JLJinye Li

Jinye Li

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Jinye Li has a total of 50 co-authors. Here are the top co-authors by number of shared publications:

  • Hailu Fu

    China Jiliang University

    2 shared publications
  • Ping Zheng

    2 shared publications
  • Zhou Ye

    Department of Environmental Engineering, China Jiliang University, Hangzhou, China

    2 shared publications
  • Baolan Hu

    1 shared publication
  • Baolan Hu

    Key Laboratory of Environment Remediation and Ecological Health, Ministry of Education, College of Environmental Resource Sciences, Zhejiang University, Hangzhou, China; College of Environmental and Resource Sciences, Zhejiang University, Hangzhou, China; Zhejiang Province Key Laboratory for Water Pollution Control and Environmental Safety, Hangzhou, China

    1 shared publication
  • Chengran Fang

    College of Civil Engineering, Zhejiang University of Technology, Hangzhou 310023, China

    1 shared publication

Latest Publications

  • Reclaim water from real leachates reverse osmosis concentrate by pervaporation

    by Zhou Ye, Hongliang Xu, Zhenyuan Zhou, Ye Chen, Zitong Pan, Yifan Liu, Jinye Li

    Pervaporation (PV) is a cost-efficient separation process successfully used in the dehydration of organic solutions, which is also regarded as a promising concentrating and desalination technology. However, the performance of water reclamation by PV from real high-strength wastewater is still lacking. In this study, the feasibility of reclaiming water from real leachate reverse osmosis concentrate was investigated with both laboratory and pilot-scale apparatus. With a feed temperature set to 70 ℃, the laboratory-scale setup achieved a water flux of 17.4 LMH, while the pilot-scale system obtained 8.9 LMH with flat membrane modules. Increasing the feed temperature from 70 to 85 ℃ resulted in a minimal enhancement of water flux, whereas a linear increase in water flux was observed as osmotic side pressure decreased. Results showed high salt rejection (> 99.8%) and COD removal efficiency (94.6%) under all operating conditions, and the reclaimed water could meet the quality requirements for reuse.

  • Rhodamine B removal via ozonation catalyzed by bamboo leaf biochar with Fe–Mn bimetallic oxides

    by Jinye Li, Jiaying Wang, Yirong Zhu, Zhenyuan Zhou, Ziwei Shen, Yifan Liu, Ming Zhang, Hailu Fu


  • Research on prediction of near-road PM 2.5 concentration by integrating traffic flow and meteorological factors

    by Yanxia Liang, Wenjing Wang, Xuemei Zhang, Yunqiu Gao, Qiang Yang, Chengxiao Zhao, Zhou Ye, Tao Ding, Jinye Li

    Near-road particulate matter poses significant risks to public health and the ecological environment, and its levels are affected by the meteorological and traffic factors significantly. However, the contributions of these factors to particulate matter concentrations and the interactions among these factors were not well studied. In this study, the causal relationships among traffic flow (TF), near-road PM2.5 levels, and meteorological factors were elucidated based on the long-term real-time data on near-road PM2.5 concentrations alongside concurrent meteorological and traffic data. A predictive modeling framework was developed to predict near-road PM2.5 concentrations using traffic and meteorological data as input. The results indicate that the correlation between TF and near-road PM2.5 concentrations is significant (P < 0.05). Furthermore, robust causal relationships were identified between TF and meteorological parameters such as temperature and atmospheric pressure. It is suggested that TF could indirectly influence the level of near-road PM2.5 by altering meteorological factors. By comparing the prediction performance among Long Short-Term Memory (LSTM), Backpropagation (BP) and Extreme Learning Machine (ELM) models for near-road PM2.5 concentrations, combined with Shapley Additive exPlanations (SHAP) for feature importance analysis, it revealed that the inclusion of TF data markedly improves model accuracy in near-road PM2.5 concentrations prediction.

  • Research on characteristics and influencing factors of road dust emission in a southern city in China

    by Jinye Li, Wenjing Wang, Yanxia Liang, Zhou Ye, Shengqi Yin, Tao Ding

    One of the primary causes of urban atmospheric particulate matter, which is harmful to human health in addition to affecting air quality and atmospheric visibility, is road dust. This study used online monitoring equipment to examine the characteristics of road dust emissions, the effects of temperature, humidity, and wind speed on road dust, as well as the correlation between road and high-space particulate matter concentrations. A section of a real road in Jinhua City, South China, was chosen for the study. The findings demonstrate that the concentration of road dust particles has a very clear bimodal single-valley distribution throughout the day, peaking between 8:00 and 11:00 and 19:00 and 21:00 and troughing between 14:00 and 16:00. Throughout the year, there is a noticeable seasonal change in the concentration of road dust particles, with the highest concentration in the winter and the lowest in the summer. Simultaneously, it has been discovered that temperature and wind speed have the most effects on particle concentration. The concentration of road dust particles reduces with increasing temperature and wind speed. The particle concentrations of road particles and those from urban environmental monitoring stations have a strong correlation, although the trend in the former is not entirely consistent, and the changes in the former occur approximately 1 h after the changes in the latter.


  • On Potentials of the Gamma Densities to Blind Face Hallucination

    by Yufan Chen, Zihan Cheng, Xinru Chen, Jinye Li, Wenze Shao

    As to blind hallucination of blurry low-resolution faces, the supervised learning methods obviously lack generalization for blur kernels in various types and scales. While, the unsupervised learning ones usually require pre-trained deep generative models. The involved non-convex inversion is often highly challengeable, especially as the blurred low-resolution face image is undergone a blur process much distinct from the ones in the pre-training stage. This paper falls into unsupervised blind face hallucination, while takes a step forward. That is, a deep discriminative face prior has been proposed by innovatively exploring the Gamma densities for unsupervised blind hallucination, which is expected to regularize better the inversion of pre-trained deep generative models. The experimental results well prove the effectiveness of the proposed method.

  • Open Access

    Enhanced Adsorptive Removal of Ammonium on the Na+/Al3+ Enriched Natural Zeolite

    by Hailu Fu, Lingling Zhong, Ziyao Yu, Wenxiang Liu, Mona A. Abdel-Fatah, Jinye Li, Ming Zhang, Jie Yu, Wenjie Dong, Sang Soo Lee

    Various biological methods for the removal of ammonium from surface water are ineffective at low ammonium concentrations and temperature. In this study, natural zeolite (NZ) is modified using sodium a luminate (SA, NaAlO 2 ) in combination with calcination to determine its ammonium removal efficiency. The NZ impregnated with 0.50 M SA solution followed by calcination at 573 K exhibits the best ammonium removal rate, which increases by 21.20% in comparison to that with NZ under the same conditions. Regeneration through NaCl solution impregnation further improved the ammonium removal performance of the modified zeolites. More adsorption sites are created through Na + -cation exchange and Al 3+ engrafting into the skeleton. The average pore size and percentage of meso-porous volume are also increased. It is determined that ammonium adsorption onto the modified NZs is a diffusion controlled endothermic process, and the isotherm better fits the Freundlich model because of the coarse surface functionalized by SA and calcination. The effect of coexisting ions, pH and dosage on ammonium adsorption was also determined.


  • Filamentous granular sludge bulking in a laboratory scale UASB reactor

    by Jinye Li, Baolan Hu, Ping Zheng, Mahmood Qaisar, Lingling Mei


  • Identification of a denitrifying bacterium and verification of its anaerobic ammonium oxidation ability

    by Baolan Hu, Ping Zheng, Jinye Li, Xiangyang Xu, Rencun Jin

    A strain D3 of denitrifying bacterium was isolated from an anammox reactor, and identified as Pseudomonas mendocina based on the morphological and physiological assay, Vitek test, Biolog test, (G+C) mol% content, and 16S rDNA phylogenetic analysis. As a typical denitrifying bacterium, strain D3 achieved the maximal nitrate reduction rate of 26.2 mg/(L·d) at the nitrate concentration of 88.5 mg N/L. The optimal pH and growth temperature were 7.84 and 34.9°C, respectively. Strain D3 was able to oxidize ammonia under anaerobic condition. The maximum nitrate and ammonium utilization rates were 6.37 mg/(L·d) and 3.34 mg/(L·d), respectively, and the consumption ratio of ammonia to nitrate was 1:1.91. Electron microscopic observation revealed peculiar cell in clusions in strain D3. Because of its relation to anammox activity, strain D3 was presumed to be anammoxosome. The present investigation proved that denitrifying bacteria have the anammox ability, and the results have engorged the range of anammox populations.