Ahmed Labidi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Ahmed Labidi has a total of 79 co-authors. Here are the top co-authors by number of shared publications:
- Mosbah Amlouk
Unité de Physique des Dispositifs à Semi-Conducteurs, Faculté des sciences de Tunis, Tunis El Manar University, Tunis, Tunisia
8 shared publications K. Aguir
7 shared publicationsM. Maaref
6 shared publicationsA. Mhamdi
5 shared publicationsA. Bejaoui
4 shared publicationsC. Lambert-Mauriat
4 shared publications
Latest Publications
- 16 January 2024
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 35 (2) , 1-15
Cobalt doping effect on TiO2 sensing properties under C1–C4 alcohols vapors
- 16 January 2024
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 35 (2) , 1-15
Cobalt doping effect on TiO2 sensing properties under C1–C4 alcohols vapors
- Open Access
- 22 February 2023
- Published by MDPI AG in Applied Sciences
- Vol. 13 (5) , 2797
Investigation of Annealing Process Effects on the Response and Stability of Sprayed Co2SnO4 Film under Ethanol Vapor
The ethanol (C2H5OH) vapor detection properties of a layer of cubic spinel cobalt stannate as-prepared Co2SnO4 (denoted as CTOas), elaborated by a low-cost spray pyrolysis method, were investigated before and after an annealing process. The response of layers under ethanol vapors of different concentrations exhibited a stable behavior in a dry atmosphere at the optimum working temperatures. The elaborated nanomaterials were characterized by transmission electron microscopy (TEM), scanning electron microscopy (SEM), X-ray diffraction (XRD), direct current measurement (DC) and impedance spectroscopy techniques (AC). After the annealing process of pure CTOas, an n-type to p-type conductivity switch was observed and attributed to Co3O4 apparition in the Co2SnO4 structure. The layer’s ethanol response increased and became more stable after annealing. The stability was measured over a period of three months. DC and AC investigations allowed us to propose a detection mechanism involving grain boundary regions in a Co2SnO4/Co3O4 composite obtained after annealing (denoted as CTOann). According to its stable and receivable sensing response, the Co2SnO4/Co3O4 composite could be considered as a promising novel sensitive layer for ethanol gas sensors.
- 22 February 2023
- Published by MDPI AG in Applied Sciences
- Vol. 13 (5) , 2797
Open AccessInvestigation of Annealing Process Effects on the Response and Stability of Sprayed Co2SnO4 Film under Ethanol Vapor
The ethanol (C2H5OH) vapor detection properties of a layer of cubic spinel cobalt stannate as-prepared Co2SnO4 (denoted as CTOas), elaborated by a low-cost spray pyrolysis method, were investigated before and after an annealing process. The response of layers under ethanol vapors of different concentrations exhibited a stable behavior in a dry atmosphere at the optimum working temperatures. The elaborated nanomaterials were characterized by transmission electron microscopy (TEM), scanning electron microscopy (SEM), X-ray diffraction (XRD), direct current measurement (DC) and impedance spectroscopy techniques (AC). After the annealing process of pure CTOas, an n-type to p-type conductivity switch was observed and attributed to Co3O4 apparition in the Co2SnO4 structure. The layer’s ethanol response increased and became more stable after annealing. The stability was measured over a period of three months. DC and AC investigations allowed us to propose a detection mechanism involving grain boundary regions in a Co2SnO4/Co3O4 composite obtained after annealing (denoted as CTOann). According to its stable and receivable sensing response, the Co2SnO4/Co3O4 composite could be considered as a promising novel sensitive layer for ethanol gas sensors.
- 18 November 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 22 (1) , 671-677
VOCs Identification Method Based on One Single ZnTTP Sensor
In this work, an innovative approach based on the combination of hierarchical ascending classification (HAC) and principal component analysis (PCA) is proposed to discriminate individual vapors such as methanol, toluene, acetone, isopropanol, and ethanol using dynamic responses of one single sensor based on 5, 10, 15, 20 tetratoloylphenylporphyrinato Zn (II) (ZnTTP) at room temperature. Experimental data of 20 measurements as individuals (i.e., four different concentrations of each vapor) and extraction of new mathematical features associated with dynamic behavior were the basis of two subsets entered into the gas identification method. With PCA, four distinct groups were observed for each subset. The first three principal components have been added as data features for each previous corresponding subset of the HAC process. The classification becomes clearer and unambiguously separates the different clusters in good compliance with PCA. The obtained results have demonstrated the possibility to recognize the studied vapors by exploiting a single gas sensor with an opportunity to apply the developed PCA/HAC-based platform in cost-effective and highly selective gas monitoring systems.
- 18 November 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 22 (1) , 671-677
VOCs Identification Method Based on One Single ZnTTP Sensor
In this work, an innovative approach based on the combination of hierarchical ascending classification (HAC) and principal component analysis (PCA) is proposed to discriminate individual vapors such as methanol, toluene, acetone, isopropanol, and ethanol using dynamic responses of one single sensor based on 5, 10, 15, 20 tetratoloylphenylporphyrinato Zn (II) (ZnTTP) at room temperature. Experimental data of 20 measurements as individuals (i.e., four different concentrations of each vapor) and extraction of new mathematical features associated with dynamic behavior were the basis of two subsets entered into the gas identification method. With PCA, four distinct groups were observed for each subset. The first three principal components have been added as data features for each previous corresponding subset of the HAC process. The classification becomes clearer and unambiguously separates the different clusters in good compliance with PCA. The obtained results have demonstrated the possibility to recognize the studied vapors by exploiting a single gas sensor with an opportunity to apply the developed PCA/HAC-based platform in cost-effective and highly selective gas monitoring systems.
- 1 September 2020
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 319
Highly sensitive nitrogen dioxide gas sensors based on sprayed β-In2S3 film
- 1 September 2020
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 319
Highly sensitive nitrogen dioxide gas sensors based on sprayed β-In2S3 film
- Open Access
- 9 December 2019
- Published by IOP Publishing in Materials Research Express
- Vol. 7 (1) , 016406
Thickness effect on sensing properties of pure Cu2O thin films under sub-ppm O3 levels
The sub-ppm ozone (O3) sensitivity of pure cuprous (Cu2O) thin films based sensors have been investigated by utilizing conductivity measurements at different temperatures varies from 150 to 200 °C. The structural and morphological properties of Cu2O sensitive layers have been investigated by the scanning electron microscope (SEM) and x-ray diffraction (XRD) respectively. The detection properties of Cu2O layers have been strongly altered by the electrode geometries and sensitive layer thickness. The sensors’ responses and structural investigations revealed that the ozone sensitivity has improved with the increase in the degree of crystallinity along the preferential direction (111). Ab-initio calculation shows that O3 adsorption mechanism could be semi- dissociative of O3 molecule on the Cu2O (111) surface, giving O2 molecule remaining in interaction with the surface and an adsorbed oxygen Oads.
- 9 December 2019
- Published by IOP Publishing in Materials Research Express
- Vol. 7 (1) , 016406
Open AccessThickness effect on sensing properties of pure Cu2O thin films under sub-ppm O3 levels
The sub-ppm ozone (O3) sensitivity of pure cuprous (Cu2O) thin films based sensors have been investigated by utilizing conductivity measurements at different temperatures varies from 150 to 200 °C. The structural and morphological properties of Cu2O sensitive layers have been investigated by the scanning electron microscope (SEM) and x-ray diffraction (XRD) respectively. The detection properties of Cu2O layers have been strongly altered by the electrode geometries and sensitive layer thickness. The sensors’ responses and structural investigations revealed that the ozone sensitivity has improved with the increase in the degree of crystallinity along the preferential direction (111). Ab-initio calculation shows that O3 adsorption mechanism could be semi- dissociative of O3 molecule on the Cu2O (111) surface, giving O2 molecule remaining in interaction with the surface and an adsorbed oxygen Oads.
- 12 November 2019
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (12) , 126409
Ethanol sensing enhancement of low-coast sprayed α-Fe2O3 films
This work reports the manufacture and the characterization of α-Fe2O3 thin and thick films grown on glass substrates at 350°C using the chemical spray technique and subsequently modified by thermal annealing at 450°C. The Crystalline structure, the surface morphology and the optical properties of the films were investigated. The decreases of the α-Fe2O3 film thickness affect all physical properties by improving the optical, structural and mostly ethanol sensing properties wherein we note an improvement of ethanol response from 4 under 5000 ppm for thick layer to 13 under only 100 ppm for thin layer.We note also for this layer, an improvement of phase purity which is confirmed by the increases of optical bandgap from 2.15 eV to 2.19 eV, with guarding the same preferred direction (104).Under ethanol α-Fe2O3 thick films exhibit a transition from n to p-type conductivity whereas thin films exhibit only p-type conductivity, the detection mechanism of this behavior was attributed mainly to grain size effects.
- 12 November 2019
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (12) , 126409
Ethanol sensing enhancement of low-coast sprayed α-Fe2O3 films
This work reports the manufacture and the characterization of α-Fe2O3 thin and thick films grown on glass substrates at 350°C using the chemical spray technique and subsequently modified by thermal annealing at 450°C. The Crystalline structure, the surface morphology and the optical properties of the films were investigated. The decreases of the α-Fe2O3 film thickness affect all physical properties by improving the optical, structural and mostly ethanol sensing properties wherein we note an improvement of ethanol response from 4 under 5000 ppm for thick layer to 13 under only 100 ppm for thin layer.We note also for this layer, an improvement of phase purity which is confirmed by the increases of optical bandgap from 2.15 eV to 2.19 eV, with guarding the same preferred direction (104).Under ethanol α-Fe2O3 thick films exhibit a transition from n to p-type conductivity whereas thin films exhibit only p-type conductivity, the detection mechanism of this behavior was attributed mainly to grain size effects.
- 1 May 2019
- Published by Elsevier in Superlattices and Microstructures
- Vol. 129, 91-104
Physical properties investigation and gas sensing mechanism of Al: Fe2O3 thin films deposited by spray pyrolysis
- 1 May 2019
- Published by Elsevier in Superlattices and Microstructures
- Vol. 129, 91-104
Physical properties investigation and gas sensing mechanism of Al: Fe2O3 thin films deposited by spray pyrolysis
- 1 May 2018
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 261, 522-530
Ethanol sensing properties of sprayed β-In2S3 thin films
- 1 May 2018
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 261, 522-530
Ethanol sensing properties of sprayed β-In2S3 thin films
- 1 September 2017
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 521, 178-187
Electrical and gas sensing investigations on the sprayed ZnO:Cu thin films
- 1 September 2017
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 521, 178-187
Electrical and gas sensing investigations on the sprayed ZnO:Cu thin films
- 1 June 2017
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 708, 769-779
Electrical conductivity of Zn2SnO4 thin films along with wettability and EtOH-sensing
- 1 June 2017
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 708, 769-779
Electrical conductivity of Zn2SnO4 thin films along with wettability and EtOH-sensing