NPNicolay Poletaev

Nicolay Poletaev

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Nicolay Poletaev has a total of 58 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Effect of ionization in an aluminum particle dust flame on the size distribution of Al₂O₃ nanoparticles

    by N. I. Poletaev

    In this review, we present the theoretical investigation results of the coagulation behavior of both neutral and thermally ionized aerosols formed by micro‑dispersed aluminum combustion particles in a dust flame. A mathematical model is proposed to describe particle coagulation in both thermo‑emissive and complex dusty plasma, comprising charged Al₂O₃ particles, electrons, and gas‑phase ions. Particle charges were calculated using the orbital‑motion‑limited (OML) approximation. Ionization equilibrium in the plasma was determined by jointly solving the Saha equations for the gas phase and the charging equation for the particles. The model enabled the study of coagulation dynamics of Al₂O₃ nanoparticles. It was shown that particle charge significantly affects both the characteristic particle size and the width of the size‑distribution function. In thermo‑emission plasma, a strong dependence of particle size and distribution width on temperature was observed. The addition of potassium carbonate to the flame reduced the average Al₂O₃ particle size. Furthermore, increasing the concentration of the ionizing additive resulted in a narrower particle size distribution, approaching monodispersity. The results underscore the importance of accounting for Coulomb interactions in ionized systems for accurate description of the formation of condensed-phase aluminum combustion products in dust flames.

  • Open Access

    Correlation method for measuring the combustion time of micro-sized metal particles in a dust flame

    by N. I. Poletaev

    The paper considers the possibilities of experimental determination of the combustion time of metal particles using the correlation analysis of flame luminosity. Experiments were carried out for dust flames of micro-sized spherical particles (d10< 5 µm) of Fe, Zr and Al in an axisymmetric laminar diffusion dust flame. The number density of particles in the gas suspension (in nitrogen) was about 1012 m-3. The width of the combustion zone at temperature T = (2000÷3000) K in the flame was 1÷2 mm. Under these conditions, the combustion zone is optically thin. This ensures the additive contribution of each particle to the combustion zone radiation. It was shown experimentally, as well as by simulation modelling methods, that the accuracy of combustion time measurements is affected by the stationarity of the object of study, the shape of the radiation trace from the burning particles, and the polydispersity of the initial fuel particles.It was found that the main cause of flame nonstationarity is low-frequency oscillations of different nature, which arise in the reacting two-phase flow at the moment of radiation registration.Studies have shown that processing of flame intensity time series by a high-pass filter (HPF) with a cut-off frequency of about 20 Hz significantly improves the appearance of the autocorrelation function (AF) and allows a more accurate determination of the effective correlation time (particle burning time). Limitations of the application of the HPF, which may lead to distortion of the AF and correlation time, are discussed.The interpretation of AF and correlation times is significantly complicated for polydisperse particle gas suspensions due to the dependence of the particle burning time and their radiative characteristics on the particle size. Simulation modelling methods show that in practice the range of monodispersity of fuel particles can be extended to values of the coefficient of variation of 20-25%.

  • A machine learning method for real estate operation projects forecasting

    by Kyiv National University of Construction and Architecture, Sergey Bushuyev, Denis Bushuiev, Nikolay Poletaev, Odesa National Maritime University, Mykola Malaksiano, Dmitriy Kravtsov

    The study examined the impact of heterogeneous urban night lighting on the possibilities of improving the forecast accuracy for real estate operations projects in a large city. By transforming high-resolution night satellite images into light clusters, new dataset features were obtained after calculating the centers of light clusters and the distances between them. The study used a dataset on real estate rentals in Houston, Texas, USA. The light clusters were linked to the terrain based on their geometric coordinates obtained using QGIS. These new features were integrated into a machine learning model based on the LightGBM regressor. Calculations showed that the reduction in forecast error (in the mean squared error metric, MSE) for our dataset was 11.8%, significantly exceeding the influence of other features investigated in the study. The results suggest that the “light” feature can be considered highly promising for real estate operations projects.

  • Augmentation of Aluminum and Boron Ignition

    by F. K. Bulanin, A. E. Sidorov, N. I. Poletaev, M. A. Starikov, V. G. Shevchuk

    Effect of K2CO3 and KCl additives on the process of high-temperature oxidation and ignition of conglomerates of powdered boron and aluminum particles and on the critical conditions for the ignition of particle–gas mixtures of these metals is studied experimentally. It is revealed that the mixtures of boron and aluminum particles covered (encapsulated) with salts ignite at temperatures lower than the ignition temperatures of mechanical mixtures of metals with these salts in appropriate proportions and significantly lower ignition temperatures of pure boron and aluminum. This indicates the active role of salts in the process of heterogeneous ignition. It is established that, for boron conglomerates, the accelerating effect of salt additives on the oxidation of conglomerates is noticeable at all investigated concentrations and compositions starting from 1% (by weight). For aluminum, an increase in the reaction rate is noticeable only for KCl additives at concentrations of 3% and above.


  • Combustion of Iron Particles Suspension in Laminar Premixed and Diffusion Flames

    by N.I. Poletaev, M.Y. Khlebnikova

    In the work, the combustion regimes of iron particles (d10 = 4.7 µm) in a laminar pre-mixed flame (LPF) and in an axisymmetric laminar diffusion flame (LDF) are studied. For (LPF), we studied the effect of variations in gas suspension of the concentrations of fuel Cf = 0.4 ÷ 0.6 kg/m3 and oxygen CO2 = 21 ÷ 40%, and for (LDF), pure oxygen blowing and variation in the iron concentration Cf = 0.4 ÷ 1.5 kg/m3. The results of particle temperature measurements in the combustion zone of LPF and LDF, the dispersed and phase composition of the combustion products (depending on the concentration of fuel and oxidizer) are presented. It is shown that, under certain conditions, iron particles in LPF switch to a “high-temperature” diffusion mode of combustion. This mode is accompanied by intensification of gas-phase reactions and leads to a two-mode particle size distribution of combustion products. In this mode of combustion of a gas suspension (at temperatures much lower than the boiling point of iron), the mass yield of a nanoscale fraction of combustion products reaches tens of percent and increases with increasing oxygen concentration in LPF. This mode of iron particles combustion was not observed in LDF. The features of the thermal structure of the diffusion dust flame are analyzed. It is shown that in LDF the burning time of metal particles in the diffusion mode is proportional to the particle radius r p ( \~ r p in the kinetic mode), and should depend on the concentration of fuel and the size of the burner.


  • Open Access

    Coagulation of the Ionized Combustion Products in a Dust Flame of Aluminum Particles

    by N. I. Poletaev, M. Y. Khlebnikova

    The addition-agent effect of atoms of alkali metals (K, Na, Li, and Cs) and halogens (Cl and I) introduced into the combustion zone of a dust flame of aluminum particles on the average size of Al2O3 nanoparticles is studied. A physical model of coagulation of a monodisperse aerosol is proposed. The model takes into account the formation of a complex plasma consisting of positive and negative ions, electrons, neutral gas molecules, and suspended particles of the condensed phase in the combustion zone. The effect of the forces of Coulomb repulsion of unipolarly charged Al2O3 particles as well as their possible attraction by ion wind on the constant of the coagulation rate is also taken into account. It is shown that at low ion concentrations in the plasma, the coagulation rate is determined by the Coulomb repulsion of the particles, and at ion concentrations greater than 1020 m−3 the coagulation rate is determined by the attraction of the particles by the ion wind. The results of calculations of the dependence of the average Al2O3 particle size on the concentration of the additives are in a good quantitative agreement with the experimental data. The combined effect of the additives and the equilibrium products of aluminum oxide (AlO, Al, and Al2O) evaporation on the concentration of positive and negative gas ions, electrons, and Al2O3 particle size in the condensation zone is analyzed. The peculiarities of the influence of the additives of electronegative gases (Cl and I atoms) on the coagulation rate of a thermally ionized aerosol and on the particle size of Al2O3 are considered.


  • Producing and properties of zinc dust flames

    by N. I. Poletaev, M. Y. Khlebnikova, K. Y. Khanchych

    Premixed and diffusion dust flames of zinc particles dispersed in the gas (particle size d10 = 4.4 µm; metal mass concentration Cf = 0.40 kg/m3) with propane additives of molar concentration Cg = (2–8)% are studied. Two different burning modes of zinc gas suspension are found. The conditions of formation of these modes depend on the burning temperature of such systems. Two-zone structure of the flame—a zinc evaporation and combustion zone and a zinc vapor condensation zone—is observed. Its origin is explained by the unique specificity of a zinc burning process in contrast to other metals—zinc vapor does not react with oxygen in the gaseous phase, therefore, ZnO molecules and zinc oxide clusters are absent in the combustion zone. The morphology and dispersive composition of the condensed zinc oxide also depend on the gas suspension’s burning mode. In a low-temperature burning mode of zinc dust, the combustion products mostly contain tetrapods, needles and nanorods of zinc oxide. At higher temperatures of the flame, zinc oxide nanorods prevail.


  • Relationship between the dust flame propagation velocity and the combustion mode of fuel particles

    by N. I. Poletaev

    A possibility of determining the regime of combustion of individual fuel particles on the basis of the dependence of the flame velocity on the fuel and oxidizer concentrations is considered by an example of a dust flame of microsized metal particles with diameters < 15 μm and particle concentrations from ≈10 to 10 m in oxygen-containing media at atmospheric pressure. The combustion mode (kinetic or diffusion) is responsible for the qualitative difference in the character of the normal velocity of the flame as a function of the basic parameters of the gas suspension. The analysis of such experimental dependences for fuel-rich mixtures shows that combustion of zirconium particles ( = 4 μm) in a laminar dust flame is controlled by oxidizer diffusion toward the particle surface, whereas combustion of iron particles of a similar size is controlled by kinetics of heterogeneous reactions. For aluminum particles with = 5–15 μm, there are no clearly expressed features of either kinetic or diffusion mode of combustion. To obtain more information about the processes responsible for combustion of fine aluminum particles, the flame velocity is studied as a function of the particle size and initial temperature of the gas suspension. It is demonstrated that aluminum particles under the experimental conditions considered in this study burn in the transitional mode.


  • Bioanalytical system for detection of cancer cells with photoluminescent ZnO nanorods

    by R Viter, K Jekabsons, Z Kalnina, N Poletaev, S H Hsu, U Riekstina

    Using photoluminescent ZnO nanorods and carbohydrate marker SSEA-4, a novel cancer cell recognition system was developed. Immobilization of SSEA-4 antibodies (αSSEA-4) on ZnO nanorods was performed in buffer solution (pH = 7.1) over 2 h. The cancer cell line probes were fixed on the glass slide. One hundred microliters of ZnO-αSSEA-4 conjugates were deposited on the cell probe and exposed for 30 min. After washing photoluminescence spectra were recorded. Based on the developed methodology, ZnO-αSSEA-4 probes were tested on patient-derived breast and colorectal carcinoma cells. Our data clearly show that the carbohydrate SSEA-4 molecule is expressed on cancer cell lines and patient-derived cancer cells. Moreover, SSEA-4 targeted ZnO nanorods bind to the patient-derived cancer cells with high selectivity and the photoluminescence signal increased tremendously compared to the signal from the control samples. Furthermore, the photoluminescence intensity increase correlated with the extent of malignancy in the target cell population. A novel portable bioanalytical system, based on optical ZnO nanorods and fiber optic detection system was developed. We propose that carbohydrate SSEA-4 specific ZnO nanorods could be used for the development of cancer diagnostic biosensors and for targeted therapy.


  • Luminescence study of nanosized Al2O3:Tb3+obtained by gas-dispersed synthesis

    by I V Berezovskaya, N I Poletaev, M E Khlebnikova, I V Zatovsky, K L Bychkov, N P Efryushina, O V Khomenko, V P Dotsenko

    Terbium-doped Al2O3 samples were obtained by gas-dispersed synthesis. It was shown that the resulting powders, with particle sizes of 10–70 nm, consist of a mixture of transition aluminas, among which the δ *-polymorph is dominant. The luminescence properties of Al2O3:Tb3+ have been studied upon excitation in the UV–visible range of the spectrum. It was found that Tb3+ ions cause several groups of inhomogeneously broadened emission bands in the range of 470–640 nm, which are characteristic for disordered materials. In addition, the emission spectra contain a broad band at about 450 nm and several narrower ones in the 680–720 nm region. These features are attributed to surface defects and impurity Cr3+ ions occupying Al3+ octahedral positions, respectively.