HYHassan Younas

Hassan Younas

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Hassan Younas has a total of 24 co-authors. Here are the top co-authors by number of shared publications:

  • Long-Zhu Chen

    Department of Civil Engineering, Shanghai Jiao Tong University, Shanghai, 200240, China

    3 shared publications
  • Syed Taseer Abbas Jaffar

    Department of Civil Engineering, Shanghai Jiao Tong University, Shanghai, 200240, China.

    3 shared publications
  • Fan Luo

    Department of Environmental Science and Engineering, School of Environmental and Chemical Engineering, Shanghai University, Shanghai, 200444, People's Republic of China

    2 shared publications
  • Rong Ye

    Department of Environmental Science and Engineering, School of Environmental and Chemical Engineering, Shanghai University, Shanghai, 200444, People's Republic of China

    2 shared publications
  • Xue-Feng Hu

    Department of Environmental Science and Engineering, School of Environmental and Chemical Engineering, Shanghai University, Shanghai, 200444, People's Republic of China

    2 shared publications
  • Yiliang He

    Shanghai Jiao Tong University

    2 shared publications

Latest Publications

  • Open Access

    Development of Photocatalytic Ultrafiltration Membranes for Enhanced Removal of Carbamazepine: Optimization and Mechanistic Insights

    by Zohaib Ur Rehman Afridi, Hassan Younas, Abdul Jabbar Ehsan, Shahzada Muhammad Sajid Jillani, Muhammad Ahsan Amjed

    Carbamazepine (CBZ), a persistent antiepileptic drug, poses significant challenges in water treatment due to its recalcitrance to conventional degradation methods. This study presents a breakthrough in CBZ removal by integrating a photocatalytic ultrafiltration (UF) membrane with precisely engineered surface‐immobilized TiO₂ nanoparticles (NPs) fabricated via an innovative technique developed in our prior work. The UF process, conducted under UV irradiation at 0.5 L/min crossflow, demonstrated exceptional performance when optimizing membrane composition (18% PVDF, 5% ethanol, and 1.5% embedded TiO 2 ) and surface TiO 2 NP density (3.04 g/m 2 ), achieving 80% CBZ rejection with a high permeate flux of 100 L/m 2 /h at low pressures (0.05–0.1 MPa). Crucially, membranes lacking surface TiO 2 NPs showed negligible CBZ removal, regardless of UV exposure or pressure, underscoring the necessity of photocatalytic activation. Further analysis revealed that increasing pressure (0.05 → 0.1 MPa) and CBZ concentration (1 → 4 mg/L) reduced rejection efficiency (80% → 42% and 80% → 55%, respectively), highlighting the interplay between operational parameters and membrane performance. This work establishes a groundbreaking strategy for enhancing CBZ elimination, offering critical insights for advancing engineered membrane technologies in water treatment applications.


  • Open Access

    Biogas Production and Fundamental Mass Transfer Mechanism in Anaerobic Granular Sludge

    by Zohaib Ur Rehman Afridi, Wu Jing, Hassan Younas

    Anaerobic granules are responsible for organic degradation and biogas production in a reactor. The biogas production is entirely dependent on a mass transfer mechanism, but so far, the fundamental understanding remains poor due to the covered surface of the reactor. The study aimed at investigating the fundamental mass transfer characteristics of single anaerobic granules of different sizes using microscopic imaging and analytical monitoring under single and different organic loadings. The experiment was conducted in a micro reactor and mass transfer was calculated using modified Fick’s law. Scanning electron microscopy was applied to observe biogas production zones in the granule, and a lab-scale microscope equipped with a camera revealed the biogas bubble detachment process in the micro reactor for the first time. In this experiment, the granule size was 1.32, 1.47, and 1.75 mm, but 1.75 mm granules were chosen for further investigation due to their large size. The results revealed that biogas production rates for 1.75 mm granules at initial Chemical Oxygen Demand (COD) 586, 1700, and 6700 mg/L were 0.0108, 0.0236, and 0.1007 m3/kg COD, respectively; whereas the mass transfer rates were calculated as 1.83 × 10−12, 5.30 × 10−12, and 2.08 × 10−11 mg/s. It was concluded that higher organic loading and large granules enhance the mass transfer inside the reactor. Thus, large granules should be preferred in the granule-based reactor to enhance biogas production.


  • Open Access

    Fouling-free ultrafiltration for humic acid removal

    by Hassan Younas, Jiahui Shao, Yiliang He, Gul Fatima, Syed Taseer Abbas Jaffar, Zohaib Ur Rehman Afridi

    Membrane fouling is a serious concern that significantly affects the membrane filtration process. In this study, an ultrafiltration (UF) membrane was developed with surface auto-regeneration potential by immobilizing a photocatalyst [titanium dioxide nanoparticles (TiO2 NPs)] on a hybrid polyvinylidene fluoride (PVDF) membrane to reduce fouling. The combination of photocatalysis and UF, namely, photocatalytic UF, induced the surface auto-regeneration potential to the membrane. The photocatalytic process was initiated after UV light reached the TiO2 NPs through a quartz window in the membrane containing cell. The membrane, with an optimized distribution of TiO2 NPs (3.04 g m−2), could completely regenerate itself during photocatalytic UF [with 2 mg L−1 humic acid (HA)] without experiencing membrane fouling during 90 min of filtration. The impact of temperature, an important factor for increasing the kinetic rate of the photocatalyst, was also studied. The results showed that an increase in temperature did not affect the photocatalytic process, but increased the permeate flux, which was attributed to the decrease in kinematic viscosity of the water. Finally, four consecutive photocatalytic UF cycles demonstrated the stability of the membrane for a fouling-free UF process.


  • The Extent of Heavy Metal Pollution and Their Potential Health Risk in Topsoils of the Massively Urbanized District of Shanghai

    by Syed Taseer Abbas Jaffar, Fan Luo, Rong Ye, Hassan Younas, Xue-Feng Hu, Long-Zhu Chen

    Urbanization and industrialization increase the concentrations of heavy metals in soils, which affect human health. A total of 127 topsoil samples were collected from the massively urbanized and industrialized district of Shanghai: Baoshan District. The sampling sites were isolated based on the land-use practice: industrial area, roadside area, residential area, and agricultural area. The absolute concentrations of heavy metals (Zn, Cr, Ni, Mn, Cu, Pb, and Cd) were determined using atomic absorption spectrometry and compared with Shanghai and the National soil background values. The geoaccumulation index (Igeo) and Nemerow pollution index were used to determine the existence and severity of the pollution of heavy metals. Enrichment factor (EF) analysis, spatial variability of pollution, and multivariate statistical analyses also were employed to determine the anthropogenic loading of heavy metals, their spatial dependency, and correlation among their sources, respectively. Moreover, potential ecological risk and human health risk [carcinogenic risk (RI) and noncarcinogenic hazard (HI)] were evaluated. The average concentration of all the metals (accounted as 229, 128, 56, 719, 55, 119, and 0.3 mg kg−1 for Zn, Cr, Ni, Mn, Cu, Pb, and Cd, respectively) was many folds higher than the background values. The indices depicted that the pollution exists in all the sites and severity decreases in the following order: industrial soils > roadside soil > residential soils > agricultural soils. However, Zn, Pb, and Cd showed high levels of pollution in all the soils. The EF values suggested that the majority of heavy metals are anthropogenically loaded; spatial variability showed that the pollution is more concentrated in Songnan town; Pearson’s correlation, principal component analysis (PCA), and cluster analysis suggested different sources of origin for the majority of the heavy metals. RI of Cr and Pb ranged between 2.8E−04 and 2.7E−07. However, HI was site-specific (only for Cr, Pb, Mn), and most of the sites were in Songnan town. This study could be used as a significant piece of information for management purposes to prevent heavy metal pollution and to protect human health.


  • C60 Aggregates as a Novel Catalyst: Application and Mechanism for Dyes Degradation

    by Bo Zhang, Ling Ge, Hassan Younas, Yiliang He

    Molecular C60 has been reported to enhance the photoactivity of semiconductor-based photocatalysts, leading to the production of improved reactive oxygen species (ROS), but little is known about the catalytic activity of fullerene aggregates (nC60) in water. In this study, we investigated the effect of nC60 on the degradation of organic dyes (orange II, orange G, indigo carmine, acid yellow 36) in H2O2 oxidation processes. The nC60 was found to drastically increase dye degradation under low pH condition and shift ROS balance, favoring the formation of superoxide radical (O•– 2) compared with hydroxyl radicals (•OH). Results suggested that nC60 can act as a catalyst even in the dark by promoting the consumption of H2O2 and enhancing the production of O•– 2 and subsequently accelerating the degradation of organic dyes. This work presented herein provides a strong indication that nC60 possesses some catalytic capabilities, even under the dark condition.

  • Visible light photocatalytic water disinfection and its kinetics using Ag-doped titania nanoparticles

    by Hassan Younas, Ishtiaq A. Qazi, Imran Hashmi, M. Ali Awan, Asif Mahmood, Hafiz Adil Qayyum

    The UN estimated about five million deaths every year due to water-borne diseases, accounting from four billion patients. Keeping in view, the ever increasing health issues and to undermine this statistics, a reliable and sustainable water-treatment method has been developed using visible light for water treatment. titania nanoparticles (NPs) have been synthesized successfully by a more applicable method Viz: liquid impregnation (LI) method. The bacterial death rate by photocatalysis under visible light was studied by employing a typical fluorescent source and was found to follow pseudo first-order reaction kinetics. The nanoparticles were characterized using X-ray diffraction (XRD), scanning electron microscopy, and energy-dispersive X-ray spectroscopy to deduce their size range, surface morphology, and elemental compositions, respectively. Among all the prepared grades, 1 % Ag–TiO2 was found to be a very effective photocatalytic agent against Escherichia coli. The resulted photoinactivated data were also evaluated by different empirical kinetic models for bacterial inactivation. Hom, Hom-power, Rational, and Selleck models were not able to explain the disinfection kinetics but modified-Hom model fitted best with the experimentally obtained data by producing a shoulder, log-linear, and a tail region.