Keiji Oyoshi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Keiji Oyoshi has a total of 142 co-authors. Here are the top co-authors by number of shared publications:
Y. Takeda
National Institute for Material Science (NIMS)
14 shared publications- Alexander D. Pogrebnjak
Faculty of Materials Science and Technology in Trnava, Slovak University of Technology in Bratislava, 25, J. Bottu St., 917 24 Trnava, Slovakia
11 shared publications V. M. Beresnev
Karazin Kharov National University
10 shared publications- Oleg V. Sobol
National Technical University “Kharkiv Polytechnic Institute
9 shared publications Shuhei Tanaka
8 shared publicationsH. Amekura
National Institute for Materials Science (NIMS)
7 shared publications
Latest Publications
- Open Access
- 7 April 2026
- Published by Springer Nature in Nature Communications
- Vol. 17 (1)
Enhancing hydrogen permeation barrier performance of ErCo2 magnetic refrigeration material via surface oxide layer formation
The ErCo 2 intermetallic compound exhibits a significant magnetocaloric effect at approximately 32 K and has potential applications as a magnetic refrigeration material for hydrogen liquefaction. However, exposure to a hydrogen atmosphere may lead to hydride formation, which weakens the magnetocaloric effect. Thus, preventing hydrogen permeation into ErCo 2 is crucial. Herein, we enhance the hydrogen permeation barrier (HPB) performance of ErCo 2 particles by using electroless Cu plating followed by oxidation treatment to form a CuO layer with a thickness of a few micrometers. In experiments, ErCo 2 particles, with a 1.5- to 5-µm-thick CuO surface layer, exhibited a large magnetic entropy change of 24 J kg⁻¹ K⁻¹ even after exposure to a H 2 atmosphere at 1.27 MPa and 296 K for 7 d. Experimental analyses and first-principles calculations revealed the potential of CuO as an HPB material for magnetic refrigeration.
- 7 April 2026
- Published by Springer Nature in Nature Communications
- Vol. 17 (1)
Open AccessEnhancing hydrogen permeation barrier performance of ErCo2 magnetic refrigeration material via surface oxide layer formation
The ErCo 2 intermetallic compound exhibits a significant magnetocaloric effect at approximately 32 K and has potential applications as a magnetic refrigeration material for hydrogen liquefaction. However, exposure to a hydrogen atmosphere may lead to hydride formation, which weakens the magnetocaloric effect. Thus, preventing hydrogen permeation into ErCo 2 is crucial. Herein, we enhance the hydrogen permeation barrier (HPB) performance of ErCo 2 particles by using electroless Cu plating followed by oxidation treatment to form a CuO layer with a thickness of a few micrometers. In experiments, ErCo 2 particles, with a 1.5- to 5-µm-thick CuO surface layer, exhibited a large magnetic entropy change of 24 J kg⁻¹ K⁻¹ even after exposure to a H 2 atmosphere at 1.27 MPa and 296 K for 7 d. Experimental analyses and first-principles calculations revealed the potential of CuO as an HPB material for magnetic refrigeration.
- 25 January 2023
- Published by American Physical Society (APS) in Physical Review Materials
- Vol. 7 (1) , 014411
Carbon-induced magnetic properties and anomalous Hall effect in thin films with -like structuresthin films were synthesized via vacuum carburization of the host CoMn alloy films based on a conventional gas-solid reaction to demonstrate the effect of C, a common light element, on the magnetic and spintronic materials. The crystal structure transitioned from the disordered face-centered-cubic CoMn to the -like , for which the lattice constant increased from 0.356 to 0.378 nm. The C x-ray photoemission spectra of the film indicated hybridization in C-Co and C-Mn and a homogeneous concentration of C in the film. The enhancement of both the saturation magnetization and the anomalous Hall conductivity () was induced by C, attributing to the magnetic transition to the ferrimagnetic spin order. The surface flatness and high are promising characteristics for spintronic applications such as the spin-anomalous Hall effect. The atom- and spin-resolved density of states (DOS) via first-principles calculations revealed that face-centered Mn(II) and Co could be significantly influenced by C because of p-d hybridization, resulting in enhanced spin polarization of the DOS at the Fermi level of ∼0.82. These results demonstrate that the use of C could be an essential way to boost material properties in the future.- 25 January 2023
- Published by American Physical Society (APS) in Physical Review Materials
- Vol. 7 (1) , 014411
Carbon-induced magnetic properties and anomalous Hall effect in thin films with -like structuresthin films were synthesized via vacuum carburization of the host CoMn alloy films based on a conventional gas-solid reaction to demonstrate the effect of C, a common light element, on the magnetic and spintronic materials. The crystal structure transitioned from the disordered face-centered-cubic CoMn to the -like , for which the lattice constant increased from 0.356 to 0.378 nm. The C x-ray photoemission spectra of the film indicated hybridization in C-Co and C-Mn and a homogeneous concentration of C in the film. The enhancement of both the saturation magnetization and the anomalous Hall conductivity () was induced by C, attributing to the magnetic transition to the ferrimagnetic spin order. The surface flatness and high are promising characteristics for spintronic applications such as the spin-anomalous Hall effect. The atom- and spin-resolved density of states (DOS) via first-principles calculations revealed that face-centered Mn(II) and Co could be significantly influenced by C because of p-d hybridization, resulting in enhanced spin polarization of the DOS at the Fermi level of ∼0.82. These results demonstrate that the use of C could be an essential way to boost material properties in the future.- 1 November 2016
- Published by Elsevier in Materials & Design
- Vol. 110, 821-829
Effect of ion implantation on the physical and mechanical properties of Ti-Si-N multifunctional coatings for biomedical applications
- 1 November 2016
- Published by Elsevier in Materials & Design
- Vol. 110, 821-829
Effect of ion implantation on the physical and mechanical properties of Ti-Si-N multifunctional coatings for biomedical applications
- 1 November 2016
- Published by Allerton Press in Journal of Superhard Materials
- Vol. 38 (6) , 393-401
Effect of the high doze of N+(1018 cm–2) ions implantation into the (TiHfZrVNbTa)N nanostructured coating on its microstructure, elemental and phase compositions, and physico-mechanical properties
Structure and properties of (TiHfZrVNbTa)N nanostructured multicomponent coatings implanted with a very high (1018 cm–2) dose of N+ions have been studied. As a result of the implantation a multilayer...
- 1 November 2016
- Published by Allerton Press in Journal of Superhard Materials
- Vol. 38 (6) , 393-401
Effect of the high doze of N+(1018 cm–2) ions implantation into the (TiHfZrVNbTa)N nanostructured coating on its microstructure, elemental and phase compositions, and physico-mechanical properties
Structure and properties of (TiHfZrVNbTa)N nanostructured multicomponent coatings implanted with a very high (1018 cm–2) dose of N+ions have been studied. As a result of the implantation a multilayer...
- 1 September 2016
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 679, 155-163
Irradiation resistance, microstructure and mechanical properties of nanostructured (TiZrHfVNbTa)N coatings
- 1 September 2016
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 679, 155-163
Irradiation resistance, microstructure and mechanical properties of nanostructured (TiZrHfVNbTa)N coatings
- 26 July 2016
- Published by Pleiades Publishing Ltd in Physics of the Solid State
- Vol. 58 (7) , 1453-1457
Recrystallization and formation of spheroidal gold particles in amorphous-like AlN–TiB2–TiSi2 coatings after annealing and subsequent implantation
- 26 July 2016
- Published by Pleiades Publishing Ltd in Physics of the Solid State
- Vol. 58 (7) , 1453-1457
Recrystallization and formation of spheroidal gold particles in amorphous-like AlN–TiB2–TiSi2 coatings after annealing and subsequent implantation
- 1 November 2015
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 41 (11) , 1054-1057
The microstructure of a multielement nanostructured (TiZrHfVNbTa)N coating and its resistance to irradiation with Au– ions
The formation of a phase with a FCC lattice of the NaCl structure type is observed following the deposition of a multielement nanostructured (TiZrHfVNbTa)N coating. An increase in pressure results in...
- 1 November 2015
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 41 (11) , 1054-1057
The microstructure of a multielement nanostructured (TiZrHfVNbTa)N coating and its resistance to irradiation with Au– ions
The formation of a phase with a FCC lattice of the NaCl structure type is observed following the deposition of a multielement nanostructured (TiZrHfVNbTa)N coating. An increase in pressure results in...
- 1 September 2015
- Published by Allerton Press in Journal of Superhard Materials
- Vol. 37 (5) , 310-321
Structural features and physico-mechanical properties of AlN-TiB2-TiSi2 amorphous-like coatings
The coating of the AlN-TiB2-TiSi2system has been produced by the magnetron sputtering of a target. At the high-temperature (900 and 1300°C) actions the coating crystallization to form crystallites...
- 1 September 2015
- Published by Allerton Press in Journal of Superhard Materials
- Vol. 37 (5) , 310-321
Structural features and physico-mechanical properties of AlN-TiB2-TiSi2 amorphous-like coatings
The coating of the AlN-TiB2-TiSi2system has been produced by the magnetron sputtering of a target. At the high-temperature (900 and 1300°C) actions the coating crystallization to form crystallites...