Bingge Zhao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Bingge Zhao has a total of 51 co-authors. Here are the top co-authors by number of shared publications:
- Yulai Gao
State Key Laboratory of Advanced Special Steel, School of Materials Science and Engineering, Shanghai University, Shanghai 200444, China
15 shared publications Chenhui Wang
7 shared publicationsKai Ding
Shanghai University
7 shared publicationsLuojia Zhang
7 shared publicationsYulai Gao
7 shared publicationsQijie Zhai
6 shared publications
Latest Publications
- 27 September 2025
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 1042
Modulation of crystal nucleation and growth enables tailoring the mechanical properties of Zr55Cu30Al10Ni5 powder
- 27 September 2025
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 1042
Modulation of crystal nucleation and growth enables tailoring the mechanical properties of Zr55Cu30Al10Ni5 powder
- 3 August 2024
- Published by Elsevier in Thermochimica Acta
- Vol. 740
Revealing the effect of annealing at Tg on the crystal growth in Au49Ag5.5Pd2.3Cu26.9Si16.3 metallic glass via nanocalorimetry
- 3 August 2024
- Published by Elsevier in Thermochimica Acta
- Vol. 740
Revealing the effect of annealing at Tg on the crystal growth in Au49Ag5.5Pd2.3Cu26.9Si16.3 metallic glass via nanocalorimetry
- 19 April 2024
- Published by Elsevier in Intermetallics
- Vol. 169
Effect of cooling rate on the crystallization behaviors of Mg65Zn30Ca5 metallic glass composites
- 19 April 2024
- Published by Elsevier in Intermetallics
- Vol. 169
Effect of cooling rate on the crystallization behaviors of Mg65Zn30Ca5 metallic glass composites
- 16 April 2024
- Published by Springer Nature in Journal of Materials Research
- Vol. 39 (12) , 1717-1726
Glass transition and crystallization of Ce68Al10Cu20Co2 bulk metallic glass studied by Flash DSC
- 16 April 2024
- Published by Springer Nature in Journal of Materials Research
- Vol. 39 (12) , 1717-1726
Glass transition and crystallization of Ce68Al10Cu20Co2 bulk metallic glass studied by Flash DSC
- 7 February 2024
- Published by Springer Nature
- p. 132-139
Preparation of Cu Powders with Electrical Explosion of Wires and Their Size-Dependent Mechanical Properties
- 7 February 2024
- Published by Springer Nature
- p. 132-139
Preparation of Cu Powders with Electrical Explosion of Wires and Their Size-Dependent Mechanical Properties
- 3 February 2024
- Published by Springer Nature
- p. 559-568
Nucleation of One Single Sn Droplet on Al Thin Film Explored by Nanocalorimetry
- 3 February 2024
- Published by Springer Nature
- p. 559-568
Nucleation of One Single Sn Droplet on Al Thin Film Explored by Nanocalorimetry
- 4 December 2023
- Published by Elsevier in Thermochimica Acta
- Vol. 731
Effect of annealing at Tg on the crystallization behaviors of Au49Ag5.5Pd2.3Cu26.9Si16.3 metallic glass revealed by nanocalorimetry
- 4 December 2023
- Published by Elsevier in Thermochimica Acta
- Vol. 731
Effect of annealing at Tg on the crystallization behaviors of Au49Ag5.5Pd2.3Cu26.9Si16.3 metallic glass revealed by nanocalorimetry
- 15 December 2022
- Published by Elsevier in Thermochimica Acta
- Vol. 720
Heterogeneous nucleation of embedded droplets in the Zn-15Bi immiscible alloy studied by nanocalorimetry
- 15 December 2022
- Published by Elsevier in Thermochimica Acta
- Vol. 720
Heterogeneous nucleation of embedded droplets in the Zn-15Bi immiscible alloy studied by nanocalorimetry
- 23 November 2022
- Published by Polish Academy of Sciences Chancellery in Archives of Metallurgy and Materials
- Vol. 67 (4) , 1293-1298
Effect of High-Temperature Annealing on the Cross-Tension Property of Resistance Spot Welded Medium-Mn Steel
As one of the most promising 3rd generation advanced high strength steels (AHSS), medium Mn steels attract much attention because of their exceptional mechanical property and reasonable cost. However, their application in the modern automotive industry is limited by poor weldability. In this study, 7Mn steel was welded by resistance spot welding (RSW), which was followed by high-temperature annealing to increase the cross-tension property. With this effort, enhanced cross-tension strength (CTS) with a partial interfacial fracture (PIF) mode was realized. During the annealing after RSW that produced martensite, austenitization was realized and then evolved into martensite by the following air cooling. This process produced structure homogeneity across the joint. With respect to the RSW joint, martensite remained the dominant structure after annealing while the diffusion of C and Mn solutes was triggered. With the increase of annealing temperature, the diffusion was enhanced, and the grain boundary embrittlement was reduced, leading to higher CTS.
- 23 November 2022
- Published by Polish Academy of Sciences Chancellery in Archives of Metallurgy and Materials
- Vol. 67 (4) , 1293-1298
Effect of High-Temperature Annealing on the Cross-Tension Property of Resistance Spot Welded Medium-Mn Steel
As one of the most promising 3rd generation advanced high strength steels (AHSS), medium Mn steels attract much attention because of their exceptional mechanical property and reasonable cost. However, their application in the modern automotive industry is limited by poor weldability. In this study, 7Mn steel was welded by resistance spot welding (RSW), which was followed by high-temperature annealing to increase the cross-tension property. With this effort, enhanced cross-tension strength (CTS) with a partial interfacial fracture (PIF) mode was realized. During the annealing after RSW that produced martensite, austenitization was realized and then evolved into martensite by the following air cooling. This process produced structure homogeneity across the joint. With respect to the RSW joint, martensite remained the dominant structure after annealing while the diffusion of C and Mn solutes was triggered. With the increase of annealing temperature, the diffusion was enhanced, and the grain boundary embrittlement was reduced, leading to higher CTS.
- 8 November 2022
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 935
Crystal nucleation in Au49Ag5.5Pd2.3Cu26.9Si16.3 glass and undercooled melt
- 8 November 2022
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 935
Crystal nucleation in Au49Ag5.5Pd2.3Cu26.9Si16.3 glass and undercooled melt