James Regis Matey
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
James Regis Matey has a total of 178 co-authors. Here are the top co-authors by number of shared publications:
A. C. Anderson
Department of Physics, University of Illinois at Urbana-Champaign, Urbana, Illinois 61801
4 shared publicationsPatrick Grother
4 shared publicationsGeorge W Quinn
3 shared publicationsRobert W. Ives
U.S. Naval Academy, USA
3 shared publicationsA. John Mallinckrodt
2 shared publicationsB. T. Collins
David Sarnoff Research Center, Princeton, New Jersey 08543-5300
2 shared publications
Latest Publications
- 1 September 2018
- Published by National Institute of Standards and Technology (NIST)
Iris cameras: standards relevant for camera selection - 2018
- 1 September 2018
- Published by National Institute of Standards and Technology (NIST)
Iris cameras: standards relevant for camera selection - 2018
- Open Access
- 1 December 2015
- Published by Institution of Engineering and Technology (IET) in IET Biometrics
- Vol. 4 (4) , 200-205
IREX VI: mixed‐effects longitudinal models for iris ageing: response to Bowyer and Ortiz
Bowyer and Ortiz, in their study ‘A Critical Examination of the IREX VI Results’, make seven criticisms of the authors application of linear mixed‐effects models to longitudinally collected iris recognition Hamming distances. We reject these as either irrelevant, misinterpretations, or qualitatively correct, but quantitatively irrelevant.
- 1 December 2015
- Published by Institution of Engineering and Technology (IET) in IET Biometrics
- Vol. 4 (4) , 200-205
Open AccessIREX VI: mixed‐effects longitudinal models for iris ageing: response to Bowyer and Ortiz
Bowyer and Ortiz, in their study ‘A Critical Examination of the IREX VI Results’, make seven criticisms of the authors application of linear mixed‐effects models to longitudinally collected iris recognition Hamming distances. We reject these as either irrelevant, misinterpretations, or qualitatively correct, but quantitatively irrelevant.
- 1 September 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-7
Modest proposals for improving biometric recognition papers
We present practical recommendations for improving the clarity, transparency, and usefulness of many biometric papers. Several of the recommendations can be enabled by preparing a publicly available library of state of the art Receiver Operating Characteristics (ROCs). We propose such a library and invite suggestions on its details.
- 1 September 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-7
Modest proposals for improving biometric recognition papers
We present practical recommendations for improving the clarity, transparency, and usefulness of many biometric papers. Several of the recommendations can be enabled by preparing a publicly available library of state of the art Receiver Operating Characteristics (ROCs). We propose such a library and invite suggestions on its details.
- 3 July 2015
- Published by Springer Nature
- p. 992-997
Iris on the MoveTM
- 3 July 2015
- Published by Springer Nature
- p. 960-964
Iris Device
- 1 February 2014
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 85 (2) , 021901
Preface: Radon-thoron instrumentation and measurement
- 1 February 2014
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 85 (2) , 021901
Preface: Radon-thoron instrumentation and measurement
- Open Access
- 1 September 2013
- Published by Institution of Engineering and Technology (IET) in IET Biometrics
- Vol. 2 (3) , 107-116
Performance assessments of iris recognition in tactical biometric devices
Tactical biometric devices are used to establish the identity of individuals of interest in various military and law‐enforcement scenarios. Most testing of these devices has been conducted in laboratory settings rather than in operationally‐realistic tactical scenarios. This study describes an experiment which can viably replace this paradigm by measuring the performance of handheld biometric devices in a variety of tactical environments. The experimental procedure assessed the collectability, quality and matchability of images collected in operationally‐realistic scenarios. Iris recognition accuracy was measured using several commercial algorithms. Results illustrate performance degradation in operational results relative to laboratory results; the collection limitations of the devices in operationally‐realistic settings; and the effects of operators, subjects, devices and environments on performance. The authors believe that this experiment is unique in its exploration of these elements and that the powerful results presented suggest a need for refinement of design and procurement criteria.
- 1 September 2013
- Published by Institution of Engineering and Technology (IET) in IET Biometrics
- Vol. 2 (3) , 107-116
Open AccessPerformance assessments of iris recognition in tactical biometric devices
Tactical biometric devices are used to establish the identity of individuals of interest in various military and law‐enforcement scenarios. Most testing of these devices has been conducted in laboratory settings rather than in operationally‐realistic tactical scenarios. This study describes an experiment which can viably replace this paradigm by measuring the performance of handheld biometric devices in a variety of tactical environments. The experimental procedure assessed the collectability, quality and matchability of images collected in operationally‐realistic scenarios. Iris recognition accuracy was measured using several commercial algorithms. Results illustrate performance degradation in operational results relative to laboratory results; the collection limitations of the devices in operationally‐realistic settings; and the effects of operators, subjects, devices and environments on performance. The authors believe that this experiment is unique in its exploration of these elements and that the powerful results presented suggest a need for refinement of design and procurement criteria.