Zhounian Lai
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Zhounian Lai has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
- Dazhuan Wu
College of Energy Engineering, Zhejiang University, Hangzhou 310027, China
6 shared publications Shuai Yang
Assistant Research Fellow, Institute of Process Equipment, Zhejiang Univ., 38 Zheda Rd., Hangzhou 310027, China
2 shared publications- An Zhao
Process & Energy Department, Delft University of Technology, Leeghwaterstraat 39, 2628 CB Delft, The Netherlands
1 shared publication - Bryan Karney
Professor, Dept. of Civil Engineering, Univ. of Toronto, 35 St. George St., Toronto, ON, Canada MSS 1A4
1 shared publication - Bryan William Karney
Univ. of Toronto
1 shared publication - Cv Radhakrishnan
School of Traffic and Transportation Engineering, Central South University, Changsha, China
1 shared publication
Latest Publications
- 1 January 2021
- Published by American Society of Civil Engineers (ASCE) in Journal of Hydraulic Engineering
- Vol. 147 (1) , 04020091
Numerical Investigation of High Frequency Wave-Leak Interaction in Water-Filled Pipes
Actively generated pressure waves are studied widely and applied in transient-based leak detection for pipe systems. High-frequency (HF) waves, the wavelength of which is on the order of the pipe diameter or smaller, provide higher resolution to pinpoint defects. However, the mechanism of how HF waves interact with a leak is not yet well understood. This paper investigated the effect of a leak on the HF waves in a water-filled pipe using computational fluid dynamics (CFD) simulations. To facilitate the analysis, only the plane wave and the first high-order radial modes were considered. The interaction between the leak and the two modes was analyzed. The group velocity of the first high mode was analyzed to investigate the effect of the leak on the cut-off frequency. However, the shift in cut-off frequency was not observed for the moderate leak size investigated in this paper. Therefore, it was concluded that the shift of the cut-off frequency is very small and should not be used as a signature for leak detection. On the other hand, the results showed that the leak induces very significant scattering of the excited modes. Such scattering provides clear information that may be utilized for leak detection.
- 1 January 2021
- Published by American Society of Civil Engineers (ASCE) in Journal of Hydraulic Engineering
- Vol. 147 (1) , 04020091
Numerical Investigation of High Frequency Wave-Leak Interaction in Water-Filled Pipes
Actively generated pressure waves are studied widely and applied in transient-based leak detection for pipe systems. High-frequency (HF) waves, the wavelength of which is on the order of the pipe diameter or smaller, provide higher resolution to pinpoint defects. However, the mechanism of how HF waves interact with a leak is not yet well understood. This paper investigated the effect of a leak on the HF waves in a water-filled pipe using computational fluid dynamics (CFD) simulations. To facilitate the analysis, only the plane wave and the first high-order radial modes were considered. The interaction between the leak and the two modes was analyzed. The group velocity of the first high mode was analyzed to investigate the effect of the leak on the cut-off frequency. However, the shift in cut-off frequency was not observed for the moderate leak size investigated in this paper. Therefore, it was concluded that the shift of the cut-off frequency is very small and should not be used as a signature for leak detection. On the other hand, the results showed that the leak induces very significant scattering of the excited modes. Such scattering provides clear information that may be utilized for leak detection.
- Open Access
- 12 March 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 58427-58434
Improving Reliability of Pumps in Parallel Pump Systems Using Particle Swam Optimization Approach
Parallel pump systems are widely used in industries. However, pumps are often operating under off-design conditions due to many reasons, which reduces the efficiency and reliability of the pumps. This paper aims at reducing the power consumption of parallel pump systems and improving the reliability of pumps by improving the operation points of pumps. To achieve this goal, a combination of selecting the proper number of pumps to put into operation and their speed is needed. Also, a control valve is adopted to further improve the operation points. The optimization model is built for a parallel pump system. Particle swarm optimization algorithm is used to solve the problem. Experimental verification shows that the proposed method improves the reliability and can also reduce power consumption for some cases compared to conventional PID speed regulation method. But for cases with large flow, extra power might be needed because the control valve introduces extra flow resistance in order to improve the operation point. The proposed method can be easily extended to applications based on their requirements on reliability.
- 12 March 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 58427-58434
Open AccessImproving Reliability of Pumps in Parallel Pump Systems Using Particle Swam Optimization Approach
Parallel pump systems are widely used in industries. However, pumps are often operating under off-design conditions due to many reasons, which reduces the efficiency and reliability of the pumps. This paper aims at reducing the power consumption of parallel pump systems and improving the reliability of pumps by improving the operation points of pumps. To achieve this goal, a combination of selecting the proper number of pumps to put into operation and their speed is needed. Also, a control valve is adopted to further improve the operation points. The optimization model is built for a parallel pump system. Particle swarm optimization algorithm is used to solve the problem. Experimental verification shows that the proposed method improves the reliability and can also reduce power consumption for some cases compared to conventional PID speed regulation method. But for cases with large flow, extra power might be needed because the control valve introduces extra flow resistance in order to improve the operation point. The proposed method can be easily extended to applications based on their requirements on reliability.
- 1 December 2018
- Published by American Society of Civil Engineers (ASCE) in Journal of Hydraulic Engineering
- Vol. 144 (12)
Numerical Simulation of a Check Valve Closure Induced by Pump Shutdown
High pressure surges induced by the sudden closure of check valves can cause severe damage to mechanical and hydraulic facilities. A three-dimensional unsteady numerical simulation of a dual disc check valve closure induced by upstream pump shutdown was performed and validated experimentally. An overset mesh was applied to achieve a full closure of the check valve discs and capture pressure surges accurately. The velocity field graphs improve the understanding of the flow field evolution during the transient event. The impact of system outlet pressure, initial flow rate, and pump shutdown speed on pressure surges was investigated to explore factors that affect the amplitude of pressure surges. This work improves the understanding of check valve closure behavior, which is beneficial to check valve design, selection, and operation. Additionally, this work proves that overset mesh technology could be applied to other similar flow domain breaking cases.
- 1 December 2018
- Published by American Society of Civil Engineers (ASCE) in Journal of Hydraulic Engineering
- Vol. 144 (12)
Numerical Simulation of a Check Valve Closure Induced by Pump Shutdown
High pressure surges induced by the sudden closure of check valves can cause severe damage to mechanical and hydraulic facilities. A three-dimensional unsteady numerical simulation of a dual disc check valve closure induced by upstream pump shutdown was performed and validated experimentally. An overset mesh was applied to achieve a full closure of the check valve discs and capture pressure surges accurately. The velocity field graphs improve the understanding of the flow field evolution during the transient event. The impact of system outlet pressure, initial flow rate, and pump shutdown speed on pressure surges was investigated to explore factors that affect the amplitude of pressure surges. This work improves the understanding of check valve closure behavior, which is beneficial to check valve design, selection, and operation. Additionally, this work proves that overset mesh technology could be applied to other similar flow domain breaking cases.
- 1 March 2017
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 101, 15-22
Transient performance of a dual disc check valve during the opening period
- 1 March 2017
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 101, 15-22
Transient performance of a dual disc check valve during the opening period
- Open Access
- 26 September 2016
- Published by Wiley in Mathematical Problems in Engineering
- Vol. 2016, 1-10
A Control Method to Balance the Efficiency and Reliability of a Time-Delayed Pump-Valve System
The efficiency and reliability of pumps are highly related to their operation conditions. The concept of the optimization pump operation conditions is to adjust the operation point of the pump to obtain higher reliability at the cost of lower system efficiency using a joint regulation of valve and frequency convertor. This paper realizes the control of the fluid conveying system based on the optimization results. The system is a nonlinear Multi-Input Multioutput (MIMO) system with time delays. In this paper, the time delays are separated from the system. The delay-free system is linearized using input-output linearization and controlled using a sliding mode method. A modified Smith predictor is used to compensate time delays of the system. The control strategy is validated to be effective on the test bench. The comparison of energy consumption and operation point deviation between conventional speed regulation and the new method is presented.
- 26 September 2016
- Published by Wiley in Mathematical Problems in Engineering
- Vol. 2016, 1-10
Open AccessA Control Method to Balance the Efficiency and Reliability of a Time-Delayed Pump-Valve System
The efficiency and reliability of pumps are highly related to their operation conditions. The concept of the optimization pump operation conditions is to adjust the operation point of the pump to obtain higher reliability at the cost of lower system efficiency using a joint regulation of valve and frequency convertor. This paper realizes the control of the fluid conveying system based on the optimization results. The system is a nonlinear Multi-Input Multioutput (MIMO) system with time delays. In this paper, the time delays are separated from the system. The delay-free system is linearized using input-output linearization and controlled using a sliding mode method. A modified Smith predictor is used to compensate time delays of the system. The control strategy is validated to be effective on the test bench. The comparison of energy consumption and operation point deviation between conventional speed regulation and the new method is presented.
- 1 July 2015
- Published by Elsevier in ISA Transactions
- Vol. 57, 254-261
Application of fuzzy adaptive control to a MIMO nonlinear time-delay pump-valve system
- 1 July 2015
- Published by Elsevier in ISA Transactions
- Vol. 57, 254-261
Application of fuzzy adaptive control to a MIMO nonlinear time-delay pump-valve system