TPToni Pfennig

Toni Pfennig

*This is an algorithmically generated author record based on publicly available information.

Toni Pfennig has a total of 15 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Solvent-driven isomerization of cis,cis-muconic acid for the production of specialty and performance-advantaged cyclic biobased monomers

    by Jack M. Carraher, Prerana Carter, Radhika G. Rao, Michael J. Forrester, Toni Pfennig, Brent H. Shanks, Eric W. Cochran, Jean-Philippe Tessonnier

    The quest for green plastics calls for new routes to aromatic monomers using biomass as a feedstock. Suitable feedstock molecules and conversion pathways have already been identified for several commodity aromatics through retrosynthetic analysis. However, this approach suffers from some limitations as it targets a single molecule at a time. A more impactful approach would be to target bioprivileged molecules that are intermediates to an array of commodity and specialty chemicals along with novel compounds. Muconic acid (MA) has recently been identified as a bioprivileged intermediate as it gives access to valuable aliphatic and cyclic diacid monomers including terephthalic acid (TPA), 1,4-cyclohexanedicarboxylic acid (CHDA), and novel monounsaturated 1,4-cyclohexenedicarboxylic acids (CH1DA, CH2DA). However, accessing these cyclic monomers from MA requires to first isomerize biologically-produced cis,cis-MA to Diels–Alder active trans,trans-MA. A major impediment in this isomerization is the irreversible ring closing of MA to produce lactones. Herein, we demonstrate a green solvent-mediated isomerization using dimethyl sulfoxide and water. The mechanistic understanding achieved here elucidates the role of low concentrations of water in reducing the acidity of the system, thereby preventing the formation of lactones and improving the selectivity to trans,trans-MA from less than 5% to over 85%. Finally, a Diels–Alder reaction with trans,trans-MA is demonstrated with ethylene. The monounsaturated cyclic diacid obtained through this reaction (CH1DA) can be converted in a single step into TPA and CHDA, or can be directly copolymerized with adipic acid and hexamethylenediamine to tailor the thermal and mechanical properties of conventional Nylon 6,6.


  • Open Access

    Paired electrocatalytic hydrogenation and oxidation of 5-(hydroxymethyl)furfural for efficient production of biomass-derived monomers

    by Xiaotong H. Chadderdon, David J. Chadderdon, Toni Pfennig, Brent H. Shanks, Wenzhen Li

    Electrocatalytic hydrogenation and oxidation of 5-(hydroxymethyl)furfural in one paired electrolyzer produces two biorenewable monomers with a combined electron efficiency of 187%.


  • A new selective route towards benzoic acid and derivatives from biomass-derived coumalic acid

    by Toni Pfennig, Jack M. Carraher, Ashwin Chemburkar, Robert L. Johnson, Austin T. Anderson, Jean-Philippe Tessonnier, Matthew Neurock, Brent H. Shanks

    The selective production of aromatics from bio-based sources is an area of interest to expand the potential for greener alternatives to petroleum-derived chemicals. A scalable, efficient route to produce bio-based benzoates is demonstrated by carrying out heterogeneous catalytic reactions in non-toxic bio-based solvents at 180 °C obtaining yields of up to 100 mol%. This approach extends the 2-pyrone (coumalic acid/methyl coumalate) Diels–Alder platform by utilizing a bioavailable co-reactant ethylene. A detailed investigation using a combination of kinetic experiments, DFT calculations, and multi-dimensional NMR was carried out to determine the detailed reaction network, and the corresponding activation energies for critical steps. Additionally, a series of experiments were conducted to maximize the yields by comparing different solvents, for both coumalic acid and methyl coumalate. Our results show that the choice of solvent was a significant factor when coumalic acid was the reactant (yields 71–92 mol%), while methyl coumalate was only minimally affected by the solvent (yields 95–100 mol%). Interestingly, the reaction network and kinetic analysis showed that the Diels–Alder reactions were not significantly different between coumalic acid and methyl coumalate, with the rate limiting step for both being decarboxylation with an activation barrier of 141 kJ mol−1 compared to 77 kJ mol−1 for the formation of the bicyclic adduct. Finally, the reaction cascade was found to be highly susceptible to by-product formation when as little as 5 vol% water was present in the solvent, which demonstrates that the absence of water is essential for high yielding benzoate production.


  • The formation of p-toluic acid from coumalic acid: a reaction network analysis

    by Toni Pfennig, Robert L. Johnson, Brent H. Shanks

    Diels–Alder cycloaddition of biomass-derived 2-pyrone coumalic acid (CMA) with propylene provides an alternative pathway to produce toluic acid (TA), a precursor to terephthalic acid (TPA) which is a key component in the manufacture of polyethylene terephthalate (PET). To maximize yield and selectivity of the preferred isomer p-toluic acid (p-TA) we herein report a detailed reaction network that was established through investigating the influence of the dehydrogenation catalyst, solvent, temperature and reaction time on the formation of p-/m-TA. We further provide experimental results showing that the inverse electron demand Diels–Alder (IEDDA)/decarboxylation cascade of the reaction of CMA with propylene was not influenced by the catalyst, and, therefore, was solely dependent on temperature. Evident from changes in the p-/m-ratio of TA decreasing from 6.91 to 4.43 with increasing temperature and reaction time, p-TA was both the thermodynamic and kinetically favoured product. TA formation from CMA and propylene afforded an overall yield of >85 mol%, using γ-valerolactone (GVL) as the primary solvent. Throughout the reaction network analysis we observed that the TA intermediates 3-/4-methylcyclohexa-1,5-diene carboxylic acid were reactive towards by-product formation whereas TA was quite stable under reaction conditions. Henceforth, rapid dehydrogenation of the diene intermediates is crucial to maximize selectivity of the desired aromatic product. Lastly, CMA thermally decomposes under reaction conditions which was rapidly accelerated by having as low as 5 vol% water in the solvent, demonstrating the importance of water-free solvent to limit CMA decomposition and maximize product yield.


  • cis,cis-Muconic acid isomerization and catalytic conversion to biobased cyclic-C6-1,4-diacid monomers

    by Jack M. Carraher, Toni Pfennig, Radhika G. Rao, Brent H. Shanks, Jean-Philippe Tessonnier

    Renewable terephthalic and 1,4-cyclohexanedicarboxylic acids can be produced from biomass via muconic acid using a combination of biological and chemical processes. In this conversion scheme, cis,cis-mucononic acid is first obtained by fermentation using either sugar or lignin monomers as a feedstock. The diunsaturated cis,cis-diacid is then isomerized to trans,trans-muconic acid, reacted with biobased ethylene through Diels–Alder cycloaddition, and further hydrogenated or dehydrogenated to yield the desired 100% renewable cyclic dicarboxylic acid. The isomerization of cis,cis- to trans,trans-muconic acid represents the main bottleneck in this process due to undesired side reactions that promote ring closing to form lactones. Therefore, new technologies for the selective isomerization of muconic acid are urgently needed. Here, we studied the corresponding reaction kinetics to elucidate the mechanisms involved in both the isomerization and cyclization reactions with the objective to identify conditions that favor the selective formation of trans,trans-muconic acid. We demonstrate that the reactivity of muconic acid in aqueous media strongly depends on pH. Under alkaline conditions, cis,cis-muconic acid is deprotonated to the corresponding muconate dianion. This species is stable for extended periods of time and does not isomerize. Conversely, cis,cis-muconic acid readily isomerizes to its cis,trans-isomer under acidic conditions. Prolonged heating further triggers the intramolecular cyclizations through reaction of the carboxylic acid and alkene functionalities. The formation of the muconolactone and its dilactone is kinetically favored over the isomerization to trans,trans-muconic acid over a broad range of conditions. However, strategies involving the chelation of the carboxylates with inorganic salts or their solvation using polar aprotic solvents were found to hamper the ring closing reactions and allow the isomerization to trans,trans-muconic acid to proceed with high selectivity (88%). The obtained compound was further reacted with ethylene and hydrogenated to 1,4-cyclohexanedicarboxylic acid, an important monomer for the polyester and polyamide industries.