Jacek Szumbarski
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jacek Szumbarski has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
J. M. Floryan
Department of Mechanical and Materials Engineering, The University of Western Ontario, London, Ontario, N6A5B9, Canada
4 shared publications- Tomasz Wejrzanowski
Faculty of Materials Science and Engineering, Warsaw University of Technology, Wołoska 141, 02-507 Warsaw, Poland
3 shared publications - Łukasz Łaniewski-Wołłk
Institute of Aeronautics and Applied Mechanics
3 shared publications A. Cabal
Department of Mechanical and Material Engineering, The University of Western Ontario, London, Ontario, N6A 5B9, Canada
2 shared publicationsJ. Skibinski
2 shared publicationsJ.M. Floryan
2 shared publications
Latest Publications
- 21 January 2026
- Published by Elsevier in International Journal of Heat and Fluid Flow
- Vol. 119
A new nonlinear dissipative boundary condition for internal incompressible flows
- 21 January 2026
- Published by Elsevier in International Journal of Heat and Fluid Flow
- Vol. 119
A new nonlinear dissipative boundary condition for internal incompressible flows
- 1 January 2022
- Published by Elsevier in Computers & Mathematics with Applications
- Vol. 106, 40-56
Adjoint-based optimal control of incompressible flows with convective-like energy-stable open boundary conditions
- 1 January 2022
- Published by Elsevier in Computers & Mathematics with Applications
- Vol. 106, 40-56
Adjoint-based optimal control of incompressible flows with convective-like energy-stable open boundary conditions
- Open Access
- 1 June 2020
- Published by Elsevier in Computers & Mathematics with Applications
- Vol. 79 (12) , 3547-3569
Open-loop optimal control of a flapping wing using an adjoint Lattice Boltzmann method
- 1 June 2020
- Published by Elsevier in Computers & Mathematics with Applications
- Vol. 79 (12) , 3547-3569
Open AccessOpen-loop optimal control of a flapping wing using an adjoint Lattice Boltzmann method
- 1 October 2018
- Published by AIP Publishing in Physics of Fluids
- Vol. 30 (10) , 104105
Flow dynamics in longitudinally grooved duct
Flow in a finite-width rectangular duct with a corrugated top-bottom wall has been studied. The primary goal is to establish geometries that allow early flow destabilization at a possibly low drag increase. The flow is assumed periodic in the streamwise direction and bounded by the duct sidewalls in the spanwise direction; the top and bottom wall corrugations have a form of sinusoidal waves oriented transversely to the flow and form longitudinal grooves; i.e., the lines of constant elevation (or phase) are parallel to the direction of the flow. The analysis is performed up to the Reynolds numbers resulting in the formation of secondary states. The first part of the analysis is focused on the properties of the two-dimensional base flow. Mainly, the dependence of hydraulic losses and drag reducing properties on duct’s geometry is characterized. The second part of the analysis discusses the onset of the three-dimensional travelling wave instability over a wide spectrum of geometric configurations. Linear stability is investigated by means of the direct numerical simulation of the Navier-Stokes equations. Critical conditions for the onset of instabilities at a range of geometric parameters are determined. Finally, the nonlinear saturation of unstable modes and the resulting secondary flows are examined. We have shown that in the state resulting from the nonlinear saturation of the disturbance, the flow becomes more complex while the drag reducing properties of the base flow can be maintained.
- 1 October 2018
- Published by AIP Publishing in Physics of Fluids
- Vol. 30 (10) , 104105
Flow dynamics in longitudinally grooved duct
Flow in a finite-width rectangular duct with a corrugated top-bottom wall has been studied. The primary goal is to establish geometries that allow early flow destabilization at a possibly low drag increase. The flow is assumed periodic in the streamwise direction and bounded by the duct sidewalls in the spanwise direction; the top and bottom wall corrugations have a form of sinusoidal waves oriented transversely to the flow and form longitudinal grooves; i.e., the lines of constant elevation (or phase) are parallel to the direction of the flow. The analysis is performed up to the Reynolds numbers resulting in the formation of secondary states. The first part of the analysis is focused on the properties of the two-dimensional base flow. Mainly, the dependence of hydraulic losses and drag reducing properties on duct’s geometry is characterized. The second part of the analysis discusses the onset of the three-dimensional travelling wave instability over a wide spectrum of geometric configurations. Linear stability is investigated by means of the direct numerical simulation of the Navier-Stokes equations. Critical conditions for the onset of instabilities at a range of geometric parameters are determined. Finally, the nonlinear saturation of unstable modes and the resulting secondary flows are examined. We have shown that in the state resulting from the nonlinear saturation of the disturbance, the flow becomes more complex while the drag reducing properties of the base flow can be maintained.
- 21 July 2018
- Published by Springer Nature
- p. 479-494
Robust Optimization with Gaussian Process Models
- 1 August 2017
- Published by AIP Publishing in Physics of Fluids
- Vol. 29 (8)
Instability in a channel with grooves parallel to the flow
Flow in a channel with corrugated walls has been studied, with the primary goal of establishing channel geometries that enhance achievable mixing at possibly low drag increase. The wall corrugation has the form of a sinusoidal wave oriented transversely, i.e., the lines of constant elevation (or phase) are parallel to the direction of the flow. The analysis is performed up to the Reynolds numbers resulting in the formation of secondary states. The first part of the analysis is focused on the properties of the two-dimensional, base flow. Mainly, the dependence of the drag on the channel’s geometry is characterized. The second part of the analysis discusses the onset of the three-dimensional traveling wave instability. Linear stability is investigated by the Direct Numerical Simulation of the Navier-Stokes equations. Critical conditions for the onset of instabilities at a range of geometric parameters are determined. Finally, nonlinear saturation of the unstable modes and the resulting secondary flows is examined. It is shown that the drag reduction property of the base flow can be maintained in the state resulting from non-linear saturation of the disturbance.
- 1 August 2017
- Published by AIP Publishing in Physics of Fluids
- Vol. 29 (8)
Instability in a channel with grooves parallel to the flow
Flow in a channel with corrugated walls has been studied, with the primary goal of establishing channel geometries that enhance achievable mixing at possibly low drag increase. The wall corrugation has the form of a sinusoidal wave oriented transversely, i.e., the lines of constant elevation (or phase) are parallel to the direction of the flow. The analysis is performed up to the Reynolds numbers resulting in the formation of secondary states. The first part of the analysis is focused on the properties of the two-dimensional, base flow. Mainly, the dependence of the drag on the channel’s geometry is characterized. The second part of the analysis discusses the onset of the three-dimensional traveling wave instability. Linear stability is investigated by the Direct Numerical Simulation of the Navier-Stokes equations. Critical conditions for the onset of instabilities at a range of geometric parameters are determined. Finally, nonlinear saturation of the unstable modes and the resulting secondary flows is examined. It is shown that the drag reduction property of the base flow can be maintained in the state resulting from non-linear saturation of the disturbance.
- 1 December 2015
- Published by Elsevier in Chemical Engineering Science
- Vol. 137, 320-337
Pressure drop in flow across ceramic foams—A numerical and experimental study
- 1 December 2015
- Published by Elsevier in Chemical Engineering Science
- Vol. 137, 320-337
Pressure drop in flow across ceramic foams—A numerical and experimental study
- 29 April 2014
- Published by Emerald Publishing in International Journal of Numerical Methods for Heat & Fluid Flow
- Vol. 24 (4) , 907-919
Unconditionally stable numerical scheme for natural convection problems
Purpose – Both the importance of the natural convection in science and engineering and the shortage of publications in the field of numerical features of time-stepping schemes for the simulation of coupled heat and fluid flow problems motivate the present work. The paper aims to discuss these issues. Design/methodology/approach – The paper presents the unconditionally stable time-stepping scheme for simulation of coupled problems of mass and heat transport. The paper is divided into two parts. The first part concerns the mathematical formulation of the scheme and discusses its implementation. The second part focuses on the numerical simulation and its results. A detailed investigation of the temporal order of the scheme with respect to the L2-norms of the errors of the pressure, velocity, temperature and divergence of velocity fields has also been given. Findings – The work shows that it is possible to formulate a numerical scheme which is unconditionally stable with respect to the time step size. Moreover, application of the spectral element method for the spatial discretization results in a high order of approximation in space and very good overall accuracy. Furthermore, the investigation of the numerical features of the scheme showed that the formal temporal order of the scheme (formally second order) has been deferred very slightly and the order of 1.8-1.9 is achieved for all unknown fields. Originality/value – The paper presents a new unconditionally stable scheme for simulation of unsteady flows with bidirectional coupling of heat transfer and the fluid flow. It also carefully investigates the numerical behaviour of the method.
- 29 April 2014
- Published by Emerald Publishing in International Journal of Numerical Methods for Heat & Fluid Flow
- Vol. 24 (4) , 907-919
Unconditionally stable numerical scheme for natural convection problems
Purpose – Both the importance of the natural convection in science and engineering and the shortage of publications in the field of numerical features of time-stepping schemes for the simulation of coupled heat and fluid flow problems motivate the present work. The paper aims to discuss these issues. Design/methodology/approach – The paper presents the unconditionally stable time-stepping scheme for simulation of coupled problems of mass and heat transport. The paper is divided into two parts. The first part concerns the mathematical formulation of the scheme and discusses its implementation. The second part focuses on the numerical simulation and its results. A detailed investigation of the temporal order of the scheme with respect to the L2-norms of the errors of the pressure, velocity, temperature and divergence of velocity fields has also been given. Findings – The work shows that it is possible to formulate a numerical scheme which is unconditionally stable with respect to the time step size. Moreover, application of the spectral element method for the spatial discretization results in a high order of approximation in space and very good overall accuracy. Furthermore, the investigation of the numerical features of the scheme showed that the formal temporal order of the scheme (formally second order) has been deferred very slightly and the order of 1.8-1.9 is achieved for all unknown fields. Originality/value – The paper presents a new unconditionally stable scheme for simulation of unsteady flows with bidirectional coupling of heat transfer and the fluid flow. It also carefully investigates the numerical behaviour of the method.
- 1 February 2013
- Published by Elsevier in Computational Materials Science
- Vol. 67, 216-221
Structure of foams modeled by Laguerre–Voronoi tessellations
- 1 February 2013
- Published by Elsevier in Computational Materials Science
- Vol. 67, 216-221
Structure of foams modeled by Laguerre–Voronoi tessellations
- 26 June 2012
- Published by WITPRESS LTD.
Computational design of the flow properties of foams
In the present studies the quantitative relationships between the structure and flow properties of porous materials are addressed. In order to...
- 26 June 2012
- Published by WITPRESS LTD.
Computational design of the flow properties of foams
In the present studies the quantitative relationships between the structure and flow properties of porous materials are addressed. In order to...