static condition results. It is found that the coalescence time of bubble pairs slightly increased under the pulsation condition, and then the bubbles will continue to pulsate with almost the same period as the inlet flow rate after coalescence. In view of these facts, this study could offer theory support and method basis to a better understanding of the two-phase flow configuration under flow pulsation condition.
- 1 April 2019
- Published by Wiley in Science and Technology of Nuclear Installations
- Vol. 2019, 1-13
Open AccessNumerical Study of Bubble Rising and Coalescence Characteristics under Flow Pulsation Based on Particle Method
Two-phase flow instability may occur in nuclear reactor systems, which is often accompanied by periodic fluctuation in fluid flow rate. In this study, bubble rising and coalescence characteristics under inlet flow pulsation condition are analyzed based on the MPS-MAFL method. To begin with, the single bubble rising behavior under flow pulsation condition was simulated. The simulation results show that the bubble shape and rising velocity fluctuate periodically as same as the inlet flow rate. Additionally, the bubble pairs’ coalescence behavior under flow pulsation condition was simulated and compared with static condition results. It is found that the coalescence time of bubble pairs slightly increased under the pulsation condition, and then the bubbles will continue to pulsate with almost the same period as the inlet flow rate after coalescence. In view of these facts, this study could offer theory support and method basis to a better understanding of the two-phase flow configuration under flow pulsation condition.
- 1 March 2019
- Published by Elsevier in Nuclear Engineering and Design
- Vol. 343, 257-268
Theoretical investigation of two-phase flow instability between parallel channels of natural circulation in rolling motion
- 1 March 2019
- Published by Elsevier in Nuclear Engineering and Design
- Vol. 343, 257-268
Theoretical investigation of two-phase flow instability between parallel channels of natural circulation in rolling motion
- 1 January 2019
- Published by Elsevier in Fusion Engineering and Design
- Vol. 138, 272-281
Conceptual design and coupled neutronic/thermal-hydraulic/mechanical research of the supercritical water cooled ceramic blanket for CFETR
- 1 January 2019
- Published by Elsevier in Fusion Engineering and Design
- Vol. 138, 272-281
Conceptual design and coupled neutronic/thermal-hydraulic/mechanical research of the supercritical water cooled ceramic blanket for CFETR
- 22 July 2018
- Published by ASME International
Experimental Investigation on Critical Heat Flux From Downward-Facing Flat Plate for Different Orientation Angles
After the severe accident inside a nuclear reactor, the IVR (In-vessel retention) management strategy is an effective way to keep the integrity of pressure vessel and reduce risk of radioactive leakage by holding the damaged core materials through External Reactor Vessel Cooling (ERVS). The damaged core materials aggregate in the lower head of pressure vessel and releasing heat to the lower head. Therefore, it is very important to remove heat timely to keep the integrity of pressure vessel by ERVS. The shape of lower head is hemispherical and the local Critical Heat Flux (CHF) of different parts changed with latitude. In this paper, influence of orientation angles, area and length-width ratio on CHF of plate heating surface for saturated pool boiling is investigate experimentally. The results show that CHF increases with increasing orientation angles and decreasing area, meanwhile, length-width ratio has a significantly effect on CHF.
- 22 July 2018
- Published by ASME International
Experimental Investigation on Critical Heat Flux From Downward-Facing Flat Plate for Different Orientation Angles
After the severe accident inside a nuclear reactor, the IVR (In-vessel retention) management strategy is an effective way to keep the integrity of pressure vessel and reduce risk of radioactive leakage by holding the damaged core materials through External Reactor Vessel Cooling (ERVS). The damaged core materials aggregate in the lower head of pressure vessel and releasing heat to the lower head. Therefore, it is very important to remove heat timely to keep the integrity of pressure vessel by ERVS. The shape of lower head is hemispherical and the local Critical Heat Flux (CHF) of different parts changed with latitude. In this paper, influence of orientation angles, area and length-width ratio on CHF of plate heating surface for saturated pool boiling is investigate experimentally. The results show that CHF increases with increasing orientation angles and decreasing area, meanwhile, length-width ratio has a significantly effect on CHF.